Ford A/C :: 1999 F250 - Fuse Blowing When Compressor Tries To Kick In
Jun 11, 2011
My truck has been blowing HOT when I put the A/C on. I suspected the blend door actuator and changed it out. I later discovered that the A/C fuse is blowing when compressor tries to kick in. I pulled clutch/compressor plug and fuse still blew. When I pulled plug on pressure switch fuse held. I put a fused jumper onto plug for pressure switch and fuse in cab held but fuse in jumper blew. Put cheapo can gauge on low side and it went to "warning' status (high, without compressor running). Is it a clogged something or is it electrical?
View 1 Replies
Advertisement
I have an 01 f250 5.4l standard. #19 fuse keeps blowing. I hAve taken the gauge cluster out and do not see any wires melted or burned. It blows the fuse as soon as I turn the key over. I have read things saying the overdrive but that doesn't work with mine.
View 4 Replies
I have 2005 F250 6.0 XLT. I was driving the other night and all of a sudden my dash lights went out. I noticed I was being flashed from other drivers and discovered that my parking lights are not working. A preliminary check of fuses I discovered fuse #17 (15a mini) was blown. I installed and new one and upon turning my lights on, the fuse popped again. My headlights and turn signals work properly. It appears I have a wire shorted to ground somewhere on this circuit.
The truck is completely stock with the exception of an aftermarket radio which I installed two years ago.
I checked all the fuses with my test light and they are all correct (both sides of each fuse). I disconnected the gray connector and black connector in the driver side rear of the truck to isolate the issue. New fuse pops as soon as I turn lights on. I completely removed the tail lights, trailer 7 pin connector , completely removed both headlights. I did not disconnect the roof running lights or the mirror lights. I am completely stumped.
View 4 Replies
Just bought a used 15 F-250 with 57,000 miles, yesterday tried to start it and nothing happened. Checked the starter fuse and it was blown, replaced it and it immediately blew when i tried to start the truck. Pulled the starter and had it tested and it was good, replaced the relay and still blowing fuses. I have got it to start a couple of times but as soon as you kill the engine and try to restart it blows the fuse. What was the fix? Truck had no problems trying to start before this problem started.....
View 7 Replies
2004 5.4L F-250 ... it's a one owner truck I bought brand new in 2003 and only has 50,000 miles on it.
I have the 2V 5.4 engine no tuner or chip. 4x4 with 4" lift and 35's and I changed the rear to 4.88's. I love the truck but my problem is when I hit a large bump or drive too fast on a dirt road the fuse#23 that controls the PCM will blow. Consistently. I have to keep a box of 20 amp fuses handy. I have a 2 post lift in my shop and have scoured over every wire that is connected to the fuse. The EVAP solenoid, AC Clutch, Transmission solenoids and the O2 sensors. I only have 2 sensors I could find one on each side of the headers.
I couldn't find any rubbing wires or exposed wires. I am at a loss. It only happens when I hit a large bump. Could it be the Torque Converter Clutch Solenoid?
My brother in law is a mechanic and he brought over the diagnostic computer and when it blew while hooked up he seemed to think it was the TCC solenoid because when it engages the chart shows it angling up but when it disengages it drops off straight like it should. My truck seems to run fine when the fuse isn't blown, but when it blows it goes into a limp mode with the tranny stuck in 3rd or 4th gear and I have to drive it home in 1st.
View 3 Replies
My wifes truck is having some issues right now. Last week I was driving it down the highway, and the gauges all went off, the door buzzer was sounding, and the door locks where going up and down constant when I had my foot off the gas pedal. Found the fuse and fixed it with a replacement, but its down it three times all together since then?
View 9 Replies
The fuel pump fuse keeps blowing intermittently. I would assume it's a wire grounding out somewhere but I can't seem to find one yet. I do have a faulty purge solenoid on the canister but I don't think that would cause this. The reset switch doesn't seem to be tripped either.
View 3 Replies
I have a 95 f-250 psd with factory remote keyless entry. about 3 weeks ago i had a fuse blow that powers the keyless entry module, speed control, and a number of other systems.
If I replaced the fuse it blew right away so i got my wiring diagrams out and started unplugging parts of the circuit and my last attempt was to unplug the keyless entry module. presto no blown fuse so i got a module from a junk yard fixed the problem and now it has happened again. same exact thing. unhook the module and no blown fuse. i took the first module apart and saw no burned parts and no visible damage but here i am blowing fuses with no door locks, dome light and a few other things.
The fuse that blows is fuse 8. I am a mechanic and have full access to anything I need. I have another module under warantee but I want to be sure that its not something other than the module causing problems.
View 6 Replies
Whenever I manually pull my gear selector into first gear it blows one of the 10a fuses (not sure which number). I lose all gauges and accelerator pedal. It's about the fourth fuse from the right on the bottom row.
View 4 Replies
99 Jetta VR6... 190k
So the heat doesn't really work on my car- and its getting cold outside.
I read the DIY on fixing the resistor pack, but there is a lot of hooptiness to my ride, (not sure if that's the issue).
All the fan control speeds work, but the most I ever get is vaguely warm air- it never gets fully hot.
The temperature gauge does not work most of the time- it does occasionally (but randomly) work as expected.
The defrost doesn't work either due to an issue with the AC (it keeps blowing the fuse for the AC compressor- like, right away)
There's a multitude of issues happening here I know, but need to narrow down the suspects for the heat, that would be very useful.
View 2 Replies
My 2006 f-250 just started blowing the #22 fuse when i go over a bump! Where the wire harness is for this. I've checked all the harnesses I could locate that looked like they could be rubbing on something.
View 14 Replies
I have an 03 6.0 F250. My truck started blowing fuse #45 and it would kill my gauges (fuel, oil, mph, rpm, temp, trans temp, and odometer) and I was just replacing the fuse and putting off the repair.
However, the most recent time my gauges blew, the fuse did not, and I put in a 20 amp fuse, in hopes that it would not blow so quickly, bad idea. So naturally, I ordered a new shift lever, in hopes that it would fix the gauges and I wouldn't have to deal with it anymore, but I think it was too late and something else needs to be replaced. What I could possibly have blown by having a larger fuse in there?
View 9 Replies
As the title states I have a 2001 f250 with the 5.4 4x4 and lately the auto headlight / overdrive fuse keeps blowing. Both seem to function just fine but a couple of days later the fuse will be blown. I am not functioning the OD button when it blows so I'm guessing its something with the headlights. What else does that fuse protect?
View 2 Replies
AC compressor won't kick on at all. I know the system doesn't have much refrigerant (just replaced the line that runs from the expansion valve to the bottom of the drier, the drier itself, and the condenser)..
Evacuated the entire system with a pump. Tried putting refrigerant in and the pressure on the gauge goes up immediately into the yellow/red...jumped the connector on the high pressure switch and the fans came on, shouldn't the compressor kick on too?
Checked the 14 pin connector on the fcm for 12V...PIN number 8 is barely seeing any power which leads to no power getting to the compressor...
View 11 Replies
I have a 2001 F-450 SD with 7.3. What the problems would for the blowing of fuse #3. The DLC fuse. I mean I know it goes to the cigarette lighter as well. but when not in use it still blows.
View 1 Replies
My problem had been intermittent for last few days. I have a Ford Crew Cab - 7.3 Powerstroke Diesel. The ford store told me it would cost hundreds of dollars to chase this short- to wait til it finally burns out then - bring truck to them.?
My fuse # 45 a 10 AMP fuse . Keeps blowing out. This fuse controls the gauges on dashboard and fuel peddle. I can start engine and if gauges come up like they should- I can place into driver - and give engine fuel from peddle- gauges down dead and no fuel go to motor. It just idles and still runs and will still move forward or backward. But only at idle speed.
I could replace blown fuse - #45 - 10 amp and it would a the first few times would go and work normally.
Now everytime I replace fuse it blows fuse - sometimes after putting 10 or more fuses in- one might work until I stop or put into park. Then fuse blows again??
Last night and today it took no less than 20 - 10amp fuses to get close to home and end up straight wiring with a small piece of electrical wire - severing as a jumper- it ran great - til I stop at mail box and got mail - saw slight smoke and pulled wire quickly out and idled down driveway to house..
View 10 Replies
Started my truck the other day no problems,minute into the start truck shuts right off like someone turned key. Checked fuses , #30 fuse under the column was blown, replaced it and tried to start truck. No luck fuse keeps popping. After changing again i was able to get truck started for a second and POP goes the fuse?
1999 F550 superduty 7.3....
View 4 Replies
1999 ford superduty keep blowing the 30 amp fuse under the dash, want let it start, why this is happening and the cause of it.
View 1 Replies
I had a problem with this issue a few months ago, was 45 minutes away from home, blew the fuse to the starter. Switched another one in, blew it too. Had it towed to a shop, they did some diagnostics, felt like it was a short in the starter, replaced it and all has been well (as far as that particular issue) until this morning. Got in it, turned the key it cranked for less than a second and stopped. I pull the fuse, sure enough, blown. Swap it with another, it blows.
I know I have a bare wire in the column, the OD light wire is chaffed, I fixed it before but it must be worn again because I can get it to light up depending on positioning of the shifter lever and as I recall, every time the fuse blows the steering wheel is cranked to the left.
View 14 Replies
Why I"am blowing #19 fuse it is a 10 amp fuse. It is in the passenger compartment fuse panel. It controls the auxiliary powertrain control module (diesel only),Instrument Cluster, GEM Module, Overdrive Cancel Switch, Idel Validation (Diesel only), Overhead Console and Diesel PCM via Clutch. I would like to know where to start looking to solve this problom.
View 12 Replies
2002.5 VW Jetta GLI VR6 24V 6-Speed. Barely accepts a small can of Freon from full empty, and pressure goes to over 100 psi in the red, compressor does not kick in, idle fluctuates with A/C button on, small fan kicks on fine, some air pump turns on and off with the erratic idle and sounds like shot of compressed air. When I turn the A/C button off, idle comes back to normal and that psss sound is gone. I already changed compressors and that made no difference. Video below.....
View 5 Replies
