Ford Aerostar :: Location Of 02 Sensors?
Jul 31, 2012
Where are they located?
View 7 RepliesWhere are they located?
View 7 RepliesMy 2005 F250 started stuttering, lurching, having wild swings in rpms, nearly dying at stop signs, no pickup when stepping on the gas, then taking off like a bat outta hell. After reading many, many posts here and on other sites, I have concluded that the most likely culprit is the ICP sensor, so I picked one up today (along with a EBP sensor - another story). It appears from the many posts that I have read that Ford/Navistar have frequently changed the location of these sensors. My question is: Where are the ICP and EBP sensors located on the 2005s (actual manufacture date is 07/2004)?
View 6 Replies97 3.0 2WD, Where is the differential vent or does it even have one? I've got a rear axle seal leaking.
View 5 RepliesWhere the fuel filter for a 1997 ford aerostar is located? I have been told it is under the driver side near the front tire. I cannot find it anywhere. Is it near the middle by the transmission? I would like to see a schematic also?
View 4 RepliesWhere is the Blend Door Actuator on the ford Aerostar?
View 14 RepliesI'm having some trouble with the front blower fan on my 97 Aerostar 3.0, it will only intermittently work, one time we had it running, lifted up the hood on the van, checked the connection to the motor, looked good, dropped the hood and the fan immediately started working again, I'm wonder if the relay might be starting to go bad, the fan in the back works, so I'm not sure. Where the relay is for the blower motor, or what might be wrong?
View 6 Replies1992 3.0L aero crancks but won't start. Gives codes 114 and 116, these are about IAT and ECT sensors. Where is the ECT exactly located? I see 3 or 4 sensors that are screwed to intake manifold over there. I would like to find the sensor for dash cooling meter too, because it is moving only a fraction of the distance that it should. Thermosthat is checked, it seems to work.
View 2 RepliesI plan on changing the 2 sensors from the codes p0138 (bank 1, sensor2) and p2195 (bank 1, sensor 1). Any visual picture on here to locate these sensors?
2007 Xamry XLE V6
Looking for a diagram of the locations of the oxygen sensors on this vehicle, I am getting miss information from all around saying it has anywhere from 2-4 oxygen sensors and i think it has 3 am i right? two in the front behind the radiator on the exhaust manifold, and 1 somewhere by the catyaltic converter. There isn't a whole lot of manuals out there for these cars.4.0 ltr engine...
View 4 RepliesI have a 2004 vw toureg 3.2l v6 and i have two questions. first is where are the brake pad sensors located in the pad or outside of the break pad? Second question is TPMS light is on due to a dead battery in one of the tires how do i kill the whole system?
View 1 RepliesMy gf's son has an old 2000 Jetta 2.0 and when the check engine light came on and shifted poorly, it was diagnosed as a problem with the transmission input and/or output sensors. Where are they located exactly?
Both look pretty much the same, but here's a pic of one of them : [URL] ....
Bought a 2005 Ford Explorer XLT and 3 sensors keep going off for no reason door oil and low tire has any one or does any one know how to fix - DIY?
View 1 RepliesSo Wife did this nice "How-To" for the site and then we celebrated with a trip to Steak N' Shake. Halfway there I could feel it running a little off so I pulled up the app on the phone and connected it. I pulled up the codes and this is what I got.
So am I looking at an O2 sensor you think? It's shifting early and chugging a little as well. When driving it sounds a little like I have dual exhaust or a flowmaster. When sitting still at a light there is a small bump like bass turned WAY low coming from the exhaust as well. I turned around halfway there and went home and we took the wife's Highlander
Recently smogged my excursion, passed the emissions but failed self test. O2 sensors not ready. Drive it 40 miles everyday and still wont pass.
View 10 RepliesIs it possible to turn off the backup sensors on my X ?
When I am towing these things drive me nuts!
I just replaced the transfer case BW 4405. And I noticed that the 2 sensors (front drive shaft and rear drive shaft) are bad. What is the name of these two sensors? I'm looking for a brand new ones...
View 13 RepliesI've replaced the rear sensor and the two front ones on my 2002 Ltd, but the lights still on! It's driving me crazy...what now?
View 7 RepliesOutside backup sensors both went out on my03' Excursion, but the inside ones are still working.
View 3 RepliesI have a 1998 Ford Explorer 4.0 V6 with 200K miles. I plugged an OBII scanner with live data readings and my o2 sensors never relayed any information (voltage), they all ead -100% and the voltage never changed. Could all four be bad? I left the truck running for 15 minutes with the scanner attached and nothing changed.
BANK 1 SENSOR 1 = -100%
BANK 1 SENSOR 2 = -100%
BANK 2 SENOR 1 = -100%
BANK 2 SENOR 2 = - 100%
Just started doing this. Sometimes I can get them to turn on in I hit the button enough. Switch going bad?
View 12 RepliesI can't find any info about this "always on" reverse light issue. My searches show that most people with the problem only have it when they put it in to revers. Mine's broken but the light is on all of the time indicating it's not working.
I can go through the sensors, but I think the system only recognizes sensor failures when the car is in reverse. What's my first/next step?