I have a 2001 F250 (Platinum Edition). I purchased about a year ago. The water in fuel light came on. I ran an additive to remove water and changed the fuel filter several times. Light still on. How to turn it off? I missing something? Only fuel filter I see sits on top of engine...
View 14 RepliesMy 99 F350 cranks, but won't start, and the "water in fuel" light on the dash stays on while cranking. I have never paid close attention to it in the past. Is it supposed to be on while cranking?
I drained the water from the yellow lever located on top of the engine, and tried to start it. The light went off for the first few cranks, but again the truck still will not start.
I just came from a 10 hours round trip to NC. I filled the truck up two times from gas stations on the way. Is it possible that the fuel is bad? I drove on the same fuel almost 3/4 of this tank and now at the last 1/4 I am having this issue.
A little update:
I took the top of the fuel bowl off to see what the filter looks like, and it is nasty and completely black. I could not tell if the fuel in the bowl contained any water, but it looks greenish and uniform, no the obvious separation that happens when you mix water and oil.
Could the fuel filter be the problem?
A little history about the truck. It's always hard to start if cold and not plugged in overnight. I know it's the glow plugs relay, so I just keep it plugged in all the time until I get a chance to fix it.
IDM was acting up shutting off half of my engine, but I took it off, cleaned it, plugged it back in and it has been working fine for over 2 months.
Not another dumb "water in fuel" post... I had the warning light come on the other day, so I got under to drain the filter. Not much water came out before the diesel, but I let some diesel drain anyway to be sure. What was strange though, was the electrical connection was off. I must have hit something somehow and pulled it out? What I'm wondering, because of the little water that came out of the filter, would the light have come on from the plug getting pulled out?
View 14 RepliesI just changed the drain valve on the fuel filter bowl. All went well and no more leak, but now I am getting an "emission system" warning light.
After I replaced the valve, I filled the fuel bowl with diesel fuel. Was there any other priming that needed to be done (if any)? What the emission system warning light may mean?
2002 F250 7.3L 4x4.
My 2000 F350 7.3 has been stalling out with the water in fuel sensor for the last to tanks of fuel. I thought I needed to buy a new Titan fuel tank, I pulled the tank and was surprised to see that my tank was not a metal tank, It's polyethylene, I bought the truck in California with 60,000 miles it has 180,000 miles now. It was sold new in Canada, I expected the tank to be metal with the the liner coming off.
The two fuel filters in the tank are just about plugged solid I'll be removing them and repiping the return line. When I repipe the return line do I put the duck bill on the end or just leave it open? Also I searched the web for hours looking for a stock size polyethylene tank with no luck. On the bottom of the tank I found The ford part #s. I'm going to siphon the fuel out of the tank today. and reinstall....
Well, like the title says, my fuel was a little low. It was the first time I had gone near the red zone.
I was planning to drain the tank so I could remove it for some mods., so I thought I would run it down to 3-4 gallons remaining. I usually fill at 1/4 tank and it takes about 18 gallons, so I thought I had a LOT of fuel remaining when the gauge was between 1/4 and the reserve zone.
I happened to see the low fuel light come on and within 5-10 seconds I was losing power and coasting to a to the side of the road. "Next" time I will be sure to carry a can of fuel.
I recently purchased a AAA membership, so I decided to utilize it for the first time. It took over an hour for my tow to arrive and hundreds of cars and trucks went by while I was waiting for my tow truck (roll back because of 4wd). I'm glad I had the AAA.
I thought I read somewhere that there was supposed to be about 5 gallons of fuel remaining when the low fuel light comes on.
Okay a little update on my truck not starting, and for those who have not read my earlier post. My water in fuel light has been on in my truck for probably a month of use. I drained the water sep under the truck nonstop and added several bottles of water remover and the light would not go out so I assumed the sensor was just bad. (im new to owning a powerstroke btw) I broke down coming home from work, got it towed home, and still cant get it started. It will crank fine just wont fire up. I tried unplugging the ICP, i replaced the CPS, and ordered a new water sep/ fuel filter for under the truck. And the fuel filter on top was just replaced a month before breaking down. Every single time i drain the separator tons of clear water diluted fuel comes out before it turns greenish.
Not sure if this could be a cause of getting water in my fuel but one time i filled the truck up completely and it was like the water overfilled and probably a quart or two of fuel spewed out onto the ground. Not sure where it came from. Also I have just over a quarter tank so i was thinking maybe the float broke and I just needed to add fuel but today before i went to add fuel i drained the sep and tons of water came out... Im so worried about hydrolocking my engine or ruining my injectors. But I dont know if my issue even is water related if the sensor just went bad...
I was about 2 miles from my home today when the Water In Fuel Warning appeared on the dash. I drove home and got everything read to drain the water separator. I crawled under the truck and the wiring harness was unplugged from the filter housing and wrapped around the rest of the harness. I just last week had both fuel filters changed during a routine oil change.
It appears the dealer left the wire unplugged. I drained some fuel just to be safe and as expected found no water. I plugged in the wire and started the truck. The warning went away. Here is my question: Has this event set some stupid bit or trigger in the ECM that Ford can use later to deny a claim? I called the dealership and talked to a tech who said "no". The service manager is supposed to call me tomorrow.
Looking for the Ford (or even Dorman) part number for the Water-in-Fuel sensor that bolts to the outside of the fuel bowl?
Guzzle has it pictured here:
The water sensor tip on mine is badly corroded and eaten away.
What's a part number and who sells them that I can get it delivered next day?
Had the ole factory fuel separator/bowl drain start leaking on me about a month back. So i ordered and installed a new one, issue fixed. Well last night the fuel leak started again, I looked everywhere and i cant see anywhere else it may be leaking at. I felt the underside of said piece and it didn't feel wet, but the valley is full of fuel.
I got in there and tightened the 4 bolts down some more, they were tight but i got a some turns on em and am hoping i either didn't tighten it down enough or they maybe backed out some. Now just gotta see if that solves the problem, again.... the replacement is a doorman, the o-rings were bigger/thicker than the factory orings on the old part, of which the o-rings were shot.
Like I said once i replaced the part the leak stopped for 3 weeks until last night. If the tightening of the bolts doesn't solve it where should I look next? I have an FRX mod but i checked all that and its dry as a bone around all the fittings by the bowl and the heads. No indications of leaks anywhere around any of the FRX assembly.
I have a very small fuel leak in my 2001 F-250. I was going to just let it go until I needed to do other work (since I get 20mpg city and 25mpg highway), but I went to a "new" inspection guy, and he flunked me. So now I have to fix it. And for all I know, my mpg and fifteen other things will break when I try to fix this.
Today I spent 4 hours in the heat putting in two new o-rings on the water separator valve. But the truck still leaks fuel. Climbed up on top of motor while it was running and looked, but I don't see where the fuel is leaking out.
Online research suggests to me that the next most-likely culprit is a steel fuel line that wears through from vibration and chafing. Is that correct?
This truck is so eaten up with rust (came from salt belt) that I bought a LOT of fuel line stuff a year or so ago, so that when things started falling apart from rust, I would have the parts on hand.
Now I'm wondering whether I already have the part I'm likely to need.
So far, I have bought:
1. Dorman Fuel Supply and Return Lines
2. Riff Raff Diesel High Pressure Crossover (HPx)
3. Riff Raff Diesel Fuel Rail Crossover (FRx)
So my question is, am I likely to have something to replace the part that commonly leaks on these trucks due to vibration/wear/chafing ... or will I still need to buy another part?
I'm thinking that one of the two lines in item #1 above is the problem child...
On my 2006 6.0 the water in fuel warning kept coming on the dash. After going draining a few times and a few tanks later I knew something wasn't right so I bought a new sensor. When I pulled the old sensor out, it was full of gunk that was like a white jelly. I probably could have just cleaned the old sensor but I put the new one in anyway. My issue went away for a few months when the WIF alert came back. I pulled the sensor out again and sure enough it was gummed up. I've decided to pull that little panel door off and clean the inside. I have a few questions:
1) Can that oring be purchased separatly?
2) Can I just reuse my oring if it still looks good?
During a heavy rain the "water in fuel, drain filter" warning came on. I drained the filter like suggested and a water bottle full of water drained out. This is less then a week after I had the titan fuel tank installed. After I drained the fluid I restarted the engin and "reduce power an water in fuel" warning came on. I am 250 miles from the nearest ford dealer. How major is this???
View 12 RepliesSo my 7.3 started sputtering and lost power, died on the side of the road. I wasn't far from home put about 8 gallon of diesel in the tank with a couple of fuel jugs and it fired right up.
Gauge was reading 1/8 of a tank and low fuel light did not come on. (low fuel light comes on when you start) Gauge came up to about 1/2 after putting fuel in.
What happened? Gauge was always reliable and low fuel light always did work. Only work done to fuel system was had new tank straps put on a couple of months ago.
Changed fuel filters today. Now my water in fuel light is coming on. But the truck is not running any different no sputtering or anything. ????? Could this be human error
View 14 RepliesThe past few weeks the dashboard warning light for my alternator/battery will occasionally light up while driving down the road. Whenever it does, my plug in voltage meter shows a healthy 14.x reading. It usually goes out after a few seconds, but will stay lit up for as much as thirty seconds. So other than voltage being too high or too low, what else will cause the dash trouble light to illuminate?
View 14 RepliesMy water in the fuel light came on for the first time since I have owned the Excursion, which is a little over a year. Only thing i have done different is Monday this week i put in some hot shot diesel fuel additive to try with stiction. Dothe additive is the cause of the light to come on?
View 2 Replies2004 6.0 and I put in a new WIF sensor and took off the cover and cleaned the junk out but it still comes on after a minute or 2. What am I missing??
View 3 RepliesWhat is the part number for the gasket that goes on the water separator on a 2003 6.0 diesel.
View 6 RepliesSo I am happily driving my 2011 F250 Powerstroke and the water in fuel light comes on. I drain the filter and drive about 10 miles and it happens again. Drain again and 5 miles later the engine dies. Had it towed to my dealer who found an exploded high pressure diesel injection pump. They talked to Ford and found out that they needed to install an all new fuel system from the injectors to the tank! The bill was 18,000 and no warrantee. Bad stuff gets right by the filters!!! I have two of those trucks and since the dealer used exactly the same parts as the broken ones, it can happen today again.
View 14 RepliesI have a 2006 f250 with 120k. I am having trouble getting the water in fuel light off. I drainned the water out and replaced both filters and the fuel water sensor. The check engine light is now on and the water in fuel light is as well. I'm stumped and can't figure out what to do next. Will the check engine light come on as well with the water in fuel light or is it two different problems?
View 2 Replies