Ford 7.3L Power Stroke (1999-2003) :: Power Loss And Truck Started Hiccuping When Wipers Turned On
Jul 11, 2017
A few weeks ago I replaced my CPS on the 99 7.3. Today was the first day I drove my truck in the rain. When I turned my wipers on, I noticed that I lost power and my truck started hiccuping. I read on these forums that an aftermarket CPS is most likely the problem, so I am planning on getting a ford CPS this afternoon. My biggest concern is that before I replaced my CPS, my wipers only had 2 speeds. Also, if I pressed the end of the blinker switch to squirt the cleaner the wipers would not turn off until I turned the truck off. I am not sure why this would be happening and I wanted to ask if there is more than just the CPS involved with this.
View 7 Replies
Advertisement
I was driving my truck then all sudden truck started losing power then slowly died. I restarted it, it was a lil shacky then died again. Iunscrewed the fuel filter and looked in the housing and there was lil fuel in bowl i turned the key to on position and bowl did not fill with fuel looked as if it were shooting some bubbles up(air) could it be outta of fuel???
View 10 Replies
While headed back to town my 2000 f350 7.3 with 444,650 miles (I'm original owner) and have performed maintenance and repairs since mile 3. Truck started to loose power and eventually stalled, was able to restart several times to limp home 7 miles in one hell of a snow storm. Very confused, replaced cam position sensor ( keep one in jockey box ) replaced fuel filter truck starts then stalls out. Don't know if a bad HPOP would allow start up at all. Fuel pump???
View 6 Replies
I have a 2001 F350, 7.3. My service engine light came on and immediately the truck started to run rough and lose some power. I've checked the under the cover connections and they were both connected, I replaced the cam position sensor and I still have the same problem. The worse part of the hold thing is that there are no codes stored so I'm flying bind. Where to go next.
View 8 Replies
2003 CC 4x4 ... I am pretty sure I know what is going on, but I wanted to start a thread for when I confirm it. I am driving to work this AM and I hear the door ajar chime and I think to myself, uh oh...gauges all look good, there are no lights illuminated on the dash. I get to work and turn the truck off and my fan stays on. I think the ignition module is going bad. Either that, or my remote start is going on the fritz. I will update when I find out more.
View 3 Replies
Need to diagnose this before I start ripping wires:
Truck started blowing the # 8 fuse under the hood tonight (15 amp #8 - trailer tow electronic brake illumination, park lamps, trailer tow park lamp relay coil fuse) which also controls the dash board lights (can't see gauges at night) and the tail light lights (brakes lights work) are out too. Figure I have a short somewhere.
View 14 Replies
2000 Ford Excursion, 7.3 PS with 210,000 miles. I am on I40 at a truckstop. I was rolling down the freeway last night when the truck started bucking. I pulled of the freeway and here came a thunderstorm. I waited til this morning to check for codes cheap scanner. I pulled a code P1211. I waited for NAPA to open so I could take it in the shorts. I bought a fuel filter and an ICP sensor. After changing them out, the truck runs then starts missing. My battery is about to die so I will finish post shortly.
View 14 Replies
Here in the last week or so I have noticed what seems like loss of power in my 04 F250. When I get on the gas it doesn't seems to respond like it used to. When I turn off the truck i can smell diesel a little bit. could it just be a clogged injector, bad plugs or what?
View 2 Replies
When I start my truck it takes 30 seconds or so for the truck to start moving... especially when in reverse. If I give it some gas it doesn't take quite as long. I am not a transmission guy. I assume it has something to do with building pressure but I don't know what would be the cause. The fluid is full and looks good.
View 8 Replies
I am still failing to appropriately diagnose the problem(s) with my '03 Ford E-350 7.3L Powerstroke. This van has only 69,000 miles on it. A week or two back (just a few days back in work time) it suddenly went from running perfectly smooth, clean and wonderful to this:
- Zero power. Putting the van in gear and flooring the engine causes lots more smoke not nearly any rev of the engine and just a crawl forward.
- Lots of smoke out the back exhaust, whitish. I cannot discern wether it smells like diesel or oil (because I'm ignorant here), but the smell is very strong.
- After warming up and idling ~ 15 min I check under the coolant cap and see no signs of bubbling or disruption (from opening the cap in the coolant tank).
- After warming up there are no warning lights visible on the dash, and I don't have a computer to read codes (if there are any to read).
- I replaced the turbo up-pipes which had a visible leak previously. This did not hurt the symptoms, though no more visual leaks under the dog house.
- I thought maybe I put gasoline instead of diesel in the truck, not so.
- To do the above test I had to use the fuel pump to get gas out the tank to test. I hijacked the fuel pump output and turned the car on a few times to get gas out to a tank. The pump seemed to work just fine.
This was all very sudden which is perplexing, and, in use, the van was previously an ambulette and in my few miles with it (maybe 200-300 only) use was extremely light for such an engine/van, just driving around doing errands. I am not sure if this is relevant (no one has suggested so, yet) but before all this happened I uninstalled the rear HVAC that came with the van when I bought it. The AC lines were sealed under the hood. The coolant line was returned at the doghouse (you can see this at the beginning of the video).
At the moment the van has no power to go anywhere. I have not yet checked the CPS or IPC sensors, and understand this might be the next route in standard troubleshooting?
2003 Ford E 350 7.3L Trouble - YouTube....
View 14 Replies
I have a 2001 ford 7.3l powerstroke diesel. When I first noticed the problem I was towing a trailer going up a grade and got into the throttle almost to the floor and noticed a loss of power and the service engine soon light flashing extremely rapidly a few times and never came back on. I made it home, still lacking power but not running rough. I drove the truck to work the next day and the truck was running rougher and loosing power. It ran great through lower RPM's but seemed to trip as soon as you gave it over half throttle. eventually the truck wouldn't run right at all and lacked complete power. It idled rough as well. My mechanic threw the computer on it and it said injector pressure reading too high or too low.
I was told to replace the IPR on the HPOP and I did. (I also replaced the fuel filter and changed the oil). After replacing the IPR it ran great, had full power! then it began to slowly die like it did before until it sounded like it was running off 4 cylinders again. I pulled the ipr out, cleaned it and changed the oil again. It seemed to clear it up for an hour and ran great but then began ran rough again. I also replaced the CPS sensor. I feel like its not getting enough fuel or something, im just wondering if it could be the ICP or the lift pump. There is no check engine light at all. Its just got me stumped because cleaning the IPR clears everything up.... temporarily.
View 14 Replies
I just recently bought a 199 E350 4x4. I changed the injectors and it drove a little bit better but was still lacking power and was throwing a p0472(exhaust back pressure code) and a p0113(IAT sensor circuit hight output) code. Last night i put a new ebp sensor and the truck came back to life for about a half mile or so then went right back to the way it was. I took the sensor back off and cleaned it in case it some how got clogged from my short ride. It surprisingly did have some soot in it which i cleaned out. Also blew air into the ebps line while still mounted. Put everything back and still nothing. What could it be? Could i possibly got a bad ebps?
View 14 Replies
I am going along and the power just goes away. Sometimes it is a 50% loss other times it is an 80% loss. I hooked up my scanner and found an IPR code. I replaced the IPR and connector, nothing changed.
As the scanner info shows the Duty Cycle and Pressure track about identically until something goes wonky. When I loose about 50% power the pressure will not get above about 1500 psi but the duty cycle will run up to 60%. Other times when I have a bout an 80% loss the pressure and duty cycle both track low, no more than 1200psi and about 20%.
View 14 Replies
I have a F350 that has intermittent power loss.
View 14 Replies
For some stupid reason, my truck decided to lose power today when exiting the freeway. D/s egt gauge verified it with no increase in temp when stepping on go pedal. After about a minute, I could feel it gain power. So, rolled into fuel station, and topped off tank. While filling, I popped the hood and started messing with the uvch and looking around. It was then I noticed that darn hose riding on top of a ton of wires. Pulled said hose up and sure enough, a wire is shafed clean off of insulation. Anyway, something to check while looking around under there....
View 4 Replies
1999 f250, 280,000 miles. I use Power Service with every tank, oil changes every 3500. Had a few of the injectors changed several years ago after getting bad fuel. Tranny "built" when rebuilt, about 60,000 miles ago.
Truck starts and drives every time, no miss or rough idle, no smoke. Just not as much power. It downshifts sooner and really seems to resent towing my atv trailer. Where do I start ?
View 8 Replies
I own a 2000 7.3 6 speed with 175,000 miles. I just bought it less than a month ago and it is my first diesel.
About a week ago I stepped on the gas and it just had nothing. I have a TS 6 position chip that I unplugged as soon as I noticed the loss in power. When I first bought the truck it was incredibly fast and now it has nothing to it at all. I have to have it higher in the RPM's to go up hills (especially when its not warmed up). If I push the pedal down it will sound the same, boost will get to about 14 (without chip) and the truck doesn't let out any smoke but it just doesnt have any power at all. I recently towed another vehicle on a trailer and it really struggled with it, more than I thought a diesel should.
When the chip was in, the truck would let out black smoke even after I noticed the loss in power. That made me think that the engine was getting enough fuel. I thought there could be a boost leak somewhere but it still builds 14 psi. However, I do not feel boost kick in at all! When I first got the truck it would only build around 14-15 stock but it felt a hell of a lot faster and I could feel when boost would really kick in. I took off my intake and looked at the turbo and the fins are in great shape and there is little to no play.
What the problem could be? I don't have very much money to start dumping parts into the truck and Im not sure what to do. I guess my questions would be:
1) Is it a boost leak, fuel problem, or something else?
2) Could a gelled filter give me these problems?
3) What should I do and where should I start?
View 3 Replies
I have been getting about a 1-2 second power loss while driving. happened last friday when at a stop light, pressed the pedal and started to go then it dropped out for a second or two and then caught right back up. only cut out twice in 10 minutes then ran fine for another week. This friday oddly enough , it happened again while driving down the road. happened about 5 different times in 10 minutes, then back to normal. I replaced the passenger uvch with dorman, but not driver side a couple of months ago . Does this sound like the other uvch, or tps?
View 6 Replies
2002 7.3L SD ... He told me when he was taking his son to school he turned on the heater. When he did this he could feel the truck lose power, he turned the heater off and it drove fine. Turned it back on and power loss happened again. I haven't driven it to test yet or see what is happening but I also don't understand how this can happen. The heater did get warm, and he does not have to add coolant to the system.
View 13 Replies
A little background first on my 1999 Ford F350 7.3. A few months ago I noticed i had fuel in my coolant which lead me to a cracked injector cup. I replaced all 8 cups and since I had it apart, and I bought the truck used and didn't know what had been serviced, I replaced the injector o-rings, glow plugs, valve cover gaskets, and valve cover gasket wiring harnesses. Got it all back together and had been running great.
About a week ago I was parked with engine running and the stereo suddenly turned off. A few minutes later I turned the truck off and turned it back on about 10 minutes later and it wouldn't start. Batteries appeared dead so I jumped it and made it home. Took both batteries down to AutoZone and since they were under warranty got two new ones. Figured out my alternator was bad and not charging my batteries so I ordered a new one.
Up to this point truck has been running fine. Truck had sat in my driveway for the week while waiting for the alternator. While I was out of town my father in law went to use the truck and noticed it wouldn't start. He hooked some jumper cables up and got the truck started. He said as he drove off the truck had no power and smoke was pouring out the exhaust.
I charged the batteries and installed the new alternator. Truck starts great and seems to be idling normal. When I took it for a test drive it has no power when accelerating and black smoke pours out the exhaust. The truck will barely make it up any type of incline.
I thought maybe it was the injectors not firing. Wiring harnesses are plugged in and do not appear to be damaged. I did not remove the valve covers yet as it's not difficult but time consuming and I figured since I just replaced all of it that it should be ok. I did a buzz test and all injectors passed. I get no trouble codes or check engine light.
View 8 Replies
I have a 02 f350 7.3 with 296,000k its been running ruff lately with a serious loss in power. The truck sounds good at idle starts up fine but when im on the throttle under load it almost crackles and sometimes bucks. I thought its was injectors replaced them all with stock ford remains but didn't fix the problem. I have AE and it passes a buzz test but i did a KOER test today and it started what seemed like a misfire during the test my ICP went to 2400-2500 and my IPR was at 38%. I have already put a new hpop in a couple month back along with new hpop lines do to a burst, ICP sensor, and i rebuilt the IPR valve. Not sure if this is a problem with fuel or the hpop I have also cleaned the screens in the tank and replaced the fuel pump which were pretty bad....
View 9 Replies
