I have 1999 f350 Powerstroke the Ac compressor,accumulator and orfice tube were recently changed. Now the Ac only blows cold while I'm driving my truck when it's at an idle it starts blowing warm almost immediately. I had it looked at again they changed the blower motor and vacumn pump but the problem is still there...
View 6 RepliesMy new to me 99 f350 has a great a/c but it only blows on high. Am I looking at a blower motor, resistor, or the fan switch? I'm grateful that it does blow on high being in SE TX and SW LA. If it didn't I couldn't ride in the old girl. A black truck with no a/c is not happening this time of year....
View 12 RepliesI have a '99 F150 4.2 5 speed, my problem is, my heating isn't working. My A/C works fine, my blower motor does too, i changed my heater core about a year ago. I turn my truck on wait for it to warm up and once my gauge reads normal temp, i turn my control to the warm position but the air blows cold with just a very small hint of heat. I looked it up in my Chilton book and they said to check my hoses that go to the firewall/heater core. They say that both hoses should be hot and if one isn't to check it. i did that and the one on the left side(facing the truck) is barely warm. what could be my problem? heater core? my friend from Autozone said something about a vacuum control somewhere in the engine compartment but i don't know where it is, could that be a problem? Or would the flapper door be stuck?
View 7 Replies2007 F350 Dually, 6.0L
AC will blow cold, then shift to blowing warm, muggy air, then back to cold. Seems to be some relationship with throttle movement. Cruising steady ac seems normal. Multiple throttle shifts in changing traffic seems to trigger the warm air. Once accelerate back to normal cruise, can feel clutch/compressor shift and blows cold again.
Any ideas? I have read a possible cause can be the ac clutch can wear and need to remove spacers? Is this a DIY job? What about the ac clutch relay switch? On reading an online repair manual, seems that the clutch is magnetic, and if no battery power to clutch, it removes itself from compressor?
Just had an EGR delete kit installed. Any relationship to this and ac problem?
I have a 2011 F250 with ac problems. When you start it in the morning and turn the ac on it only takes a small amount of time for the air to start cooling. If you turn the truck off then start it again after driving to town the ac blows hot air out up to 4 minutes (yes I timed it) before it starts cooling. I took it to a local repair shop and the first time they said it only had half the freon it needed. The charged it and off I went. Same problem. The second time they informed me the fan clutch was not engaging and replaced it. I picked it up and the first time it was turned off and back on it had the same problem. I am scheduled to take it back to the same repair shop on Monday.
View 1 RepliesI've got a 2005 F-350 PSD KR. At highway speeds I get heat coming out everywhere it should. In stop-and-go traffic or at idle, the fan just blows cold air. Once back up to speed, hot air starts blowing again.
The fan stays running and the heat position (lower/upper-vents/defrost) stays the same. Just the temperature of the air blowing thru changes.
Things I know it isn't, thermostat is fairly new, anti-freeze is topped off, and the radiator cap is both good and on like it should be.
It sounds like maybe the blend-door or a vacuum leak according to a few of the posts I found with similar symptoms.
Is there a filter for the AC somewhere?
2001 F-350 gas
The air blows cold but it smells like something died in side it somewhere.
I am the proud owner of a 2002 F250 Super Duty 4x4, which has 158K miles on it. I live in South Florida and use the truck as my daily driver and also from trips up into the Blue Ridge Mountains.
Recently, I noticed that when I have the A/C on it blows nice and cold for about 15 minutes, but then the air gets really warm. I had the system checked and the Freon levels are right where they should be. A bit of experimenting reveals that if I turn off the A/C for about 10 or 15 minutes after it starts to blow warm air, the systems blows cool air as it is supposed to.
Therefore, I suspect that something is freezing under the hood and preventing the system from operating properly. Since A/C is pretty well essential for us in south Florida, this is a problem, when I have the family or customers in the truck.
The heater blows cold air from the driver side only. Very cold. Vey hot on passenger side.I have read that this is likely a blend door issue. Comments? Fluids are full. I hear slight noises from under the dash like "click click" like a door is trying to activate?? Truck out of warranty. If it is the door I heard the driver side is not as tough to install. Again comments? Instructions?
View 2 RepliesI have a 2003 f250 xlt with the 5.4l engine in it and lately my AC hasn't been standing up to the heat of the Midwest. When driving around town or on the highway my AC blows really cold but at idle you can tell a drop off in temp. Is this normal due to extreme heat or is there something I can do?
View 12 RepliesI have a Buick park avenue 1998, 3.8L V6 engine. the problem is: The ac vent on the driver's side blows cold air but on the passenger side blows EXTREMELY hot air. no matter how cold or hot you set the ac it blows at the same temperature on both sides. Florida heat is setting in and my passengers are melting. I am really hopping that is not something to bad and that I can fix it myself. Tip: this started happening after i had the alternator and the battery replaced.
View 1 RepliesMy 1999 f350 psd air condition wont start until you hit around 2800 rpm. Hit 2800ish rpm then the clutch engages and it blows ice cold air.The truck will sit and idle once the clutch has been engaged and stays engaged. Turn of the air and it wont start again until it sees 2800 rpm . Put power to the clutch with the engine off and it works fine. Cant see it being a pressure problem because without the clutch engaged nothing changes in the air conditioning system so why does it take 2800ish rpm to have it engage.
View 7 Replies99 f-350 crew cab. The A/C is not blowing cold as it should. Have already replaced the compressor and clutch, orifice tube and accumulator, also cleaned evaporator coil and put a new blower motor on, also a new blend door actuator. Also put a valve in to block coolant from the heater core. System has had vacuum pulled and charged correctly by my mechanic, he says he doesn't know of anything else to do, that it was as good as its going to get. Ive been in 2 more trucks identical to mine and the A/C will freeze you out, as to where mine will not come close. Temp coming out of the vents barely gets down to 60 degrees
View 14 RepliesI have a 01 f350 7.3 turbo dsl. will not start cold. engine turns over fine. plug into block heater over nite , will start! outside temp does not make difference. I have replaced glow plugs, glow plug relay, wiring harness under valve covers. Where to go from here?
View 14 RepliesJust picked up an 87 150 and have found the following few problems. (Chilton no longer has a "troubleshooting" section...taking that POS back). Anyway here we go... No heat. AC blows cold, but there's no heat. Possible problems and fixes?
View 9 RepliesI'm having with my truck. During a drive cross country my heat started to go from hot to mildly warm to cold in probably 5 hours. After stopping I checked my coolant level and it was empty. I do have a leaky head gasket and have driven about 18 hours so I'm guessing that's where it went. I could not find a leak anywhere. I filled it back up and left the cap off the reservoir to let any air work it's way out. My heat still blows cold as ice but if I shut off the heat completely and wait ten seconds then turn it back on it will blow warm air for maybe two seconds. What this could be?
View 3 RepliesMy 2015 f350 6.2 truck started making this whine noise..... Sounds like a bearing..... Stops at 40 seconds.. [URL] .....
View 14 Repliesi have a f350 superduty with a 7.3 turbo diesel and I pretty much hafta keep it plugged in to get it to start, i have installed all new glow plugs and both relays have been changed and the problem is still there, only other option i have not tried yet was changing the pcm controller but unsure if that is the problem ..
View 14 RepliesI picked up my 05 F350 dually 5 speed w/ the 6.0 powerstroke motor in august... It only had 38k on it when I bought it... its got 43K miles on it now...
Ran great in the warm weather but ever since it got cold out its been a struggle. It was running rough on the way home and kept stalling while i was driving it.. (acting like it was starving for fuel).
I went and replaced both fuel filters and started the truck... let it warm up and it stalled while sitting in my drive way and haven't been able to start it since...
I have fuel additive in it but since I don't drive it all the time (maybe 3 times a week for 30 miles) could it be possible that the fuel is gelling?
I was going to check the EGR valve tonight...
2003 F350 7.3L 164k miles. Got towed in with hard to start cold complaint.
Hooked it up to the Snap On Verus Pro scan tool and we get up to 3000 psi on the ICP cranking, IPR value seems within spec, we have rpms over 100 on tool, pulse width within spec, computer voltage above 10v while cranking, verified output of glow plug module (California) and glow plugs get voltage for approx 50 seconds @ 80 degrees farenheit, glow plugs all read 0 ohms resistance.
injectors do NOT sound the same during buzz test.
Vehicle takes EXCESSIVE cranking cold to eventually get it started. LOTS of cranking. Just had to replace starter and a battery because driver burned em out. It feels like the vehicle shakes when it gets running. Black smoke when revving cold. Sometimes white smoke while cranking.
Once the engine has been warmed up, it starts perfectly every time.
I have spent two days in the engine bay looking for chaffed wires and doing diag and my current diagnosis is bad injectors. I feel there COULD also be high pressure oil leak, or a mechanical issue such as low compression. No compression guage yet for this truck. We have the ICP and IPR fittings to do a shop air test. Recently did a 6.0L and went thru everything and eventually diagnosed it as bad HPOP. LOW ICP pressure.
I noticed two of the cylinders were at maybe 8% Perdel on the data. Seems too high. Also, it "passed" the KOER self test and "passed" the injector buzz test with no codes after, but the audible sound of injectors didn't "seem" right to me, but I am new to these engines.
How do you diagnose and repair a non working AC? The blowers still work, but no cold air blows.
View 4 Replies