Ford 7.3L Power Stroke (1999-2003) :: Wiring Diagram For Small LEDs?
Apr 20, 2016
I am looking at putting a couple small LEDs in the pinch weld area under the doors on the cab. I want to have them come on when I open up a door. Where is the best place to grab power from the door switch circuit for that? The passenger side I was thinking of grabbing it where it goes into the sleeve between the cab and the door, but on the drivers side there are a lot of things in the way to get to that point. Can I pick it up down in the door jamb area? Is there a wire going to the dome light there?
View 8 Replies
Advertisement
I am going to add some led's to illuminate the steps getting into my truck at night. I plan on putting them directly under the door over the steps. Is there a wire under the door threshold I can tap into at each door? If so what color? If not, where to get the power from. I want them to turn on and off with the interior lights when doors are opened.
View 1 Replies
I can't find a wiring diagram for the UVCH pigtail anywhere. The one that came with the harness assumes the old one was still connected. My wires were burned through and I need to know what colors to wire in from the truck to the new harness so everything matches up.
View 9 Replies
Got a 2002 7.3 f550 and the other morning it wouldn't go into high idle. Noticed my parking brake light was off. Messed with the switch and eventually jumped straight from the connector to ground... still no light. The light does illuminate with key on. I have tested the fuses. Where do I go from here? Looking for a wiring diagram....
View 14 Replies
Any pic or wiring diagram of the starter relay that is mounted to the fender. I'm trying to start the truck finally but it's just cranking and I think I might have mixed up the wiring. Is there supposed to be a constant hot at the glow plug relay when the ignition is off?
View 14 Replies
I have a new to me 1999 F250 with the 7.3 engine. The previous owner installed a push button start to get around the ignition actuator being broke. Over the weekend I pulled the column and replaced the actuator but the truck will still not start with the key; with the push button it starts just fine. I'm not getting any power on the starter relay signal wire, so I suspect something in between the key and starter relay. I searched around a bit, but could not find a wiring diagram for a 1999 diesel super duty.
View 3 Replies
My truck didn't come with factory option aux switches. Can it be added, and is wiring present?
View 14 Replies
I need a wiring diagram for my 2000 F-350 power mirrors also to go along with the power window schematics that I posted before.
View 8 Replies
Where I can find a wiring diagram of the inside and outside lights on the 6.0s? I'm trying to wire up my running boars lights to my dome lights and tail lights but don't know the colors or locations of the wires. The tail lights wouldn't be as hard to find as the dome lights, what is the location and color of both.
View 14 Replies
Looking for the wiring diagram with colors for which port should be what wire for the obd2 connector for my early 99 f-250. I actually think it is obd 1 on our trucks but you get the idea. My truck doesn't have power to the plug I guess. I have a guy plug in a scanner to take a look at everything but he said the plug wouldn't power up his scanner. Just trying to get this fixed. Another question, if I buy a AE does that require the truck to power up the software or does it get powered my the laptop?
View 11 Replies
2013 F350 Lariat with the factory OEM rear view camera. I am replacing the tailgate with a 5th wheel tailgate for a few months and would like to still retain the convince of a rear view camera.
I have obtained a Ford camera harness to use as a jumper for a non OEM camera which comes with the standard basic RCA wiring which I plan to mount to the bottom of the 5th wheel tailgate.
My hope is to wire the camera direct to the Ford wire harness which is a 6 wire pigtail. Which wires on the camera mate to which wire on the trucks wire harness.
View 14 Replies
I need to connect a remote start stop for a bucket truck attachment to this new 2016 F550. Found everything except the ignition wiring harness diagram. Need to know what I can tie in to.
View 4 Replies
Working on putting this project back together and cant find my notes when I pulled it apart last year. Any schematic or picture of their brake lines from the master cylinder to the rabs or front brakes? Better yet, which port on the master cylinder goes to what axle?
View 9 Replies
I am trying to add courtesy lights to the existing reflectors in the front doors of my supercab. I can't find a wiring diagram that shows where to connect the light sockets. 1999 F250 SD...
View 2 Replies
I'm trying to find the wiring diagram for the power windows in a 96 f150. I've got a set of these that i need to fab a harnes for to install in my 82.
View 12 Replies
The leak drains into the first valley of the block. This is after a cleaning and about 300 miles driving. I thought it may be the IPR but, it's looking pretty dry:
Some more pics .....
The HPOP line fittings are dry too. Where else do there the HPOP's tend to dribble a leak of oil from?
View 9 Replies
I switched to red ELC back in September , bought a billet thermostat housing , and did the "dual alternator " upper hose. now i seem to be getting small leaks around my hose connections and thermostat housing. I don't have any pics yet but I'll get some. It looks like it barley leaked. Then dried up
I re tightened everything again but no difference. My coolant level hasn't dropped or Anything that's why I haven't been too concerned. Here's when it first started happening
View 14 Replies
2001 7.3 auto with 188k miles. Supposed to have had a new tranny at 99k miles. Fluid nice and red with no smell.
Here's problem: during the 3rd shift (gear before overdrive), and between 40 and 50 mph, I get a small vibration in tranny. Seems to be just that shift. It's not noticeable if I run it a little harder on the shift (speed up). If I let it lag on the shift, the vibration is worst. All other gears seem ok.
Questions:
1. I believe I have a 4R100. It has a drain plug, but how do I confirm?
2. I have a couple different scan tools. Should I be getting codes if I have tranny problems? Or is there a scan PID I can check?
3. I was thinking of starting with fluid change. Since it probably hasn't been changed since 99k miles.
Last question: any detailed write on fluid change handy? That would include type of fluid, filter part number, etc?
View 8 Replies
After cleaning entire valley on my 2001 f350 with 7.3 I have found what appears to be a small leak under the hpop drivers near the IPR. HPOP lines are clean and dry. Possible for IPR to leak at 120k miles and what will need to be done to fix.
View 2 Replies
I've read weeks worth of post to try and fix my late 99.5. First, I'll give syptoms then what has been changed/worked on. While driving at low rpm truck will shut off. As if the key was completely turned off. I am able to throw it in neutral and start back up. Not very safe.
Most the time when I feel the power/electrical loss I can hit the gas pedal fast and most the time "catch it" before it will completely shuts down. Also, I feel a very small "hiccup" at higher speeds. Not often tho.
Changed. Cps. Twice. First aftermarket, second ford.
Changed ICP sensor.
Had dp tuner installed. Right after tuner install abs sensor went out. Like the same day.
I have edge insight for all gauges.
I'm lost.. if these symptoms ring a bell for any of you that would be fantastic. I'm original owner...
View 7 Replies
I need connector pinouts and wiring diagrams for a 200 7.3
Multifunction switch
Headlight and dimmer switch
Airbag
Ignition harness
Any other column connectors...
View 1 Replies
