Ford A/C :: 1997 F150 - Heater Only Blows Warm Air?
Jan 18, 2009
I have a 1997 ford f 150 lariat with the 4.6 v8 and my engine had a piston slap so I replaced the engine with a used one and I put a new water pump on the engine. My problem is the heater does not get hot and it only gets warm when I get on the freeway and the rpms stay steady for a bit. but when i idle it just blows cool air. the heat door works cause I can turn it to cold air when I'm on the freeway and i just replaced the thermostat so I don't believe its that. It weird because the heater worked fine before I changed out the engine so i cant figure it out. the only thing i can think of is the water pump is bad out of the box. Could it be the belt or does spacing on the water pump have something to do with it. nothing is leaking.
View 7 Replies
Advertisement
A friend has a 2003 F150 that after starting up will run hot but blow cold air when the heater is on. The truck will run hot for ~ 5seconds then all of a sudden the temp drops to normal range and the heater begins to blow hot. Simultaneously, the oil pressure light comes on when the truck runs hot, then falls to the normal range when the temp drops. I thought perhaps the thermostat is in backward.
View 2 Replies
I've noticed that my X in the winter does not seem to warm up as it should. I watch the temperature gauge and notice that it barely gets to the first mark in the operating zone of the gauge. The heater blows warm air but not hot. I think its the thermostat that needs replaced because in other vehicles I would see the temp gauge rise and then drop when the thermostat opened. I've flushed the radiator and changed the fluid and not difference. I did find the heater valve on the right side was unhooked from the vacuum line and plugged it back in but no change from that being connected. Anything else I should check?
View 5 Replies
I have a '99 F150 4.2 5 speed, my problem is, my heating isn't working. My A/C works fine, my blower motor does too, i changed my heater core about a year ago. I turn my truck on wait for it to warm up and once my gauge reads normal temp, i turn my control to the warm position but the air blows cold with just a very small hint of heat. I looked it up in my Chilton book and they said to check my hoses that go to the firewall/heater core. They say that both hoses should be hot and if one isn't to check it. i did that and the one on the left side(facing the truck) is barely warm. what could be my problem? heater core? my friend from Autozone said something about a vacuum control somewhere in the engine compartment but i don't know where it is, could that be a problem? Or would the flapper door be stuck?
View 7 Replies
Ford crown vic, 1999, 125k miles, no engine work has been done, did flush cooling system in spring of 2013 and put in a 50/50 mix of coolant and distilled water (from a jug). No problems for the summer of 2013, have been using heater with no problems until around Tuesday of this week.
Car runs fine, no leaks, coolant checks out good. BUT now.. My temperature gauge hardly moves (up) and the heater blows warm air only. If I am driving the gauge will not move, if the car sits running for awhile it will move up some and the heat will get warmer inside of the car. My guess maybe a stuck thermostat?
View 3 Replies
So the other morning I drive the 140 miles out of town to work for the week. when I pull up to the job site the cooling fans were revving really really high! never heard this before. then it went back to normal after I opened the gate and parked my truck and shut it off. I'm driving maybe 5 miles tops to the job and back to the motel every day. however that is far enough that my heater should be warming up and it's not even coming close to warm. it blows cold air. and to compound that I'm not sure the cooling fans are even working. they don't appear to be. Is there a connection here?
2011 xlt 4x4 super crew.....
View 12 Replies
I have a 2007 Dodge Charger. The heat blows out warm air. I have replaced the water pump and thermostat. When accelerating the vehicle, the heat turns to hot. Is this normal, perhaps a speical feature? I have 66,000 miles.
View 9 Replies
I have a weird issue on my 2008 Elantra. The heater starts blowing luke warm/cold air after running for about 1 hour or so and stays like that.
View 9 Replies
My 2007 es350 77k miles. Heater starts to get warm and then it blows cold air. What could cause this.
View 8 Replies
I need to diagnose a heat problem. I have a 2001 F150 XL. 4.2L Manual controls. The a/c blows nice and cold, but when you put the heat on its not really hot, blows warm air. I changed the blend door actuator,it got a little warmer. Now that winter is around the corner need to figure it out and fix it. The thermostat, water pump, and coolant flushed before I bought it. Could it be the blend door itself, or is there another actuator I'm missing.
View 14 Replies
I took the dive into a new heater core, as the heater was not getting hot. These are the things I did while on my adventure.
1. Before reinstalling the hoses, I blew thru them to make sure of no clogs...water flew out the other hose..no problem..no clog.
2. inspected mix door not cracked or broken...no problem
3.actuator opens and closes ok, I assume, I can hear the motor run and the door thump closed...no problem
4. water and anti freeze level good....no problem
Start vehicle,let warm up, turn on heat.....No Heat...
5. check hoses at core, one is hot ,the other is not....Problem...
1997 f150 4x4 ...
View 14 Replies
1998 F150 step side, 4.6 V-8 automatic, 176,000 miles -
Heater begins to blow heat as the engine warms up - heat gauge moves up to normal level - running at speed, suddenly the heater blows all cold, the heat gauge pegs to total hot - the oil light comes on, the engine begins to miss - stop the truck, shut off the motor, wait 10 seconds, start back up and all is normal and away I go. Heater working just fine. Gauges are just fine. Have checked the hoses when it pegged to hot, and they are just warm just as if everything is normal.
Problem is intermittent.
Have changed radiator reservoir cap, thermostat, made sure fluid level and mixture is correct - what else to check? Computer issue?
View 7 Replies
I have a 2003 Ford f150 5.4. Heater blows hot, then cold, then hot then cold. When it start blowing cold it pukes out the degas bottle. I have burped it, did the combustion test to make sure not a blown head gasket, the oil clean, there is moisture coming out tail pipe but it has no coolant in it. flushed heater core, pulled water pump off and checked it, its good. Changed thermostat 2 times, put front on ramps to get any air out. I am at a total loss now.
View 8 Replies
My AC blows cold for a little while, then it blows warm. If I wait and turn it back on the cycle repeats it self. I had the freon filled. Not sure what to do? 1997 nissan pickup....
View 3 Replies
This problem is on my son's 2000 F-250 5.4. It's into October and my son tells me he has no heat coming out of his vents. I figure it has to be the control valve that should be in the heater hose lines. Could be jammed closed or a vacuum line has come off the pot that controls the open close cycle. We open the hood and nowhere can we see a coolant control flow valve. It is so tight and dark under all that mess of wires, intake, air conditioner lines and whatever.
Just where should we be looking for the valve. Also it could be the vacuum line is unplugged on the dash, behind the warm/cool selector. And even there is a possibility that some doofus has removed something. He bought the truck this summer. So to get us on the right path, where we start looking for the flow control valve?
View 3 Replies
I just bought a 1997 Toyota Tercel 5-speed stick, with 175,000 miles, and the temperature gauge moves from its lowest possible position to its highest possible position when the key is turned on, although the engine does not overheat, and no coolant is leaking or being burned. I replaced the coolant temperature sensor, but the actions of the gauge were not affected. I don't know if it is somehow related, but the heater blows cold, regardless the setting of the temperature dial on the dash. What I might try next?
View 3 Replies
We got our first taste of fall weather in Houston this weekend, and with it I've discovered a new problem with my truck. After the engine was up to temp, I noticed that the heater would blow cold air any time I sat at idle. If you rev up the rpm's to 1500-2000, you can feel the air start to get warm again. I'm guessing this means my heater core needs to be backflushed.
View 4 Replies
I can't seem to get the engine temp to middle range on the marker, but yet my heater blows "to me" hot air. Even while sitting in idle for extended amounts of time I cannot get it to "operating" temperature. I would think if my thermostat was stuck open my heater would blow either cold or slightly warm air. I have the 5.4L engine with knn air filter and no cats.
View 14 Replies
It seems the local dealership has finally figured out why the rear ac blows warm while the front blows cold. It only took 5 trips.
The part # comes out to F75Z19A522AA or F75Z-19A522-AA. Its listed on Tousley and other online parts outlet but so far all that I have called said it is no obsolete and they are no longer available from Ford.
Rear inlet door actuator - obsolete part? Where I can find this part (I'll even consider used)?
View 4 Replies
Tested/checked the blend door, actuator, Low pressure cycling switch, compressor clutch and they all work. The accumulator does not condense, or at least that I've noticed. The gauge on a can of R134a reads 55 at 85 degrees outside. Anything else I can check to diagnose a problem?
View 4 Replies
Here's the situation....It blows cold for about 5 mins, then the air starts to warm and stays warm. I just bought the truck 06 350 crew cab and they supposedly charged the system. I'm wondering if it has a leak but it should start out blowing warm air? I just wanted some thoughts before I start throwing money at it.
View 1 Replies
