Ford 6.7L Power Stroke Diesel :: Truck Went Into Limp Mode While Towing
Oct 25, 2015
I was towing a fairly heavy trailer yesterday (around 10k) and laying into the throttle to gain some speed before a big hill when I completely lost power. It slowed me down to about 10 MPH.
I was able to drive home at very slow speeds and the only way to get over 10 MPH (only up to about 20MPH was to very lightly accelerate up to speed. Any hard acceleration and it cut me off to 10 MPH. No warning lights of any kind going off...
Truck has a Hypertech Max Energy programmer on stage 2.
View 7 Replies
Advertisement
What's the best tune for this motor? I have an hs mini max with the spe hot tune and has nothing but problems towing with with it. They swore up and down for a year I was the only one with issues for a year and then finally admitted it's not good for towing and lots of people had issues with it so they gave me their towing tune for free but it isn't very good either.
The hot tune is a little too hot and keeps going into limp mode when towing up hills even on the lowest stock setting, or really getting on the throttle on any setting not to mention way too high of boost for a stock turbo at 30-32 on every level . It makes sports cars look slow before hitting limp mode though.
Their tow tune fixed that problem but it's boost is too low at only 18-19 (had 24 running stock Ford programming) and it smokes like crazy, more smoke on higher settings without getting any faster or any more boost. It doesn't smoke much on the stock setting but clearly the other settings aren't very well tuned.
I want a tune that will tow 25k without issues and smoke(not literally) sports cars off the line at factory boost level s so it doesn't blow the turbo.
View 4 Replies
What the problem is with my F-350 6.0. I have an intermittent problem with my Speedo reading zero while I'm doing 70mph on the fwy. since the speedo won't work the truck goes into limp mode, the turbo will not function at optimum level. I have replaced the diff. sensor, the trani sensor, the a.b.s.sensors, the instrument cluster to a reman cluster. Then when I had a local mechanic plug a laptop dianostic program on it as he was running through the system inadvertently the radio cut out, so I found that who ever installed the after market stereo they cut a few wires to the harness, I went to the junk yard found the harness end and replaced the end. so with all that said and done no one knows what is causing this speedo not to work and limp mode. about 4 years ago the oil pump stopped working and ruined the turbo so the whole front end of that glorious 6.0 was rebuilt the problem started about a year after that.
View 2 Replies
I was driving to work and got about 15 kms from home and all of a sudden, the engine lost power and I coasted to a stop, with the engine running rough on 3 or 4 cylinders. No engine light on and I have a Scangauge II and all the gauge readings looked ok. the fuel pressure was 42, but the glycerine in the gauge froze solid in the winter and I didn't think it was right. I stopped the engine and looked for obvious problems like a failed o-ring on the fuel filter, any leaks and found none. tried the engine again and it ran perfect again, drove the remaining 40 kms to work with no problem. It happened again on the way home, no engine light, again, stopped on the side of the road, it would not restart, check the SG for codes and there was none. Then it started again and I drove home fine again.
I picked up a new gauge for the dash I had added, and checked the pressure, it was 48 and steady with the engine running, but I then changed the fuel filters and installed the blue spring kit to the filter housing I was waiting for warmer weather to install. Drove it to work again the next week, it ran perfect, fuel pressure steady at 60. Then I used it yesterday and it lost power again. I could not get it to run properly for quite a few attempted starts, the it was fine again and I drove it home.
I idled it and checked for codes again, none. ICP was 740, FMP was 54, SYC 1, Fuel Pressure 60. While it was idling, it did it again, idle slowed down and all the previous reading stayed the same, fuel delivery did go up though.
Previous work done. (Current Kms = 390000) 180000 kms, new injectors, turbo, EGR cooler, (EGR blocked off as well), ICP sensor and regulator, in dash Fuel Pressure and ICP gauges installed. FICM sent to Swampy's after alternator died and took out FICM and upgraded to 54v.
The SG when I try to clear the codes it says "Not Responding" with the key on or off, so I don't think it will read or clear them. Where to start? I am thinking wiring somewhere...
View 14 Replies
I'm going to do a weld-in-plug delete in my RV in the next couple weeks, and its a crapshoot apparently if it'll throw a code. My immediate concern is I want to go on a trip right after, and I won't have time to fiddle about getting an SCT tuner to turn the code off. What I definitely don't want is a code for EGR flow restriction to eventually cause my motor to go into some kind of limp mode while I'm in the middle of a long drive. Is this possible?
View 14 Replies
While exiting the interstate just now my 2011 f250 just went in to limp mode going up the ramp and cut off. I am sitting at the top of a very busy exit truck won't restart .
View 12 Replies
I was towing the 5er (about 15000#), across Southern Mn and SD today going right into a 20-25 mph wind in upper 90 temps, saw 228 on the oil temp and 199 on the tranny temp. When tow need to see for warmest temps and at what point you start to get concerned...
View 10 Replies
2013 CCLB, 33,500 miles, stock emissions
While towing a 9000 pound trailer at interstate speeds (75 to 80 in Wyoming), when pulling a hill, the truck downshifts to 4th gear, boost is about 18psi, eng and transmission temps in the 230F range, EGTs around 500C or 935F. RPM increases normally to 3000 then the turbo gets very loud and boost drops to about 10psi. The truck shifts to 5th gear, noise decreases but is still present, shifts to 6th and noise goes to normal after a couple seconds and boost builds normally.
This just started today. I have about 8000 miles towing this trailer and never had this before. I have about 350 miles until I'm home so I'm headed back out. Will play around with manual mode and see what it does. I also took a video of the gauges while this happens. Audio is difficult to discern. I will try to get better audio and post when I get home.
View 5 Replies
My truck gave me low fuel pressure and reduced pressure limp mode at 21,000 miles. The fuel and air filters were changed at 16,000. The dealer said all they found was the fuel filters (at 21,000) were what needed to be changed. Also, why does my truck hum??
View 14 Replies
I want test my fuel pressure. What is a good gauge or kit to buy? My truck has lost power towing and is now starting to miss a little. I'm wandering if i my problem is in the tank. Is there a good scan tool that would diagnose things too?
View 14 Replies
Just fully rebuilt transmissin 4r75 replaced all planet gears clutches etc. Now with it all back together the speedo does not work on truck goes into limp mode. I replaced the vss sensor an no luck
View 8 Replies
Last year while towing my fifth wheel to the North Rim of the Grand Canyon my oil temp went to 260 degrees several times. The outside temps were 95 degrees at the start and it is a long steep climb with a heavy load. Each time I pulled over for a bit, as I couldn't remember at what temp that plastic thing inside the oil filter melted. Each time it cooled off fairly quickly but it really stressed me out. So how hot can the oil get. I am using Rotella T-6 and my temp different is only 12-15 unloaded. Could I allow 280 for 15 minutes or so?
View 11 Replies
I am looking at a 1997 F150 with a 5.4 in it, guy who owns it says if you drive it down the street the temp gauge climbs and then the truck goes into limp mode but if you check the engine temp under hood it is nowhere near overheating. Where I should start to look for a problem here? If this is too complicated I will pass on the truck, its not worth it to me to get this truck if it is going to be a nightmare. I have a 2000 with a 4.6 that runs great so this would just be a spare for me, but would like to have it because its in such nice shape.
View 1 Replies
My dad recently bought 2006 6.0. He has had it about 2 and half months. Has the egr delete kit installed. The truck has ran great. Up until Wednesday the 3rd. My dad headed to Ut to pick up our new quads. While heading up a small grade with empty trailer in tow. Truck went to limp mode, fan kicked on, orange wrench came on on dash board. He pulled over let her cool down turned her off.
Checked fluids Then started her back up and she was fine. That has happened 3 times. Now he is on his way back (tow haul mode turned on) and it is doing it again. She hasn't went into limp mode yet. As soon as the fan kicks in my dad pulls over immediately and puts it in park. And lets her cool down checks fluids. This issue only happens mid way up a grade. So my question is...... What is causing this? How do we fix her and make her a happy truck again.
View 7 Replies
I have a 05 6.0l that started over heating while towing recently. In 2012 i did egr delete, oil cooler, stc fitting, and coolant filter. I recently changed radiator and tstat think that was the problem due to small leak in radiator, but still towing about a 4-5k load temps rise to over heat while towing. What to look for next. Also fan seems to be work properly I monitor fan speed etc., and tft on my scangauge.
View 14 Replies
I have an 06 F-250 with 122,000 miles. When driving empty at 70-75 mph the coolant temp runs 194-200 and the oil temp 5 to 10 degrees higher at the most. When I pull my travel trailer the coolant temperature will start to steadily climb then abruptly drop down under 200. I have seen the coolant temperature pass the oil temperature when this happens.
The last time I pulled the trailer I was driving at 60 mph and the coolant temperature climbed to 220 then dropped to 196. A few miles later it climbed to 230 then dropped to 200. While the temperature was climbing I slowed to about 45 mph. As it was dropping I accelerated and the temperature continued to drop.
I have flushed the cooling system, replaced the thermostat and cap with no improvement.
The pickup has an SCT tuner set to street 1 and I was told by the previous owner that the egr was deleted, but the stock egr cooler is in place. It is possible that a plug was put in. I pulled the egr valve and the carbon coating on it is gooey like it has been wet.
View 12 Replies
Just looking for comments on using the cruise control while towing? and what's the recommended weight for using the tow haul mode. The enclosed trailer I have is about 3300 lbs. taking it across the country empty. 2004 6 liter.
View 11 Replies
I recently bought a h&s tuner and installed a dpf delete kit. Everything works great when the truck is not plugged in to the tuner although when I do plug it in, the truck keeps throwing a communications code and goes into a limp mode until I delete the code. I believe it was p0073 but i maye be mistaken. Regardless it has to do with communicating through the obd2 port. I sent the tuner in to get checked out and it turns out its something to do with the truck. I've checked all the fuses and tried to check for broken wires. Where to look next?
View 4 Replies
I have a 2006 f250 bulletproofed for about 5 years now with no problems other than normal wear and tear. I had the factory water pump go out a couple months ago so I decided to go with the bulletproof diesel pump for piece of mind now I do tow anywhere from 8K-15K about once a week with custom Gearhead tunes using SCT.
While I was changing water pump, I ordered low temp thermostat figured it would work with towing temps even though they weren't that bad to begin with my deltas always around 10-128.. Now i am seeing signs of puking out degas bottle, I replaced cap seems to work a little the truck doesn't puke unloaded unless i really get down on it.
I noticed the other day while towing I was cruising with TC locked in at around 55 mph and i watched my EOT 210* and ECT 205*, the n ECT started climbing up followed by EOT then at ECT 222* fan came on ECT finally hit 234* and started dropping fast while EOT never got over 226*. ECT would level out at 188* go back up to 205* and stay there for awhile and do it all over again...
What is going on. I've talked to a could mechanics and they aren't confident its the HG..
View 14 Replies
Took my first camping with 2012 King Ranch F350 and 37 feet Challenger 12k fifth wheel trailer over the weekend.
I noticed there is lot of transmission slips in first gear. Once it enters 2nd gear, no more slips.
My previous Chev 2008 2500HD diesel didn't slip much with same trailer.
Is this normal for this F350? My rear ratio is 3.55. No slips without hauling.
Maybe I need to ask dealer to check 1st gear towing?
View 14 Replies
I've got about 1100 miles on my new truck now and I will be heading to S.D in a week or so towing my car hauler with FJ40 on top and camping gear. About 10 000 pds.
Would it be wise to dump the factory oil and go with 5w40 Rotella? It has been getting really hot here the last two weeks and its only getting hotter as I drive south.
View 14 Replies
