I want to replace the lock cylinder which apparently I should have already done but now the key won't turn at all and the wheel is locked in place, so I can't turn the key to the run position in order to remove it. Is there some way of working around that?
View 9 RepliesMy fuel pressure is at 24 engine of and 29 engine running. Is this a bad fuel pump? I was told that it is supposed to be between 40-45 PSI. Is this correct?
View 5 RepliesI have a 1990 Aerostar that has leaked gas 3 or 4 times. I am not sure where it is coming from exactly but it seems to be towards the back of the engine, kind of near the torque converter. This leak happened 2 days ago when i was warming the van up and it was cool outside. The time before that, it was after driving for a while. The day before yesterday I drove it probably 50 miles with no problems and it was about 85-90 degrees outside. I drove it today and there was no leak and today is a cooler day.
View 14 RepliesI have had an intermittent Check Engine Light for a couple of days --- the van started and ran fine, but the CEL would come on after about 15 minutes of driving. It would sometimes go off before I reached my destination, but it was always off the next time I started the van. No sweat.
I went to read the codes this afternoon and now have a problem. I put one end of a jumper wire into the Self Test Input (STI) and then accidentally let the other end of the wire touch the 12V connector of the starter relay (why is that thing unprotected anyway?). I saw a little arc so I know there was some current flowing.
After this, I connected the STI to SIG RTN for reading the Key On Engine Off codes and got no pulses at all. I rechecked the jumper wire but got the same result. I then removed the jumper and started the van --- it ran quite rough and would only stay running by giving it plenty of gas. The CEL was on the whole time. I did this a couple of times just to be sure.
I guess there's nothing more annoying than turning a little problem into a big one... crap.
I couldn't find an electrical circuit diagram showing the STI in my Haynes manual, so I'm not sure what is likely to have been damaged. I assume the engine control module (ECU) has been damaged, but that is just a guess.
Some specific questions:
- where is the ECU?
- Should I spring for a new one (depending on the ID number), or is one from a junk yard just as good?
M y 90 aero 3.0 heads are leaking front and back freeze plugs. I think back ones are pretty accessible from inside. How hard to change it . I changed block plugs. What size are head plugs?.
View 14 Replies1990 Ford Aerostar. When I start runs really rough and has excessive fuel consumption and the exhaust smells like gas and has a misfire my friend says its the coil pack going bad im not sure. I love my ford aerostar dont wanna get rid of it.
View 5 RepliesI have a 1990 Aerostar 4WD, 4L, with about 120k miles. About 6 months ago I started my van and noticed under it that gas was dripping onto the exhaust at the Y-joint and evaporating. I shut off the van and drove another car to work. That evening with fire extinguisher at hand I drove my car up on ramps and quickly got under it looking for the leak. NOTHING. 6 months later...yesterday. I drove for a few blocks from home and notice heavy gas fumes etc. Stopped the van and again gas was dripping onto the Y-pipe joint.
This was an explosive situation... I pulled off the doghouse cover and saw, smelled and touched gas friom on the right top of the engine near the back. My questions are: What could randomly be leaking at this location and is it fixable without pulling the engine. I pushed the van to a secure location and am afraid to turn it on. Maybe I will drain the gas tank before then. I am just now trying to find the schematics for the fuel line delivery stuff. Where to go for a manual.
199) Ford Ranger will turn over but isn't firing. We've replaced the battery, positive battery cable, distributor, distributor wires, the selonoid inside the distributor, starter selonoid.
View 18 RepliesI have a 1990 aerostar 4.0 eddie bauer. I cant figure it out but when I turn the head lights on the dash lights go out. with the head lights turned off, the dash lights work just fine. I have changed the headlight switch, and the panel dimmer switch.
View 14 RepliesI have a 1990 F350 super duty truck, the rear stop/turn light doesn’t work. It has voltage, light bulb and connector are new and connection is good, is some thing else I need check?
View 1 RepliesI have a 2004 freestar that cooling fans come on when engine gets to temp but not when I turn on ac it has 5 relays for the cooling fans and they run in series and a dropping resistor. Ithink someone replaced #2 relay with the wrong one and has caused my problem because they did not know what they were doing...
View 3 RepliesI have a 1990 f-150 that periodically (and rapidly) blows the fuse for the turn signals. The brake/tail lights continue to work, but just the turn signals quits. Looking for a schematic of those systems?
View 1 RepliesIs it normal in these vans to here the fuel pump humming? I hear it when I turn the key on and while I am driving. It never gets quiet.
View 3 RepliesI just bought a 93 XL and had some parts to replace.
Had to replace the clock spring and wiper/signal assembly to restore the wiper squirter function, cruise, horn and airbag.
Thing about the repair is that now my cruise quits holding the set speed when I lift the turn signal to change lanes from the left to right lane or turning right.
Does not turn the cruise off; it just does the same as hitting the brake. When I hit the resume button, she goes back to the set speed. Replaced it with a new assembly, thinking it was a defective part. Not so.
The replacement part is not OEM.
My 1988 Mustang 5.0 GT has stalled out once last year and again recently. Same situation. I drove it for 300 miles with stops about every hour and a half. Pushed to to 90 MPH at times. Ran fine other times on the road for more than two hours. But all of a sudden the engine dies. Electrical all works but won't turn over. If I sit in it for about 10 minutes, it will start and run for the next 5 to 10 minutes than a cough or two and pull over. I have had new plugs put in and also replaced the whole distributor. Ford mechanics have stared at it and scratched their heads and say it is running fine when they hand it back to me.
View 2 RepliesI have a '97 AWD and my brake light, turn signals and emergency flasher have stopped working. I've checked all the bulbs, checked all the fuses (under the dash) replaced the flasher just in front of the fuse box...nothing. All the running lights work, and the 3rd brake light above the rear door window works.
View 3 RepliesWhen I put my key in the ignition, I cannot turn the key. I tried putting a small amount of WD40 in the ignition and turning the wheel back and forth while trying to start, but all that did was make my key greasy and my wheel lock up. I've tried getting a new key made from Lowes and Home Depot, but their keys are too wide and will not fit in the keyholes. The only thing I am down to is replacing the ignition switch completely but I'd rather do that as a last resort because my car has had a big problem every week (alternator gone, new wheels, new master cylinder, new rotors/brakes). I haven't explored yet? And also, if it comes down to replacing the ignition switch, how would I do that without being able to turn the key?
View 2 RepliesI bought a dodge d150 a month ago. when i bought it, the lights work fine. one night i pulled out the headlight switch to turn the lights on, and the headlights came on, but no parking/running lights came on, and the back lighting didn't come on. if i sit there and jiggle the switch between off and where the original "notch" for the parking lights were, i can get them to come on intermittently. but they turn off as soon as i let go of the knob. all the other lights work, headlights, directional, hazards, reverse lights, cargo light...
View 4 RepliesI have a 1990 toyota celica. The parking attendant somehow locked the steering wheel and the key will no longer turn in the lock. I tried everything i could think of: turning the wheel whilst turning the key, putting car in all positions other than park and then turning the wheel and key, changing the key, etc....The steering wheel remains locked and will not unlock.
View 11 RepliesThe last few days, when I would start my 1990 Acura Integra (morning or afternoon after sitting at work), it had just the slightest hesitation before the engine would start or "turn over", if that is the correct term.
Sometimes I just thought I did not have the clutch engaged the whole way and did not worry. This morning I went to start it and it hesitated again, but now won't start at all..makes the clicking starter sound after a second attempt, but nothing else. NO lights were left on!
The Battery (Duralast Gold 8 year battery) was replaced in Feb 2011, the Distributor in August 2011 and the Distributor in 2007. Could it be the latter?
I have this Accord I have replaced the starter, distributor, ECU, spark plugs and the ignitor and still can't get it to start. It turned off on me making a right turn and hasn't started since.
View 5 Replies