Ford Aerostar :: 1988 Suddenly Died And Won't Restart / Injectors May Not Be Firing?
Sep 4, 2017
I jump started my wife's mini Cooper using my aerostar van 3.0l cargo. Her battery was so dead we had no luck after running my van for 8-10 min. There were a couple of attempts. My van suddenly died when she wasn't cranking the mini. It won't restart.
About one week prior I had a no start situation. I thought I had solved the problem. The first thing I did was listen for fuel pump engagement. I didn't hear it. I pulled the fuel pump relay and cleaned the connections. I put it back and the van started. I drove all week and then I get the call to jump start the mini.
So back to today. Fuel pump is engaging. I checked for spark at #4 cylinder with fuel relay disconnected so as not to flood the engine. I have spark. Battery is strong. I put a new fuel pump relay in place even though it appeared to be working properly. I had my wife crank the engine and the pink/blue wire at the fuel pump relay which goes to the pump lit up my voltage tester. Power appears to be present when cranking and not just initial engagement.
I'm thinking the original no start had nothing to do with the wire connections which I cleaned and it was just coincidence that it started and ran again for a week. The connections are now clean with a new relay attached and not starting. I'm thinking if I have spark and a fuel pump engaging then injectors may not be firing???
View 3 Replies
Advertisement
My 1988 Mustang 5.0 GT has stalled out once last year and again recently. Same situation. I drove it for 300 miles with stops about every hour and a half. Pushed to to 90 MPH at times. Ran fine other times on the road for more than two hours. But all of a sudden the engine dies. Electrical all works but won't turn over. If I sit in it for about 10 minutes, it will start and run for the next 5 to 10 minutes than a cough or two and pull over. I have had new plugs put in and also replaced the whole distributor. Ford mechanics have stared at it and scratched their heads and say it is running fine when they hand it back to me.
View 2 Replies
My Father in Law's 95 Ranger, 4 Cylinder, 5 Speed has started acting strange. It has, in the past 3 weeks just died suddenly, and won't restart. No action at all when you turn the key, as if the battery is disconnected. Wait for 45 minutes to an hour, and it starts back up again.
He has had it to a local shop twice, and the only thing they have done is let it idle for 5 hours at the shop. Of course, it never stopped.
Now they are saying it is the clutch, and depending on the type of clutch, (big or small).
I've been working on cars most of my life, and even had an 87 Ranger, and I've gotta call BS on this. He says it happens mostly when coming to a stop.
View 4 Replies
'88 Ranger 2.9L V6 starts and runs but shuddering. Most noticeable when shifting and revving the engine. Will a dead cylinder cause this? How do I check?
View 2 Replies
I have a 1988 f-250 with a 460 motor. I have fuel and I have fire. And the truck starts with I prime it. I tried looking for the crank sensor but can't find it. I looked behind the balancer and I didn't feel any wires or anything. I checked on the sides of the motor nothing. It has a new coil pack and ignition mod. Fuel pump and starter. What else can it be?
View 4 Replies
1995 aero, 4.0 auto AWD. wouldn't start about a month ago and got parked. got around to working on it and it would start and run a couple seconds then just crank and crank, I tossed another edis module on it that i had with no change, tried it without the MAF plugged in, had consistent spark while cranking. fuel pump would prime just fine. after a while I was experimenting around and held the throttle WOT and got a couple coughs.
after a while of cranking and trying different stuff I had began to get a few backfires (and by this time i had the spout and the octane plug out) and I was actually trying to see if i could see backfires out the tail pipe cause i couldn't determine if they were intake or exhaust side, it finally started. it ran really rough and coughed and sputtered and backfired a few times, then after about 30 seconds it smoothed out and started idling like normal.
I took it for a drive and it ran normal, so i shut it off and reinstalled the spout and octane plug and took it for another drive and it ran better (assuming the ign advance is working, so it must not be in limp home mode)
When I first started I pulled codes 114 and 118, ACT sensor out of range and ECT voltage high (Note: when I got it started the gauge didn't show it as being very "warmed up" even though it idled about 30 minutes before I drove it about 10 miles). I am gonna let it cool for the night and see how it starts in the morning, then try pulling codes again...
View 6 Replies
1988 F250 351 5.8
I've worked for months on this truck and I now have it in the shop. The truck shows a 41 code and has a lean miss at idle that get worse during acceleration and cruise. The injectors were refurbished 6 months ago and the ECM was replaced 3 months ago. All sensors are new and within specs. Fuel pressure is good and there are no vacuum leaks.
The mechanic has verified that the condition is not electrical related. The O2 sensor will react if carb cleaner is sprayed into the throttle but other wise shows constantly lean. He's now checking all pins at the computer for any off condition. He is suspicious of the refurbished injectors. I'm wondering if the computer somehow went out again. Which way to go or what/how next to test?
View 9 Replies
I have a 94 EB AWD I am restoring and have recently picked up an 88 EB to restore as well. The 88 did not run. Here's a list of things done.. New head gaskets, new fuel pump, full tune up, radiator flush n fill, oil change, new transmission and rear seal, new battery, new iac valve, many new lights etc. Well here's where your expertise may come in.. the van starts and runs fine for the first minute or two, but when stopped at red lights the van wants to stall.. and while idling actually has stalled. I was going to replace the MAP sensor as I have found that sometimes causes idling issues. I assume the 88 does not have the MAF sensor to clean/replace? Any other things I could check before heading to the vaccuum lines? Also, both power mirrors are inop, the horn is inop and the gas gauge reads CO. I will check the fuses for those problems..
View 4 Replies
Ok all.. been working on the 88 getting it running (3.0L EB 2wd). It does run now pretty well.. definitely need some suspension work.. but that's a different post. I have had the rear main seal replaced and the oil pan gasket replaced to stop the oil leak. There is a lot less oil on the ground now.. but still leaves spots on the street. It appears oil is leaking down the oil pan from above and dripping off of it to the street. I also had the main cap bolts replaced (one was broken and the end was in the oil pan).
View 14 Replies
I took the 88 out yesterday (3.0 with rebuilt transmission).. it looks like there is transmission fluid on the back (spots all over it).. I can only assume it's transmission fluid... I tried to wipe it off... but it was kind of a mist.. I assume the modulator should be checked? I'm not sure where it is or what it looks like though...
View 14 Replies
Yes, I have photos of this, its possible, I did this twice!
View 14 Replies
My `88 Aerostar needs a replacement steering column. I believe everything can be swapped over therefore color of steering wheel does not matter. Cruise control buttons and tilt are a must. I would like to find one that is tight(er) and not sloppy floppy like mine is slowly becoming (143k miles).
View 1 Replies
I have an 88 EB, and every time I fill up the gas tank and park on my driveway (slight incline) gas leaks from the top of the tank. 3 different mechanics have checked it out completely and say there it nothing wrong - including the dealer that totally topped off the tank. Does this sound like a fill line to the tank? It only leaks until the gas gauge goes down a notch....
View 14 Replies
I have '88 Isuzu Trooper that has been sputtering lately. I'll be driving for a while then all of a sudden, it will start sputtering, lose all power and die. When I try to restart it, it will go immediately back to sputtering/dying mode. It's done it 3 times now. The first time, I waited about 20-30 minutes and was able to drive it for 5 minutes before the problem happened again. After waiting ~1 hour it started just fine and drove fine. The car drove fine for a few weeks then the same thing happened.... again, after waiting a few hours, it drove fine. I didn't have the problem again for a year and just happened again last night.
View 5 Replies
150K 2003 durango 4.7, ran like a top, backed in my driveway to eat lunch. Went to start and it sounded like it was firing on 1 or 2 cylinders give it a little gas and it died. Repeated 3 or 4 times now no fire at all. No check engine light at first now it flashes. About 30 miles with new fuel from a reputable local station tank was on reserve ( 0 miles on the overhead indicator ). All fuses are good . could it be a relay.....
View 2 Replies
I've got an oddball '88 SWB with the M5OD transmission. Since I've had it (about a year now), its always required a lot of gas to get it rolling without it stalling after sitting overnight or during the day at work, especially putting it in reverse for the first time. The shifts have always been a little choppy/jerky/grabby/whatever you want to call it, too. Mostly going into first from a stop, but you can feel it other gears too, especially if you're not flooring it.
Anyway, it seems to have gotten worse and I'm getting to the point where I'm looking at a cause. One thought I had was oil contamination on the clutch discs, I know this will make a clutch feel "grabby". There is some sludge accumulation between the trans and engine, and it appears I may have a very slow leak there.
I have to change the trans fluid this weekend and am wondering if there's anything I should inspect while I'm at it -- I don't know a whole lot about the clutch system on this van and there's next to no information on it. Frankly, I don't even know if its hydraulic or cable.
View 14 Replies
Starting a hot engine in my 94 3.0L RWD occasionally produces a low- pitch 'wah-wah-wah' groaning noise that goes away after 3-4 seconds. It sounds like it's coming from the engine itself and what I'm hearing is an engine running without sufficient oil. It has never happened on cold starts, but about 30-40% of the time when restarting, like at a gas station after fill up, etc. I live in sunny San Diego so I put 10W40 in at the last oil change. It's also currently overfilled by about a quart--I intend to remedy, but have not gotten around to it yet. Could it be the viscosity or quantity of oil? It's a real sphincter puckerer of a sound and I want to get it resolved.
View 2 Replies
Went out to start my 150 last Wednesday. It started up, then quit, and then wouldn't start again. Later that night, it started up and then kept running. Called up a couple of auto parts stores and was told it was probably the fuel pump. The next day, we got it running and took it into the shop. They couldn't figure out what the problem was, so we took it back on Friday. On Saturday, I drove it about 40 miles, then parked it for about an hour, then it wouldn't start up again.
The mechanic came and checked it, said it almost certainly was the fuel pump, then he got it started with some brake cleaner. I drove it home and then later drove it again. I made a stop and it wouldn't start again. Had to get it towed to the shop. They spent all day Monday changing the fuel pump and filter and thought it was fixed. I picked it up and had no problems that night. My wife drove it Tuesday about 50 miles and had no problems with stopping or starting it. I went to start it up Tuesday evening and it died again and wouldn't start up.
View 5 Replies
I have an 88 New Yorker whose digital amp gauge swings between its lowest and highest setting this makes the audio command center report electrical malfunction service immediately. Shortly after the car dies it will restart after 15 to 30 minutes. It doesn't throw any relevant codes, has had the alternator replaced still no luck.
View 8 Replies
I was leaving work in my 05 Escape. Started up fine, made it to the other end of the parking lot and it died. Restarted it and made it about 10 feet and it died again. Now when I try to start it, it just make a single click. Tried getting a jump from a friend and nothing but the same click when trying to start it. Lights are bright (haven't checked batt voltage yet, but will tomorrow).
View 6 Replies
So... Tonight I had just stopped at the bank to deposit a check, hopped in the truck and started her up (started great with no problem), drove the truck through the shopping center and was about to turn on the main road when she died. I coasted into a parking spot and tried to restart her... But all I get is cranking, no firing up or any signs of trying to fire up. Any thoughts?
View 14 Replies
