Ford 7.3L Power Stroke (1999-2003) :: Severe Oil Leak And Coolant Disappearing
Dec 23, 2016
I was searching for an oil leak forever. In my search for the leak I resealed my hpop, redid oilcooler rings and last week had a friend pull my motor to redo the pan gasket. The leaks were almost down to where I thought we had them beat. Now in the last couple days I'm losing coolant and oil....bad. there is oil on the ground mostly from the cross member. Question is did my oil cooler fix not take? I have read that a nicked of ring can cause this.
View 11 Replies
Advertisement
Even though I had head gasket done/timing belt/water pump & other stuff, 3 months, ago, I'm having to check the coolant level weekly & adding about 1 cup of water to pink coolant every 8 - 9 days. The mechanic who did the work tells me that adding that "little" water in "that amount of time is nothing unusual". I know of no one else who keeps a coolant log. I'm obsessed with this problem. I've spent so much on differing repair to this car - it's as if I bought a lemon.Car has 104K mi. Have coolant problem with no coolant winding up on the ground?
VW Passat station wag. 2003 1.8 L Turbo 4 cylinder...
View 4 Replies
I have a coolant leak from behind my timing cover found while doing a coolant system pressure test. I do not want to remove the engine. Looking for info on successful cover install with the engine still in the truck?
View 8 Replies
2003 7.3 175,000 miles...
Saw a stain in my driveway where you normally see AC drip. Opened hood and saw degas empty.
Looking around like crazy and find wet area. Where the coolant line turns down beside the passenger fender.
Looks wet near bend going toward running board. Didn't get to inspect much but I pulled back a bit of loom to inspect shape of lines and they look great.
What could be going on?
View 14 Replies
The truck has been a dream for several months and I had a coolant leak at the thermostat outlet. Changed the fitting and thermostat and sealed with lots of blue monkey snot. It's been perfect for a couple months but a week ago it started leaking again. Exactly the same as last time. I cleaned the mating surface of the water pump with a plastic scraper to remove the old sealer and then finished it with fine scotch brite. I looked at several parts breakdowns and none of them showed a gasket.......
View 14 Replies
Is this common? No coolant in the oil-YET........
Any way to fix it without pulling the cover?
View 3 Replies
The truck has been just terrific, mostly used for towing our travel trailer. Earlier this year i developed a leak and lost 3 quarts of oil before I caught it. I would think with 15 quarts in her this shouldn't have been too big a deal. However, I am now experiencing 10-15 degree swings between ECT and EOT. Before I give the particulars, yes, I have had three new thermostats, two Ford and one brand X.
Anyway, coolant temps are 184-200 depending upon load, terrain, etc. At the same time, oil temps run 205-230. There is no oil cooler to get plugged up. She's got 120K on the clock, doesn't burn oil, no disappearing coolant. I am concerned about blowing a head gasket or other serious damage at these temps, but don't have a clue where to start? Yes, the fan does come on, but still this seems plenty hot.
View 14 Replies
My serp belt started squealing so I pulled the thermostat housing to inspect the rubber gasket. It looked OK, but I cleaned up both surfaces and replaced with a new gasket, and put it back together. The housing was replaced just a couple months ago along with new hoses. It was not corroded and OK to reuse.
Started the truck up and saw a slowish/steady drip of red Cat ELC dripping on the driveway. Opened the hood up again and carefully inspected around the thermostat housing - no coolant is leaking there.
I did notice the same slow/steady drip coming from just behind and beneath the thermostat housing. See in pic, this is where it is dripping. One other question, what is this plug for on the side of the water pump?
View 14 Replies
2003 F250 7.3... I noticed a water leak dripping down onto passenger side front leaf spring. I saw this before but attributed it to the AC (which kicks butt) but haven't used the AC. No scent to the clear fluid, temps all look good. Running fine. Where does the AC discharge go? Could AC be on (not on AC but set in blue zone on dial)? Reservoir looks ok but could e small volume of drips.
View 12 Replies
Ok I bought a 2006 Ford F350 with 6.0 after driving for about 3 weeks I noticed a little bit of coolant was disappearing out of reservoir. So yesterday I was driving with a load Reservoir overflows replace coolant with one gallon of coolant and finish trip with no issues. I started truck today and it will not stop smoking it is also not overheating after hearing about head gaskets. I'm hoping it might be EGR cooler white smoke smells like raw diesel fuel. What to do?
View 3 Replies
My mothers 95 blazer LS coolant is disappearing. A friend said if it's not on the ground than it's in the engine somewhere. oil pan search looked coffee looking?
View 6 Replies
I have an 04 ford explorer, with severe coolant leakage. I am far from an expert but it seems like it's coming from the center engine block, but I can't get much access in to tell. What's going on?
View 2 Replies
I have coolant disappearing but no signs of a leak anywhere. Oil is fine. Car does not run hot. There is rust in the radiator though. Heater core is not leaking. I have a 2001 Pontiac Gran Prix GT. There was a recall on the cooling system but was not serviced (I didn't own car then). A pressure test was done and it holds pressure. Should I change radiator and thermostat? What else should I have checked?
View 19 Replies
My 2003 6.0 has a coolant leak. It leaks slowly while not running and more quickly while running. I have about an 8 mile drive to work every day, I can make it there and back without having to add coolant but I'm cutting it pretty close by the time I get home. In short I go from the max fill line to bone dry in about 24 hours.
With the truck running I can see water getting slung around all over the front of the engine but the majority of it seems to be coming from around the two larger pulleys in the middle. I've read that this can either be the crankshaft seal or the water pump, any way to know for sure? Any other possibilities?
View 6 Replies
I have an '04 Ranger Edge 3.0 with a severe coolant leak. It appears to be coming from the area where the head/water pump housing meet. I have been told I've lost the seal behind the pump on the timing cover. Is there any way to know for sure? Will I be able to tell, once the pump is out that it isn't coming from the head side? Are there any "special" instructions for re-sealing after replacing pump?
View 6 Replies
My friend bartered for a '99 F250, 2wd/auto, 4 door, 7.3, 258k miles.
It had reportedly sat for one year, though the expired registration sticker and other things point to it sitting for two.
It ran low on oil, sputtered and died. Oil in the degas tank. Filled to oil to mid way on the hatch marks on the dip stick.
I drove it 25 miles to my house, and the oil level is not reading on the dip stick.
The sludgy fluid level in the degas tank is unchanged. Where is the fluid going?
I will refill the oil to see just how much it lost in the 25 miles if it important to someone, but I prefer to not waste the oil.
My first plan is to remove, inspect and replace the oil cooler o-rings. Even though the dealership charged him for this, I don't trust that they did it right. I think it is the easiest and mostly likely place for oil getting into the coolant.
It does have a really long crank before there is enough low pressure oil for it to start. At the moment I think this is a separate issue.
The dealership also charged him for a replacement injector. No idea if they replaced the cup or not.
View 14 Replies
I have a 03 F-350, 7.3L. There is a slow oil leak that only leaks after I've run the truck. In other words, it doesn't just sit and leak overnight. I'll park it after running, and the next morning I'll notice a small pool of oil, approximately 2" in diameter. The leak appears to be coming from the oil pan area. I degreased the entire oil pan area to get a better visual of where the leak is coming from. I can see oil trailing down the front of the oil pan and the rear of the oil pan. Does this sound like the gasket? Or, what else could it be? I'm praying its not as bad as I think and need to replace the gasket.
View 3 Replies
Had coolant in oil, so pulled motor. Got used motor to replace it with, thinking about doing some work on it before reinstall.
Got bellowed up pipes, injector o-rings, front and rear main seal, and will use best parts from both motors to make one. I'll also shim injector armatures back to spec.
Should I do injector cups too? What else is recommended to do at this time? Both motors are 350k or so, I was on a budget at a moment and have to make it work with what I got.
View 5 Replies
What is the effect will some oil contamination is the cooling system?
Does it significantly affect the cooling efficiency? I have some oil the coolant on my boat. I do not believe it is a lot maybe a few oz, but I have been chasing some unexplained overheating issues. Will adding water wetter solve oil issues (if there are any). The other option is Dawn and several cycles of flushing the system. ie until the cows come home!
View 3 Replies
I have a 2002 excursion and every time I try to put the coolant at the min level cold, it overflows through the cap until it is about 1.5-2 inches below the min level. Then it stops. I just did the oil cooler seals last night because I had a little oil in the coolant. Same thing happened this morning - overflowed again.
View 10 Replies
Although not certain, I *thought* I saw coolant run into the front drivers side injector hole when the injector was out and I leaned on the radiator hose. I had knowledge t pull them and changing the orings who were initially concerned then not concerned after looking closer.
Either I made a mistake in what I thought I saw on my first experience with injectors, or there really is a problem that I didn't know enough about to address at the time. So I opened this thread to get more info and stop hijacking 67speeda's thread, found here: [URL] ....
As per recommendations, I will check my coolant bottle for any fuel, oil, residue, etc. I am also going to reach out to my buddies and see if they saw a problem with coolant, too, or they realized it wasn't coolant and I didn't take note of it ...
It was a REALLY LONG day and my ability to concentrate had begun to slip quickly (health issues), so it's possible I missed something there. So IF I saw coolant going into that cylinder with the injector removed, how bad would that be? I thought it came from pretty high up and ran down where the injector sits..
View 9 Replies
