Ford Brakes/Suspension :: 2001 - Shudder / Shaking Intermittently - ABS Light On?
Mar 1, 2015
Had a shudder/shaking sometimes on my 01 Superduty. Found left front caliper was sticking. Took it to a shop and he replaced both calipers and pads. Picking it up after he was done and he asked if I had the ABS light on before the work was done and I said NO. He tried and tried to get the light off but it is still on. Codes are C1155 and C1158. I got home and checked the abs connector it seemed ok. Looked at the master cylinder and it was a little low but also noticed he did not put the cap back on(it was just sitting aside). I kinda thought if he got air in the system....it would be a hard pedal but all works ok except for the ABS light. Will not go into how it shudders a little when stopping because he did not resurface the rotors like I asked. Maybe I should go back thru and bleed the brakes again?? The abs sensor on the hug is approx. 3 years old. and have never had the abs light on.
View 2 Replies
Advertisement
I have a 97 F250 that is having reoccurring brake issues, It has an intermittent hard pedal with little to no brakes when it occurs. It will stop but you are standing on the pedal with both feet. I have replaced the booster, master cylinder, and the vacuum pump in the past trying to isolate the issue and still had the problem. On this year model the abs ids only on the rear correct???? if it is shouldn't it only be affecting the rear brakes? Since this truck has a dual reservoir MC the front should still work?
View 4 Replies
Trying to figure this out...no luck yet.
I have a 2001 Expedition (5.4L V8). The ABS light has been on for some time. I finally got around to reading the code, and it reported "B1185 - Antilock Brake System Power Relay Output Circuit Malfunction". I have read and found information on the C1185 code, which sounds similar, but very little on the B1185. Not sure what to try.
What I have done thus far is replace the rear ABS sensor that is located on the rear differential. No change. I also replaced all four rotors and pads, but that was due to a pulsing during braking caused by a warped rotor. The pulsing was cured after replacing the rotors, but the ABS light remained unchanged. I removed both front wheel ABS sensors, and thoroughly cleaned them with brake-parts cleaner. Still no change. I have checked the fuse under that dash for the ABS system, and it is fine.
What to try next? I really didn't want to just start blindly shotgunning parts because I don't understand what B1185 really means. Perhaps someone else has seen this on their truck/expedition?
View 5 Replies
My f150 steering appears to be not as smooth as when originally purchased. Only 50k miles. Typically driving at higher speeds and making slight correction turns it appears to bind just slightly then when it does move the truck tends to over steer.
This is an intermittent issue and can be hard to replicate. Best noticeable at highway speeds as the change occurs more quickly. Doesn't show up once you into a turn but instead most noticeable when going from straight to slight turns. No aftermarket changes since new. Happens with or without pulling loads. Again from center of steering position.
View 1 Replies
Have 2005 excursion. Just did ball joints , wheel bearings all of them, axle joints and seals.Also warn manual hubs. Have a intermittent scraping grinding noise sounds like driver but could be both front.4wd works fine in high or low, no vibration just this annoying noise. took brakes apart and no funny wear or foreign object in dust shield.
View 3 Replies
Two weeks ago my front left wheel would start shaking like hell when I brake, not at first but after say may eight miles of driving. I have never been in a vehicle shaking so violently and after proceeding from a stop it would continue until it cooled down. I tore out the caliper and made sure everything was clean and lubed and also to make sure I did not put the pads on wrong. Fast forward one commute and the same crap. I could not go faster than 45 mph without feeling like it was going to disintegrate.
When I got home the damn thing was smoking. I managed to get it to the dealership this afternoon and two hours later the guy told me that the guides just needed some cleaning and grease. They did not want to charge me anything (draw your own conclusion) for it. I was told they drove it up/down hills and it was alright. I left kind of suspicious and four miles later the problem revealed itself again. My next thought it maybe axle end play, bad bearings or joints? Intermittent why? 2004 f150 lariat 4x4 ....
View 4 Replies
My son was driving my 02 Passat and said the brakes were sticking. It's intermittent, so after a couple test drives, he was right. Clearly the brakes were engaged. The rotors need to be turned and it made the car shake like crazy around 45mph.
Took it to the local tire/brake/muffler shop and they replaced the master cylinder but that didn't fix it. I am getting no codes or warning lights for the braking system and it only happens about 1 in 5 drives.
View 10 Replies
2008 F-350 wheel will lock for no reason. I think the Hydroboost has a hair line crack it and when the temp and pressure reach a certain number then it sends brake fluid threw the crack to the caliper? I also heard it could be in the ABS because its locking just one wheel?
View 1 Replies
I have a 2001 5.4L excursion that intermittently shakes (feels like rumble strips/rough pavement) usually at 45-50 mph when the rpms are between 1500-2000. Increasing or decreasing rpms stopps the shaking. What could this be? I'm trying to figure out how much I might have to pay for repairs (pretty sure I'm not up to diying this one) without an expensive estimate.
View 9 Replies
Problem started with the front end shaking a little bit when braking like the rotors needed turning. Then the brakes began to intermittently hum when stopping. Then my ABS light came on. Put the truck up on the stands and disassembled the brakes on both sides. The ABS sensor was chewed up on the driver side. The less than year old hub felt sloppy so I changed it. Put everything back together.
New hub came with new ABS sensor. Went for a test drive ABS light is gone and I no longer shake or experience the hum when applying the brakes. However now when I go to stop right before I come to a complete stop the driver side (new hub/spindle side) I hear what sounds like the grade school class clown making a fart sound with his mouth, and the truck pulls to the driver side. Is the ABS system malfunctioning or is this a caliper issue? Calipers look like they are OEM.
View 3 Replies
I have a 2003 Hyundai Sante Fe 2.7 v6. About 2 months ago I started the car and it was kind of a rough start. It usually starts right up. I was driving in the rain and when I would press the brakes the car would shudder like it wanted to turn off but the head lights and dash lights did not flicker. I had it towed to my mechanic. He found a broken vacum hose and replaced it. The car seemed fine.
Today it started up kinda rough and then would shudder and not accelerate no matter how hard I pressed on the gas pedal. It was also idling roughly.
I bought the car from a friend who was the first and only owner. She has ALL of the service records and took good care of it. It has about 120k miles on it. The spark plugs and battery are only about a year old. It has a half tank of gas. I checked all fluids, pulled a few plugs and they look fine too. Air filter is clean too.
I asked the previous owner if she had ever changed the fuel filter and she said she didn't think so. I reviewed the service records (assuming I have them all) and it doesn't look like it was ever done. I have run seafoam through it 3 times since I bought it last August. I change the oil regularly and rarely let the gas get below 1/4 tank.
View 10 Replies
I have a 2001 F150. Front brakes replaced a few months ago. Last night, I realized my rear brake lights weren't working. I'm not sure how long they've been out or if it's related to the bigger problem.
While testing the brake lights by pressing the brake pedal, the pedal seemed to give out and sink lower. While driving the brakes worked but only when I pushed the pedal all the way in. Eventually the ABS light came on and stayed on.
View 3 Replies
I have a 1997 F150, 4X4. My mechanic says its time for new brakes and was curious if it would be worth possibly converting from drum brakes to disc brakes??
My mechanic has quoted me $300 to do the rear brakes, would it be worth the extra money to convert??? I really don't care for drum brakes. I have done a search on the internet and every time it brings up the issue with the parking brake.
View 1 Replies
My Superduty will randomly squeel for a few seconds or just one. It seems to happen randomly. The hub doesn't have play.
View 1 Replies
My dad has a 2008 F150 with just over 36K on the clock, and wouldn't you know it the ABS light came on. He's been a Ford guy all his life and excellent with a wrench, but has never worked on an ABS problem. BTW, this is the first problem he's had on his last 2 F150's.
I know we'll need to plug it up to a scanner. My question is can we plug up to the OBDII port or is there another ABS port we need to plug into, and will a regular scanner work, or do we need a special scanner?
View 1 Replies
92 F250 4x4 with 140,000 mi. Abs light came on, Replaced the sensor on the rear axle, Light is still on. When the light comes on the brakes still work but it takes more pedal to stop. Now the Brake light comes on, It has new pads on the front, and its bleed out good. When you drive it some times it works fine, then out of the blue it lights up.
I have checked the fluid level, parking brake switch, and even swapped the abs black box with another, also bleed the bleeder on the left frame rail. When the lights come on you can pull off the road and turn off the motor and restart the lights stay off for several brake applies, then sometimes they light back up. The light issue is not that bad to me but it drives my wife crazy. I am more concerned about it taking more/harder pedal to stop.
View 8 Replies
2001 F-350 / 7.3L / 147K ... What are some symptoms of the master cylinder going out? And is there a such thing as a rebuild kit anymore? The pedal has been getting spongier & spongier over the past months. Truck still stops O.K. but you have to brake earlier than I used to. Pedal can go almost to the floor. Pedal continues to go to floor as pressure is applied. Does not go to floor though.
View 4 Replies
So lets see if I can put my issue into writing....
Have an 02 f250 v10, last summer replaced the steering gear box, havent had any issues til this spring.
Beginning of spring my ABS light came on during casual driving, wasn't to worried as the rear sensor often gets dirty and needs cleaned- cleaned the sensor and the light remained on this time.
While driving (and the light being on) I would at random get a very heavy vibration/shake from the front end and if I apply the brakes while that was happening the truck would pull real hard to the right, the shaking feels like a death rattle- like the ABS was firing and was using steroids, then it would go away. (the brakes would occasionally smoke a bit on the left front side afterwords)
So like that problem wasn't annoying enough, while trying to diagnose the problem the ABS light clicked off, and I wasn't able to recreate the vibration, but I noticed when I would apply the brakes, at say a stop sign, the brake would press in another inch or so (after already being stopped) and then I could hear a loud whine from under the hood.
The fun is these 2 problems seem to keep swapping positions- and I am at a loss of what could potentially be the cause- (I assumed the 2nd problem where after stopping the break pedal going soft another inch and the whine could of been air in the system- I bled the brakes and no change)...
View 1 Replies
My 2012 F250 4x4 tire pressure warning message/warning light it on, I have checked all tire pressures, they seem fine, i s this a common problem and what normally has to be done to fix the issue...
View 14 Replies
Front and back brakes heating up and locking on intermittently brake pedal feels normal this has happened 3 times over the last 500 km of driving pedal not sticking down break fluid ok no swelled lines today noticed front left and rear right rotors were hotter than front right and rear left once vehicle sits they release and all is good no abs lights or any other warning lights on.
View 1 Replies
Two months ago, I replaced the rear drum shoes, wheel cylinders and seemed after that I was ok until today. I checked the rear brakes and they are split in half. i noticed my abs & brake lights lit up this morning. I would think the ABS is getting stuck? How do I check the ABS? This morning I felt like something was holding back the truck. I continued and when I got home I said to myself, let me just check the rear brakes and thais what I found. Both sides had the shoes broke.
View 1 Replies
