Ford A/C :: 2000 XLT V8 - Heater Hose Diagram
Jan 6, 2015
2000 Ford Expedition, XLT, 4WD, V8, 5.4 Liter. Had heater core bypassed, changed, am re-assembling, but need diagram for where all hoses connect on block, etc.
View 1 Replies
Jan 6, 2015
Advertisement
Ford Ranger / B-Series :: Vacuum Hose Diagram?
Where I might be able to find a vacuum hose routing diagram for a 2.9? I have searched high and low but with no luck.
View 14 RepliesFord Super Duty (1999-2016) :: Hose Diagram For 4WD?
Is there a hose diagram for the four wheel drive? My hoses are dry rotted at the hubs so I was wondering if there are more somewhere that I have to change?
View 2 RepliesFord Excursion :: 2001 V10 - Heater Hose Leaks
I've got a pretty substantial drip someplace at the vacuum heater valve and I am trying to figure out what I am dealing with. I replaced the valve and clamps but the leak persists. The three hoses are so close together I cannot tell which one is leaking.
What are the part numbers for the three hoses? There is one that runs from the intake/front passenger head to the valve that is just held on with clamps. One runs straight down to some sort of fitting and connects to a metal line. I think it may be a quick connect fitting. It is very short.
The third runs from the back of the valve to the firewall.
There is a fourth hose that comes back up from the "somewhere" below and also is a metal hard line with a fitting and rubber hose that goes "someplace" else back towards the firewall. Not connected to vacuum valve...
In any event, if I am going to rip into this, I'd like to just replace the hoses in one shot and done with it. No luck finding much on Google.
The 2 pics included show the valve and the front heater hose. ( I saved the OEM clamps by just sliding them back on the hoses as pictured. I figured if the valve and worm drive clamps didn't fix this I'd put them back on.)
Ford 6.0L Power Stroke Diesel :: Heater Hose Installation?
Had a large puddle of coolant under my '05 X this afternoon after work. Seems it's leaking from the Y connection coming off the heater water control valve. See first pic.
I think it's part number 18472 (labeled with the circled 1) on left side in pic #2. Need to confirm this is the right part and the full part number?
Lastly, how the heck do you change this hose? It's tucked up under the cowl and looks like difficult.
Ford F-150 - 1997-2003 :: 1998 - Heater Hose Blowing Off
98 F150 2wd 5.4 -even though VIN says its "W" 4.6; it has a 5.4 with 4.6 timing setup-found. But that's a whole other story...
So, Replaced heater core. did the blend door too.
A week later it overheated and blew a heater hose off the core at the firewall (several times). Temp was up and down, forced me into cylinder head protect mode, so i called my mechanic.
Mechanic used a sniffer (blue liquid turns yellow) in my overflow tank and there was exhaust gas in it... so we replaced head gaskets, intake, timing, water pump, radiator and the rotted out rad support.
Got it done and back on the road, but a few weeks later and the heater hose quick disconnect blew off again, spewing coolant all over (again). This was what we thought was part of the original problem- head gasket allowing cylinder compression into the coolant passages. the little rubber hose that comes from the back of the intake and goes up into the heater core builds enough pressure to pop the disconnect right off and I dont know why. Like I said- I thought it was the head gasket blowing pressure into it but that's all been replaced. Why the pressure would be so high at that point, and how do I correct this?
This is my daily driver, so for now I've bypassed the heater core, but I'm afraid that pressure is gonna burst a hose and/or fitting again.
Ford Aerostar :: Heater Hose To Water Pump Failure
I just wanted to share with you all about a coolant leakage problem I had experienced for a couple of days.
It all started a few days ago when I noticed the temperature gauge needle, which I hardly ever look at, began fluctuating in the hot region. I thought "oh my god" what is wrong? I then stopped at the nearest gas station and added some, I mean a lot, of water. My initial thought was the coolant level was too low.
The following day, I noticed the belts were squealing a bit (at that time I thought it was another vehicle with loose belts, but NO... it was mine making the belt noise). At that time, I did not realize it was because the coolant was leaking onto the belt(s). But then when I made a stop at a location for a couple of minutes, I returned to my Aerostar and noticed a trail of coolant leaking from underneath the vehicle.
I thought "oh my god" the water pump is busted! I then took it to a local repair shop and inquired about the cost to replace the water pump.
But after I inspected the vehicle more thoroughly, I noticed some dryed out green colored stuff where the heater hose connects to the water pump. I then removed the heater hose from the water pump and discovered to my surprise a tiny hole had developed where the hose is expanded from 5/8 to 3/4 inches.
My plan to repair the problem is to purchase about 6" of 3/4" heater hose (to connect it to the water pump), and a Gates or Dorman plastic adapter reduction fitting that reduces it to 5/8", in order to plug it into the factory original old heater hose.
This is an emergency repair. While inspecting the heater hose, I discovered an electrical connection that goes no where.
Ford Escape / Hybrid :: 2005 - Heater Core Hose Diameter
What is the inside diameter of an '05 Escape heater core hose?
View 5 RepliesFord Ranger / B-Series :: 1989 - Heater Hose Leaking Around Behind The Valve Cover
Found a tee on the heater hose leaks when it warms up. Appears the PO had noticed it but put a hose over it and now is leaking around behind the valve cover. This is a hard plastic line around 5/16. No online parts show it as being available. Is there a fix for this ?
I would bet several others have had this problem as it lays right on top of the flange of the valve cover where I think it would rub a hole pretty quick.
1989 Ranger 4X4 4 cylinder....
Ford - Windstar :: 2002 - Pipe Where Heater Hose Hooks On The Manifold Is Leaking Antifreeze
On the manifold there is a metal/steel pipe that the heater hose hooks to. That pipe is leaking anitifreeze. It has a small hole in it. Is this pipe replaceable or is it part of the manifold.
View 19 RepliesFord Super Duty (1999-2016) :: Leak At Heater Hose Assembly - Replacement?
Today I noticed a leak at the heater hose assembly at the right rear of the engine compartment. It appears to have special connectors and that appears to be where the leak is coming from.
View 1 RepliesFord Super Duty (1999-2016) :: F250 V10 - Heater Hose Inlets Or Outlet?
99 F250SD V10. There are two connections on the heater core at the firewall. Is there an 'inlet' and an 'outlet' or does it not matter? Put a cummins in the truck, the V10 has been out for a while and cant remember which one is which.
View 5 RepliesMalibu - Chevrolet :: Heater Hose In And Out On The Engine
Wanting to no what the inlet and outlet ports for heater hoses on a chevy 350. I have a air gap intake with the the four water hoses 2 in the front and to in the back and of course the one on the water pump.
View 1 RepliesElantra XD (2001-06) :: Heater Not Providing Hot Air / Radiator Hose Leaking
I have been encountering issues with my heater not providing hot air when the engine is idling. My Elantra has around 121K miles on it. I have not replaced the thermostat, water pump, timing belt, radiator, radiator hoses, or done any coolant flushes.
I checked the overflow reservoir and radiator. I didn't see coolant at top of the radiator so I topped it off as well as the reservoir. It seemed to have fixed the issue for now but I had this similar issue about 5-6 months back. I also topped off the coolant and things have been fine until now.
I checked the hoses and squeezed them to see if I could see any notable leaks but didn't see anything. I checked the overflow reservoir tank and line and nothing seemed out of the ordinary. I also checked the top of radiator to visually inspect for any notable cracks but didn't find anything. Also to note, the coolant inside the overflow bottle was bright green and not discolored.
I did however notice a lot of white chalky residue on the bypass hose below the upper radiator hose and the engine block. My guess is that my upper radiator hose is slowly leaking? Leaking in the thermostat assembly? And I also noticed a tiny puddle of coolant below the lower radiator hose at the engine block. See the pics below.
Golf IV / Jetta IV :: How To Remove Heater Core Hose Connection
I have a new hose I need to install because the one on now is cracked... I have pulled the metal clip down, but how do I remove this so I can install the new one? I don't want to break anything else yanking on it too hard.
View 5 RepliesChevrolet - Caprice :: 1994 - Leaking Coolant From Heater Hose?
The leak looked like it was coming from a heater hose. The individual I bought it from said he fixed it and it wasn't leaking the day I bought it. Upon driving it home...cranked the heat up and windows fogged, switched to defog with no luck. Added some coolant and still the same thing and leak began again.
It smells like antifreeze inside and fog has oily feeling when wiping it off the window. Got in on the lift and no luck seeing where it was leaking from, even with it running. My previous experience with bad heater cores is that it leaks on the inside and smells like coolant... is it leaking on the outside or is it something else?
It's NOT overheating or blowing any kind of smoke. Temp gauge read normal! It's a 4.3L, 1994 Caprice LS .....
Ford F-150 - 1997-2003 :: 2000 - ECM Pinout Diagram?
Looking for a diagram for the ecm pinouts for a 2000 5.4 4x4 f150? Im mostly trying to find the TCC for the tranny.
View 1 RepliesFord Excursion :: 2000 - Diagram Of The Steering Column?
Looking for a diagram of the steering column? I am looking to see what is behind the ign tumbler that sends power to the ign switch module. I believe a problem might be there . this is for a 2000 x limited 7.3.
View 1 RepliesPassat (B5) :: 2003 V6 Overheating - Leak At Hose On Driver Side Of Heater Box
I have in the last 5000 miles had the timing belt changed and at same time the usual other item - water pump, Thermostat etc,, Engine has 155k on it.
I have had overheating issues that I thought was related to the viscous fan clutch and replaced that (it was bad) and the issue of overheating now just take longer to happen.
I have bled the coolant system and have good hot air out with heater - engine warms up within 1/2 mile of house. I am running right now Prestome all color antifreeze as it was overheating and and loosing liquid as a result.
In trouble shooting yesterday I find that when it now overheats it is leaking at the heater hose on drivers side of heater box. I have repositioned hose and clamp after bleeding it and it still overheats and with pressure build up leaks at this location - this happens when moving or when stationary.
With heat coming from heater box (both hoses get hot) and both fans working would this be bad thermostat? (again have heat) or a bad water pump?
Ford F-150 - 1997-2003 :: 2000 - Key Less Entry Wiring Diagram?
I am trying to add a keyless entry to the already equip, power door locks but am having problems figuring the wiring schematic
View 8 RepliesFord Excursion :: 2000 V10 - Fuel Pump Wiring Diagram
Looking for a link to the fuel pump wiring for a 2000 V10 Ex? I'm trying to pinpoint my no start issue and want to make sure I don't miss anything. I think it goes from 20 amp fuse under hood to inertia switch to relay under hood to pump? 20 amp fuse has power but at the inertia switch I have no voltage, just approx 35 ohms resistance to ground on both outside wires. Does the inertia switch close a ground or should it have voltage?
View 10 Replies