Ford - Aviator :: 2005 - Airbag Light Constantly On - Code 33 Staying?
Aug 21, 2012
Just recently started getting what started as an intermittent air bag light that is now on constant. I seem to be getting a code 33.
View 5 RepliesJust recently started getting what started as an intermittent air bag light that is now on constant. I seem to be getting a code 33.
View 5 RepliesI have a 97 f150 4x4 4.6 the airbag light in the cluster is constantly staying on it does not flash at all. The only threads I can find are for the airbag light flashing which mine does not do. The passenger airbag light is not burnt out so that's not the problem. Where to start looking.
View 2 RepliesJust bought a 2002 F-250 4x4 Off-Road Crew Cab 7.3L and the airbag light is staying on. I have found out after the fact that the truck has been previously involved in a front end collision. The damage was to the passenger side front. I turn the ignition on, the airbag light will come on solid (just like all the rest, with the exception of the 4x4 and 4x4 low) then go out. Then it flashes slowly 2x then 5x, then goes out for a bit then repeats a few times before staying on. This tells me I am getting a code of 25. I have searched with no luck to narrow this issue down. Everything mechanically works, cruise, horn, etc. The only thing I can find wrong is when I engage the 4-wheel drive (floor shifter) the indicator lights do not illuminate in the instrument cluster. Neither the 4x4 nor the 4x4 low. I am unfamiliar with this truck, so I don't know where to began searching. I cant afford to take it to a dealer and I have children in the truck quite often, so I would like to remedy this very quickly.
View 9 RepliesI have a 2005 dodge caravan auto trans the air bag light stays on hooked it to a computer it reads driver seat belt tensioner circuit open I have replaced both ends of the seat belt but it is still on what could be wrong?
View 2 RepliesRecently I have noted the SRS light has stayed on constantly -- I thought perhaps because I placed a heavy box of books on the front passenger seat - and it was telling me that I needed to fasten the seat belt. The light went off initially but not too many days later -- the SRS light came on and has stayed on ever since. I had it "diagnosed" at the dealer and was told that the OPDS sensor has failed. It was explained that this is something "electrical" and if not working properly that none of the airbags will deploy if needed in an accident. However, since the "diagnosis" -- and driving my car home and on an errand or two -- now I see that the SRS light is off. Did the "diagnosis" with the computer actually "reset the SRS light" and is it possible that my OPDS sensor is actually "okay and not in need of an expensive repair"? I would like to know that my airbags are going to work -- in the event of a serious impact - would running another diagnosis confirm that the OPDS sensor is faulty or confirm that "all is working well with the SRS system". I know the dealer doesn't care -- if he takes my car if for a repair that is no longer needed - but I do care.
View 8 RepliesI have a 2004 Aviator with a 5r55S transmission.
O/D light started flashing, difficult to shift gears, MIL came on with P0745 code
I have changed the filter, installed new solenoid block, adjusted bands, topped off fluid with Mercon V. No change in symptoms.
Bought an '04 Aviator 2wd on Saturday. ABS light is on almost all of the time, but it has turned off a few times. Pulled a C1155 code. I removed the left front sensor, and there was no dirt, metal, debris, etc in the hole. Before I buy a new sensor, is there a test procedure to follow on the old sensor??
View 2 RepliesI have a bad sensor in a tire that just had a flat. I have ordered the sensor for the wheel and I am wondering after I install the sensor in the tire will the 'reader' pick it up and reset itself or do I need to go through the programming of the new sensor? At this time the TPMS warning light comes on and flashes for a minute or so before staying on constantly. This tells me it's trying to read the tire sensors but there is a fault, which is the tire sensor where I just had the flat. Costco tells me that sensor reads 78psi, which is incorrect. The fact that the reader is trying to read all the sensors and getting an error makes me think that it might reset itself when the new sensor transmitter is put in the tire? Any chance of this resetting itself or will I need to reprogram the receiver unit?
View 12 RepliesThe air bag lite is flashing 3-3 when you start up the truck. After several 33 codes it stays on constantly. I look up on internet and 33 is "passenger air bag open circuit". Pulled the glove box door and disconnected the wires and wiggled and reattached, still have code.
View 7 RepliesWhere to begin, I've checked things i thought could be the issue but aren't. I am having a constant e-brake light on which as you know emits the loud and annoying beep sound. What I've checked and done:
I checked the brake fluid, its fully topped off. I also removed the ebrake switch (the thing under it that when depressed pushes the button and turns the light off) and just crossed the wires to complete the circuit (this does the same as the button essentially) before buying a new one to see if that was the issue, which is doesn't seem to be. I had my buddy run vagcom which turned up no codes that SHOULD make this issue occur. I even popped in a new brake light switch which didn't work.
At the same time of this happening my car is making ZERO boost at all. Is it a coincidence? I don't know... it's just weird they would both happen at the same exact time. Again, no codes are showing up. Checked lines and didn't see any potential boost leaks. What to do.
O/D light was blinking and "check trans" message was on display. I brought in for service and they changed trans fluid & filter. I have to take back to service center because now tranny is slipping. I would like to have some information before going back. It was not doing this before service. It is OK on highway for most part, happens more when starting out. Also has shut off a few times while sitting at a light. It didn't do any of this before service. What would cause this? Could it be the wrong fluid or not enough added?
View 1 RepliesI have hooked up an amplifier in my 06 sonata.For that i had disconnected the battery for around 4 hours.After finishing the installation i reconnected the battery started the car now airbag light is constantly on. What should i do?
View 6 RepliesSo today I get in my car and the air bag light is on solid, no blinking. I scanned it with my scanner and it says no codes Any body else have this happen? I got a bad feeling about this light
View 10 RepliesThe airbag readiness light stays on while driving my chevy truck. I know it means that there is a problem with the airbag system. My question is: Will the airbag go off randomly while driving? not during an accident?
View 1 RepliesNot sure what happen that led to the Airbag light next to the speedo staying on.
Codes retrieved:
B1346 = DAB circuit resistance high
B1481 = DAB module circuit resistance high
B1329 = DFIS to SRSCM communication error
B2502 = Telltale ind light circuit malfunction
B1388 = Driver Seat track position sensor open or short to power
B1378 = DSAB circuit resistance too high
B2500 = Air Bag Warning light circuit fault
B1511 = Driver Belt Buckle switch circuit open or short to power
Where to begin solving for this problem.
I have a 1999 jeep Cherokee there is no check engine light on. But the air bag light stay on. I scan for a code it gave me a ( p.0.1698). What that is. My code scanner only go up to p.0.900...
View 2 RepliesI have a 2007 sonata gls with 2.4l engine. The airbag light on instrument panel stays on. A code b1102 has been stored. The code description is low voltage. I've been told its a bad srs module under center console.
View 2 RepliesMy girlfriend just bought a 98 XLT AWD 4.0. does have a few problems.
First, the brake light is on (on the dash). all the lines are good, but the front pads need to be changed. if i take off hard, the brake light goes out for a bit.
Second, had a CEL. P0743, torque converter clutch circuit blah blah. also, the o/d light flashes constantly.
The trans shifts fine, even under WOT. also goes into o/d with no problems, and the button works.
Any way to disable the annoying seat belt alarm. I do wear my seat belt but I can't even get out of my driveway before it goes off, also if I drive one block to the store and don't feel like putting it on. I have tried the disabling procedure in the owners manual many times and it does not work. I have also tried other procedures posted on the internet and they didn't work either. If the alarm wasn't for other things like keys left in ignition, etc I would have cut the wires by now.
View 14 Replies05 GMC pickup,service air bag light staying on. What needs to be done with this?
View 2 RepliesMy car is a 2005 Mazda-RX sport. It was parked outside in the -14C Celsius and towed away to the next street .I now notice, for the first time, that the engine warning light is on constantly as I drove it today.Yesterday, it was the TCS/DSC light that was on constantly but that was not the case today!According to car's manual it could be either the engine's electrical system or exhaust gas cleaning system. It also recommended that I should drive it slowly and take it to a Mazda dealer immediately. Needless to say that while driving it today at top speed engine sounded perfectly Ok!Waht could be the actual problem ,if any, and what should I do?
View 2 Replies