Ford Aerostar :: Replacement Plastic For Extended Rear Bumper?


Jul 11, 2015

Mine is all busted up. All I can find are covers for shorties.

View 6 Replies

Advertisement

Passat (B5) :: How To Remove Red Plastic Lens On Side Of Rear Bumper

How is the red marker light lens, located on either side of the rear bumper, removed to allow the bulb on the inside to be replaced?

View 2 Replies

Ford Wiring/Electrical :: Bar Light Replacement Between Rear Bumper And Tailgate

2000 F350 CC DRW 4X4. There's a 3 light bar lamp mounted here that needs replacing. Plastic mounting -Grote 10-7016-01 PCC.- Can't find one. looking for replacement PN? like to have LED.

View 1 Replies

Ford Super Duty (1999-2016) :: Replacement Of Rusty Rear Bumper?

my rear bumper is pretty much eaten up, too.

How difficult is this to replace?

Good source for rear bumpers? Just something stock; don't need anything wild, crazy, lighted, etc.

It's a work/hunting/fishing/hauling truck. That's all.

View 1 Replies

Lexus RX 2004-09 :: 2008 350 - Rear Bumper Reflector Replacement?

My rear bumper reflector in 2008 Lexus RX350 broke (red plastic part below the tail light). I see replacement part in ebay for around $50. Is it easy to replace? Do we have to remove the bumper?

View 1 Replies

Accent RB (2012+) :: 2013 GLS - Rear Bumper Cover Replacement?

I have a 2013 Accent GLS and I have to replace the rear bumper cover. Any detailed instructions on how to do this?

View 2 Replies

Lexus RX 2004-09 :: RX350 Rear Bumper Reflector Replacement / Installation?

Do I need to remove the rear bumper to replace the rear bumper reflector?

View 8 Replies

Ford F-150 - 1997-2003 :: Rear Door Will Not Open Of 2002 Extended Cab

I have a 2002 F-150 extended cab and the rear door(drivers side) quit opening a few days ago. No warning--worked one day and just stopped opening the next. Are there any tricks to getting the panel off to ck. for trouble spots?

View 13 Replies

Ford Aerostar :: Back Glass Replacement?

I recently came home to a shattered back window on the lift gate. We were gone on vacation for a week and I didn't notice it for a couple days after we were back. The van was backed up to my second garage door. Not really sure how it happened. Nothing was taken from the van and I live in a pretty decent neighborhood, so I don't think it was vandals. Only thing I can contribute it too is the heat (it had gotten pretty hot in WI while we were gone).

So I'm in the process of replacing it. After a pretty good search I was able to obtain a used window from a junk yard. The glass is in good shape but it is missing 3 of the 'studs' that are imbedded in the rubber molding. I have the 3M Window Weld butyl 'tape' (3/8") to seal/adhere it to the fiberglass. Will the remaining studs plus the tape be enough to permanently keep the window in place?

If not, I can salvage the studs from the old molding but then I have to figure out how to glue it to the new window. I'm not sure what I can use to do this. I've considered JB Weld, Epoxy, super glue or something like rubber cement. It looks like the old studs were ripped straight out leaving kind of a void in the hard rubber molding. The bottom of the void is I believe rubber (not glass).

View 10 Replies

Ford Aerostar :: 1995 - Outer Tie Rod Replacement

I was wondering how do i replace the outer tie rod on a 95 ford aerostar awd 4.0L. I have enough for the parts but not extra tools. Need a tutorial on how to do it?

View 6 Replies

Ford Aerostar :: Code 9 Flashes - Electrical Replacement?

What's inside that electric clutch? Mine will not lock up. I checked the sensors, the solenoid resistance - all good. Hotwired the thing to bypass the control module - no avail. It flashes a code 9 which is a mechanical problem but I was told that the clutch is so simple there is nothing that can be broken. Does it have some kinda lining that can be worn?

View 14 Replies

Ford Aerostar :: Fuel Pump Replacement Through Floor

I seem to remember a old post but I can't find it! Someone replaced the fuel pump by cutting a hole through the floor.

View 14 Replies

Ford Aerostar :: Bushings And Upper Control Arm Replacement

We've got a '96 aerostar (4x4). The bushing and upper control arm seem to need replacement but the parts seem to be obsolete. Any source for these (other than salvage yards)?

View 14 Replies

Ford Aerostar :: Upper Control Arm Bushing Replacement

Any hints on a easy way to change these.

After I have the wheel off do I need to disconnect the upper ball joint to remove these. It looks like I can just remove the two nuts on each side and use a jack under the rotor to support the weight. It looks like it might shift back and forth enough to get them out/in.

Will this work?

View 14 Replies

Ford Aerostar :: Replacement Of Proportioning Combo Valve?

cant drive 96aero cause cant find a proportioning combo valve.

View 5 Replies

Ford Aerostar :: 1988 - Steering Column Replacement

My `88 Aerostar needs a replacement steering column. I believe everything can be swapped over therefore color of steering wheel does not matter. Cruise control buttons and tilt are a must. I would like to find one that is tight(er) and not sloppy floppy like mine is slowly becoming (143k miles).

View 1 Replies

Ford Aerostar :: Driver Seat Bottom Swap / Replacement

I'd like to know if a 2nd row captains seat can be use as a replacement for the 1st row driver's. I'm referring to the seat section itself, not the entire frame. I found some excellent condition seats but they are from the 2nd row. My Aero is a '95 and I don't know(yet) which year van the seats came out of.

View 11 Replies

Ford Aerostar :: Power Steering Fluid Leaking - Pump Replacement?

Proud owner here of a '96 3.0L RWD Aerostar Utility Van with about 138k miles, and leaking power steering fluid. At this point I'm replacing fluid from zero every time I have to drive it which is about once a week. I've located the leak and it seems to be coming from the pump/reservoir around the pressure hose. The hose is loose as in i can move it around a bit, but from what I've read, this is normal and the hose is supposed to be like that. I figure that at this mileage, with so much air going through the pump, all the crazy squealing and whining it does even when full, at this point it probably makes sense to replace the whole pump while I'm in there, as opposed to just doing the reservoir. Anyway, I'm planning to do this in a couple of weeks, and have some questions...

1) The pump - I've read on this forum that the best way to go on brand of the pump is Motorcraft.

2) Hoses - I'd like to replace the hoses coming out of the pump while I have this thing all taken apart, but I'm not exactly sure what parts to get. I know one is the pressure and one is the return, but there are variations of each based on the research I've done. The parts on the Napa site have different descriptions like "with switch port", "without switch port" "56in hose" "26in hose", and so on. Which ones I need, specifically the ones connecting directly to the pump? I havent been able to find anything in my research online, in Haynes, or Chiltons manuals.

3) Washers - Whether or not I replace the hoses, should I replace the washers at the connection point? Chilton's seems to recommend replacing them. Will they come with the new pump?

My local auto parts shop has the pulley remover/installer for me to rent so I've already got that squared away. I'm pretty sure I've covered all of my bases otherwise.

View 1 Replies

Ford Aerostar :: Driver Side Front Door Window Glass Replacement?

Did some searching but didn't find anything on how to replace the driver's side front window glass. Someone decided they liked my GPS unit more than I did while I was at work. Smashed out my driver's side window and took it. Now to replace that window. I did manage to find a replacement window.

Pulled off the door panel and now I'm trying to install the glass. Anything I try though, I can't seem to get the glass back into the tracks. Does anything inside the door need to be removed before I can install the glass back into the tracks? Such as the window motor/regulator assembly? On the left side of the drivers door towards the bottom, there is also another small alignment track. Does this need to be removed as well?

View 9 Replies

Lexus LS 2007+ :: Front Bumper Cover Replacement?

Replacing bumper cover, is there anything I would need to replace underneath it or is it just a simple swap out?

View 4 Replies

Touareg :: Installing Reflector On Right Rear Side Of Lower Rear Bumper?

How to remove/install a reflector on the right rear side of the 'lower' rear bumper? I don't see any screws. So, can I pop it out with a screwdriver? Or, is it attached from the inside?

View 2 Replies





Copyrights 2005-15 www.bigresource.org, All rights reserved