Ford 7.3L Power Stroke (1999-2003) :: Buzzing Noise From Fuse Box Area
Feb 12, 2015
My friend and I were working on my truck and he was testing my AIH relay, as he was testing it the fuel pump was clicking on and off a few times over about 10 minutes. He explained that the current must be back feeding through the system and activating the pump. After testing the relay he determined that it non-functional / broken.
When we went to start it there was a strange buzzing from the fuse box area. After testing all of the fuses and then his code scanner not being able to connect to the truck we can only figure that the PCM is done.
The truck will turn over but not start. Any time the key is in the run position the buzzing noise is there unless you pull the PCM relay or the IDM relay. He says (I know very little about this stuff) that the IDM relay is trying to close but because the PCM is fried the IDM is not getting the signal to do so....?
So what now? Do I need a new PCM? He said something about it need to be reflashed to match the old one, is that right? Are all PCMs equal? What else should I know?
View 14 Replies
Advertisement
I went on deployment and handed the wife to crank the truck up she did but didn't drive it so batteries didn't charge back up. I got them charged up and the truck cranked right up. I was plugging it in at night and it would start just fine the next morning. Then a week later batteries kept dying in a few hours during the day. Had to jump it again. then even when plugged in trying to crank it there was a buzzing noise and it would crank but not start. I bought new batteries and it cranked right up and drove fine until I shut it off and same problem and batteries were low again and it will crank but wont turn over. I am thinking maybe alternator.
View 3 Replies
2001 F-350, 7.3L,
Has done this off & on for a few years and am tired of it! Noise is kind of a buzzing that seems to come from the flasher/turn signal relay. It stops buzzing when you turn on a turn signal, activate the flashers, or lift up on the shifter arm(?). Had to drive home yesterday with the flashers on! So I see from researching that it may actually be the multi-funtion switch on the steering column. So I removed that, cleaned up all the contacts, and put it back on and the buzzing did not go away.
View 14 Replies
I was to leave tomorrow for a trip with three horses. Last night when I parked my truck the dome light went on and off and there was a noise (like a relay opening and closing?) coming from the area. (I have been having issues with the turn signal getting "tired". At times they would only come on solid then other times try would quit after sitting at a long light.)
Checked my manual for fuses to this issue and I removed the fuse in the spot indicated for the "dome and courtesy lights", number 14. Actually I had removed spot number 15 (5amp). This ended the noise. Drove the truck after and all seemed in order, cruise control, turn signals, interior lights! This was the incorrect fuse according to the book! This event occurred with the ignition in the OFF position. Not wanting to start my trip before I get this in order.
View 4 Replies
Thats the sound coming from I think the front left area and the rate is proportional to speed. It only occurs at slow speed from about 5 to 15 mph and it seems to only occur for about 30% of each rotation. I plan to jack it up and check tire wobble or if the sound occurs during free spin. Any other things to check?
View 11 Replies
I've recently picked up a new noise. At idle the engine buzzes. It sounds like the vacuum pump running but coming from the engine (the vacuum pump is not running while this noise is happening). This noise could also be happening while I'm driving too but the RPMs bring up the engine noise so I can't tell. Nothing looks out of the ordinary and I haven't done anything different that would give me any direction (no off-roading). It was just there one day.
The truck doesn't seem to be running any differently (right now), just the buzzing. I just want to catch it if it's going to become something serious. An ounce of prevention is worth a pound of cure (not to mention the towing bill!).
View 14 Replies
I have a 2007 3.3 litre Sonata and just recently heard a buzzing sound coming from what I think is the fuse box area. When in park and neutral (buzz) .... drive and reverse - no buzz.
View 4 Replies
I just finished a cab swap and I'm having a little trouble. Here's a link to what I've done : [URL] ....
KOEO the WTS light, battery light, SES light all stay on and no power to fuel pump. No communication with PCM (using AE). All fuses are good, but no power to PCM fuse (#22). When I apply 12v to #22, the truck will start and idle - but poorly because I still don't think fuel pump comes on. The idiot lights all stay the same.
I did get to pull codes while it was running and got stuff like IAT circuit high (its not plugged in), fuel pump relay short to batttery, and a few other short to battery things (park assist stuff IIRC). I thought that might have something to do with the redneck idea to boost the fuse with an external power source?
Just thinking while typing, I don't have 3rd brake light hooked up yet (just thought of that, I'll hook it up first) and bed/bumper are not installed, so no tail lights or park assist stuff is hooked up. I'm also not using overhead computer, so it's not plugged in.
My next step is to go back through all of the connectors and make sure something isn't 1/2 way plugged in or possibly plugged into the wrong place(s).
Looking thru the wiring diagrams is not a strong subject for me, but I was trying to figure out how power gets to the fuse and how PCM relay works (does it complete circuit to ground to energize the coil?).
View 14 Replies
I have a 2003 F250 and dont have power at fuel pump, or fuse #30. I put power directly to fuel pump and it worked and truck fired right up.
View 13 Replies
I have a 2001 F-450 SD with 7.3. What the problems would for the blowing of fuse #3. The DLC fuse. I mean I know it goes to the cigarette lighter as well. but when not in use it still blows.
View 1 Replies
OK I'm putting a plow on my truck. I am wondering if it's possible to add more circuits to the fuse box in some of those unused slots?
View 6 Replies
I have had a 2000 f250 crew cab for little over a year now. Two previous times, after heavy rains, the cabin light would blink on and i would get a buzzing sound under the dash. I would solve the annoying buzzing sound by opening and closing the door. After a few times, it would work, but my clock and radio could go on without the key in the on position. The next time i used it, no problems... so i put that worry in the back of my mind.
This morning it rained really heavy, sideways type of rain. I opened the door and noticed a small puddle on the vinyl floors right where my left foot goes. OH,oh i thought, but the truck turned over and ran like normal. I picked up a heavy load of hickory in the bed and hopped back in and noticed my speedometer jumping from 0- 30 when I was going about 35. The OD light was blinking, but the transmission shifted normally. I got up to about 1700 rpm and the speedo was barely jumping at 53-55. I make another stop to unload the wood and go back home and i get an intermittent buzzing sound on the way home and no speedo. OD light would start blinking before i hit 2nd gear. I also noticed the odometer not working (speedo related, right?)
I got home and took the fuse relay cover off and found that if I would remove the #1 relay "plug" (black square box 5 prongs) that dreaded buzzing sound would go away, checked it out , plugged it back in, buzzing back on. The clock light still stays on and radio will turn on without the key. I think that water obviously leaked in over something electrical and i have been searching this and other forms for a couple of hours. I am within a couple of weeks of saving up enough to buy the gauges, exhaust and possible DP Tuner and now this happens?
View 14 Replies
I had a problem with this issue a few months ago, was 45 minutes away from home, blew the fuse to the starter. Switched another one in, blew it too. Had it towed to a shop, they did some diagnostics, felt like it was a short in the starter, replaced it and all has been well (as far as that particular issue) until this morning. Got in it, turned the key it cranked for less than a second and stopped. I pull the fuse, sure enough, blown. Swap it with another, it blows.
I know I have a bare wire in the column, the OD light wire is chaffed, I fixed it before but it must be worn again because I can get it to light up depending on positioning of the shifter lever and as I recall, every time the fuse blows the steering wheel is cranked to the left.
View 14 Replies
After disassembling what felt like the whole front end of the truck, I finally gain access to the danged thing. Mine has been acting up intermittently for about year and half I guess. When flipping to switch to signal turning, it started making a buzzing sound. At first it was doing it most of the time. Then it cleared up and started working right for several months, then act up, the act right. Well, now it makes the buzzing noise more often than not so i decided to address it. I went to Oreilly, they didn't have one, but told me the part number.
I went across the street to Autozone, that had one on the shelf that was same part number as Oreilly. I put it in and when flipping the switch, the relay does it tick tock sounds like its working, except for there is no indication on the dash cluster that its working, nor are the actual lights working. I swap back to original and buzzing, put in new one and tick tock but no lights. Whats the deal? Is this one of those things that you have to go back to Ford? Or maybe i got a bum relay from parts house and should exchange for another to see if it works?
View 6 Replies
So I have a 1999.5 F350 diesel and the fuse panel under the steering wheel is acting up. I was driving my truck home the other night and I lost power and my truck shut off. I have had a problem in the past with the #30- 30 amp fuse ( controls the PCM and glow plugs from my understanding) that is under the steering wheel, I replaced the fuse and everything started working normally again. Until the other night when my truck shut off, so I replaced the fuse the truck drove again for 20 feet died again, I was able to hold the #30 fuse and allow my truck to start up again but would eventually killed the PCM and shut off again and would not start up due to what I believe the fuse location shorting it out and killing the power to the PCM preventing me from starting it up again.
I had my truck towed home and charged the battery and it started up fine the next morning. If I push on the #30 fuse my truck the shorts out and kills the power, I do not know if this is normal? The fuse is sitting loose in the fuse holder is there anyway making it fit tighter to prevent it from being so loose? I have read every other post online about the problems and tried everything they have recommended but still can not figure out what was wrong with my truck. I disconnected the fuel filter heater, and also the wastegate solenoid to see if that would prevent the truck from shorting out if I pushed the fuse it did not work.
What the problem could be causing the #30 - 30 amp fuse to be shorting out preventing everything from working? Or how to test the fuse panel and all the relays?
View 5 Replies
Been a while... Problem today while towing... I was in some hilly areas but nothing too .. I was pulling an unloaded trailer and experienced a significant loss of power and overheating. Engine started getting hot (almost to red) and then the transmission came up in temp. Made it to a rest area and all cooled down within 2 to 5 mins... but the strange thing about the power uphill is that it is happening at slow speeds as well... boost seems normal. Recently did the injector cups, so the thermostat is new (motorcraft), coolant is new, and put new o-rings on injectors.
View 14 Replies
So the other day my 20amp maxi fuse for my fuel pump decided to blow, put a new one in & everything has been going good since. Is it just a fluke or is this an indication my pump is going out? I inspected wires off the pump & connections for corrosion & that's good, fuel filter is also new about 2 months ago & I always run #1 diesel with a little additive in the winter.
View 1 Replies
i have a 99 f350 psd, my problem is i don't have normal; FONT-SIZE: 100%; COLOR: dark green; FONT-FAMILY: inherit">parking</NOBR> and instrument lights, it blows fuse number 8 as soon as i turn the switch on. i checked all the wiring on my tail lights and the trailer hookups. i even disconnected the wiring harness going my tail lights and trailer hookups and it still blows the switch. #8 fuse is trailer tow electronic brake, illumination, park lamps, trailer tow park lamp relay coil. it also blows #4 fuse which is trailer tow backup lamps, trailer tow park lamps.
View 14 Replies
So my understanding is that if your turbo is leaking oil, you either need to rebuild it or get a new turbo cause the one you have is shot.
I have some oil leaking, but it's not a ton. One one of my buddies was telling me that it's possible that the amount that is leaking is normal due to the PCV (Pressure Control Valve) system, or something like that. Here are a few shots of the turbo, as well as the boots that are leading up to the turbo.
View 9 Replies
I've been having an electrical issue for the past few months that I've decided to address now that the weather is getting a little warmer.
What happened is the left turn signal was blinking fast, so I assumed bad bulb, and later that day it stopped blinking fast and now I press the lever down to indicate a left turn and there is a quite loud buzzing sound. Sounds like it's coming from where the relays are, but I've replaced them and the bulbs and still nothing has changed.
I've also replaced the multifunction switch to see if that was an issue, but a new one did the same thing so I returned it.
Running lights work all around, but now there are no left blinkers, and also my left brake light doesn't come on. Pulling a trailer I have the same problem, I had the plug tested and only 3 of the pins have anything to them.
I know nothing about auto electrical systems.
View 12 Replies
I've got a 2011 F-350, when i'm on the driving over 60 mph i hear this humming or buzzing noise coming from around the dash. It kind of comes and goes depending on the wind direction or if I'm passing a semi. Thinking it may be coming from around the windshield seal.
View 4 Replies
