Ford 6.7L Power Stroke Diesel :: Upper Radiator Hose Leaking?
Dec 24, 2016
After chasing the smell of coolant for a couple weeks, discovered that the upper radiator hose was leaking at the engine. Based on my schedule and drive schedule, and unfamiliar location this last week, I took my truck to the last people I wanted to - the Ford dealer, where they attempted to charge for the hose replacement. During this time I discovered the nature of how these hoses work and asked the tech why they don't just replace the O-rings ... "Ford Motor Company wants to sell you a new hose with labor" - a direct quote from the Ford tech. And that is why Ford is the LAST place I want to go for repairs I cannot perform. I kept the old hose - any spot where you can get the O-rings alone?
View 5 Replies
Advertisement
Noticed this past month on colder days my upper hose is collapsed, typically a symptom of a bad radiator pressure cap.
This hose is connected from the water pump to the radiator. The radiator is connected to the Degas bottle which has a nonstandard radiator cap.
Do these plastic caps vent the same way a typical cap does?
Cap for 2011 Ford F-350 Super Duty|9C3Z-8101-B
View 3 Replies
This weekend while towing a light load I noticed my FWT and EOT starting to climb rapidly, EOT reached 260 FWT I think about 240. I exited the interstate to find I had a busted radiator hose. I replaced the hose and filled the system with distilled water, but didn't add antifreeze at this time. The system wasn't completely empty.
I noticed once back on the road my EOT seemed to be higher than normal but FWT seemed to be normal. Could the lack of antifreeze cause a greater delta between FWT and EOT? I have seen articles which state do not use Ford Premium Gold Coolant, but to use CAT EL-1 coolant instead. Which should I use?
View 6 Replies
I have an 03 super duty with the 6.0, came back from vacation with my 5th wheel in tow. Lost the upper turbo hose twice on way home. Managed to get it rigged and made it home and parked it. a week later went to uncouple and move the truck and had some very strange issues. Started fine but could barely make it up driveway (no trailer at this point). No power, felt like when turbo hose came off. Got it moved and checked turbo hose and all was good?? Went out a couple days later and no start.
Checked all relative fuses and relays and all checked good. Jumped starter solenoid and starter worked fine. turned key on and jumped quick connect on right side of engine compartment to battery and it fired right up and ran. Jiggled shifter around in park and neutral and nothing. BTW I always here the relay clicking and swapped with one of the others just to be sure, same thing. After looking on the internet for a day and a half thought maybe a NSS in the tranny but I think I have the 5R110 that does not apply??
View 4 Replies
Just had to replace radiator at 38k on my 2012 SD. Now I have another leak at 41k. Looks like it's wherever the lower radiator hose leads. Kind of a weird junction. I don't think it's coming from above there, but not sure. It's the primary dgas bottle that was low. The radiator was covered under my ESP. We'll have to see what's up with this one. Been eying a denim blue SD at dealer, thinking this is going to talk me out of it though. Not especially happy right now.
View 3 Replies
Recently I had a radiator hose split while traveling. The EOT got up to 250 degrees before I could pull over and stop the truck. I flushed the cooling system with water, replaced the thermostat, and added Ford Gold coolant as per the recommendations in the Tech folder. My oil temps are higher now than prior to this incident. Unloaded on a flat road my deltas are about 10 to 12 degrees @ 60 mph.
My water temp will stay around 190 to 195 degrees while my EOT have reached 212-215. I pulled a small utility trailer and saw a delta of 17 degrees this was at about 75 mph. Typically unloaded I would only see a delta of about 8 degrees and this was at 80mph. My question is do you think a EOT of 250 would burn the oil, I had Shell Rotella T5 5W40 in the engine. Would it be possible that the oil cooler is partially plugged from this temp?
View 14 Replies
Is there one thing that when broken makes both the steering and brakes lose all power? Does the power steering and hydroboost share a pressure source?
My brake pedal is dead and I get no steering boost, but the master cylinder and PSP are full of fluid. Do I replace both, or replace one first to see if that fixes both? Or could it just be a hose leaking? Not sure how to diagnose this one.
View 1 Replies
, 211,000 miles and the third radiator that was put in this truck is leaking!! Has there been a recall This is not right. I haven't even had the truck five years and this will be over 5 grand in radiators. Is a person suppose to budget an extra grand a year if they want to own a ford diesel?
View 14 Replies
Read that this is a common issue, leaking out crimped seam on lower LH (2012 F250 King Ranch). I have called Ford customer service twice, they said "we do not have any recall or programs to cover the out of warranty repair". I keep adding coolant and thinking eventually Ford will address this problem. They did cover my bad EGT sensor....
View 9 Replies
Recently turned 100k and since have had my exhaust RTD's go out. While fixing that they found the back radiator leaking. Since then both batteries died which didn't surprise me at 40 months. Then my windshield washer started leaking, then my DEF heater went out and two days ago my AC quit. I was ready to buy a new 2015 but now not sure. I've contacted Ford customer service and they are getting with the dealer to see what they may cover but haven't heard anything back yet.
Mine is a 2011 with 105,000 on it. This is pretty frustrating. I have been very pleased with this truck up until now it has been very dependable. However when that dependability begins to go south at only 100k it brings to question what exactly are we paying for here? A heavy duty truck that costs upward of 60k should be one you can count on for a lot longer than that. How Ford approaches this with me is definitely going to have a direct bearing on which 2015 diesel truck is in my driveway in the next few months. Again let me say that i have been very pleased with this truck and FOMOCO in general.
View 11 Replies
Ok I now have the dreaded leaking radiator on my 2011. I am wondering how the aftermarket radiators are holding up? I was talking with my local radiator repair shop and they have been repairing the oe radiator with good results. They also claim that they have repaired some aftermarket radiators. He did not mention any brand names so I can not make any claims against them. I am considering a mishimoto replacement.
View 14 Replies
In April I replaced the radiator, hoses, water pump and Tstat. I used Mishimoto for the radiator and hoses (silicon). I am having trouble with the hoses leaking where they clamp to the radiator. I put 2 on the lower hose and that seemed to work. No other signs of leak on than drip from the top hose - factory clamp is on and tight as I can turn it - still lost a gallon in 2-3mo. Should I just get a new clamp? OEM stuff was not this prone to leaking ....
View 14 Replies
So i cant figure out how to remove the radiator side of the upper radiator hose. I pulled out the pin but i cant remove the hose.
Do I just pull it straight out? Or do I twist and pull? I dont want to break the connection.
View 2 Replies
On Friday am I noticed a 6" sized puddle on the garage floor. Coolant leak on the drivers side coming off the frame. Dropped it off at the dealer on Sunday and today the tech tells me it was in fact a radiator leak and the new one will be here wed. They hope to have it buttoned late Wednesday. I am assuming all will be covered under warranty.
I have 23k miles logged and had just got home from a 1300 mile run pulling about 18k worth of hay and trailer. Truck performed flawlessly. Averaged 11mpg for the trip. I am hoping this is the first and last radiator replacement I have to go thru.
View 14 Replies
1992 3.0L V-6 RANGER
New thermostat
New Water Pump
I noticed the other day that the Upper radiator hose gets Sucked Flat when RPM is higher than Idle BAD it completely collapses IDK how it can circulate the coolant very well in this Condition. If the hoses have ever been changed But the Upper hose Really gets sucked flat. I've seen this a few times on vehicles that have been shutdown But they have always expanded upon startup and are fine....
The Lower Looks Fairly Old and only partly collapses under higher RPM.... I am going to change the Upper hose at a Minimum as its really Bad and probably a lot older than I am thinking and really Soft. I am just wondering if the radiator could be plugged up causing some of this.. Or anything else I should check into????
View 6 Replies
I smelled antifreeze when walking by my fiances Sonata, so I popped the hood and saw there was a small leak from the upper radiator hose, where it meets the thermostat housing. I adjusted the stock clamp, but the leak was much worse.
I swapped it out for new clamp that you can tighten, and all is well again. But, what I noticed when I had it off was that the metal neck of the housing was really corroded. Only 15,000 on the car, so I was surprised to see that the corrosion on the metal had already built up causing the leak (pushing the hose away from the housing). I scraped and scuffed to get it clean again, but just wanted to give you all the heads up in case you notice a leak in the same area. The antifreeze tested good and is really clean.
View 22 Replies
1991 Toyota Celica 2.2 liter standard water is boiling in upper radiator hose what could be the possible cause of this problem I have changed radiator and cap, water pump, radiator hoses and have flushed the system. could crossed hoses from engine to heater control valve and heater core cause this problem?The head has been checked and no exhaust gas was found in radiator fluid ...
View 4 Replies
Well I was fueling the truck today and I opened to hood to check it out and noticed that there was no pressure in the cooling system by squeezing the upper hose. I did have a spare degas bottle cap and removed the old one slowly and replaced. I have been driving over 30 minutes and it is close to 100 degrees.
I then drove on down the road, the truck is not getting hot. I stopped to look at some running boards and the truck was running and then I came home and still no pressure, the truck is still running, I removed the cap and no pressure, I then removed the small hose going to the top of the degas tank and no coolant came out. I turned the truck off and disconnected the upper hose and some coolant did come out.
Is this normal? The truck runs just fine, just has me worried. I just bought the truck and the previous owner recently replaced the water pump, T-stat, hoses, etc. All parts were bought at O'Reilly. So everything looks good.
View 3 Replies
I have an '08 250SD diesel. The upper hose that goes onto the water pump has a leak. Is it usually just the Oring or the hose plastic fitting?
View 2 Replies
I'm going to be replacing my lower radiator hose so figured might as well switch over to the extended life stuff going to probably go with the Delo ELC.. Supposedly it's good for 750k.
View 14 Replies
2001 F250- V10... Lower radiator hose has coolant leaking - Right now I cannot tell if its the hose or the radiator itself (hoping not) - I tried to take the clamp off and it broke - Any tricks to removing the hose? its on there pretty tight.... I guess if I don't want to save the hose I can rip it off with a pair of pliers but before I do that wasn't sure.
View 2 Replies
