I took the 88 out yesterday (3.0 with rebuilt transmission).. it looks like there is transmission fluid on the back (spots all over it).. I can only assume it's transmission fluid... I tried to wipe it off... but it was kind of a mist.. I assume the modulator should be checked? I'm not sure where it is or what it looks like though...
View 14 RepliesLeaking from the top, right center. I taped over the brake light, still leaking. Not the gasket, any water sources others have found? I guess it wasn't a problem its first 8 years of life in the Arizona desert, but I bought it and brought to the wet northwest!
View 6 RepliesMy mother-in-law has a 2003 Escape with a V-6. For the last week the rear lift gate and window will not open. Tried the door key and the driver's side door unlocked. Turned the key again within three seconds (according to the operator's manual). The two lights flashed, the remaining doors opened except for the rear gate. I pressed my ear to the gate and it sounds like it is trying to release the locking mechanism. Any recommendations?
View 7 RepliesRear lift gate refuses to stay up in cooler weather, cylinders must have leaked down.
View 14 RepliesMy lift gate handle has come loose for a second time. First time epoxy was used and that worked really well since the contact was plastic and it Broke. This time it's more loose and afraid if I use epoxy again in same exact spot it won't. Adhere the Same?
View 5 RepliesI have a new RX 450h with 3500 miles on it and the lift gate is not working. before I drive 100+ miles to the dealership?
View 5 RepliesMy power liftgate recently stopped working. The motor seems to be working but the motor will only move the gate a ltittle bit, then beep and stop. It does this regardless of which buttons I push or manually move the gate. I have no issues with the lock function. I can't seem to find out where the sensors are as I want to try fixing those first.
View 2 RepliesWe're coming up on 36k miles and it will be a real hassle to get it into the dealer before it reaches the end of warranty. The lift gate is rattling horribly (my 8 year old diesel truck is tight compared to this car). Is it worth trying to get it into the dealership for this or would I be wasting my time because they can't do anything about it anyway? Or, is there a fix I can do relatively easily myself?
View 2 RepliesI just replaced the battery, and since then the electronic latch for the lift gate will no work. The only way I can get it opened is from the inside using the access hole and a screw driver. I have checked the fuse and it is good.
View 1 RepliesI forgot I had my lift gate open and backed out of the garage...crunch! Broke off the plastic air spoiler thing. It was attached with some kind of adhesive covering 5 bolt heads and a snap on grommet at each end.
I drilled out the old adhesive on the plastic panel and chipped it off the bolts. I hope I can get two new plastic fasteners at Toyota or a body shop. Question...should I just use a two part epoxy (or what else is recommended) on the bolt heads to mount it again?
How to remove inside plastic of the rear lift gate? Want to remove a few dents.
View 6 RepliesI have a 2009 Saturn Outlook. The rear lift gate does not work anymore, as a matter of fact it tries to slam itself shut whenever it is lifted. I am not extremely mechanically inclined but I can do minor repairs so I also need to know if I can fix this problem or need to take it to a mechanic.
View 3 RepliesOne of the interior handles for the liftgate broke off. I removed it. From what I can tell, this handle is molded to the interior trim part.
I'd like to glue this piece back on, rather than having to purchase the complete lower trim piece.
What is the best type of glue for this plastic?
My 2010 RX350 (~30k miles) recently has been making a squeaking noise when I close my rear lift gate. Sounds like the squeaking is coming from the left side "Rear Door Hatch Support" ..i believe that is what it is called. Is this something I can WD-40 and lube? Car is under warranty..
View 3 Repliesim trying to lift my truck to clear 44's its a 88 f250 ext cab long bed, I will be using a dana 60 front and stearling 10 1/4 rear, if I get 6 inch lifted leafs front n back with my 3 inch body lift is 9 inchs enouph? If not will it be atleast high enough for 40s?
View 1 RepliesI took my wife's 2010 tig for a drive after washing it this morning and noticed water on the rear window so I turned on the rear wiper. Well, to my dismay, the wiper didn't clean the water off because it was on the inside. I noticed water streaks on the inside part of the rear window a few weeks ago but I figured it was from condensation. It wasn't one or 2 drops, it was leaking down across the whole back window. I assume it is a seal but wanted to see if this is an identified issue.
View 2 Replies1989 Shorty - 3.0
problem with washer fluid - the motor seems to work, but nothing comes out of the tubes...
I know the motor works, cuz there is water all over the engine compartment (near the battery) and down... soaked there...
so, my guess is that the rubber has come off the pump? where is the pump first off, and second, how do I get to all that? - just remove the cowl?
any diagrams or photos would be great!
I have a 94 EB AWD I am restoring and have recently picked up an 88 EB to restore as well. The 88 did not run. Here's a list of things done.. New head gaskets, new fuel pump, full tune up, radiator flush n fill, oil change, new transmission and rear seal, new battery, new iac valve, many new lights etc. Well here's where your expertise may come in.. the van starts and runs fine for the first minute or two, but when stopped at red lights the van wants to stall.. and while idling actually has stalled. I was going to replace the MAP sensor as I have found that sometimes causes idling issues. I assume the 88 does not have the MAF sensor to clean/replace? Any other things I could check before heading to the vaccuum lines? Also, both power mirrors are inop, the horn is inop and the gas gauge reads CO. I will check the fuses for those problems..
View 4 RepliesOk all.. been working on the 88 getting it running (3.0L EB 2wd). It does run now pretty well.. definitely need some suspension work.. but that's a different post. I have had the rear main seal replaced and the oil pan gasket replaced to stop the oil leak. There is a lot less oil on the ground now.. but still leaves spots on the street. It appears oil is leaking down the oil pan from above and dripping off of it to the street. I also had the main cap bolts replaced (one was broken and the end was in the oil pan).
View 14 RepliesYes, I have photos of this, its possible, I did this twice!
View 14 RepliesMy `88 Aerostar needs a replacement steering column. I believe everything can be swapped over therefore color of steering wheel does not matter. Cruise control buttons and tilt are a must. I would like to find one that is tight(er) and not sloppy floppy like mine is slowly becoming (143k miles).
View 1 Replies