Ford 7.3L Power Stroke (1999-2003) :: Steering Will Whine Only In The Morning When Pull Out Of The Driveway
Jun 11, 2016
So when driving my tuck the steering on it would sorta lock up like it wanted to push the truck to one side then it would free up and the steering would be real loose it just felt like it had no power steering to one side it's not the same side each time and it pulses when I'm at a stop if I move the the tires Erving the motor doesn't seem to work so far I have replaced ball joints and all tie rods they needed done anyways it would still do it got an alignment done last week and it almost seems worse now could just be coincidence.
I'm thinking power steering pump but when the steering locks up to one side I'm also wondering if it's the steering box it's kinda hard to explain it what's going on and there is no popping noise or anything when the steering frees up. It's kinda scary on the freeway when I go around a corner the steering gets real loose and wonders back and forth not all the time but quit a bit but when going strait it will feel like it wants to pull to one side then the steering will loosen up again. The steering will wine only first thing in the morning when I pull out of the driveway then it's fine
View 14 Replies
Advertisement
I am having problems with my steering being all over the place. I noticed it at first when braking. It would pull to both sides. At a stop light holding the brakes my steering would randomly pull. I replaced the power steering pump. It didn't fix it. Now just driving it pulls all over. I was thinking steering box?
View 14 Replies
2001 F350 XL... Fitting on PS pump broke and I lost PS and PB with fluid everywhere. Replaced the hose with a new one from Autozone and I have no noticeable leaks.
I know I lost more than a quart but I could only add less than a quart (Mobil 1 Synthetic ATF). I'm also getting a whine from the steering wheel when I turn stop to stop. The power steering is back and there are no leaks (that I see) but the brake pedal is mushy. I've pumped and turned stop to stop for a while. Do I have to bleed the system like I'm doing a fluid flush? I hate to waste the synthetic fluid that I changed about two years ago.
View 7 Replies
Need to identify possible oil leak location. Went through 6 quarts of oil in a couple months. Moderate oil drip on the driveway. Ford dealership said the leak was definitely from one of the high pressure oil hoses but that didn't fix the entire problem. Took it back to the dealership and they diagnosed the problem as "LH HP Oil A Head Leaking Replaced" installed a new elbow fitting. Still leaking.... They are trying to be conservative in their approach however the leak is starting to become an irritant Just want the problem solved. Any probabilities where the oil leak could be coming from?
'99 F350 SD 7.3L, 225,000 mi, 4x4, XCAB
View 14 Replies
I bought a 99 7.3 been in the trees for a few years pulled it home and now trying to get it running. Did a service new filters and oil fuel too. I can get it to start and will run but runs very rough and if you put it in drive cant pull its own self. I don't have a check eng light on. And found out my scanner is a pos lol. it will hooked up and then try to pull codes and loses it connection. But that's the scanner will not work on my other 7.3 as well.
I am making high pressure oil checked off the rail with gauge and it will build up to 2000 psi when I rev it. but missing like crazy. I swaped the pcm and idm out of my running 7.3 and it didn't change a thing. I have checked the pass though and they are fine. pulled drivers side valve cover off and no oil leaks when running and rockers are fine. new ipr valve as well too. I know I need to get a scanner to talk to this thing better.
View 3 Replies
Replaced cups 3ish years ago
Replaced IPR (non- Motorcraft) and ICP last year
New (not remans) PIS Stage 1 injectors with Hydra Flash October
Truck has been running and starting (down to 19 degrees) like a dream since the new injectors. After the last fill up the truck has been harder to start in the morning and if I don't let it warm up till at least until the needle moves it will stall and be difficult to start. Once started and up to temp it runs just fine but will definitely take aa few extra turns to get started whether cold or hot.
There is CEL, I don't smell or see any diesel in the coolant, oil looks good and the diesel in the filter is kind of a clear blue? The way it acts when it stalls is kind of like when the IPR went bad the first time... kind of. The few times I was able to get my phone connected fast enough I saw and IPR duty cycle in the 90s flash and a HPOP pressure of 1500 or so flash all while the truck is barely hanging on to an idle.
View 12 Replies
Resealed HPOP, reinstalled, started right up, ran for good half hr, shut it down, started it next day, ran for 15 min. Revved it up, n all that, good to go, took it for a spin around block, died as pulling into driveway. At crank Dashcmd shows 200 psi on HPOP. I'm double checking the gear bolt right now. When I installed the pump I seated the gear by hand n torqued bolt to spec, so idk...
View 3 Replies
So the water pump on my early 99 (158k miles) is starting to leak just sitting in the driveway, did a little research last night and read a few write ups. Just wondering if any tips or tricks I could use to make this go easier. Also any list of parts I should replace and/or might need. I read on one write up about replacing it with an Airtex water pump and was wondering about what people thought of those, I would rather fix it right then just go with the cheapest parts. Possibly there are better brand water pumps out there?
View 5 Replies
Got a 2002 7.3 F-350 with 300,000 miles and for the last couple of years I've been getting blue smoke on cold morning start ups and its been gradually getting worse, it clears up after about 30 seconds and all is normal,No loss of performance, Oil consumption is minor, however I hate a vehicle that blue smokes, I'm guessing my issue is valve seals are worn, I was wondering if it is possible to replace the seals while the heads are on the engine? and was also wondering how much time it would take to fix? as i would have to have it professionally done. I know its hard to guess a time frame and everyone is different. Sounds like textbook valve seals to me but is there anything else I should check first?
View 14 Replies
Every time I hit a hill, loaded or empty, or get on the truck on level ground after about 15 seconds it acts like it's running out of fuel. The pump starts getting noisy like it has air in it, but it'll straighten out eventually. If you don't let off the fuel it'll eventually stall out. No check engine light, no codes. Truck has a ts chip but it does it on all settings. New fuel filter, changed oil with hot shots secret, new air filter, hutch mod done. I'm at a loss for what to do. Good fuel pressure also.
View 8 Replies
I have some whine coming from my front wheel bearings so I'm going to replace them both. I'm not sure if this had been done on my truck before, but I'm thinking so since I have Moog greaseable ball joints.
Truck has 250k miles on it. I'm going to check the pads, rotors and slide pins. Anything else that might need work? I'm sure the half shaft could use a once over, but I don't keep my hubs locked so they don't turn much in regular driving.
View 7 Replies
I have a 2001 f 350 7.3 diesel r 400 tranny 320000 miles. . Im having transmission issues. It makes a slight whine/ grinding noise only in first And reverse. And it surges. Sometimes its fine though to. Check engine light came on. Only codes i get are #4 glow plug out and a low boost pressure. Checked boost before fixin Running fine at the normal about 20 psi. ive read a bad or dirty map or iat sensor can cause transmission issues along with the low boost error code. But in my experience and some reading it sounds like a stall converter.
View 9 Replies
I'm on the road and I pulled over for a pit stop so I don't have time for a search right now, but I noticed under heavy acceleration a turbo whine so high pitched it almost sounds like metal on metal. Is this normal and I just noticed it, a leak somewhere, or maybe indication of something worse? The truck seems to be running ok otherwise. It's an '02 w/7.3 and 220k miles.
View 3 Replies
After my recent cooling system upgrade and power steering pump/HP hose replacement I am still hearing and feeling the power steering whine. I flushed the fluid and used Mercon V ATF fluid. I jacked the front end up with tires off the ground and cycled the steering lock to lock 100 times or more now and the whine does not stop. Do I need to put a vacuum on the system and try to purge it that way? There was no whine before but I just replaced the pump while I had room with everything out of the way and replaced the high pressure line because the fitting was leaking at the pump. This is very irritating because I thought replacing the pump would be beneficial.
View 2 Replies
The problem makes the car unsafe to drive. The quickest way to describe it is a hard pull to the left after a very linear steering feel. My perception is almost as something is holding on and then just fails and lets go and the car quite abruptly shoots left in a very unsafe manner. Here are the things I have done to remedy the situation, I replaced the struts with factory replacements 15,000 miles ago. At the same time i replaced the left and right axles, drove the car with the problem then last weekend, I replaced the upper tie rod arms, and lower tie rod ends, the sway bar bushings, and the control arms on both sides. I literally feel as though it is a darn near new front end.
Just yesterday I had 4 new Goodyear eagle tires and an alignment done and the problem became more pronounced and worst. I really like this car and want it to be a joy to drive as I know from others these little hatchbacks are a real joy on winding mountain roads.
View 10 Replies
My 7.3 power steering is acting up. Feels like I am up against a rock. At slow speeds like parking lot maneuvering I struggle to turn wheel. Then all of a sudden I'll get power steering back and wheel will rapidly turn. Freaky.
Brake pressure is fine. They shutter pretty bad even with the new rotors I just put on but they have good pressure. But the steering is intermittent or no power steer.
I saw online to run engine at 2000 rpm and try steering but no change. Still no power steer. There is fluid in reservoir. There is fluid seeping up steering column from steering box. No clue if this is related or unrelated.
How to troubleshoot further. I hate throwing parts at problems before truly diagnosing. Also have pretty aggressive lurching during turns in four wheel drive. It's present on dirt road but worse on pavement. Don't know if this is related or not.
View 3 Replies
So, I'm replacing the Steering Box today and read an article that said you should replace the pump at the same time. what do you all think?? I have clear access to it now and they are not all that expensive?? Or are the ford one's bullet proof and leave it alone???
I don't have any leaks and it feels ok I guess..just pushing close to 200K on it.
View 13 Replies
I've got an 01 7.3 lariat 4x4 with an 03 7.3 engine in it (long story behind that) but basically I noticed one day I had a hissing underneath my dash and my brake pedal was a little spongy but my truck stopped, well before I could get it to a shop and checked out it went bad. Coming up to a stop sign and as normal hit my brakes and right before it came to a complete stop the pedal shot to the floor and I lost power steering as well as brakes and went rolling out in the road and almost got hit. So it's been parked ever since and I have changed the hydroboost, the power steering pump twice, flushed everything and bled everything and still nothing, can't even find any leaks. What to even replace now or whether to just take it to a shop and spend another small fortune.
View 7 Replies
I have been noticing my brake pedal is very firm on and off also my power steering seems to get harder to turn than other times. But today i was sitting at a few lights and could hear my power steering pump growling at me intermittently if you want to call it that.
Also sometimes my truck will pull to the left or right then it goes away if i hit the brakes again. I don't see how the hydra-boost system would do something like that. But its not the slide pins because i just greased those along with new brakes and rotors all around at the beginning of winter.
I noticed when I grabbed my fluid lines going to the hydra boost from the power steering pump they seemed to rattle very rough so that makes me wonder if the pump isn't going out. How are the brakes supposed to be on these trucks? nice and soft? rock hard?
By the way truck is an 02 with 144k on it
View 11 Replies
I have a 2000 Excursion. This weekend, I noticed some intermittent failure of the power steering where it seemed like the pump was not engaging and then would all of the sudden. Deciding to try to head off a failure, I got a reman unit from Oreilly and installed it this morning. It was fine when I tested, had good brakes and went locked to lock quietly without fuss. Let the house and within a mile, I lost steering and brake assist. I stopped and turned around, but what I am noticing is that at idle, I have no power steering, but when the RPM's are up, I do.
View 3 Replies
My power steering is only working when i turn it to the left. When I turn it to the right i have to get a 1/4 of a turn in until the power steering takes over. So i get under my truck to discover what seems to be a piece of my tranny missing. How screwed am I ???
View 11 Replies
