Ford Aerostar :: 1995 - Control Arm Bushings?
Oct 1, 2011
can you replace the upper control arm bushings (pass side) with the arm still in the truck?
View 8 Replies
Oct 1, 2011
Advertisement
Ford Aerostar :: Bushings And Upper Control Arm Replacement
We've got a '96 aerostar (4x4). The bushing and upper control arm seem to need replacement but the parts seem to be obsolete. Any source for these (other than salvage yards)?
View 14 RepliesFord Aerostar :: 1992 - Rear Control Arm / Bushings Have Worn Out
I have a '92 Aerostar XLT with a rear control arm problem. The bushings have worn out and the rear end floats side to side as much as 1 1/2 inches. Ford says one bushing comes in the arm ( no longer avail ), one is a press in (no longer available), and the other is like a strut bushing and is available but without the other 2 there is no point in replacing the one. How to fix this enormous problem???
View 10 RepliesGolf IV R32 :: New Control Arm Bushings Squeaking?
Just got my car back from the shop and it squeaks pretty loudly at low speeds. It seems pretty clearly to be coming from underneath the front seats and it sounds like rubber rubbing against steel so I am guessing its the control arm bushings.
Yesterday I took it to the shop to have the passenger side control arm installed and to have the tie rods done and get an alignment.
This past weekend I installed new drivers side control arm/ball joint, front struts (also installed a new rear hub & wheel bearing). I did not hear any squeaking after I did that.
Is this just something that needs to be broken in?
It wasn't til I got it back from the shop that it started to squeak. I only notice it from 0-20 mph then it seems to go away. Everything else seems fine, suspension, steering and alignment are all great and there's no clunking etc.
Tiguan :: 2010 WE - Control Arm Lower Bushings
Brought the Tig in for an oil change & while it was on the lift the tech noticed that the subject bushings are cracked/separating...Tig has about 43,400 mi...is this a common issue?
View 6 RepliesGTI 337/20th Anniversary :: Rear Control Arm Bushings Are Cracking
My rear control arm bushings are cracking. I was wondering if this is a serious problem and what negative effects it will have if I leave them alone.
View 10 RepliesLexus RX 2004-09 :: 2007 - Control Arm Bushings Worn?
I bought a used 2007 Lexus RX350, FWD, in December 2012 and had it looked over before I signed the papers by a non-biased mechanic. He said the control arm bushings would need to be replaced in the future.
When I took the car in last month to my mechanic (a private mechanic, not a Lexus dealership), he said the control arm bushings on the right side are worn a lot more than the left side. He said on this Lexus, it would require removing the engine to replace the parts (?) and that because it was such a labor intensive job, and the left will eventually wear, that he advises I get both the left and right replaced at the same time.
Mazda - Mazda6 :: 2003 - Control Arm Bushings Cracked
MILEAGE: 65,000
Last time I was in, the shop replaced my sway bar links, which had already been diagnosed and the repair scheduled. Then, after replacing the sway bar links, the mechanic told me that the control arm bushings were cracked. They already put new struts on the front, as well. So I asked him what else was going to go wrong with my suspension. He said nothing else should need work. He also said that the car was safe to drive for a couple months but I definitely needed to get it fixed.
QUESTIONS:
Is it normal for a car with 65,000 miles to have cracked bushings? I realize that the car is 11 years old; I just wondered how much a car's mileage plays into cracking the bushings and, if so, after how many miles should one expect before cracking occurs.
Does it sound like they're trying to soak me? Why tell me one thing at a time? Perhaps more revenue from the labor side of things?
Assuming the bushings truly need to be replaced, does the community here think there is anything else that should be checked and taken care of at the same time? It is both costly and annoying to have to take the car back numerous times.
Ford Aerostar :: 1995 - Won't Shift From 1st To 2nd / 2nd To Third?
This van has the A4LD transmission. I know nothing about transmissions, so, when it wouldn't shift from 1st to 2nd, or, 2nd to third, I researched it on here and found a lot of bad reviews. I also found out that it was likely the modulator gone bad, and how to replace it. I replaced it, and although the new one was restricted and the old one wasn't, shifting was back to normal. So, I was thinking, that was easy enough, pretty good for the original tranny which has 297,623 miles on it, and hasn't been serviced since the first 1k!
Well, that lasted about 75 miles. Now it won't go forward or backward. Everything is still in place, no leaks, fluid level is full. I didn't change the fluid or do anything other than change the modulator. (My friend can't afford to service it properly. Now it may need replacing!) I have only seen problems shifting between gears and OD, TC lockup, etc., but, nothing about not moving at all. What might be the problem? Is the tranny history?
Lexus RX 2004-09 :: Lower Control Arm Suspension Bushings Replacement?
Car has a little over 100K. How to replace the bushings on the suspension arms. Took my car in for the brake switch recall and was told my bushings were cracked. Not sure which ones, but I assume all of them. Looked online for a DIY, but not for the RX330. From some of the DIY's I've seen so far, it looks like a bit$! to replace those rubber bushings.
View 14 RepliesGolf IV R32 :: Front Lower Control Arm Bushings Completely Separated
Front lower control arm bushings are completely separated. Looking to upgrade in some way to poly bushings or some other sort of performance setup.
View 4 RepliesFord Aerostar :: 1995 Won't Shift Out Of Park
I just picked up Aerostar #6 and am in the process of transferring parts etc. Got this one cheap as it was badly abused and has issues. Big problem, the shifter takes a lot of wiggling etc to get out of park. Is the interlock easy to disable? If so how? Or would a good column from my 93 be an easy plug and play proposition?
View 1 RepliesFord Aerostar :: 1995 - ABS And Brake Light On
I have a '95 Aerostar where the two lights are always on. I'd like to pull the codes if i can. Does this year has the RABS or the RABS II module. Or is the diagnostic connector the same?
View 14 RepliesFord Aerostar :: 1995 - Outer Tie Rod Replacement
I was wondering how do i replace the outer tie rod on a 95 ford aerostar awd 4.0L. I have enough for the parts but not extra tools. Need a tutorial on how to do it?
View 6 RepliesGolf IV / Jetta IV :: Car Makes Sound As Result Of Swapped Control Arm Bushings
Picked up another gti vr6 5 speed for my girlfriend. It needed the control arm bushings replaced. Finished up and went to drive the car. Now when in gear and let of the clutch. Makes a terrible sound and won't move. But speedo goes up .
View 3 RepliesHonda - Pilot :: 2008 - Control Arm Bushings / Normal To Fail After 5 Years
I have a 2008 Honda Pilot less than 80,000 miles on it. was just told by the dealer the control arm bushings need to be replaced. They put it on the lift for me and I saw what looks to be dry rot on the bushings. I am the original owner and it has not been abused .. all required service completed.
View 4 RepliesFord Aerostar :: 1995 - Stalling When Hit The Brakes Hard
When I hit the brakes hard like seating the brakes the Aero would stall....
View 12 RepliesFord Aerostar :: 1995 - Sloppy And Loose Shifter?
My mom's 95 shifter is slowly getting worse. Right now it's at the point where we have to hunt for gears just to put it into park or reverse or d/od. It's not stiff like the rest of ours, hers is all sloppy and loose. She says it's been doing this for a while, but i think it got worse when i pulled her cluster out to change the light bulbs. I say this because i couldn't get the needle cable un done, so i just let the cluster rest on it while i was changing the bulbs, which put a little bit of tension on it.
View 14 RepliesFord Aerostar :: 1995 - Hard To Shift Out Of Park
I have a 95 Aerostar that when in park it is hard to shift into reverse, drive etc. It is an automatic, 3.0 liter.
View 7 RepliesFord Aerostar :: 1995 - Easiest Way To Change Belt?
Whats the easiest procedure
View 3 RepliesFord - Aerostar :: 1995 - Won't Start / Dirty Spark Plug?
My dad and I are having allot of trouble getting our Aerostar to start up . It is getting fuel and spark , and it won't even run with starter fluid . It was running ruff before this . It is getting an all clear on the OBD codes . We took one spark plug out and it was pretty dirty , could that be our problem? Like I said we are getting spark , when we do a spark test . We are totally out of clues .
View 7 Replies