Ford Aerostar :: Blend Door Actuator Location
Jul 13, 2011
Where is the Blend Door Actuator on the ford Aerostar?
View 14 Replies
Jul 13, 2011
Advertisement
Ford A/C :: Blend Door Actuator - Clicking
What is the difference between :
Part # XF2H-19E616-FA and
Part # YL5Z-19E616-AA?
The middle numbers are the same. And they look the same? the first one is mine. Blend door actuator out of a 2000 ford windstar. Will another part # work? If the connection is the same?
Ford A/C :: 1999 - New Blend Door Actuator Won't Working?
I have a 99 EB Expedition 5.4 with EATC climate control. I replaced the heater core that had been leaking severely. When I got the dash back on I adjusted the controls with the engine running while watching the blend door actuator under the dash. it moved but not as much as I thought it should. So I drilled an "inspection" hole behind the glove box and into the plenum cover. I watched the blend door open and close when the hot/cold buttons were adjusted, but the movement was intermittent.
I'd checked the blend door for cracks prior to installing the heater core and found none. I left things alone for a day while I drove as normal. When I had time to work on it again, the actuator quit working. I figured it was damaged from the coolant leaking into the cab so I decided to replace it. It was indeed full of coolant. I bought a Dorman actuator (part #604-216) and plugged it into the wiring harness to test it before installing it. I adjusted the controls with the ignition in the "run" position and nothing happened. I'm at a loss as to what could be the problem. I've searched for this problem, but the only threads I find are incomplete or deal with the "manual" controls. I checked all my fuses and they are all good.
My questions are:
Could I have bought the wrong actuator? Would the harness fit the "manual" actuator? The part number was identified as being for the main blend door for "automatic" controls. Is there a possibility the EATC head unit is bad? It still sends air to the panel, floor and defrost when adjusted.
How do I test the voltage at the connector? I just bought a multimeter but I'm not sure which wires in the harness deliver power to the actuator. I know there are a lot of people on this site who've gone through the heater core/blend door ordeal and have lived to tell about it. What I should do next.
Ford F-150 (2009-2014) :: Blend Door Actuator Re-Calibration Before Using?
Time for me to replace the actuator. I just have one. I've watched many videos on it but none say anything about re-calibration before using. A few posts say this is needed. Is it? if so how is it done?
View 6 RepliesFord A/C :: Blend Door Actuator Broke (Gear Inside)
I have an Explorer with automatic A/C. The blend door actuator broke (a gear inside) so I replace it with a Dorman part (could not find the Ford ones anywhere). Part #604-202, looks identical and fits. But... doesn't work.
If I do the EATC test (OFF+FLOOR, then AUTOMATIC), the display shows error coded 024, 025, 052. What is the meaning of those?
Ford F-150 - 1997-2003 :: Replace Blend Door Actuator?
Whenever my A/C is turned on, it blows nice cold air. As long as the blower is on "1", "2", and sometimes ", it blows cold air. If I turn it to "4" I can hear a small "thud" behind the dash. It sounds like the blend door is shutting. All my functions work like they should. I think the actuator is goin out and isn't pushing the door all the way closed, and when I turn it to "4" it pushes it te other way.
View 5 RepliesFord Ranger / B-Series :: 1998 - Replace Blend Door Actuator?
I purchased a 6.7 Diesel 2014 F250 Super Duty Crew Cab about 3 months ago. Yesterday I started my truck using the remote starter from inside my house. Seconds after I heard a loud noise. Looked outside, saw nothing and thought nothing of it till I went to open my door and realized that the driver door window shattered! I live in a quiet area, it wasn't a rock thrown at my truck or anything like that, it just Blew!!!!
I'm wondering if the truck might have some sort of pressure or torque if you wish on that window to make it just pop! My mirrors were folded in however I can't see that playing a role......
Ford Super Duty (1999-2016) :: New Blend Door Actuator Burned Up?
I bought this truck used and the guy said it needed a new blend door actuator so I bought a new one off eBay I installed it, plugged the wire back in and turned on the key and it started smoking, it burned up. The wires have been cut before and have been butt connected back together. I notified the place I bought it from and they sent me back a new one but I'm scared it will do it again.
View 3 RepliesFord Super Duty (1999-2016) :: Dual Climate Control - Passenger Side Blow Hot Air - Blend Mode Actuator
2008 F-350 Lariat, 6.4L, dual climate control. The passenger side blows ONLY hot air whereas driver side seems to blow whatever is called for. Is it right to assume this is the passenger side actuator, and this actuator is the "easy" one to replace (i.e. not pulling dash)? I read in another thread that there might be a question on determining the correct one to replace, so therefore I ask for clarification. How to verify if my assumption wrong?
View 4 RepliesFord Excursion :: No Air On Passenger Side - Blend Door?
Went into town earlier and the a/c was not blowing out the 2 passenger side vents. Could switch to defrost and it would blow correctly. The rear is working as well. The drivers side vents blow good and if you cover those with your hands to block them off its like it forces air to blow out the passenger vents. Could this be a blend door issue?
View 2 RepliesFord - Mountaineer :: 2003 - Very Little Heat In Cabin But Not Blend Door?
My 2003 mountaineer 4.6L has front and rear heat. The issue is the heat in the front is barely warm and the heat in the back is poor. I have replaced the blend doors front and back and I'm sure they work as I can go from cold to barely warm and back again when I change the temperature setting.
I can feel hot fluid going from the engine to the front heater core and also down under the vehicle to the rear when the vehicle is warm. The return on the front is almost cold - so heat is being given up by the heater core in front, but it seems to me that if the return is almost cold, there's not enough hot coolant delivery. The overall heat is very poor in the cabin.
The coolant temperature gauge is steady and just below 1/2 with no erratic movements. I flushed the front heater core a couple years ago. Coolant has also been flushed last year. I know that the heat is underpowered in this vehicle, but it's a far cry from when it was new.
Ford A/C :: 1997 F150 - Blend Door Stuck In Hot Position
Dad has a 97 F150 with some heater issues. He put a new potentiometer in and it didn't work. We he turns the dial to cold, it still blows hot air. Defrost =hot, vent=hot, a/c=warm etc.....
The dealership told him that the blend door might be stuck. My question is, how hard is this to fix? Is it something that I can just stop by after work and quickly fix. What is involved in fixing this and where it is?
Ford Ranger / B-Series :: A/C Works Occasionally - Blend Door?
Compressor clutch engages, lines are cold, when it works air is cold. A/C guy thinks the blend door isn't working right, is it vacuum operated or electric?
View 3 RepliesFord Ranger / B-Series :: 1997 - Blend Door Motor Removal?
My actuator/motor doesn't have the screws that hold it on. It's just clipped down. Can I just pry it up & off with out it breaking the clips that hold it down? It's a 97 Ranger.
View 2 RepliesFord Excursion :: Blend Door On AC System - Windshield And Front Dash
Having issues with the blend door on the AC system. I will have it on AC or MAX AC. I will have it on the setting to be point out of the dash at me. It occasionally will switch to the defrost windshield setting. I can hear the blend door moving and changing from chest level to the windshield.
View 12 RepliesFord F-150 (2009-2014) :: Blend Door Clicks When Truck Turned Off?
Question: blend doors clicking even when the key is removed from the ignition? Mine clicks for quite awhile after I turn off the truck (probably 10 mins or so, I haven't stuck around to see when it finally stops) Asking out of curiosity....and this thread may put some people at rest down the line.
I do love this truck and I don't mind working on it at all. The Blend doors allow me to paint the dash trim with Bright Aluminum Plastidip.
Leaky T coolant connector which I don't mind.....wanted to switch out to a 170 degree thermostat (SSI Tuned and South Texas Heat) and do a coolant flush anyways. Might as well hammer it all out. No biggs.
Ford F-150 - 1997-2003 :: 2002 - Heater Won't Working - Replace Blend Door?
Over the last few days I have read several threads about heaters not working and blend door replacement. My '02 4.6 F-150 has 250k+ miles and I've always done regular maintenance on it. With the cold front moving in I've noticed that the heater is not blowing hot air. I flushed the radiator and flushed the heater core several times to make sure the core was not clogged. I also replaced the upper radiator hose because of the "crunchy" sound when squeezed. I also replaced the thermostat. Still, the heater is not blowing hot. I assume like many others that the blend door needs to be replaced. My question is do I need to replace the door only or the door and the motor (actuator)? I guess I need to test the motor before buying a new one. I saw a video where you remove all the components on the transmission hump and can actually stick you finger in the motor opening to see if the shaft has come apart.
View 8 RepliesFord Aerostar :: Location Of 02 Sensors?
Where are they located?
View 7 RepliesSonata I45 (YF - 2011+) :: Rear Door Lock Inoperative - Vibration From Door When Actuator Try
I think the actuator for my driver's rear door is on the fritz. Basically it fails to lock/unlock automatically like the other three do. The other three work fine - to include the passenger rear door.
Again - if I manually push the lock it works as it should (both lock and unlock) - but it will not unlock with the FOB. I removed the door panel and everything looks good - I can't for the life of me figure out how to remove the inner (black) panel so I can get to the actuator.
I can hear the actuator trying to unlock it some times - I can hear a vibration coming from the door when it tries. But again - the passenger rear works fine. I think the biggest thing I need to do now is to get behind the inner door module (black trim) to see what is going on - but I can't figure out how.
Ford Super Duty (1999-2016) :: 2003 - Heater Blend Door Not Working?
My ex-has the electronic temp control. I've noticed there is very little difference from full hot to turned down less than 1/2 way.
(I'll convert to Fahrenheit here) Example - lowest temp setting is 60. If I am on heat, turning it from 60 to 66, gives me almost full hot. A slight difference is felt turning it to 68 and 70, but basically, 70 is full HOT. Continuing to turn it up to 88 makes zero difference.
I figured the blend door actuator might be toast, but it is in fact moving. I pulled the heater core cover off and here is what I noticed.
At 60, the blend door is fully open (correct, pulling cold air from outside) turning it to 66 the blend door almost fully closes. then the last little bit gets closed when going from 66-70. Anything hotter than 70 is of no use because mechanically it IS on full hot at 70. So basically I get full cold, or full hot, nothing in the middle. I pulled blend door actuator out, cleaned all the built-up crud around the shaft, took it apart and cleaned it, (no broken gears) no effect.
Ford F-150 (2009-2014) :: 2013 - Clicking Under Dash - Heater Blend Door Motor?
I have a 2013 Lariat with 135K miles. Yesterday started a loud and consistent clicking under the center dash. When I turn the heater up to 77 degrees or above it stops. I have dual AC controls and the passenger side will now occasionally blow hot compared to the driver side when I have them on the same temperature.
Based on what I have researched I need to replace my heater blend door. Need to confirm if this sounds correct? Are there different blend doors for driver vs. passenger side repair?
As importantly I am looking for a good set of instructions on how to gain access to the heater blend door motor in order to take care of the replacement myself. My understanding is it is a $40 part buy may be heavy on services due to access. My 2013 is stocked with the sync touch screen / navigation option .....