I have a 2008 f350, crew cab,6.4L. with 27,173 miles. may have a problem with the steering, seems to be tight when turning from left to right or right to left, doesn't seem to center, if I turn a little to left or right it stays there. I can go in complete a circle. Raised front off ground turns ok no binding, nothing loose on the front end.
View 1 RepliesI have a 2013 es 300h.
To make a long story short, i had to have my front bumper replaced in May due to an accident but there was no mechanical damage to the car. They did an alignment to the car just to be safe.
Earlier this week, I'm not sure why I noticed that the steering was a little tight/heavy when turning left or right sometimes. It wasn't a major challenge just a little more strength then when driving straight.
Today, I took the car to the dealer and they ran all of the tests and everything came up fine except there was a code that the hybrid battery had been disconnected during the repair while sitting at the shop which created some sort of code that they cleared. The tech mentioned that this may have created the steering issues since the car may have thought their was low power.
After, I did notice it was a little better but still a little tight at times. I took the car back to the dealer and had the tech drive the car and he said the steering was normal for the car. Are they missing something or is it that I forgot how the car drives?
my 99 f250 sd ABS light comes on and the A/C stops, when the ABS light goes off, A/C comes back on. Any clue as to what is happening?
View 5 RepliesJust did the rear brakes on my 05 EX. New rotors and pads. Now there is a squeal when going around a left turn. It is a constant squeal when going around a left turn, not a squeak-squeak-squeak. Sounds like it is coming from the left rear. Took it back apart to make sure I didnt miss anything and everything looks fine.
View 1 Replies2001 7.3L I purchased used with 200K on it. Trans hesitates going from 1st to reverse and reverse to 1st. It seems more pronounced going from 1st to reverse. Fluid is clean.
View 2 RepliesSuddenly I notice noice/clunk when moving from P to R/D or to P from R/D with voice like shifting something , also I am feeling Like something hold the gear sticky, I think the voice came from the transmission itself.
My car santa fe 2009 / 70,000 KM , 2700 cc automatic gear. I changed the transmission fluid since around 2 month @ 64k from the Hyundai dealer , with reset the transmission software ,
is it normal to have or there is something major , is that to indicate of problem at the transmission ??
My 97F250, 7.3 diesel, 4WD has an intermittent steering issue. When I come out of a turn, it doesn't want to come out of the turn all the way. It will keep pulling one way, and I have to jerk the steering wheel in opposite direction, and sometimes the truck then over corrects quickly the other direction. Mechanic said front end looks good, so he replace the power steering pump. That didn't work...
View 4 RepliesI have a 1991 F250 Lariat, 4x4, 460 engine, auto trans. I am having trouble with my steering. The power stering turns good to the left but when I turn to the right it is like there is no power and is very tough to turn.
View 1 RepliesI continuously read that people with 6.2 F250s averaging 13 mpg or so in a combination city/highway driving. This 2014 4x4 barely has enough power to move itself (honestly, I'd rather have my Ram 1500 back) and barely gets 10mpg. Basically have to give it about half-pedal to even get up to freeway speed and floor it if i want to pass anything. Is it just that much of a POS or does this not sound right? Other than a massive "clunk" sound when shifting from reverse to drive or vice versa, no indication of any problems.
View 14 RepliesMy sonata 3.3 dies when switching from forward to reverse and vice versa. Suspecting the fuel pressure regulator. Have seen conflicting sites saying its on the firewall and some saying in-tank. What else may be causing this.
View 2 RepliesOne my F350 with 175,000 miles on it, at low speeds when turning the steering wheel it seems as if it has two places during use that it rubs or has an oblong spot in it. I have 285 tires on it and have for years.
Kind of like if you were turning a shaft in a seal and it rubbed or was rough. It makes a faint, muffled, barely audible grinding noise or feel. I have a lift and level of about 4" and 285s for years. This just started in the last 5 months or so.
2016 push button start, need to confirm something? It's cold up here in these parts this time of year and I have been letting my car run for a few minutes when it's frosted over in the morning. The issue I'm having is that I start the car and go back into the house. When I come back out to get in, The driver's door is unlocked but the rest of the doors are not. When I press the unlock button on the key fob, nothing happens. Is this how it's supposed to work or do I have an issue?
View 4 Replies2008 F-350 wheel will lock for no reason. I think the Hydroboost has a hair line crack it and when the temp and pressure reach a certain number then it sends brake fluid threw the crack to the caliper? I also heard it could be in the ABS because its locking just one wheel?
View 1 RepliesLooking to replace the steering stabilizer on my 2008 F-250. It has a 6" lift and 37" tires.
Also, does "dual" mean better?
1996 F350 PSD 7.3
Front Dana 60 mono beam
4 x 4
Last week I broke my front right caliper. I replaced the caliper, rotor and pads. Now, when I apply the brakes I pull to the left. I took the truck into my repair shop and let them figure it out. They were unable to repair the truck. They replace the master cylinder, all brake lines, calipers on both sides, brake pads, bearings on both wheels, vehicle alignment, tire balancing and tire rotation. The tires are three months old. Prior to last week i did not have any problems braking or steering. Driving at 60kmh the truck goes straight until i gently brake, it will slightly pull left.
My 97 f150 had been sitting for a while and after a few miles I could smell brakes and the left front rotor was hot. So I removed the caliper to see if I could free it up. When i push 1 piston in with a C clamp the other one comes out and visa-verse but I cannot push both in with 2 C clamps. When I push the brake pedal they both come out. Its like there is a check valve in the line. How should I go about trouble shooting this?
View 1 RepliesThis is on my 2002 Ford Excursion 4x4. I have replaced the brakes 2 times with the same results.
New: rotors, pads, calipers and grease the caliper slide pins so they are sliding properly. I have also replaced the slide pins the first time. I even lightly greased the ends of the brake pad back plates where they mount in the calipers/brake clips. There is always more brake dust on the left front wheel compared to the right front. The steering wheel turns to the left when I hit the brakes. I can't figure this out.
The one thing that seems strange is it was very difficult to get the pads and brake pad clips into the caliper. It almost seems like the pads are too tight into the clips/caliper. I am wondering if taking a little material off the ends of the brake pad back plate to allow better movement in the caliper/clips.
The left front is either grabbing too much or the right front is not grabbing enough.
Lexus es 350 steering wheel is heavy/tight when turning?
View 2 RepliesI've got an 08 F150 and the steering has gotten tight when at low rpms or when not moving. The pump's whining and laboring. Fluid is clean and full.
View 3 RepliesSo our 2006 f150 fx4 has been having an issue with stiff steering... at times like it doesn't have power steering at all.
We recently had the lower ball joints on both sides replaced. Before that the upper control arm on the drivers side was also replaced.
There are days that it is better... other times not so much.
Yesterday while driving, i lost all power steering and power brakes (you would automatically think Booster). I pulled over, popped the hood and fluid was spewing from behind the power steering pump somewhere. I limped the truck home about 20 miles. I checked brake fluid and it was full. checked power steering fluid and it appeared to be empty. Yet when i added fluid it took less than a half quart. I started the vehicle to pressurize the pump and find the leak. Yet the pump never pumped any fluid. (one would thing pump was out) I am baffled as to if the pump went out, why fluid loss? If the booster was out, why do i still have brakes just without power assist? Andif a hose is blown, why such small fluid loss? I dont want to just start replacing parts till it get the right one
View 1 Replies