Ford 7.3L Power Stroke (1999-2003) :: 2000 F350 - No Gauges Or Throttle
Jan 27, 2008
2000 F-350 7.3L no gauges or throttle, I checked the fuses and no luck....
View 4 Replies2000 F-350 7.3L no gauges or throttle, I checked the fuses and no luck....
View 4 Replies(2000 F-350, 7.3L, 205k miles) Over this weekend, I noticed while driving mostly in the lower gears, that there was a slight hesitation with the throttle pedal depressed about half way or less. Seem to get worse as the day went by, but no lights or anything came on. Changed the fuel filter and added a fuel injection cleaner to the tank. Checked the oil and it was low, so I filled it to the correct amount.
Drove it around the next day, and it seemed to be good, until it warmed up some, and continued to hesitate. The hesitation seems as if it's not getting constant fuel, and the truck jerks a little. Once you get up to over 2000 rpms, it goes away. Looking up other reviews on similar issues, most have pointed to the throttle pedal sensor and just changed out the pedal assembly. Before I take it that far, I wanted to see what was the corrective action.
I have an 02 F350 7.3 ... I just installed my glowshift tripple gauge pillar set. I have an EGT, Boost and fuel pressure gauge ... I followed all the constructions on installing them. The boost is working just fine and the EGT was too, but after a while the needle started going back and forth and the red warning light what blinking and then it just sat at 0 with the warning light on and stay that way. My fuel pressure gauge is connected to a sensore i put in my fuel filter housing, my fuel pressure gayge right from the start stayed at 30 psi with the red warning light on and just stays there .... Also the buttons to change the color and set the peak on the EGT gauge are sticking for some reason and staying down and aren't letting me change the color ...
View 12 RepliesMy truck will set an idle fine but when I hit the throttle it will die.
View 3 RepliesI have a 2000 f350 manual transmission with electronic shift transfer case and my 4x4 won't kick on I've put it up on a lift and tried again but the front driveshaft won't spin and the light on my dash for the 4x4 won't work I'm also throwing 4 transfer case codes....
View 9 RepliesI need a wiring diagram for my 2000 F-350 power mirrors also to go along with the power window schematics that I posted before.
View 8 RepliesI have a 2000 F350 4x4 CC 7.3L 323,000 miles auto trans. I have removed my tuner just to make sure that it was not the issue. The truck will run fine then all of a sudden the idle will rise then fall or shudder or go up and down and sometimes it will just Die but it always restarts. No trouble lights at all. I am not sure what is causing the issue?
View 6 RepliesI have a 2000 F350 7.3 ... A couple weeks ago I noticed that it was taking longer to start then it should be. Now I have to cycle the key switch 3 or 4 time to get it to start. There is a clicking coming from the relay block under the radio. Sometimes the truck will start sometimes it has to be rolled off. I have recently replace the starter and alternator. I have had the batteries tested and they are good. I replaced the two small relays in the block under the radio, one is for the fuel pump and the other I understand is for the door locks? I also read on here the large blue one is for the turn signal so I have not changed that one. After all this I still have the same problems.
View 9 RepliesWhile headed back to town my 2000 f350 7.3 with 444,650 miles (I'm original owner) and have performed maintenance and repairs since mile 3. Truck started to loose power and eventually stalled, was able to restart several times to limp home 7 miles in one hell of a snow storm. Very confused, replaced cam position sensor ( keep one in jockey box ) replaced fuel filter truck starts then stalls out. Don't know if a bad HPOP would allow start up at all. Fuel pump???
View 6 Replies2000 f-350 cc srw 4x4 lb. Added a 4inch diamond eye and sct programmer 2 years ago. When I bought it 4 years ago no oil leaks. Last year had a small leak 1 qt every 3000mi. Went camping tuesday when we got there 1 Gallon low and a camper covered in oil. On the way home used 2 more gallons and topped it off with another gallon before parking. Checked the dip stick tube connection no luck.
Cleaned top off with simple green and garden hose finding the drain hole in the back clogged and valley full of oil. Got the front half clean and checked for leaks and found none front valley is still clean.
Had the wife run it up to 2000 rpm for a minute when she let off the throttle and when it slowed got a 3 second stream of oil from the cover at the back of the oil pan. CEL came on code 1280 found oil in the ICP plug ( will order that with orings and tool for hpop for preventative). Removed the air crossover to the turbo and still oil in the back half cleaned it all out and drying now.
Checked the plugs at the back of the engine and they are clean. Where should I look for the leak to be at?
I have a 2000 F350 super duty 7.3 turbo diesel. It has 189 000 kms or about 150 000 miles. I have had problems all winter with my engine. I can drive it for days and then without warning she quits. She will not start right away but sometimes, if I drain the fuel filter and try her she fires right up and runs for about 10 minutes then quits again. If I wait a few hours, while waiting for a tow truck, she may start and again run for days but she may not...
I have a good friend who is a mechanic, and a cracker jack at it, but he is dumfounded as to what the problem is. She does not show any codes and my buddy has a computer analyser.
So far he has done what others have suggested including changing, Crank Sensor, IPR sensor, ICP sensor, new Lift pump, Fuel pressure regulator, and removed emptied and cleaned the fuel tank and suction lines.
All this to no success. Now we have run out of thoughts. All week I drove her without problem till yesterday when she quit again. There is no set time, weather condition or anything to suggest a problem so I reach out for a solution. The truck is in mint condition and very, very, far from being condemned but this is frustrating.
Just a heads up when it comes to this code. Today at work I was working on a 2000 f350 that the driver neglected on telling me he had a CEL on and truck was kind of sluggish (drivers are idiots they cant tell the difference) but no miss or any sign of problem except the CEL (he had electrical tape on the cluster. Well I put my AE to see the vitals and immediately code p1316, so I went to do a buzz test revealing that cylinder 1,3,5,7,6 were short to open circuit (forgot the codes) but they all sounded healthy. My next step since it was a quick and easy to do was to check the passenger side uvch to see for burnt pins and what not but everything checked out.
Checked the driver side #6 cyl for the same problem bit a no go. I ohm tested the injectors all of them checked out, wires all the way to the idm checked out so at this point I was in my atemp to see what the hell was going on I decided to install my obs idm on, and guess what happened next it worked immediately the sel did not come up and when I test drove it, my god it felt like a new truck.
Just a side note the idm, had no sign of water damage, and like mentioned to the untrained person most would not tell the difference on how it ran. To anybody that has checked and can't find the problem make sure you really and I mean really check your IDM really good.
My 00 F350 has never started when the temps were below 25 unless it was plugged in. This year is no different, but now it won't start when it's plugged in. It just turned 200K and I know things have to be checked, but I don't like doing them in the winter so I was hoping to make it through this winter and fix things. I needed to use the truck the other day so I plugged it in before I went to bed, It wouldn't start, so I got looking, crawled under the truck and the block around the heater was cold, checked the plug with an ohm meter and it showed that there was an open, so I checked the cord, sure enough there's a splice in it, with a broken wire, so I fix all three splices, check it again and it's still open, under the truck again, and find another splice at the end of the factory wire loom with a broke wire, got them replaced, got a good reading with the meter, and now I'm back in business, Plugged it in for a couple of hours, hit the key and it fired like it was new. Well not that good but it did start.
View 7 RepliesWhere the fuel pump is located on a 2000 F-350 7.3L Diesel? Also, how complex is replacing this?
View 14 RepliesAm looking into buying a new transfer case (TC), and one web-site indicated there were 2 different automatic transmissions; Manual vs electronic -shift? So some TC's for 2000 AT's would not work? I found one (used) that was from a 2002.
My truck came to a grinding halt yesterday and I believe the TC. I had been hearing noise for a while and had been in the process of eliminating other causes (u-joints, ball joints) and think it was the TC all along.
I did not notice any issues with the AT prior.
The night temperture was only about 37 degrees. But every morning my 2000 F-350 7.3 crew cab 188,000 on it would not start. The first try there would be a split second where the motor would fire, but that would be it. I had to plug the engine block heater into my generator for at least an hour before it would start. I don't see how all the glow plugs could be bad at once??
View 14 RepliesWe have had significant flooding in Oregon and my truck started to smell inside, like rotten milk. Now, I don't drink glorified coffee's or drink milk or milk chocolate . So while investigating this odor I pulled up the side floorboards with the little gripy circles, exists between the side of the seat and the door. On the passenger side and the carpet was pretty wet and the trough area was full of water. It looks like it dissipates towards the passenger back door. Where this water could come from? There are no visible signs from the door seal (it looks good). This is a F350 2000 Lariat Crew Cab.
View 13 RepliesLately I have been having problems loosing power. Truck wants to miss mostly going up hill and runs sluggish I'll pull off the road and let it idle for a minute and it will run fine. And it is only occasionally some days it don't happen at all and other days it happens quit often. New fuel filter, oil is good, had it on the scanner and isn't throwing any codes. Around 230k miles newer injectors.
View 10 RepliesI have a 2000 Ford F350 7.3 with the auto and 262,000 miles on it. As far as I know everything is stock on this truck. It has been a great truck but lately its been making a strange noise. It almost sounds like an exhaust rattle or vibration but it is intermittent. Its not really loud it can be heard best in the cab at idle. I've looked all over on the truck and haven't found anything. I can't pinpoint where it is coming from. I tried starting the truck with the serpentine belt off no change.
I took the inspection plate off the bell housing and couldn't see any cracks the torque converter bolts appear tight, and the starter is not engaged while running. I've read a few forums on the torque converter going bad. It looks to me like its more the 99 trucks that had trouble with that. Did the torque converter issue carry over to the 2000's? Would a torque converter/transmission problem be intermittent?
I was out with the F350, drw, automatic, 7.3, 4 x 4, yesterday about 30 miles from home base. The transmission started pumping fluid out the front like I have never seen before. I am not talking a drip, I am talking a stream, a big one..... almost like pouring coffee from a coffee pot. I noticed it when I was backing into unload and was leaving an oil trail, a quite obvious one.
We took off the tc cover as it was coming off that to find a dry tc and flywheel, but fluid running out off the case. This is the second time this trans left me high and dry in 165k miles. The first time was a stripped tc/ input shaft. We repaired the transmission then but I don't think we replaced much besides being sure no debris went though everything, fixed what was broken. That was about 25,000 miles ago.
2000 F350. Starts great. Idles fine. After it warms up a little, it will run rough and lose power like it is only hitting on a few cylinders. It will eventually stall unless I push the clutch in and bring it back to idle and then it smooths back out. I figured it was starving for fuel but I can rev it with the clutch in with no issue. I ran it up to 2500 rpm and held it there with the clutch in and ran perfect.
I let the clutch out and start rolling....missing again. The check engine light does come on but my scanner says that there are no codes stored. If I idle it, it will smooth out, and the light goes off. All I have done so far was change the fuel filter which was almost plugged shut and the housing was full of rust looking debris which I cleaned out. BINGO! Nope. Same issue.
I am really at a loss as to where to start. I bought this with 120k on it and it now has 170k and I have not had to do anything other than routine maintenance.