Ford Aerostar :: 1997 - Rear Blower Spins Fast Enough But Front Could Use A 5th Speed
Jul 5, 2016
Is there any way the front blower can be wired to run or spin FASTER? The rear blower in my 1997 spins fast enough but the front could use a 5th speed. I have interchanged blowers and Resistors from rear to front, but no change, both resistors and blowers are identical. I remember one time a residential a/c tech showed me how to rewire the air handler blower in my apt. to make it run faster and the result was amazing, though he did explain the life of the blower would be shortened, I never had any problem. Does the same principle apply to a 12V automotive blower?
View 14 Replies
Advertisement
My 1997 XLT 4.0 AWD w/Rear A/C has been having a Blower Motor issue for many months. Occasionally the front blower does not blow. Banging on the Blower Motor, either from under the hood, or even from inside the van underneath the glove box, will start it up again. Once running, it continued running okay until at least the next shutdown. This has gone on throughout the summer. Sometimes a good bump in the road would start it.
Now that the winter is here, heat and defrost are more critical, so it has become a bigger problem. Furthermore, is is now almost constant, where it rarely works without a bang. So it is time to actually fix it now.
From other posts, I think it is either the Blower Motor itself, or the Control Module / Resistor. But since the control module is not located on the motor itself, where I bang, it is probably the motor. Question:
1 - What is the problem, and can I fix it with grease (elbow or actual) etc... or is replacement the proper option?
2 - Should I replace the wheel too, which is not available on RockAuto - but is on the junkyard options on eBay. Unfortunately those are often just as broken as mine. Generic Wheels are available in Auto Zone.
View 5 Replies
97 aerostar rear ac stopped working. Blower runs fine. Checked solenoid has power and clicks when plug pulled and refitted.
Liquid line is hot to solenoid and somewhat warm after the solenoid. Return line from evap is at room temp.
Front is 40f at register. Am I looking at bad solenoid or blocked orifice tube. Solenoid is nla. Orifice not so. Still on original evaps comp etc.
View 7 Replies
I got a 97 f150 single cab short bed. My 4x4 shifter is on the floor and moves. I put in 4x4 and the relay clicks and the light comes on. Same as 4low. Front driveshaft spins but front wheels don't. Could there be a leak in the auto locking hubs? Also I want to manual convert the auto hubs. It can be done but how?
View 1 Replies
I'm having some trouble with the front blower fan on my 97 Aerostar 3.0, it will only intermittently work, one time we had it running, lifted up the hood on the van, checked the connection to the motor, looked good, dropped the hood and the fan immediately started working again, I'm wonder if the relay might be starting to go bad, the fan in the back works, so I'm not sure. Where the relay is for the blower motor, or what might be wrong?
View 6 Replies
Problem solved- update! Found a main vacuum line, (white one), broken right above where the oil filler tube is. I guess if the plenum door is not in the proper position, it screws with the fan? Works like a champ now even with 442,000 miles on this van! --- 1997 aerostar, 3.0. Doesn't matter what I'm using, vent, heater, or AC. When I have the fan switch "on", The fan will shut off, then turn back on whenever it feels like. I've tried turning the controls on and off in any and all ways, and still random fan goes on-off when it's turned on. Is there a sensor somewhere that could cause this? Or what?
View 6 Replies
97 Aero. Just recently experienced this weird issue. Had the AC on for a warm day and heading down the freeway at 70mph. The AC is kicking out some nice cool air. Noticed that when the van was heading up a slight grade, the air speed coming out of the vent would slowly diminish until no air came through the vents at all.
As soon as the van leveled out or started heading downhill, the vent air speed would pick back up and blow normally. This happened repeatedly. Is this a blower issue? Vent door issue? Something else? Since the van was traveling at speed, I could not tell is the blower was still blowing when I was experiencing no air out of the vents.
View 14 Replies
I recently got a 2002 f150 5.4. The fan speed works on 1 & 2, and 4. It does blow on level 3, but it seems to blow at the same cfm as level 2. I'm thinking this can't be right. But, if it was a simple resistor issue, it wouldn't run at all on level 3, right? So, where I should look first.
View 10 Replies
I changed the rear end on my buddies 2003 f150 and now the speedometer is 15 mph fast I was wondering if there is a way for me to calibrate the speedometer..
View 1 Replies
My '99 F150 is having wiring issues. It started with a left flasher being fast and the rear bulb not working. I put in new bulb and that didn't fix it. Then I realized that I also had no tail lights. The reverse lights are good and the brake lights work too.
So far I have searched for and repaired suspicious splices done by PO, added a ground wire that was cut off from the trailer wiring harness, checked every fuse that I could with an ohmmeter and I pulled the multi function switch and tested it with an ohmmeter also. It tested fine but I did find one of the female pin connectors had pulled out of the harness. I managed to get it back in and seemed to click into place alright. Somewhere over the course of all that I now have both sides of my flashers fast and still no tail lights. Good news is that I haven't broken my brake lights or reverse lights yet.
Could I have a bad flasher relay? Earlier in the process I did have my 4 way flashers working correctly and a couple times I even had the turn signals going. Now, none of the rear blinking lights work but the front ones go 90 to nothing and I still have no tail lights. My truck does have the auto lamp thing.
View 10 Replies
I have a 97 expedition that i am having trouble with. It has front and back airconditioner. The compressor is short cycling real fast. Warm air in the front and cool air in the back. I put a can of freon in but still not cooling. The gauges are between 30 psi and 50 on the low side. The high side is between 100 and 150 psi. The ambient temp was 80 degrees.....
View 1 Replies
My 1997 4.0 Rear Wheel Drive is making a clicking noise when it is put into gear or when it switches from drive to reverse and vice versa. Sound is coming from the back of van. Does not make noise all the time. Drove 50 miles last night with no problems and minimal clicking. Could it be U-Joints going bad? Or is this a different problem?
View 6 Replies
Srange noises of my 1994 AWD. When driving, if I take off fast, it makes a lot of pop noise, but if I take off slowly, then It's Ok. Or when I make a quick acceleration after slowing down then it make noise, but if I take it fairly slow then it's OK. The frequency is getting worse. My front axles are in good condition (30K miles on a rebuilt pair). I have unplugged the AWD controller box, it didn't do any difference. All gear shipped OK. So what is that noise in that condition? My 94 AWD is about 110k miles, good shocks.
View 14 Replies
I've got a 2001 4.6 F150, starter spins just fine, but it won't start. Checked all the basics, but it has no spark, and no pulses at the injectors. Is the PCM dead? Wore out the Haynes manual on this one....
View 12 Replies
Here's a little more info on the truck I'll be working on:
-2001 Ford F-150 XLT Supercrew Cab 5.4L Triton.
-Has been used as a work truck so it has some miles on it 200,000+ and it shows. He showed me the lower control arm and the upper control arms bushings are a worn. Some coming apart and others with cracks in the (the bushings).
-So might need some more things replace but need to learn more about the truck to figure out exactly what?
Anyway, I'm probably just scratching the surface of the work needing to be done on this truck but for now I'll focus on the more important issues since without a functioning steering wheel he cant drive the beast. Might end up doing some customizing to the truck in the future such as changing the headlights to give the truck a more meaner look, along with the grill.
View 14 Replies
I'm trying to figure out how much of my front end I need to rebuild. 130,000 mi on the truck. About 1/2 of those miles are off road. 2008 F350 FX4. Stock. Original front wheel bearing unit and hubs. I was under the truck today and before I put it on jacks I decided to see how much play was in the front end components.
I noticed when checking out the passenger side front axle at the u-joint that I was able to spin the whole u-joint and bearing with the wheels still on the ground. I wasn't able to do the same for the driver's side. Both hubs were set to auto although I know that the ESOF doesn't work. Is this normal? Am I supposed to be able to spin the axle with the wheels on the ground?
View 8 Replies
I recently bought a 2003 F150 sport Scab 4x4 with 75k miles from a Ford dealer with a 4.6l auto. we didn't notice it when we test drove it but it has a squeak when going 0-10 mph in forward or reverse. The story goes a week after getting it home we started noticing a vibration and thudding in the rear end when braking so I take it back to the dealer (50 mile trip 1 way) and when I get there the drivers side rear rim is 30 degrees hotter than the passengers so the tear it apart and find the e-brake was dragging so they lube it up and tell me its good to go. I made it around the building and now I feel it dragging iddling around the parking lot and it is still squeaking so I take it right back in.
Long story short after going through this 2 times that day and bringing it back another day they replaced rear pads, calipers, roters and the hoses going to the caliper and tell me its good to go. Well it no longer had the dragging feel and I had to drive through DC traffic so I beat feet for home and on the way noticed its still sqeaking. I call them and they tell me to put a thousand miles on it and maybe the pads just need to wear in (??). so I took a road trip and 1.2k miles later it still squeaks.
I have tried to tell them it may be the u joints (after searching on here I learned that I am taking it back tomorrow and going to try and get something done but they are still saying its something to do with the brakes and probably won't do the u-joints. Normally, they are filling up the gas tank every trip up there and its all been under warranty (gonna see about getting the warrenty extended tomorrow due to this problem has been ongoing since we got it). Should I just let them run their own course and keep making trips back and forth?
View 3 Replies
do i stay in forth like using an automatic or is it safe to tow in fifth?
View 2 Replies
I noticed an increasingly loud noise when my GX 470 is in motion. It isn't tied to engine speed, so I figure it probably has something to do with the wheels.
I jacked up the vehicle and spun each wheel independently in neutral. Front wheels were fine. Rear driver's wheel was fine. Rear passenger's wheel - fine with parking brake disengaged. But with brake engaged, you can spin the wheel backward but not forward.
View 2 Replies
My cruise control will engage but not maintain set speed. It slowly loses KPH, 10 KPH every 30 seconds. What to look for?
View 6 Replies
I have an '02 F150 XL. 200k miles. My a/c blows cold, and I have every fan speed, but it just doesn't blow very hard. I replaced the blower motor thinking that would work, but that did nothing. I've been told to clean the evaporator core, but I don't know where that is. How to do that, as well as any other part causing the problem.
View 14 Replies
