Ford 7.3L Power Stroke (1999-2003) :: ABS Light On Dash Stays Lit
Jun 3, 2017
Ok so i have an 02 F350 7.3 with 89k on it ... Ive had the truck about 2 years now and ever since i bought it the ABS light has been on. So finally i got to scanning it and codes popped up for the front speed sensors and the rear speed sensor. So i went ahead and just put all new MOOG hub assemblies in the truck which come with the speed sensor already in the them and i also replaced the rear speed sensor, which was difficult!!! Becuase the bolt was seized and i ended up have to drill and tap a new one and even then the sensor seats in the hole in the diff but doesn't seat flush with the housing if you really tighten it down, and it leaked a little fluid at first but i ended up loosening up the bolt a little to make it seat better and then i put silicone around the bottom of the sensor and it stopped leaking... Anyway I've fixed both the code issues and cleared them, BUT, the rear speed sensor code pops back up immediately after clearing it and the ABS light on my dash stays lit .... Idk what to do at this point because I've fixed everything and it still pops the code for the rear sensor, I just want the Light on my dash to go off thats all ! ...
View 6 Replies
Advertisement
Why the heck would my dome lights (front and back) stay on while I'm driving and when the truck is off KOEO and locked? It's not the reading lights, those I can turn on and off at the switch on the light, it's the lights in between them.
View 10 Replies
long time ago i had to change master cylinder and the calipers on the fronts and the break fluid well i decided to test it out and see if they were working fter i was done with them then the light on the dash came on i thought its because the floating thing in the master cylinder was not floating which was not the case i dont think its the sensor i also lost my emergency break shoes never replaced em
01 f250 2wd 7.3l v8 diesel straight pipe 310,xxx
View 10 Replies
Trying to be proactive seems to have backfired on me. What to do? Pull sensors and clean? Checked codes points to both left and right sides.
View 14 Replies
Here are some signs of the problem.
*Key fob does not work - battery is good.
*Interior overhead light works only on manual.
*Driver's auto door lock (with driver door open) will lock all four doors but the driver's door will automatically open back. To secure the truck I manually lock the driver's door.
*I replaced the driver's door 'ajar switch' with no results. The old switch was good after testing - normally closed until the ball is depressed then it goes to open.
*No codes.
*I just checked all the mini-fuses with a VOM and they are good.
*Could one of the relays be part of the problem?
I am curious if there is a scanner that can identify the bad door ajar switch if any?
From what I have read so far it appears the VSM (Vehicle Security Module) may be bad as a many of these 2002's complain of this problem and the VSM generally solves the issues. Are there folks other than the dealerships that can program the module if I purchase a new one and remove the old OEM one? Other than the inconvenience the truck runs fine other wise.
View 11 Replies
My yellow 4X4 indicator light on the dash won't turn off for several days after engaging the 4 wheel drive. I have a manual transfer case not the ESOF system, I am certain the 4X4 is disengaged, but the light stays on, so something is sticking. It will usually take several days for the light to go off. I have had to engage my 4X4 system a bunch the last 10 days and had to engage it where I park at my office yesterday due to a huge mound of snow right on the edge of my parking space, man the guy who plows my lot sucks..oh wait, that's me.. so it will be a while before the light goes out on it's own right now. What needs to be sprayed, lubed, tapped with a hammer, replaced?
View 2 Replies
I had my dash apart to install a radio. Didn't really mess with e-brake. Got it all put back together and light on dash is on. Where should I start to fix this? Is the switch with two wires hooked to the e-brake the only way the light can come on? I have worked it manually with no luck.
View 6 Replies
A friend with a 2003 came to me Thursday. He has a dash light on that is an image of an engine. Sitting in the drivers seat, it is to his left. I do not recall seeing this image in my 2001. What might his problem be?
View 10 Replies
I have a 2002 7.3 4x4 truck. The 4x4 will not engage, the lights on the dash don't even light up. I took it to the ford dealer and they said the fuse box and gem module. (800.00 to fix). They said the windshield leaked and shorted then out, so I needed to be replaced? I have replaced the windshield and fixed the leak, my question is the fuse box and gem a plug and play and do different years work?
View 5 Replies
I have a 2002 f250 screw. my door ajar light is lit up on the dash. I have tried the wd40 trick, pulled the sensors and bench tested them. What are the codes the instrument cluster test has for each door?
What I am thinking is, if we get a list posted it would be much easier to diagnose the door sensors for others. there should be a open/closed bit for each door. possibly a code for all doors open too. I am curious if there is a code for bad communication on the VSM.
From what I have read, correctly working the doors should read 00 when they are closed. drivers front open=80, pass front open=40 ... My door code does not change no matter what combination of door open/close I use.
Truck is 2002 f250 crew cab ...
My code is C0 ...
View 6 Replies
I have a 2001 F250 Crew Cab with Powerstroke. The dash lights are starting to go out one at a time. How do I get to and replace the bulbs?
View 14 Replies
I was to leave tomorrow for a trip with three horses. Last night when I parked my truck the dome light went on and off and there was a noise (like a relay opening and closing?) coming from the area. (I have been having issues with the turn signal getting "tired". At times they would only come on solid then other times try would quit after sitting at a long light.)
Checked my manual for fuses to this issue and I removed the fuse in the spot indicated for the "dome and courtesy lights", number 14. Actually I had removed spot number 15 (5amp). This ended the noise. Drove the truck after and all seemed in order, cruise control, turn signals, interior lights! This was the incorrect fuse according to the book! This event occurred with the ignition in the OFF position. Not wanting to start my trip before I get this in order.
View 4 Replies
I've read a few things on the 4R100 and have a question.
My transmission stays in the OD off position until I hit 55 mph no matter the tune I am using and then will up shift to OD. It turns back off once I drop below 30 mph.
I was told when I bought the truck that it was a factory tow package. Is this a thing?
I would like an option to turn it off when I'm not towing or climbing a hill if I can.
Any way to modify it with a switch?
View 14 Replies
Two years ago I acquired a very very nice 2001 F350 DRW crew cab. The person I purchased it from put a Remanufactured 7.3 in it and set the truck up to pull wedge trailers. He put 25K miles on it and put it on Craig's list where I found it. It just turned over 300,000 miles.
One of the changes he made was to install a 70 gallon fuel tank in the frame rails below the bed. He told me that when the gauge reads EMPTY there is still 20 gallons in the tank. I remember him telling me that this anomaly is due to using the stock Ford pickup in the larger tank.
I have never filled the tank because so far the truck is used locally. I usually put 10 to 20 gallons in and when it gets to E I do the same fueling.
Then one day I turned the key on and the needle went up and beyond the full indication.
I can get under it and maybe the tank has some name or model number on it.
The truck runs fine, but the gauge concerns me. Eventually the truck will be making round trips from Chicago to our retirement home in Santa Fe, NM. It would be nice to have a working fuel gauge!
I have spoken to the person I purchased the truck from. He installed the tank as part of a complete upgrade that included a re-manufactured 7.3. The fuel tank is a 67 gallon Titan mounted between the frame rails. He believes that the original Ford sending unit was installed. That means it has 300,000 miles on it. I had the truck on a lift yesterday and it is a very tight fit. The garage said the best way to do the repair is to remove the bed. Six bolts, disconnect the tail lights and the 7 pin trailer connector and it is off.
So, my questions now are... Should I stay with a new Ford sending unit or are there better ones to install? Are there any other updates to the fuel delivery system that should or could be done at the time?
View 8 Replies
my 2003 f-250 4x4 6.0 engine service light stays on all the time (for about 2 weeks now) it has 33,323 miles on it. it is running fine-no problems yet. no codes are showing up on a diagnostic test. What is going on?
View 10 Replies
I was driving today and all of the sudden the dash went dark. No odometer, power windows, radio nothing. As soon as I touched the brakes it went dead. Wouldn't restart and all I could hear was a constant buzzing coming from the fuse panel by my knee. Let it sit for five or ten minutes then it would fire up and run good then do it all over again. The second time the truck had no power. I put a jump pack on it and fired right back up. After the the third time I called a toe truck. I'm guessing it is a electrical/charging issue.
View 4 Replies
I want to remove my whole dash to paint it but i cant figure out what is holding it in,i removed all the black screws from one side to the other the screws under the tabs by the windshield and it still feels like its being held in somewhere underneath?
View 14 Replies
I opened the panel to plug in my new clock spring and found some cut wires hanging down. I don't have a wire schematic to try and look them up. It's not a trailer controller that's plugged in.
View 6 Replies
My truck gave me the p1211 code today. I'm Trying to use dash command to get more info. What should I be monitoring and how do I do it? I'm not familiar with these apps at all?
View 3 Replies
2002 - 7.3 lariat, my a/c stays on max because of the recirculating effect. When I get in the next morning during summer of course, my dash vents take a few seconds to begin, default defrost till that time passes. Sure I know about leaks and redone all that to make my vacuum hubs work correctly. It didn't begin till later not right after that overhaul.
View 11 Replies
I have had a 2000 f250 crew cab for little over a year now. Two previous times, after heavy rains, the cabin light would blink on and i would get a buzzing sound under the dash. I would solve the annoying buzzing sound by opening and closing the door. After a few times, it would work, but my clock and radio could go on without the key in the on position. The next time i used it, no problems... so i put that worry in the back of my mind.
This morning it rained really heavy, sideways type of rain. I opened the door and noticed a small puddle on the vinyl floors right where my left foot goes. OH,oh i thought, but the truck turned over and ran like normal. I picked up a heavy load of hickory in the bed and hopped back in and noticed my speedometer jumping from 0- 30 when I was going about 35. The OD light was blinking, but the transmission shifted normally. I got up to about 1700 rpm and the speedo was barely jumping at 53-55. I make another stop to unload the wood and go back home and i get an intermittent buzzing sound on the way home and no speedo. OD light would start blinking before i hit 2nd gear. I also noticed the odometer not working (speedo related, right?)
I got home and took the fuse relay cover off and found that if I would remove the #1 relay "plug" (black square box 5 prongs) that dreaded buzzing sound would go away, checked it out , plugged it back in, buzzing back on. The clock light still stays on and radio will turn on without the key. I think that water obviously leaked in over something electrical and i have been searching this and other forms for a couple of hours. I am within a couple of weeks of saving up enough to buy the gauges, exhaust and possible DP Tuner and now this happens?
View 14 Replies
