Ford A/C :: Bypass Internal Rad ATF Cooling?


Jul 19, 2011

Can I bypass the internal rad atf cooling and just run the factory aux cooler? I have a internal leak in the rad. I won't tow much over 3k, van is an 88' 1ton 460 club wagon.

View 1 Replies

Advertisement

Ford F-150 - 1997-2003 :: Bypass Heater Core On The Fly

My commute into the office was more difficult than usual because of the fumes pouring out of the vents. I have a 1997 F-150 5.4 V8. should I remove both in and out hoses from the firewall and connect them with a plastic fitting not to risk breaking the aluminum fittings on the motor?(There is an advanced a mile away) OR is it possible for me to remove the in hose from the firewall and remove the out hose from the motor, and run the in hose directly into the motor. Are the fittings the same and can I do that with limited time and tools?

View 8 Replies

Ford 6.0L Power Stroke Diesel :: Oil Filtration Bypass

Opinions of the bypass filtration? I've heard some opinions that since the HUEI injectors shear the oil so badly that there is no benefit to the bypass filtration since you can't run extended intervals. I asked a reputable shop that pretty much all drive and maintain 6.0's and build parts for them, and they said it reduces the chances of stiction, improves lifter lubrication and thus lifespan, and can actually increase the intervals. Does that sound legit and justify the kit if I plan to own it until it dies?

View 12 Replies

Ford 6.0L Power Stroke Diesel :: Bypass Oil Filter?

I had pretty much ruled out getting a bypass oil filter because I've read multiple times that the HEUI injectors of a 6.0 liter shears the oil regardless of filtration so that you shouldn't run extended oil change intervals even with the extra filtration. I'm wondering though if the cleaner oil would benefit the lifters and injectors within the regular oil change intervals, and if what I read before is correct about the shearing and not running extended oil change intervals. If I could run to say 7500 miles and it was better for the lifters and injectors than not running a bypass and changing oil at 5000 miles, then I might say it would justify it. I hear more and more about lifters in the 6.0 and want to everything I can to keep them operable.

View 7 Replies

Ford F-150 - 1997-2003 :: 1999 - Exhaust Leak Or Internal Knock?

1999 F150 New 5.4 ~350 miles on it. Longtube Pacesetter Headers with cometic mls gaskets. Stainless bolts.

It is making a knocking sound and I can't tell if it is internal or from the headers. I have a video that I hope you all can tell what is. I tried listening to the block with a yardstick, but I couldn't notice a significant increase in volume but my hearing isn't the best. I made sure all the header bolts were tight, but no change in sound.

YouTube...

View 6 Replies

Ford F-150 - 1997-2003 :: How To Bypass Key Code For Remote Start

I bought truck with marksman remote starter and it worked great. until... I lost the truck keys. ford dealership reprogrammed key code and cut new keys.

Truck now thinks that it is being stolen every time i try to use remote start. nothing major, theft light on dashboard idiot-light hud flashes.

The question: How the heck to i bypass the anti-theft module? I know that there is equipment out there to do it?

View 14 Replies

Ford F-150 - 1997-2003 :: Bypass Heater Core Now A/C Not Working?

I have a 2003 f150. I had to bypass the heater core and now my A/C isn't working. The A/C compressor don't even come ON.

View 5 Replies

Ford Audio/Video System :: 2001 - Bypass Module To Do Remote Start?

...Just bought a Code CA-6551 for a great price. What bypass module would I need for my 01 F150 to do the remote start?

View 1 Replies

Ford 7.3L Power Stroke (1999-2003) :: Glow Plug Bypass With GPCM?

I've read what little information I can find about making a glow plug bypass, but everything so far applies to trucks with glow plug relays. Since mine is an Excursion I have a GPCM instead of a relay. How I might accomplish this?

View 3 Replies

Ford Super Duty (1999-2016) :: 2003 - Transmission Have Internal And External Screw On Filter?

03 F-250 V-8 Trition ... Once the weather gets warmer all be doing a transmission fluid exchange ...

Does the transmission have an internal and external screw on filter? Or is it just and internal? Also do I have options like a wix internal filter or just a stock replacement? Is it sealed with RTV/ or a one piece gasket?

View 14 Replies

Ford 6.0L Power Stroke Diesel :: Oil Cooler Blowing Seals / Bypass Oil Filter Came Loose

I just replaced my factory oil cooler again, and my bypass oil filter came loose spraying 8 quarts of oil all over under the hood.

This is the second time it has done this. Both times my wife was driving so i don't know how it was running prior to this.

Now i think my oil cooler seal to the block is blown again! Just like the last time my bypass oil filter came loose.

Could this be a symptom of another problem?

View 5 Replies

Ford 7.3L Power Stroke (1999-2003) :: IPR CF2 Bypass High Flow Coolant Filter

IPR CF2 Byasss High Flow Coolant Filter Ford 6.0

Made for the 6.0, the biggest problem on the 7.3 might be finding real estate for the filter assembly.

One review refers to using it on a 7.3.

View 14 Replies

Ford 6.7L Power Stroke Diesel :: 2012 - Code P061A / Internal Control Module Torque Performance

I have a 2012 6.7 with a Spartan tuner. Threw this code a few months ago. Reset everything, trucks runs great, no issues. Never had this code come up again. I've looked it up and it says, "Internal Control Module Torque Performance". I'm just not sure what this means.

View 2 Replies

Ford Super Duty (1999-2016) :: 6.0 EGR Bypass Now Blowing Coal / Chugging When Stop At Light

I have a 6.0 f350 and had a bypass done on the EGR... Still there just bypass done... Ran great for about a week and then yesterday starting blowing black smoke and chugging when I stop at light or stop sign... Is it possible something came loose..

View 1 Replies

Ford 7.3L Power Stroke (1999-2003) :: 4r100 Transmission - How To Bypass Neutral Safety Switch

I have the 4r100 transmission how do I bypass the safety switch? Also what are your thoughts on starting the engine with the transmission out? I know to bolt the spacer plate to the engine.

View 7 Replies

Ford Super Duty (1999-2016) :: 2001 F250 - Overheating - Replacing Bypass Valve On Trans?

I am having some trouble with my 4R100 overheating.

Truck is a 2001 F250 XLT 7.3L with 244k miles on it. According to previous owner, the transmission was replaced around 185/190k but there was no paperwork to prove it.

I recently had a leak from one of transmission lines coming into the bottom of the radiator (the one on the passenger side). I replaced it and topped off the little bit of fluid that leaked out. Last weekend I installed a temp sensor in the transmission and hooked it up to my pillar gauges. The first few days driving with it, the temp was at/around 180 degrees, 25-30 degree outside air, unloaded on the highway averaging 70-75mph.

Today on the way home, the temp got to 180 after 35-40min of driving then continue climbing. I pulled off the highway after 1.5hrs and the temp was almost at 210 degrees. I let it idle for 5-10min and the temp didn't change. I turned it off and let it sit for 15 min. Upon starting it back up, the temp had dropped to 180. I continued driving and the temp climbed back up to 210 within 35 minutes. (65-75mph, 24 degree outside temp, unloaded). Once off the highway I averaged 35-45mph on the back roads to my house. The temp started to drop back towards 180 degrees.

Before I start throwing money at it, and installing a 6.0 cooler etc. I am thinking there is something else wrong here. I am going to look at new lines and replacing/repairing the bypass valve on the transmission. I am driving 2hrs to work each way and thats when the temp really starts to go up. The fluid doesnt smell burnt, its still nice and red. I am going to try and flush the lines this weekend and see if something is plugged/caught. I ordered an inline filter today and will put that in with a new hose from the transmission to the radiator (old one is rusted).

View 2 Replies

Volvo :: Internal Ventilation - No Air Outlet

I have a problem with the internal ventilation: the fan works but no air exits through vents whatever the position of the control button. Where can I find a schematic of the ventilation system, I do not know how to disassemble it....

View 3 Replies

Passat (B5) :: How To Repair Internal Headlight Adjuster

So i was adjusting my headlamp and it popped and now the internal cartridge part is all loose and my headlamp is pointing at the ground. Long story short I need to remove my headlamp and repair, how do you fix the internal tray? I have only REPLACED lamps before never repaired them. Have to remove the cover lense or is there some other way? If I have to remove the lense I am just going to buy a new headlamp at the junk yard.

View 1 Replies

Lexus SC430 :: 2002 - Internal Failure At Navigation ECU

Recently purchased an 2002 SC430 and have an error on Navigation System which states the following...

DVD
UNABLE TO READ DATA
CHECK IF MAP DVD IS CORRECT

Dealer thinks it an internal failure at navigation ECU. Estimate for repair $1,256.00 OUCH..

View 14 Replies

Seat - Leon :: 2010 - Internal Lights Out And Now Car Won't Start

Car: Seat Leon 2010, manual trans. On Saturday, upon starting the car after it had been driven 1 hour before, no internal electricity would work (dash board/internal lights, electronic windows, turn signal (internal and external), touch screen, electrical side view mirrors). The car itself ran and got home. I assumed it was something with a fuse, but all those under the hood aren't blown and I can' seem to find (/it doesn't seem to exist as there is just empty space where the manual says it should be) the internal fuses.

Today (monday) I looked again and made sure none of the fuses under the hood are blown and made sure (by taking out and putting right back in) all the fuses in the hood to make sure they are in all the way. Although I didn't test turning the car on since saturday, now, it wont start at all. In internal overhead lights go on when the door is open and the security code needed to start up the car work, but there is zero reaction when trying to turn the key.

What is wrong with the car? a fuse? battery? wiring? did I maybe put a fuse in the wrong spot? What should I do? try to jump start it or just get it towed to the shop (as anyways its due for a checkup....

View 2 Replies

Elantra XD (2001-06) :: Internal Engine Noise / Whining

Looking for diagnosing an troubling engine noise. Working on a 04 Hyundai Elantra with a 2.0L engine. This is a reman engine installed by the dealer. Engine has ~ 25k on it since install. Orginal one, thrust washer cracked, and crank drove front seal out. So replaced under warranty.

Changed timing belt, tensioner, idler pulleys ~ a month ago. After driving I noticed a whining noise. Said Noise is RPM dependant and sounds like a bearing or belt whine. Loosed all the belts still there. Sounded to be in the area of the water pump.

Changed water pump ~ a week ago, noise still present. Removed all belts from crank pulley and noise still is there. Thought it might be timing belt or idler tensioner pulley even though they were new.

Today changed timing belt and idler/tensioner pulleys with a new Gates set again. Left lower and upper covers off of the timing belt. Whine is still present.

After all this I have narrowed the noise down to internal engine. So my question is this, Is there any common internal engine issues that might cause this. I know this motor does not have a balance shaft so not bearings there to whine. About the only thing left is cam/crank bearing. I might add the noise sounds to be lower in the motor, therefore, thinking bottom end.

View 12 Replies





Copyrights 2005-15 www.bigresource.org, All rights reserved