Ford 6.7L Power Stroke Diesel :: Truck Making A Lot Of Noise When Tried To Accelerate - Boost Gauge On Dash Stuck At 35 PSI
Dec 7, 2016
Was driving back home from shopping tonight and my truck was making a lot of noise when I tried to accelerate. I noticed the boost gauge on the dash was stuck at 35psi but the MiniMaxx showed 0psi.
No engine light so I babied it home which was about 30mins driving and managed to accelerate slowly to avoid the engine rattling. I didn't want to shut it down and restart in case it wouldn't start again for some reason.
When I got home I idled until EGT was <300F like I normally do (it never went over 700F when I was driving home) and then restarted it. The gauges worked fine, MiniMax showed boost and the engine revved freely with no rattling noise. I haven't taken it out for a road test, I'll do that when it's daylight.
Bad sensor somewhere? I would think if the turbo had failed it wouldn't have been fine after a restart.
View 5 Replies
Advertisement
One of the many things that impresses me about the 6.7 is how well it lugs...... it'll run right down to near 1,000 rpm in 6th gear and stay there till it absolutely has to shift. Like a diesel should. Well, recently, and now more frequently my truck is making some strange noises when it lugs down. It'll mainly do it if I'm towing light, like my flat trailer empty, or maybe if I have a decent load in the bed. But occasionally it'll do it empty. As soon as it lugs down low to 1,000-1,200 and pulls there for a few seconds you'll hear a couple squeaks, then a kinda chugchugchugchug noise. It immediately quits if you let off or make it shift down. It sounds like a turbo-related noise, but I don't really know. Truck only has 9k miles on it. I just know this is one of those things I'll take it back to the dealer and they'll give me the ol "we can't duplicate the problem here." What it could be?
View 8 Replies
Pulled into the yard today after about a 20 mile haul with my 2015 f450 6.7.
I shut it down after pulling in, from what i knew everything was fine. 20 minutes later i started it codes and lights went off like the four of july. A wrench light, oil light, temp light and maybe even an obama light. The gauges did not even move. I shut it down, let it cool then after starting it only the CEL came on. I bought two new trucks in 2015 and both had front end alignments off. The f450 doors fill up with water when it rains.
One day after a rain I put my seat belt on and the seat belt was soaking wet. The cab corner where the seat belt spools up was full of water. The tie rods and ball joints started making sounds after 20k miles so i checked them to find they didn't have ANY grease in them!!!! The def fill tube broke off driving through a small dip in the road (i heard it pop). My first new truck....glad l have my 96 7.3.
View 5 Replies
I was driving and went to accelerate quickly and had no power, checked the boost gauge and it had very low boost. Continued like this the rest of the drive, all gauges normal, no check engine light, not towing or hot. Got home then next time out it was back to normal.
Someting to be concerned about? Or just a computer hiccup. Truck is '13 with 66k.
View 3 Replies
Boost gauge is pegged and have no turbo don't know if the code has anything to do with the problem or not its a po6a7...
View 6 Replies
I am working on my dads 06 F350. He had four dash lights go out, so we changed out the bulbs and put the dash back together. When we hooked the batteries back up all the gauges reset except the the boost gauge. The needle went way past 0 and bounced for about 2 seconds then it just stayed below 0. We have tried to reset it by unhooking the batteries and turning the ign. switch on and off several times. Always go back past 0 and stays there. It does work it just doesn't read correctly. I am pretty sure that the needle did not get turned on the shaft? Is there a way to reset it?
View 3 Replies
Noticed the other day when I went to leave a job site my Check Engine Light came on but the truck started fine and seemed to run normal. while cruising down the highway I noticed that my factory boost gauge was showing 35psi and fluctuating between that and around 10. looking at my H&S it was showing normal boost readings for the current driving condition, when I came to a stop the H&S would show 0psi but the factory one would fluctuate between 0 and 35-40psi..
I can tell the turbo is not spooling at all during this time. if I take off from a stop with the gauge showing 35 the engine sounds louder than normal at first take off compared to when the gauge is reading normal. I haven't gotten a change to get it in my shop yet to look it over but does the dash gauge read from a different sensor that what my H&S is reading? Truck is an '11 F250, deleted both EGR and DPF with H&S tuner. I checked codes and all I have is P06A7. Where to start?
View 4 Replies
P0237 code. The truck is a 2003 f250 with an edge evo . The truck will run great then throws this code and won't build boost of over 11 psi. Now it even drops it right off to 0. I replaced the map sensor a month ago and doesn't seem to have fixed anything.
View 2 Replies
This isn't my truck, but I'm trying to diagnose it for a friend and I haven't seen it. He's scanning it with a high-end Matco scanner so I'm not convinced that the scanner is reading right but here's what I've got:
P0056 (2), P0161, and P0300 (random misfire detected). The first two are "gasser" codes and don't show up in the 6.0 bible code list so I'm wondering if they were added in to some of the later flashes??
The truck has a "new" OEM turbo and won't build over 18 psi of boost but, according to the owner, who is a decent mechanic, it's absolutely clean inside. Looking for about the weird codes it's throwing?
All my years of information on 6.0's was stolen with my laptop last year ....
View 13 Replies
I have a 2011 F350 6.7 cclb 4wd dually. 212k ... I have the dtc p0284. The run good at idle and driving. I use it to pull a 40ft enclosed trailer. I have noticed that the boost gauge peaks at the half way mark and slowly drops half way down. I can feel my truck lose power when that happens. I also noticed that it runs alot better at night than the day. I have not modified anything except a s&b cold air intake. I have the #8injector replaced.
View 2 Replies
2004 f350. Trucks starts, runs, normal. But just noticed the gauges are not moving. Speedo stuck at 50, tach is at idle. Lights up just fine.
Have a code for the fuel sender, had that issue for awhile now, but also have u1262.
View 10 Replies
I recently installed an egr delete and ever since, my vents have been stuck to the upper dash no matter which setting I put on. The vent will push the air conditioning, regular air and heat all the same. I have checked the fuses and they are all good.
View 5 Replies
I have a 2006 F250 6.0 Amarillo Edition. 133,000 When I bought the truck it was a theft recovery vehicle where the turbo, injectors, FICM and wiring harness were stolen. The company I bought it from replaced the injectors, wiring harness-new, and a used FICM, and turbo. Also has EGR delete and SCT tuner with basic tunes. I believe the SCT was put on to mask another problem. No dealer would spend that kind of money to sell a truck unless something was wrong. The truck would accelerate some with the tuner but shift the tires so hard it would bark them. I removed the tuner and went back to stock program.
The truck will barely move and takes a long time to accelerate under a load. In park and neutral it is fine. A friend has a ford diagnostic program on his computer and says the readings were all good except EBP was a little high. Removed exhaust and air intake to verify no restrictions. Turbo sounded like the vanes might be sticking so I replaced the turbo and VGT solenoid. Now truck feels like its trying to make more boost but not transferring power to the engine. Have blown the silicone hose off twice now during testing. Checked the EBP sensor and tube and only thing I see is a little carbon buildup inside the sensor. What else to check. I'm new when it comes to diesels.
View 6 Replies
2015 F350 6.7L, 43,000miles
My family and I were driving into West Virginia this morning when the reduced engine power message came up on the dash and the truck died. I coasted off to the side of the road as best I could and got out. Immediately I smell diesel fuel. I look under the truck and there is fuel all over the passengers side frame and when I keyed it back up fuel started spraying down by the right front wheel.
Pulled the fender liner back and saw a small rubber hose that looks like it came off of a tee fitting down by the egr components. I tried to get it back on but wasn't able to get it seated 100% and when I tried to restart it blew off again. Truck is completely stock and ran perfect right up until it died.
View 3 Replies
I have a 2003 Excursion 6.0. I didn't post this in the 6.0 section because it may not be just a 6.0 issue. (See what I get) On cold starts, anything under 150 degree water temp reading on the SGII. I get a CHECK GAGE light on accompanied by the check engine light. No codes read on the SGII pending or stored. Just some of the time I get a water in fuel light too. This tends to go out fairly soon after driving. (Even after I just drain the fuel pump it still happens.) other issues that accompany the lights are as follows.
The trans temp does not give a reading to the dash. The oil temp does not give a reading the dash. Both show proper temp on the SGII. When in reverse the back up alarm beeps as if something is behind me. And the auto door locks will not activate after 10 mph. The tach also will not show a reading in the dash. SGII shows the numbers. Now the kicker, this ALL gets resolved the instant the water temp hits 150 degrees. The only lingering issue is the that the tach will surge or drop every now and then. The tow/haul light does not come on when this is going on. I've checked the battery terminals all are clean. Both batteries are brand new.
View 9 Replies
heard a loud squealing noise and now no boost. 2011 with 90k miles
whats my options and what would it cost.
1. replace with factory turbo
2. replace with upgraded turbo and tune?
View 8 Replies
I have a 2013 F350. Since it was new in August the turbo has made a chattering sound that sounds to me like the waste gate (if it had one) is opening and closing rapidly. Almost like its building boost and dumping it over and over again. Usually happens when it is in 6th gear around 1700 rpm under light load. It also does it from time to time while plowing snow. You can power through it or let off and it will go away. My local dealer where it was bought new put a new turbo on it and the problem still persists. The truck just turned over 8k miles and has been in several times in attempt to resolve the issue. They say that there are no codes on the truck nor does Ford have anything on their service web. My dealer claims that no one has ever had the issue.
View 14 Replies
Wheel bearing go out? My left front just starting making noise and when turned by hand you can hear the bearings are shot. Called around this morning and with my luck its on back order and the entire hub has to be replaced since the bearing is built into the hub.
Anyways, I was wondering replacing this unit themselves and how long it took to complete? I was going to let Ford do the work but I figured I have never done a job like this and wanted to give it a try and looking at some Youtube videos on older vehicles it did not look that difficult.
If I find that its not difficult I will tackle the other side as well since I figure it is probably not long before that side is gone also and I would not want that to fail while I am out towing somewhere.
View 8 Replies
[URL] ....
Ratchet buzz noise my truck makes. Is not present until motor warms up. Noise is not present as much at idle but when you accelerate upwards to 1800 RPMs it makes such an obnoxious buzzing noise its embarrassing. Noise seems to come from top center area of motor.....
View 14 Replies
a few times when making a tight turn on hilly terrain or a hill on a road, I've noticed a grinding sound in the front of the truck and a vibration in the steering wheel. I've so far chalked this up to the hill assist feature, but today I was on relatively flat ground in a parking lot with a dip in it. While crossing the dip in a tight turn, I noticed the same thing again.
I've checked the tires/wheel wells and there is no rubbing, etc.
View 14 Replies
I have a 2003 F250 6.0l 4x4 with 230k miles. All of a sudden it seems that the fan is very very loud and there may be a very little lost of power. Also i just replaced the fan clutch not sure if that may have anything to do with it. What could it be. I need to get this fixed this week...
View 14 Replies
