Ford Aerostar :: 1997 - Cruise Control Cable Broken
Sep 16, 2006
When I had my heads replaced, the mechanic informed me that my cruise control cable was broken. News to me. It worked fine before. He said he couldn't find a replacement. I went to my local Ford parts dept. and they told me it was a discontinued item.
So I went online and ordered one from Direct Ford Parts and it did not match. The part number was FMC-F49Z9A825JA. In the parts catalog it says it fits 92-97. Not even close. The one I have has a screw off top and the one sent has a bolt on housing.
1997 Ford Aerostar 4.0 ... I really need my cruise control ...
View 4 Replies
Advertisement
My 1997 Aerostar's cruise control is not working. Horn is functional however. I've checked fuses and they seem to be ok. What could my problem be?
View 10 Replies
I have an 09 Corolla S. Back before winter, my heat control knob got real tight and felt like it broke loose inside one day. This left the heat control stuck in the red somewhere. Its way too expensive to have this fixed at Toyota. I ordered the heat control panel off Ebay, went to replace it yesterday, and it turns out the actual cable must be broke at the other end. When I tried to rewrap the cable around the knob, it has no tension and pops right back off.
My question: where this cable connects to on the car? How hard is it to replace and where do I find one?
View 3 Replies
Mine broke on the throttle body end, I think the cruise control motion caused the throttle cable to bind up as it pulled to accelerate probably over a long period of time. It is a 2000 Mountaineer V8 part is not obsolete from Ford other than a JY what other new sources are there? I was informed only 99-00 are the same from Dealer and have searched via Google. I already fixed it with new 1/8 steel cable and swedged ends, I want a new one just in case liner is gone south.
View 1 Replies
So, instead of pushing the throttle cable back and then off, I tried to pop it off and broke the little tab. I've been trying to look for a replacement, but all I'm coming up with is an entire throttle body. Not too bad, but would still like to fix it for much cheaper. It's a 2002 F150 with a 5.4L.
View 2 Replies
My cruise control will engage but not maintain set speed. It slowly loses KPH, 10 KPH every 30 seconds. What to look for?
View 6 Replies
I had a reputable repair shop briefly check out the cruise control on my Aerostar cargo van. They said it is not because of a vacuum leak. What is most likely the problem?
View 11 Replies
My speedometer, odometer & cruise control quit working and I think the transmission overdrive is also not working on my 95' Aerostar 2wd, 3.0L engine. I replaced the speed sensor that sits above the rear differential, but that didn't work. Wondering if something needs to be reset?
View 3 Replies
My speedometer stopped working yesterday after i replaced the 2 cruise control buttons on the steering wheel. When i connected the the battery the horn started blasting and I went over tap the horn then it stopped. Then i noticed that the horn did not work anymore. I put back the original cruise control buttons and still did not work .So know instead of fixing the cruise control buttons, I broke the horn and the speedometer while the cruise control is still broken. I checked the fuses and they all are good. What can it be ?
View 6 Replies
2003 ford edge 3.0 V6 ... I was driving down interstate today going 70, set my cruise control & the button broke. My accelerator was stuck, when I would hit the brakes it would literally shake the whole truck. What happened & why?
View 3 Replies
The cruise control switch on my 2000 Ranger just broke. It looks like you have to remove the airbag to access it. How is that accessed? It looks like there are 2 plugs on the back of the wheel that need to be removed.
View 9 Replies
I have a 93 Aerostar 4.0 and it is displaying the blinking airbag light (3-2) and the horn doesn't work and the cruise control failed. I believe it is the clockspring ...
QUESTION: Can the clockspring be repaired or must it be replaced. I do not have a schematic of the electrical components of the clockspring ...
View 9 Replies
My wife has a 2009 Camry LE, 4cyl with approximately 63,000 miles on it. Yesterday when driving it, I went to turn the cruise control off and my finger slipped, causing the button to pop out. Both of us have tried to fix it and I know I tried at least three or four different ways to reinstall the little three prong copper piece and no luck. The cruise control still refuses to work.
Having problem with the button popping out and been able to fix it? If so, how did you fix it? I hope it's something simple, such as re-installing the copper piece a certain way.
View 1 Replies
I have an 02 f150 5.4 and since I got it it hasn't had cruse control. I went to a local ford dealership and they ran the vin and didn't find any recall on it. Under the hood on the master cylinder there is brake fluid coming out of the brake control switch. Would I have to do something with the harness too?
View 9 Replies
I accidentally broke the control lever where the cruize control attaches. I've looked all over but I can't find the lever. Where I could buy just the lever? New throttle body is more than I want to spend.
View 1 Replies
Ok replaced the front brakes, tie rod ends, and all ball joints today. Also flushed old brake fluid and replaced with new. Now my cruise control does not work. Light on the dash momentarily flashes when I try to set the speed. I have checked all the fuses and the connections and everything appears normal.
2001 Ford F150 5.4L 4x4 off road pkg stock height and tire size.
View 7 Replies
2000 F 150, 4.2 v6, M5OD-2 Manual Transmission, LX, reg cab .. Cruise Control passed all static and dynamic self test. All fuses inside and under hood checked good and still cruse control will not engage. All other functions work: brake lights, turn signals, etc. Green cruise light is operational, checked pin #10 on wiring harness at servo,amplifier unit under hood and have good ground. The Cruise ON button will not turn on cruise control system and will not light green cruse light.
View 4 Replies
A few years ago I had the clutch changed on my 1997 F150. Afterwards the cruise control wasn't working. When I brought the truck back to the repair shop I heard the manager tell the mechanic to "attach the clip by the pedal" and that fixed it.
I just had some work done, had to replace the oil pan, and the mechanic had to remove the transmission. Now the cruise control doesn't work. I changed the Pressure switch but it didn't fix the cruise control. What that clip might be that fixed the cruise control last time?
View 3 Replies
I have an '02 F150 Lariat CC 5.4L. The truck is new to me and neither the cruise control nor the horn works. i have checked all (known) fuses and relays. I have tried the cc diagnostic, and the dash light DOES NOT illuminate. Should I assume that the dash light is not burned out? Is there a way to test the clock spring connections for continuity? and how do I access the connection
i checked the cc brake pressure switch and have continuity there.
View 2 Replies
I did the diagnosis,on my non working cruise control on my 2000 f250. The cruise light came on when, I, depressed the off switch and turned key on. I depressed on switch,cruise light came on.
I then depressed the resume, coast, and set switch, as described in the diagnostic procedure,suggested,and no light came on. Do the switches for the cruise control are bad.
I have checked the fuses at the power distribution box under the hood and checked the fuses under dash,all are fine. I just replaced the switch at master cylinder, as it was leaking and it had the recall switch replacement, too.
View 8 Replies
All, i have an issue ( or at least i think its an issue) with my 99 f150 5.4. When i use my cruise control, i notice when i put on the brakes slightly to slow down, it feels like its not coasting because you can feel the engine still engaged and wont coast. I think this happens even without the cruise on. What this could be? I have the latest update on the cruise control harness. I believe that was for power always to it even in off, causing fires.
View 3 Replies
