Ford 6.7L Power Stroke Diesel :: When Put In Reverse Transmission Would Not Shift And Truck Not Moving
Aug 12, 2016
I am using my son's truck this week, 2012 F250, 120,000 miles or so. I left it running in the drive while I got something from inside the house. Guess it was idling approximately 10 minutes. When I put it in reverse the transmission would not shift and the truck didn't move. I killed it, re-cranked it and it went in reverse.
As I was driving down the road the transmission would change gears up and down for no reason. I stopped the truck, and put it in park. I would put it in drive and the transmission sounded like it wanted to slip. I put it back in park and the transmission would not engage. I then killed the truck, re-cranked it, and it drove fine for awhile and started doing it again,
I kill the truck, re-crank it, and we go down the road.
View 13 Replies
Advertisement
When I start my truck it takes 30 seconds or so for the truck to start moving... especially when in reverse. If I give it some gas it doesn't take quite as long. I am not a transmission guy. I assume it has something to do with building pressure but I don't know what would be the cause. The fluid is full and looks good.
View 8 Replies
So my 11' F350 is over heating when the engine RPM's are below about 1300 whether the truck is moving or not. If I let it idle for 2-5 minutes I can watch the temp gauge go to red and an engine over temp message appears. I noticed that if I rev the engine to > 1300 RPM it cools back down.
This appears to be a water pump going bad, any other thoughts? Are there instructions for changing the water pump here on the forum?
View 3 Replies
2011, 69,000 miles. My truck is experiencing very hard shifts from park to drive or park to reverse after a cold soak. It goes away once warmed up. I can't find any excessive driveline play and my transmission fluid level appears fine and in good condition.
The last repair done on my truck was around 7,000 miles ago and it was for a transmission fluid leak around the bell housing. They just replaced the seal between the torque converter and transmission.
View 13 Replies
We are on vacation pulling the 5th wheel. On the last of the three days driving the transmission starting doing something I have never seen. When running about 60mph and starting up a grade, when I push the pedal and it should shift from OD down, it bucks really bad. It only does it under those conditions and only when towing. It does it when the tow/haul is on and tow haul is off. Also, in the afternoons on the last two da,ys the A/C has started to turn off. The fan still runs but the cooling cycles off. After a while it comes back and is ice cold but then cycles off again. It only seems to do this when the engine fan is running to cool off the engine under load. I have it scheduled at the local dealer for a transmission service and A/C check....
View 12 Replies
I have a new issue that started last Friday. When I put the truck in gear and let it begin to pull itself, drive or reverse, it has a strange jerking or slipping deal. It doesn't happen every time but when it does you can feel it in the drivetrain. I took it to the shop that did the motor work and they ran a diagnosis(while I watched) on the motor and its turns up nothing. It runs perfect, shifts like it always has, but just has this jerking/slipping thing when I let off the brake and it starts to pull itself.
If I go from brake to throttle its fine. I had the rearend diff worked on to fix the leaky ring and pinion seal and the differential cover sealed at the dealer last month. I searched and don't see anything like what I am experiencing. Could my tranny be giving it up now? It has never been overworked and never overheated. I had the full fluid service done at about 70k and now it has about 130k on it.
View 14 Replies
I have a 2005 f250 super duty turbo diesel 6.0 automatic. The problem I'm having is, when I engage the tow/haul button the transmission doesn't down shift unless I feather the pedal. Also the engine will overheat at times. I've replaced the thermostat...
View 6 Replies
Well I've been towing for almost 150,000 miles with a 2012 6.7 Lariat 4 wheel drive. Things have been going pretty well with the truck. I noticed some sluggish and indecisive type shifts early on but now I'm worried. I depend on this truck for pulling a horse trailer all over the country and Canada. Just recently I've been getting a hard shift or a thump or a clunk when shifting up or down in to second gear. I'm at about 152,000 miles and did a hot flush with LV ATF at about 148,000 miles. Should I worry or keep running?
I have a 97' PSD I'm thinking of giving a nice paint job and a flat bed but am reluctant to do so due to financial concerns and the fact that some folks may not want to see me pull up in an old truck no matter how nice it looks. My tranny temps have been stating under 200F and I really keep an eye on the temps when running up and down the hills while towing. The trailer is a 35' Gooseneck with a max GVRW or 14,000 pounds. Should I wait for the tranny to grenade and then drop in a built tranny and if so who's building these tranny's stronger than stock? Long time no see but this site has always been my go to for all my Ford truck questions, upgrades, etc.
View 5 Replies
Any input on replacing the entire transmission valve body or just individual shift solenoids? My truck has begun experiencing a harsh shift from 1st to 2nd under light acceleration accompanied by occasional shift flare from 2nd to 3rd and 5th to 6th. I have located parts to do either job. It looks straight forward from just disconnecting the harness. I also understand there are different bands associated with the solenoids. Is there a requirement to have new transmission programming to accompany swapping these components?
View 2 Replies
I'm having problems with my 6r140 in my 2011, the truck is an early build around 8/2010 I believe.
After cold soak when shifting into reverse after allowing engine to warm a bit the transmission almost always slams hard into reverse.
After that shifting from 1-3 is awful, the transmission will try to go into 3rd but downshift to 1st then fail to go back into 3rd multiple times. This situation is extremely dangerous when trying to pull into traffic.
Oh and once the transmission gets into 3rd it will skip 4th and go right into 5th. There is only 94k miles on this transmission/truck.
I just bought this truck about a month ago, does this sound like an issue with the solenoids in the valve body?
I'm very mechanically inclined and can swap them if need be but now we're talking few hundred in solenoids and then getting the trucks pcm flashed right?
Also fluid has been changed and I used mercon lv.
View 14 Replies
For those of you tuned and deleted......intermittent transmission shifting stutter is gone now? Mine sure is. Never once since the mods have I had that annoying stutter when the truck is cold and I'm easy on throttle between 2nd and 3rd gears. What a relief it is to have it shift NORMAL ALL THE TIME!!! Stutter no more after H&S Tune and Delete, for about two months now.
View 9 Replies
05 F-350 6L .. Automatic Transmission
When I got the truck I noticed it would slam hard into reverse. Ever since it is taking longer to engage reverse gear and now I have to rev it to 1000 rpms for it to engage with a hard SLAM.
I also noticed that if I do a fast take off, there is a knocking sound coming from drive shaft/differential area (like knock knock knock knock knock then goes away). Then a slight vibration ending at around 30 kph (~20 MPH). There is also some oil leaking from the transmission. I added some mercon sp yesterday - it was a bit low.
My guess for the knocking and vibration is the center support bearings and U-joints. Transmission??? One thing I know I am going to be banging away at that shaft but the transmission problem really scares me.
View 5 Replies
When taking off the 1-2 shift and the 2-3 shift the truck will go into a neutral state for 2-5 seconds. when this occurs, the rpms will rev since your foot is on the accelerator. Once you let off the accelerator the rpms come down and the gear will catch. I have had the truck in the shop a few times without any luck. part of the problem is no codes are thrown so the dealer has no clue what to look for. This is extremely dangerous when in my case i pull out on a 6 lane hwy with 55mph speed limit. Ford more or less said to pound salt until a code is thrown or until something else happens. this nearly caused a nasty wreck 2 weeks ago.
View 14 Replies
I picked up a 2016 F250 Powerstroke in the first of March. I owned a 2011 before and loved it.
The 2016 has been great so far, but I've noticed a sound that wasn't present in my 2011.
When the transmission is warmed up, I get a "cla-click" sound from the transmission area when sifting from park to reverse. It doesn't do it all the time and I can only hear it, not "feel" it.
This AM I heard a similar click sound when I came to a complete stop. I only heard it while stopping, not while taking off. I could repeat it almost every time I stopped. I was in drive the whole time I heard the click sound while stopping.
What it may be? I know sounds are one of the hardest things to communicate/diagnose.
View 6 Replies
My mirrors on a 2016 explorer don't move when we lock the doors, or move into position when we unlock them.
View 1 Replies
Saturday while moving some items for the inlaws my truck, while moving at slow speed, reduced power to the point where it almost stalled, anti lock brakes were growling, right rear tire was dragging the brakes skidding the tire. maybe ten seconds then ran normal. got to stop sign and made a right turn and at about 30 mph started doing the same on and off for maybe 30 seconds. All the time Advance Track light blinking 3 times then pause, and repeating.
Stopped in a parking lot for a couple mins, did not shut off but drove the rest of the way home normally. At home we could smell brakes cooking, right rear brake disk was very hot. Drove to dealer Sunday morn with Advance Track over-ridden and ran normal. What would happen at highway speeds or towing my fiver? Bet they cant reproduce the prob, left no code etc. You know what that means.... I will update later.
View 6 Replies
My truck was working fine and I drove it to school one day and I was driving and I noticed the RPM was high and the truck wasn't moving correctly luckily I made it home and parked it now it won't move at all I can shift into gears and I put it in first and reverse and let off the clutch and it doesn't move like the clutch is still disengaged. The Slave Cylinder is pressing against the pressure plate to disengage the clutch and then releasing. I have a single cab 1999 Ford F150 4.2 V6.
View 3 Replies
I have been having an issue with my 4-5 gear shift under hard acceleration and know that a rebuild is due soon but I was wondering if any high performance kit available with all the clutches and friction discs needed to rebuild.
View 6 Replies
2004 f350. Trucks starts, runs, normal. But just noticed the gauges are not moving. Speedo stuck at 50, tach is at idle. Lights up just fine.
Have a code for the fuel sender, had that issue for awhile now, but also have u1262.
View 10 Replies
Initially thought I had a clicking valve but the clicking occurs only when I shift to drive and take off. Now I think it may be related to the transmission. Clicking goes away after truck warms up. Checked the spark plugs and all were light brown no black oil.
Generally speaking, is there anything in the trans that would be able to click when the truck is moving? This sound has been around now for about 6 months so I'm stumped. Also checked the ujoints etc....can't find anything wrong.
View 6 Replies
This just started happening last week. When I put the truck into reverse, the engine lugs down and dies. It' as if the AT is fully engaging reverse gear with no clutching action. If give the truck a bit of pedal, I can put her in reverse and back up without issue. Going forward into Drive has no issues.
View 8 Replies
