Ford 7.3L Power Stroke (1999-2003) :: F550 Backfire And Shot Flames Out Of Exhaust
Nov 14, 2007
I was driving my bosses f550 with a 7.3, and while towing a loaded 40' flatbed of hay, it started bloing white smoke and lost all power and had almost no pedal feel. It wouldnt even go past 2500 RPM. Then, all of a sudden, it started billowing black, and BOOM backfired and shot flames out the exhaust. Then, I pulled over at a parts store and replaced the fuel filter, which worked for a while, but then it started blowing white smoke again. Once I limped it home and unhooked it, I took it out and let her rev a bit and it seemed to stop blowing smoke, but it still has less than the normal power it used to have. It has 226000 miles and is completely stock.
View 8 Replies
Advertisement
Having trouble with motor, driving home one day heard a noise under the hood. Then a lot of grey smoke started coming out of exhaust. Got the truck hauled home notice fuel was coming out at the number 7 cylinder at exhaust port. Thought it might be the injector just put rebuilt ones in, thought I might have received a bad one. I switch the number 7 injector with the number 3 injector. Did not make a difference still have fuel leaking out of exhaust manifold at the number 7 cylinder and a lot of grey smoke coming out of exhaust. Not sure where to start looking next? Could it be the injector cup is the problem?
View 14 Replies
Ok, I have a early 99 F550 that had a tired engine when I bought it about four years ago, but I kept using it just dealt with the low power and blow by. But last winter I decided the truck deserved a complete overhaul. New cab, new transmission, overhaul the engine, and everything else that goes with. I tore the engine down to find out it was already a ford reman. Had the heads completely gone through, new pistons, new exhaust manifolds, new turbo, brand new injectors, new 4inch exhaust, new valve cover gaskets uvch harnesses and repair ends for harness side, and a new IDM.
Now with everything back together, the truck starts an idles fine but has absolutely no power driving it takes like a half a mile to get to 45mph. No check engine lights no smoke. I took it to ford they said only stored codes were for ebpv which I deleted out of turbo housing they recommended changing injectors. So i did no difference. They also said my hpop was about 1600 at idle. And said that's enough pressure. I did resistance readings on all wires between idm an valve covers.
View 14 Replies
I have 01 F550 6spd 4x4. sounds rhythmic, smooth at idle but just over 1200 is a pattern surge but doesn't sound like one cylinder, cel is off, ICP and pigtail changed as it was leaking , no change. From what I've read duty on ICP and IPR should be about same % I've included the codes I've gotten, I have the epc disconnected right now as I thought it was a wastegate issue, checking the ICP plug next,anything I've missed? It had a cyl 8 contribution at idle which I hear is common? Will changing CPS work with that one? Think it's a grey one. There's no water in bowl I replaced filter, since replaced ICP, pigtail, and bleeding fuel bowl and new filter the codes are gone but still misses, will be checking uvch, injector buzz test showed no faults. Old diesel guy said to flood with Stanadyne fuel treat?
View 9 Replies
The last couple of days with the temps in the 50's, my 2000 F550 with a 7.3, will start normally and idle fine. When I try to drive it, I get less than a quarter mile and it just looses power and will die.
If I flutter the pedal, sometimes it will keep running, very poorly. And when it does this, it is putting out blue smoke. After it does this, it will run fine. Just like nothing is wrong.
What do I look for, or is this normal. I have had the truck since last October and this is the first time it has acted like this.
View 12 Replies
I just did an engine swap and have an odd noise that I was curious on where to start. It sounds like a buzz test on an injector at 2,250 rpm and gets louder as rpms increase but starts out very faint and get louder. Makes noise converter unlocked and locked in gear under load and free rev no load.
-2002 F550
-Fuel pressure is 60+ psi all the time
-Regulated return fuel system
-New injectors all AD
-Stock tune
-38R turbo
-New flexplate
-injector hold down tight
-new degas res
-new water pump.....
View 2 Replies
I seem to not be catching a whole lot of luck lately. The rear end on my F550 has a bunch of play. Going reverse to drive it clunks pretty bad but no ujoints are bad. I can rotate the yoke by hand and hear clunking so i am guessing the ring and pinion are bad, at 100,000 miles. Seems like the rear ends should be more stout than that, certainly look it.
Where to find a source for reman third members since this one had a drop out? Most axle places won't touch it
View 7 Replies
I just replaced all 8 injectors in my 01 F550 with remans from FFD. I have noticed a constant knock at idle but truck runs great. Blowby has no pressure behind it, truck does not smoke. Does this sound like a problem unrelated to an injector?
It did not make this noise before replacing the injectors
[URL] .....
View 12 Replies
Just joined today, I have a 2003 550 7.3. New HPOP, 3 new injectors, new seals on others, new fuel pressure regulator, new fuel pump, sending unit mod to eliminate filters. 733 HPOP pressure, 65 fuel pressure at idle. Truck runs out of fuel pressure after its warmed up and driven about 20 miles. Haven't checked voltage at pump while driving. I had taken it to a seasoned tech of 20 years and he had replaced HPOP and 2 injectors and it does start better but problem is still there.
View 14 Replies
I have now replaced hpop, injectors, cups, gpr, batteries, uvch on both sides, icp and ipr on my 2002 F550 and it still has a long crank to start.
It has been driven about 1,000 miles since then and no change. I have no codes except buzz test produced a high to low 1272 1274 1276 1278 one time. Cannot get that to happen again.
It is taking 4 seconds of cranking to start consistently hot or cold. It always starts but cranks for what seems like too long compared to my other 7.3s. I have included a screenshot of the data and am curious on what everyone's thoughts are as I am out of things to look at!
View 14 Replies
Ok I'm working on a 2000 7.3 on a F550 truck was running but had no power so we changed out all the injectors and glow plugs and rebuilt the turbo now there is no start it turns over and were getting black smoke from the tail pipe. What is going on with it?
View 2 Replies
I just installed a new MBRP 5'' exhaust system in my 7.3. I have only put a few miles on the truck since it was installed and I now have a black thick oily residue in the tailpipe. The exhaust system had some sort of oil in it when it was shipped. I remember getting it on my hands when installing it. I think the oil in my tailpipe is just the oil burning out of the exhaust system which mixes with soot that turns it black. When I installed the new up-pipe, the exhaust side of the turbo was dry. Like I said, I haven't ran the truck many miles with the new system yet. A few friends of mine have looked at the exhaust and they think I have a bad turbo seal. I didn't have any oil in the exhaust with the old system. It was sry. My truck has 135,000 miles on the original turbo. I hope my turbo seals aren't bad.
View 7 Replies
Recently I came across a guy parting out his F-250 with a 7.3 powerstroke. Said it had a blown engine, and didn't know what was wrong, but oil was coming out of the exhaust.
My question here is why that's happening. I don't have any experience with the powerstrokes, so I'd like to know what the culprit is before I even consider buying it.
View 8 Replies
I own a e1999 Ford F350 7.3 4x4 with a Garrett GTP38R turbo. I have been having issues with very little power and pulled an CEL of P0221. I know it's for the APS and have been trying to trouble shoot it as a new APS has not fixed the problem. However, while working on that I just noticed an oil leak appear. I tracked it down and can visibly see it leaking out the top of the passenger side exhaust manifold in two places. It is seeping out the top. Is oil supposed to even be running through here like that?
I recently replaced my up pipes with the newer style bellowed ones. While I had the turbo off I replaced all the o-rings top and bottom and did the EBPV delete on the pedestal. I have been having very little power and cannot the truck over 5-10 MPH and stays at low RPM's so I originally thought it was the leaky up pipes. Those were fixed along with fuel pressure checks which came back good. I then pulled the P0221 code finally. While I had the turbo off I inspected it and it did spin freely and had no side to side play in it.
What was unusual to me was there was a small pooling of oil in the turbo when I took it off. I know the CCV goes through here so some oil is normal. Also, when I was diagnosing the up pipe leak I could see a small amount of oil spraying out the blown donut gasket along with the exhaust gases. I don't think that is normal.
Is there an internal seal in the turbo that can go bad causing oil to spill into my exhaust and possibly leak at the exhaust manifold? Or do I have an internal oil leak from somewhere else?
View 14 Replies
New up pipe and manifold gasket time!
Massive exhaust leak.. Likely the reason for my 5psi boost.
Wish I had the funds for headers but on the up side, no broken bolts!
View 14 Replies
I went to change the small filter that is mounted just behind the radiator and is inline with the 5r100 . with a socket on the bottom all i was able to do was flex the brackets going to the 3 mounting bolts as this thing is on there real good. Looking for examples on unthreading the bottom cup to access filter?
View 6 Replies
I have a 2001 F450 7.3 chassis cab with just over 100k. I have a new problem... So far on two different occasions the service engine came on followed by a loss of power under a load and white smoke from the exhaust. Took it to the shop the first time, they determined it to be a dirty air filter, which seemed odd since it just happened all of a sudden. They changed air & fuel filter, problem gone- for two weeks..
View 8 Replies
I'm having an issue with massive oil consumption and no oil leaks on the ground! No clue where the oils going but I burned more than 2 gallons today in a few hours of driving exhaust smells awful but the truck is running fine.
View 14 Replies
I've been mulling over the idea of doing a muffler job on my 2002 f350 7.3 cc short bed. I do tow on and off for work and dual material for work. I am thinking of upgrading the exhaust because I noticed a couple small leaks in the muffler and I'd like to lower the egt's for the truck so it breath a bit smoother. I'm not a fan of the really high pitched sounds I've heard on some I want it deep and heavy sounding. The turbo is fine for now but eventually I'll need to know what to upgrade to once it starts to wear out. I don't plan on doing dumb chips or tunes because it's not a toy truck but a work and daily driver.
View 10 Replies
Just bought a 03, the seller showed me a exhaust leak. I found a bolt broken off, flush with the head. Looked at the passenger side when I got home, that side leaks too, and found one broken off bolt there too. Question, are these easy to do? As in, I have extracted broken bolts before, but they where on my V10 and I could just weld nuts to them and they came right out.
View 14 Replies
As it says, I have a tick. It's not apparent at idle and increases with engine speed.
Just spent $570 having bellowed up-pipes installed and while a little quieter, the tick is still there. What else tends to go out on these things? Manifold(s) cracked, manifold gasket(s)? It's seen high EGT's quite a bit but not for longer than 20-25 seconds.
View 8 Replies
