Ford 7.3L Power Stroke (1999-2003) :: Electrical - Tail Light Bulb Out No Rapid Blinker
Feb 1, 2016
Passenger tail light bulb went out who knows when, but was alerted about it today. Every other time this has happened, in multiple vehicles, the turn signal blinks rapidly to let you know the bulb is out. Mine blinked normally.
In the past year I've had to change my multi function switch and more recently the flasher relay for the blinkers. Just a standard relay from the parts store, not the heavy duty one or anything. It did say it was LED compatible, so I wonder if that is why it didn't pick it up? Why I didn't get the rapid blinking?
View 2 Replies
Advertisement
I have a 2001 F250 Crew Cab with Powerstroke. The dash lights are starting to go out one at a time. How do I get to and replace the bulbs?
View 14 Replies
So again the a/c in old green gave out. it has been an ongoing battle over the past few years, but this time I took it to a good friend who has all the right tools as our level of frustration dealing with it has peaked.
We removed everything, and got it all "new" from oh-rye-lees. a new compressor was installed a few weeks back and it worked fine, but cycled very strangely. it would rapidly kick in and out, then just stay engaged. found out the condenser was plugged up and thought maybe that was causing it.
At any rate, it now has a new compressor, condenser, evaporator, drier, orifice tube, and low pressure switch. all the lines were flushed and checked.
it was vacuumed and checked, then charged with freon. The compressor is doing the exact same thing! it is cycling very strange. sometimes rapidly at higher rpm, and sometimes it works just fine. the a/c is working, but it is freezing up the drier, evaporator, and line all the way back to the compressor. vent temps are about 30.
The WOT relay and high pressure switch was replaced, and it did not make a difference. we are at a total loss.
We were told by another person that the clutch on the new compressor was too small and that was causing the issue. It measure 4.8" and we were told is is supposed to be 5.3". is there any truth to that? we just do not know what is causing this, but want to get it right as surely something will break if it stays this way.
View 6 Replies
When starting, rapid clicking like failing batteries. Had dealer install new Motorcraft batteries, and it's still happening. Clicks when i turn the key and then labors while turning over for 20 seconds. Sometimes it takes 2 or three times before it starts. I put in a rebuilt alternater 5 years ago. It seems like a fuel problem, but I'm guessing.
View 2 Replies
so all of a sudden I put my blinker on and it was flashing fast. My first response was to check if a bulb is out, not the case. Five minutes down the road my brake lights stopped working and the 3rd brake light stays on.. when I put a blinker on the rear lights and 3rd brake light and the lisence plate plate lights all flash at once.
View 3 Replies
I would I have a 01 7.3 e350 with 111k miles. I drove the van a couple of days ago.it sat for 2 days and now it wont go past 30mph.the van shakes crazy and went when i hit the petal no power with smoke coming out the tail pipe sometimes. When I shut the van off and restart it to drive it,it sounds better. I changed the fuel filter with motorcraft and changed the oil. Here is the kicker. It ran good after I changed the fuel filter the whole day and now its 4th of july and I went to get some drinks and it happened again.
View 11 Replies
I have a 2003 2wd F250 with the 7.3l. I replaced the stock tail gate with an aftermarket 5th wheel tailgate. Seems to work good but a couple of times the bottom of the tail gate where the hinge connects pops out when on dirt roads. I know it is probably from the shaking and rattling that the road causes but any way to prevent that from happening? I know most will say stay off the dirt roads but until they pave the road to the dunes camping spot I'm stuck with going down it.
View 3 Replies
I just came back from a 200 mile trip and parked my truck. Next day, got in the truck and turned the key.... it turned over and white smoke coming out the tail pipe. After doing some research(you tube),I ruled out cps sensor because it was showing low rpms on tach. Replaced glow plug relay and still have same issue.. what else to look at that I can do without getting it towed. Hunting season coming soon and I need the beast.
View 14 Replies
I am on my third EGT gauge. My mechanic installed it as per "auto meter" specifications. He told me, the only reason he could find that the gauges have been failing is low voltage output. I have an onboard compressor for my airbag suspension and every time I start my vehicle it runs to fill up the air system. The voltage drops to 11.1V. It comes up once all is running and the compressor quits. is there any such thing as surge/brownout protection for these systems?
View 1 Replies
I recently installed a Banks Ram Air Intake on my stock 1999.5 powerstroke and wow did it ever wake up the turbo. A few weeks later i installed a Flo-Pro 5" stainless exhaust from turbo back with no muffler. The truck is running better than it has in years and with 272000 miles, I am pleased with the results. HOWEVER, I have since noticed a little black sticky soot coming out of the tail pipe, a bit of vapor (no oil spitting) from the oil filler tube with the lid off, and now my dip stick tube where it enters the oil pan is leaking. What is going on , or am I now chasing and fixing week points on this truck?
View 6 Replies
Ok I'm working on a 2000 7.3 on a F550 truck was running but had no power so we changed out all the injectors and glow plugs and rebuilt the turbo now there is no start it turns over and were getting black smoke from the tail pipe. What is going on with it?
View 2 Replies
My Volt gauge on the dash has started reading around 10V with the key on waiting on the GP's. Batteries read +/- 12.6V with a DVM in a static state, no key.
But, quickly as best as I could see the reading on the DS battery drop to around 10V with the key on, GP's cycling. Cranking drops down around 8Vish.
After starting the reading on the DS battery is back up to 10V. This lasts anywhere from 30 seconds to a few min. Then it jumps up to the expected 14.6V reading.
I cleaned up the battery terminals and clamps while doing my turbo,and all the connections are tight.
View 14 Replies
I have a 2002 F-250 with a 7.3.
I have been having a no crank, no start issue off and on for a while. batteries are new, cables are new, connections are clean, and starter has been rebuilt and checked. I bought a "starter relay" which i thought was the top solenoid in this picture. I also replaced the lower solenoid in the picture. The bottom solenoid was replaced with what im sure is the correct replacement. The upper I think is wrong. It started but then shut down and will not restart. The upper solenoid also was very hot after it shut down.
Long story short what is the upper solenoid for? Im assuming its not the starter solenoid. If so where is the Starter solenoid on a 2002 7.3?
View 14 Replies
New ghost in the machine.
Pulled out of the driveway two days ago to go trailer a wrecked car home. Got about half a mile up the road, and my electrical system started flickering. Engine died, dash went nuts, everything is clicking on and off real fast. This went on for a minute or two, then stopped. After a little internal debate, I decided to continue on.
Ran fine for another mile or so. Hitched up the trailer and checked the lights, everything A-OK. Started rolling down the lane and the truck went dark. Engine shut down, no sign of electrical power anywhere. It was as if my batteries had been suddenly abducted by aliens. Truck stayed dark for about 5 - 10 seconds, then like a switch was thrown all the electric came back on. Dropped the trailer and drove back to the house without incident. Not towing a car like this.
Checked the battery connections. Looked really good and tight. Pulled and cleaned them anyways.
Pulled the fuse box out from under the dash and looked for water damage. Absolutely no sign of moisture or corrosion anywhere on the box or anything else under the dash.
Started the truck and turned every electrical item I could think of on. Truck sat and idled for 15 minutes without a hiccup. Voltage at the batteries was normal. I wiggled wires everywhere with no effect.
Decided to quit for the night. Got into the truck to move it to it's parking spot and POOF, all went dark again. Engine died, heater blower, radio, headlights, interior lights, all dark. About 5 seconds later, everything came back online.
No CEL. No other symptoms. She was either running perfectly or had no juice at all.
I drove it last night to the mechanic I use. 7 miles, bumps, potholes, stop and go traffic, no issues.
Just spoke with the mechanic. They can't reproduce the problem. I told him I can't reproduce it on demand either. I asked that they put it up on the rack and check all the ground points.
View 14 Replies
I just replaced my Wiper motor last week and noticed something strange. For the last year or so when I turn on the key to start the truck, once in a while my radio, gauges, and other electricals such as windows wouldn't work for a bit, anywhere from a couple seconds to maybe as much as a couple minutes. Since my wiper motor was on the fritz, I pulled the fuse and the radio,gauges,ect. wouldn't work until the WTS light went out, then everything worked just fine, even after I started the truck and the glow plugs come back on.Since I replaced the motor everything works as soon as i turn the key. Coincidence? Or could one of the internal relays on the motor being stuck cause that?
View 5 Replies
My left side rear blinker/ brake light is not working. The running/taillight side/filment of the bulb works, but the brake/blinker side/filament does nothing ! Just bought the truck used and it's my only issue, waiting on a owners manual, but I think each bulb is fused separate, and since half the bulb works, can I rule out the fuse and start chasing wires ??
View 5 Replies
I am currently converting a 1999 E350 7.3 diesel bus into a camper to live in. The bus has already had a lot of weird custom work. Done by someone else and a lot of the interior torn out and extra insulation put in. There is an exposed electrical panel behind the drivers seat. It was a cheap buy, previously fleet maintained with only 120k.
I was hooking up a battery for accessories to a terminal labeled "Battery" that does run indeed directly to the + terminal of the battery in the engine compartment.
Unfortunately I mistakenly connected the accessory battery to a terminal labeled "ignition" that runs to behind the dash. When I tried starting the vehicle off the auxiliary battery for a test everything went out for 2 seconds, I heard a click from the engine compartment, and everything than came back on. This is when I realized my mistake.
It used to be the speedo only didn't work (which I assumed was the step motor), now after this mistake all the gauges, the odometer and the buzzers don't work. Lights like the battery and airbag warning indicator still function.
Checked fuse 2 (15 amp) for the instrument cluster and it is intact. Actually checked every fuse in the vehicle in both fuse panels and all are intact. The radio works though and the vehicle is not equipped with power windows.
Going to go get a radio removal tool to take apart the dash and get back there. What this could be? Did I fry a relay? Did I fry the cluster circuit board.
View 6 Replies
I have a 2000 7.3 f450 having some electrical issues. When you turn the key on sometimes the dash will start ticking and left side light flashing...engine will turn over but it won't start. The ticking is coming from under the hood relay 32 (you can hear and feel it clicking). Book says its injector driver module power relay. A lot of the times it will start fine other times it will be running and just die (prob because of this issue) happened once when I was driving.
What to check here already replaced the relay still have the problem.
View 6 Replies
Passengers side tail light doesn't react when braking, using hazards or blinker, what do I replace? The bulb is lit, but doesn't blink or brighten when the brakes are applied. As of right now I'm replacing the bulb socket seeing as when I replaced the bulb the contacts were covered in a brown crust, is there something else I should be looking at?
View 3 Replies
Lately my right fog light bulb is burning out, and I notice water on bulb and lens fogged. Dealer is telling me they have to take picture, send to ford for approval to replace under warranty. Really?
View 3 Replies
Lexus IS: How to Replace Your Tail Light Assembly
Step by step instructions for do-it-yourself repairs
Browse all: Lexus IS Lighting Guides
View 7 Replies
