Ford 7.3L Power Stroke (1999-2003) :: 2000 F350 Missing Mostly Going Uphill And Running Sluggish
Apr 19, 2017
Lately I have been having problems loosing power. Truck wants to miss mostly going up hill and runs sluggish I'll pull off the road and let it idle for a minute and it will run fine. And it is only occasionally some days it don't happen at all and other days it happens quit often. New fuel filter, oil is good, had it on the scanner and isn't throwing any codes. Around 230k miles newer injectors.
View 10 Replies
Advertisement
Just a heads up when it comes to this code. Today at work I was working on a 2000 f350 that the driver neglected on telling me he had a CEL on and truck was kind of sluggish (drivers are idiots they cant tell the difference) but no miss or any sign of problem except the CEL (he had electrical tape on the cluster. Well I put my AE to see the vitals and immediately code p1316, so I went to do a buzz test revealing that cylinder 1,3,5,7,6 were short to open circuit (forgot the codes) but they all sounded healthy. My next step since it was a quick and easy to do was to check the passenger side uvch to see for burnt pins and what not but everything checked out.
Checked the driver side #6 cyl for the same problem bit a no go. I ohm tested the injectors all of them checked out, wires all the way to the idm checked out so at this point I was in my atemp to see what the hell was going on I decided to install my obs idm on, and guess what happened next it worked immediately the sel did not come up and when I test drove it, my god it felt like a new truck.
Just a side note the idm, had no sign of water damage, and like mentioned to the untrained person most would not tell the difference on how it ran. To anybody that has checked and can't find the problem make sure you really and I mean really check your IDM really good.
View 9 Replies
2000 F250, 7.3, 170K, running rough, knocking loudly, missing, shaking, no power to get up driveway, intermittent, no codes spit out at all. No smoke visible, no leaks visible, New fuel filter, air filter, update cam sensor, new fuel rail lift pump, new uvc harness, new glow plug relay.
View 14 Replies
Well, long story is that I starting have problems with my 2000 F350 Dually 7.3 PSD about 6 months ago ( ~10K miles ago ). I have sunk almost 5K$ in mechanics and the problem is still present.
By troubleshoot, I do not mean try this, try this, as that has been what is happening. I mean making test measurements and diagnostics. I am fairly mechanically inclined, but I am no mechanic. Looking for primers on how the 7.3 PSD works.
Symptoms: After the truck sits 12 to 14 hours, it starts and idles fine ( ~ 700 RPM on the 'Dash Tach' ) just as it has always done. During the first 5 miles of driving it, the SES light comes on and it sputters, stalls, and vibrates as if a couple of the injectors are not firing. It then clears up and the SES light goes out, except that it idles at about 1200 RPM ( 'Dash Tach' ).
It runs fine like this the rest of the day, If I shut it down it will start right up and run fine, but it has the high idles. Only if it is shut down longer than 12 to 16 hours do the symptoms, other than the high idle, reappear. The high idle is constant. Also mpg have fallen ( 13 opposed to 16 ).
It does not seem to be related to ambient temperature, or the amount of warm-up idle. I have idled it for three hours on startup and it is fine, until I drive the first 5 miles or so.
Now, I have had three mechanics work on it and they have replaced: the ICP sensor ( 3 times ), the Fuel filter ( twice ), drained, flushed and refilled the HPOP, replaced both sides of the valve cover wiring harness, put in a new IDM, fuel heater, CPS sensor ( 3 times ), fuel pump in fuel tank, EBPV ( not sure what this is ), and the last straw was saying the injectors needed to be replaced ( or at least the O-rings, but while we are in there you might as well ... ).
I bought a cheap code reader and it says: P1316 & P1211. I believe these are the same codes since day 1.
View 5 Replies
I have a 2000 F350 super duty 7.3 turbo diesel. It has 189 000 kms or about 150 000 miles. I have had problems all winter with my engine. I can drive it for days and then without warning she quits. She will not start right away but sometimes, if I drain the fuel filter and try her she fires right up and runs for about 10 minutes then quits again. If I wait a few hours, while waiting for a tow truck, she may start and again run for days but she may not...
I have a good friend who is a mechanic, and a cracker jack at it, but he is dumfounded as to what the problem is. She does not show any codes and my buddy has a computer analyser.
So far he has done what others have suggested including changing, Crank Sensor, IPR sensor, ICP sensor, new Lift pump, Fuel pressure regulator, and removed emptied and cleaned the fuel tank and suction lines.
All this to no success. Now we have run out of thoughts. All week I drove her without problem till yesterday when she quit again. There is no set time, weather condition or anything to suggest a problem so I reach out for a solution. The truck is in mint condition and very, very, far from being condemned but this is frustrating.
View 14 Replies
I am still trying to debug my 7.3 running sluggish in the 1200-1800 rpm range. The problem is intermittent. I checked the wiring harness under the valve covers to verify they are plugged in and there are no opens in the circuit. I replaced the crankshaft position sensor and the high pressure oil sensor.
This will run fine one time and a few miles down the road it will chug and smoke out the exhaust until I either get into the accelerator or back off and re press the accelerator. Again, it does it intermittently hot or cold.
I ran both a cylinder contribution test and perdels with a Snap On Verus. The cct passes everytime. The perdels have a couple of cylinders 5-6 and 8 fluctuate between 0 and 1.80% with #8 up to 2.5%.
My question is. Do the cylinders in the test correspond to the actual cylinders in the engine? Reason I am asking is the Verus does not follow the firing order on a gas engine. The cct is in order of 1-8 and I have to correlate the cct order to the firing order. Found this out the hard way when I had a bat cop on a 5.4 and replaced it only to have the same cylinder still show not firing.
I got out the graph leads and tested the cylinder and pulled the injector thinking it was bad. Everything showed good but the cct still showed it not firing. I had to unplug each coil and watch the cct to determine what the true cylinder in the test was. It turned out to mimic the firing order so I am asking out of concern that cylinder 3 in the perdels is really cylinder 3 or a different cylinder.
Btw, the perdels all show 0% if the transmission is in drive. I would have thought that a load on the engine would have showed higher perdel percentages with a load on it.
View 13 Replies
2001 193K miles. Has a miss, like starving for fuel. Starts fine and it will clear out at higher RPM, 1800 and up. idles...
View 14 Replies
I ran out and test drove a new to me 2001 F350 7.3L tonight. Everything seemed good, until I got back from the test drive. I pulled in and was sitting there with it idling. It seemed to idle fine, then a very small miss and very small shimmy then idle fine again; then another small miss and another shimmy. It continued like clockwork. Every time it seemed to miss and shimmy, the RPM would drop just a little, but not much. Does an ICP sensor sound like the problem, or maybe something more serious? 2001 F350 7.3L with 235,733 miles new trans, turbo replaced at 150,000 something miles. No blow by. Idled fine before driving, also drove fine. It doesn't seem to surge when idling, just kind stalls and shimmys for a split second then idles fine for a few seconds.
View 1 Replies
I have looked through a ton of threads to see if I can find one similar to my problem but have not. I have stock setup but had a dealer installed anti-theft device. The first time it would not crank, it was like the the anti-theft plug was missing so I checked out the key, tried the spare and finally removed it all together. I checked all the fuses and swapped the Starter relay for another of the same part number.
I later sifted it into neutral assuming it was the P/N Switch and it started. This continued intermittent for several days but then Neutral wouldn't work. I got under the truck and pushed on the actuator rod for the transmission and it started again for a few days. If finally failed again and I had time to buy a replacement switch.
Once installed I verified I had back up lights in reverse but still no crank. I have since pulled off the starter and had it verified as good. Is there more to setting/adjusting the neutral switch or is there something I am missing before I tow it in?
View 4 Replies
I have a 03 F-350, 7.3L. There is a slow oil leak that only leaks after I've run the truck. In other words, it doesn't just sit and leak overnight. I'll park it after running, and the next morning I'll notice a small pool of oil, approximately 2" in diameter. The leak appears to be coming from the oil pan area. I degreased the entire oil pan area to get a better visual of where the leak is coming from. I can see oil trailing down the front of the oil pan and the rear of the oil pan. Does this sound like the gasket? Or, what else could it be? I'm praying its not as bad as I think and need to replace the gasket.
View 3 Replies
My brother is having a issue with his 99 F350 diesel automatic tranny pu. When in manual 1rst gear the engine stumbles and runs like crap. In drive or 2nd gear it runs fine. He's getting a code for a bad cam sensor. A new OEM and aftermarket sensor has been tried with no solution to the engine problem. What might be going on?
View 1 Replies
I have a 2001 F350, 7.3. My service engine light came on and immediately the truck started to run rough and lose some power. I've checked the under the cover connections and they were both connected, I replaced the cam position sensor and I still have the same problem. The worse part of the hold thing is that there are no codes stored so I'm flying bind. Where to go next.
View 8 Replies
Recently I have had many problems with my 2000 7.3l .... The one I cant get rid of is the p1316 code. I have changed out the uvc harness and gasket with new ones, then removed valve cover's to double check connections again and they are fine. I am getting white smoke and the truck misses. I do not have a advanced reader for the codes just using my edge programmer. I have also disconnected the battery and cleared the code but it comes right back.
View 14 Replies
What is a "normal" number people see on their load factor? Mine was around 25-30 a few weeks ago but I noticed it is increasing to around 30-40 once I'm in gear, in park it's fine. My acceleration is also getting a bit sluggish too especially going up hills and my throttle isn't responding all the way, my turbo boost is normal though and I don't think there is any VGT stiction. I'm thinking either a fuel filter or a MAF sensor to start with. Fuel filters have been in exactly 10 months. Can a dirty fuel filter, air filter, or MAF sensor affect engine load at idle and how fast it accelerates? I feel like I'm pulling a trailer and with it being more sluggish, my transmission is shifting harder as well.
View 14 Replies
I have a 2001 F350 and over the past few nights the horn has started honking once randomly. It always only honks once but will do it several times a night (may be more that I don't hear). I'm thinking that this has something to do with the alarm maybe? I can't afford to take it to the shop at the moment (nor any moments in the foreseeable future, come to think of it) and am hoping that its something that I can fix myself?
I'm having other miscellaneous electrical type issues, but don't know it there are related at all. For example, the power locks don't work (they try to, but don't seem to have enough power), the overhead console that digitally displays the outside temp/mpg/etc. stopped working suddenly and the lighter/power plug outlet stopped working, but I was able to fix this by replacing the fuse.
View 11 Replies
I recently (in the last few months) have noticed my truck (1999 F350 duallie) seeming to be running very rich … I pull a 32' trailer with it and noticed on the art few trips the front and right side of the trailer covered with diesel fuel spots when I got home …. It also smells very rich when idling…. The last couple times I started it in the mornings it seems to crank a very long time before it starts …it still runs but its got issues evidently … it has these 3 codes :
P1280
P0475
P1670
The 1670 will clear , but the other 2 I can't clear, they are right back every time you turn the key on …
View 14 Replies
I have a 2000 f350 manual transmission with electronic shift transfer case and my 4x4 won't kick on I've put it up on a lift and tried again but the front driveshaft won't spin and the light on my dash for the 4x4 won't work I'm also throwing 4 transfer case codes....
View 9 Replies
I need a wiring diagram for my 2000 F-350 power mirrors also to go along with the power window schematics that I posted before.
View 8 Replies
I have a 2000 F350 4x4 CC 7.3L 323,000 miles auto trans. I have removed my tuner just to make sure that it was not the issue. The truck will run fine then all of a sudden the idle will rise then fall or shudder or go up and down and sometimes it will just Die but it always restarts. No trouble lights at all. I am not sure what is causing the issue?
View 6 Replies
I have a 2000 F350 7.3 ... A couple weeks ago I noticed that it was taking longer to start then it should be. Now I have to cycle the key switch 3 or 4 time to get it to start. There is a clicking coming from the relay block under the radio. Sometimes the truck will start sometimes it has to be rolled off. I have recently replace the starter and alternator. I have had the batteries tested and they are good. I replaced the two small relays in the block under the radio, one is for the fuel pump and the other I understand is for the door locks? I also read on here the large blue one is for the turn signal so I have not changed that one. After all this I still have the same problems.
View 9 Replies
2000 F-350 7.3L no gauges or throttle, I checked the fuses and no luck....
View 4 Replies
