Ford 7.3L Power Stroke (1999-2003) :: Hard Steering When Stopped While Stepping On The Brake
Sep 8, 2006
I posted last month that I have hard steering when stopped while stepping on the brake. Feels like there is no power steering boost at all. The dealer claimed it was a failure in the steering box due to a leaking seal. Replaced the box. Not fixed. Dealer now says it is normal; there is not enough pumping capacity or pressure at idle to operate both the brake booster and the power steering booster. Its true that when I ease off on the brake a little and let the truck roll even just a little bit, I get steering boost.
I need a handful of guys with trucks like mine (02, 250, PSD) to go check their trucks, and let me know if they behave the same way. Mine turns with steering boost as soon as I ease off the brake and let it roll a little, but at full stop is feels like no power steering; very hard to turn wheels, and pump makes a slight growl (more like a grinch) just as if it was at a full turn stop.
View 14 Replies
Advertisement
I have an 8 inch lift with 37x13.5 inch tires and dual front steering stabilizers. when I'm stopped I can barely turn the wheel. my buddy has a 6 inch lifted excursion with 35 inch tires in his is easy, one hand no problem. Would the difference in tire size really make that big of a difference or am I having a steering pump issue?
View 9 Replies
2001 F350 XL... Fitting on PS pump broke and I lost PS and PB with fluid everywhere. Replaced the hose with a new one from Autozone and I have no noticeable leaks.
I know I lost more than a quart but I could only add less than a quart (Mobil 1 Synthetic ATF). I'm also getting a whine from the steering wheel when I turn stop to stop. The power steering is back and there are no leaks (that I see) but the brake pedal is mushy. I've pumped and turned stop to stop for a while. Do I have to bleed the system like I'm doing a fluid flush? I hate to waste the synthetic fluid that I changed about two years ago.
View 7 Replies
Recently my power windows stopped working...sort of. Here's what I mean: If the drivers door is closed none of the windows will go down. However, if I open the drivers door halfway or all the way I can roll up/down all the windows. If the windows are down and the drivers door is closed I can, almost always, roll up the drivers window, however the other windows in the truck will usually not roll up. Open the door halfway and up they go.
A couple of other things I have noticed. When I press the down button for the drivers door window, with the door closed, I can hear the relay, under the dash, kick on and the window will move about a millimeter down then stop. Additionally, the courtesy light on the drivers door comes on while the door is closed. I haven't checked if the other courtesy lights come on at the same time.
Hopefully my explanation is understandable. I would love to solve this issue. Getting tired of opening the door to roll down the windows. Plus when there's a fly in the truck and I'm driving I can't get it out.
View 7 Replies
03 F250 7.3. I busted a brake line last week somehow, Got it replaced and fixed up, Bled that line and everything was somewhat good.
Now, when i hit the brakes hard, I have pressure. If I let off even a little, My pedal will start to sink till i apply more pressure. I am gonna fully bleed my brakes when I'm home to see if this could solve the problem.
View 7 Replies
I just had a remote start installed with a turbo timer that works off of the parking brake being engaged. No matter how hard I press it the light does not go on, however when the installer probed the sensor to ground it, it worked fine.What part this is that needs to be replaced. The stealership quoted me at 200 something for a whole parking brake assembly.
View 14 Replies
Iam looking at a 2000 7.3 Powerstroke that has some problems first it is hard to start cranks like it has a dead cyl. Second after starting it has no power not even enough to move. At first it would only run if held wide open but once it warmed up it would idle and rev and move but barely still had a miss. The weird thing is it did not smoke blue-black or white also no strong smell of diesel and no smell of oil at all. The truck has 230ish miles and there are no maintenance records.air filter was new.
View 7 Replies
I've got an E99 powerstroke. Recently it's been getting hard to steer, if not impossible. When I'm parked i can't turn the wheel and it gets better if i Rev the engine up, driving is usually ok and going around corners. It's just low speed, low rpm that it won't.
Also every once in a while when braking it feels like i lose all power brakes. The pedal goes to the floor and the brakes let go, then i can feel the pedal pump back up and i get a good feeling brake pedal again that actually stops well. All this happens within about a seconds time. But the steering is by far the worst.
I just did the power steering flush with atf and it didn't work. I'm thinking i need a new power steering pump, but want to ask here first to make sure. The truck has 290,000 on it, and it never has been replaced to my knowledge. I bought the truck with 147,000 however so it may have been done before that.
View 3 Replies
My 02 F350 7.3 new to me trucks ac stopped blowing cold. Not air gap issue (shims have been removed prior to my ownership-I pulled hub and checked), the charge is good (according to the shop I went to for evac and refill), and the compressor's cycling quickly. I'm no HVAC guy by any stretch. I have a cheapie gauge from days long ago that I connected to my low side port (which I know isn't definitive) and it reads from 25 to about 40/45 depending on the cycle.
Additional info that may not be anything:
1) Where the line goes from accumulator to evaporator the foam seal is slightly messed up and I feel ice cold air coming out of the housing.
2) The line is warm before the orifice and cold after it.
3) The lines going to the accumulator are both hot (after taking it to shop, before were lukewarm).
4) The condenser doesn't seem to have excessive plugging and I have rinsed it with garden hose sprayer with no difference.
5) The air from the vents blows good, just warm.
6) I've replaced the actuator for the blend door already.
View 14 Replies
The heater fan stopped blowing the other day. The fuses check out ok. What would be the most likely culprit after that? relay? Switch? Blower motor?
View 7 Replies
I drive a new to me 2005 F350, he has a 2001 F350. While we were talking he said he didn't think his pickup had the power it should have. He pulls a 5th wheel camper that weighs around 8000 pounds fully loaded. He said it takes a couple of miles to get to 55 mph, and it is hard to hold the speed. It doesn't have the power it did when he first got it last year. He was told that a diesel is slow getting started. He rode with me in mine, when I dropped it about half throttle to pass a slow car he said he could tell mine had way more power.
His check engine light is not on, it starts good both when hot and when cold. It runs smooth, no miss as far as I can tell listening to it. What are some common issues that could cause this? He did just change the oil and fuel filters, not sure about the air filter. He said the power loss came before he serviced the engine, and did not improve after the fuel filter change. Where to start? He was also told to check the filter inside of his fuel tank, so he is getting ready to drop his tank.
View 14 Replies
Cruise just stopped working. The fuses all check out ok. What would be the next simplest thing that I could check before turning the problem over to a mechanic?
View 14 Replies
Well a few days ago I pulled up to a gas station on my way to work for some coffee and since I leave for work before 6:30 AM my headlights were on. Well only the running lights were working. Well I shrug it off and later that night I come to the realization that both headlights weren't working. I tried the high beams and they do work. I also pulled both bulbs and both the filaments on each bulb seemed to be intact. What could cause this? I checked fuses 9 and 11 under the hood and they were both fine. I'm kinda at a loss right now.
View 9 Replies
While stopped, engine running, in D, the engine cut off just like I turned the key off. I sat there for about thirty minutes and on the 7th or 8th try, the engine finally started. I drove it back to camp and thinking it might be the CPS, I swapped it out. Unfortunately it must be something else because I can't get it started anymore.
ICP and IPR are fairly new, but I unplugged the ICP and tried to start it anyway. It didn't choke out (like it was a fuel issue) but I checked the fuel bowl anyway and the pressure builds fine. I got it restarted once, so it can't be a fuse but I checked them all anyway.
Oil pressure builds to 780+ when cranking. Batteries still have plenty of cranking juice and without my AE, I'm frustrated beyond belief.
View 14 Replies
My e99 f250 has been getting harder and harder to start over the last year.
I think one of my batteries is dying or dead but it still cranks fast while it does.
For instance when I tried starting today it seemed to crank just like normal but their was some relay clicking inside the cab that was abnormal.
My understanding is aside from cranking no power is required to start the motor? what if the dead battery is taking some cranking amps from the good battery preventing the computer from getting juice?
would the truck throw a code if it was a glow plug?
View 9 Replies
So I have a 2000 F-250 7.3 and my over drive won't work. I also had hard shifting from 3rd to 4th and 3 gear wouldn't try to shift until about 2500 RPMs which is high. I replaced solenoid pack and no change. I have rebuilt the tranny and found that OD snap ring had came off I put upgraded spiral ring on. When I went on a test drive I found out nothing had changed except shifted smoother. So I changed valve and accumulated body still no change. Truck is throwing 4 codes:
P0733 Gear 3 incorrect ratio
P0750 Shift Soleniod a fault
P0783 3-4 shift error
P0541 intake air heater a circuit low
Could it be PCM??
View 14 Replies
I have run into a problem. My early '99 7.3 PSD decided to throw a very hard shift at me the other day, lit up the SES light and I had to limp it home going 5mph.
I looked on here and found most problems that caused power loss/engine die and replaced the ICP, IPR, EBP and tube, and the CPS. I also did an oil change after all of that to make sure everything was clean when I went to start it up.
BUT, when I tried starting it, nothing happened. It cranks, but does not start. What is the problem? I watched hours of videos and read hundreds of pages of instructions on how to replace everything, and now the truck won't start.
View 10 Replies
I noticed my '99 started getting difficult to get in gear & shift, within a coupe of days the peddle was barely off the floor before it would engage. A day later it started 'creeping' if started while in gear. Replaced the master/slave cylinders with no change.
Is a clutch replacement the next step? Just thought I would ask before throwing money at it, since the only other times I've had clutch issues there was slipping or it just plain exploded.
View 14 Replies
My 2000 F250 4 x 4 just started being almost impossible to steer to right when stopped. To the left it is ok. I was on a trip and when I got where I was going noticed the steering very hard. I checked the fluid level and it was almost empty. I filled the reservoir and let it sit 4 days. I am back on the road now and it is still doing it. Stopped to left is easy to right almost impossible.
My brakes are good. I noticed a couple times when I had to slam on the brakes on the tirp the rear tires chirped. I don't tow anything with it, just a family vehicle with 408000 miles. The power steering pump was replaced a few years ago. Pump, gearbox, etc? I need to get this fixed as I have another trip coming up in a few days.
View 2 Replies
so all of a sudden I put my blinker on and it was flashing fast. My first response was to check if a bulb is out, not the case. Five minutes down the road my brake lights stopped working and the 3rd brake light stays on.. when I put a blinker on the rear lights and 3rd brake light and the lisence plate plate lights all flash at once.
View 3 Replies
My 7.3 power steering is acting up. Feels like I am up against a rock. At slow speeds like parking lot maneuvering I struggle to turn wheel. Then all of a sudden I'll get power steering back and wheel will rapidly turn. Freaky.
Brake pressure is fine. They shutter pretty bad even with the new rotors I just put on but they have good pressure. But the steering is intermittent or no power steer.
I saw online to run engine at 2000 rpm and try steering but no change. Still no power steer. There is fluid in reservoir. There is fluid seeping up steering column from steering box. No clue if this is related or unrelated.
How to troubleshoot further. I hate throwing parts at problems before truly diagnosing. Also have pretty aggressive lurching during turns in four wheel drive. It's present on dirt road but worse on pavement. Don't know if this is related or not.
View 3 Replies
