Ford Aerostar :: 1991 - Interior Door Panel And Windshield Compatibility
Feb 2, 2012
Will interior door panels from a '91 Aerostar fit a '96? No power windows or locks. The panels in our '96 are busted and I found a good set in the salvage yard in a '91. Lady at salvage yard says they're different, but I'm not so sure. Also, will the windshields swap?
View 3 Replies
Advertisement
Im new to the forum and have a 96 extended aerostar. My question ia has any one made custom front interior door panels. Mine are badly broken up and I feel beyond repair.
View 6 Replies
When I close my rear, driver side, door there is a lot of movement at the top of the door panel. I can pull it away a good bit so I think there may be a broken clip. I searched the FAQ but could not find instructions for removing the rear door panel?
View 2 Replies
So my brand new previously gorgeous tiguan, which is only 20 days old, unfortunately had a ding on it on the panel between the windshield and the passenger door.
I drive about 60 miles daily to and from work (and didn't notice anything like that on the car this weekend), so im guessing a rock or something kicked up and nicked the car. Paint doesn't look to be scratched or anything.
Of course since my car is new, im pretty frustrated and annoyed. I know dings will happen but I guess I assumed the body was stable enough to deal with minor kickups.
View 15 Replies
2012 Golf TDI. I'm trying to find the actual part number for the rear, driver's side door panel (door card). I've found some listings for the actual panel but none that provide the part number. It's the one that has the aluminum insert w/o premium audio.
#1 in this diagram.
View 4 Replies
My automatic door lock is making a buzzing noise when it locks the door. It does not make any noise when unlocking. I need to remove the door panel to take a look. How to remove the panel on the drivers door of a 2000 Dodge Grand Caravan?
View 4 Replies
My engine stalls when cold or warm, when put in gear or idling in gear at a stop. If I left foot break and give a little gas I can usually keep it going. I ran 2 bottles of fuel injector cleaner through, but no dice. Could the fuel filter need to be replaced? If so, where is it located? 1991 Aerostar 3.0 Auto RWD
View 14 Replies
It would appear as though my steering leak on my 1991 Aerostar is coming from the seal, where the steering shaft enters the steering box. I'm trying the Lucas treatment but it doesn't appear to be working. Can this seal be replaced WITHOUT replacing the entire steering box?
View 6 Replies
Where/how to check the ATF in the transfer case? I found the lower drain bolt,but I don't see anything up higher that looks like a fill hole.
'91 Aerostar 4.0L AWD
View 6 Replies
1991 aerostar 4.0 ... My van was running well til last week.it allegedly has 77000 miles on it. It started running really rough within a 50 mile period. I've quit driving it til I am sure. I am not harming it. I put a vacuum gauge on it. It wildly fluctuates between 3 and 7 pounds at idle. I've tried plugging the four vacuum lines one at a time to eliminate the accessories as the problem.the check engine light is off and my scan tool shows no codes.i unhooked the exhaust at the manifolds to make sure the cats aren't clogged.it doesn't have egr. There's no water in the oil or bubbles in the radiator.i have a compression tester but id like to avoid trying to get to the plugs unless necessary.
View 5 Replies
Have a 91 Aerostar that won't start. Has fuel pressure, pulse to fuel injectors, strong spark, strong compression, etc.
Thinking that the spark may be coming at the wrong time I tried a spare ignition module that I keep. No luck. Since my distributor had a lifetime warranty I got another one, again, thinking spark was coming at wrong time. Nothing. Engine won't even pop.
I am going to drop the front pipe in the unlikely even that the new converter is plugged or, somewhat more likely, the muffler, but I am leaning toward a computer at this point.. Still don't understand since it is getting spark and gas why engine won't even pop.
View 14 Replies
How to remove roof rack on 91 Aerostar? Google and search box here yielded no result so a new thread is likely in order. I have leaky roof. Not windows.
View 8 Replies
I developed a freeze plug leak while driving into town in my 1991 Aerostar with the 3.0 liter engine. Got to Schuck's (my destination) and bought some antifreeze, noted where the leak was and filled up the coolant system.
Drove a few miles to the mechanic's house. Coolant blowing out everywhere, obviously boiling off. Let it cool down while going over an estimate for repair. Topped it off one more time and went home. Have not moved it since.
There is sludge, almost like thick foam, that I suspect is what's left of coolant that has had the water mostly removed. It is the same color as the coolant - bright orange-ish green. Will a few flushes with fresh water clear this out of the system?
View 1 Replies
I have a 1991 Aerostar 2wd 3.0. I recently had freeze plugs replaced and the mechanic had to drop the tranny to get to some. Now the shift cable has come off the gear selector lever. I have googled everywhere and can't locate the procedure for reattaching it. My mechanic was doing the work on the side and charged me only labor for his assistant. He is at work right now..
View 5 Replies
When I turn on my headlight the instrument panel will intermittently not light up. Is this a known problem for this concern and what is the remedy for this problem?
And with the HVAC, when I turn the HVAC to max a/c (even though is won't be until spring or summer) I have problems with the a/c wanting to turn off at times almost like automatic climate control, but it isn't that.
View 7 Replies
My white 96 is for sale...Parked it for two months and now no nothing.. It runs but thats it...fuse 12 no power...
View 7 Replies
We all know the front door speakers on these are horrible. I am changing them out all the time under warranty for being blown. In doing so I decided it was time for a video on how to remove the door panel without damage to get at the speakers and swap in aftermarket etc.
2009+ Ford F150 Front Door Speaker Replacement- Door Panel Removal Procedure - YouTube ....
View 9 Replies
For about 3 months, my wife's 2003 explorer has had a bad door sensor (I'm guessing). The car claims a door is ajar and the alarm would go off randomly if it's locked. Yesterday the battery died because apparently the alarm had been going off for so long while she was at work. After having a stranger jump it, she has had major problems:
-She claimed the headlights didn't work in any setting except in the on position with high beams on, but now they seem to work.
-The instrument panel is totally out including all gauges and all lights
-the power windows don't work
-the radio won't turn on or show any display
-the interior lights won't turn on
All of the fuses are fine and my mechanic checked them as well. He did say that a few key fuses aren't getting any power to them on either side. But the battery is charging and drawing just fine. The car doesn't seem to have any other issues and all of the flashers work just fine.
What the problem could be? I have wondered if one of the relays is busted.
View 3 Replies
I have a 1997 explorer 5.0 AWD. The problem is that when it is about 44 degrees and below, the windshield wipers, power windows, and interior lights don't and won't work. We will run the heater until it warms up the interior, then everything seems to work fine. I usually leave the wipers on so I know when it is warmed up enough. I have checked all of the fuses and all are fine. the only thing that I can think of is there is a crack in the back of the fuseblock that breaks contact when the metal is cold.
View 2 Replies
I attempted to remove a 7.5 amp fuse from the interior panel under the dash on the left side. Using the fuse removal tool in from the fuse block under the hood, I grabbed one and worked it out slowly.
When I got it out, the metal prongs were broken off of the plastic housing. I thought this was weird and looked into the fuse block trying to see if I can see the prongs. No luck!
I attempted to pull another fuse to see if it will come out and sure enough, the metal prongs are broken off in the fuse block. I tried again to see if I could see the the prongs but again, no luck!
I put the plastic housing (top half of the fuse) back into the slot and the electronics for that fuse is working. However, I am concerned that something is wrong and causing the fuses to break when attempting to pull them out.
View 5 Replies
How to remove the interior trim on the rear quarter panel?
View 1 Replies