Ford 6.7L Power Stroke Diesel :: Trailer Turn Signal Lights Inoperative
Jan 2, 2014
Last night I was heading home from a two day race and found that my turn signals wasn't working. the running lights are working and obviously i could feel the brakes working.
well i hooked up some jumpers to a 12v battery and the 7 pin and the lights work. to make 100% sure it works i hooked it up to my neighbors Tacoma. it all worked. well..........
On my last f150 when it was new this happened to me too. it ended up being the turn signal fuse on my truck.
I hooked right back to my truck again and just made sure my plug was all the way in and still nothing so i know its my truck side.
Now my last f150 owners manual had a section to where it told you what fuse is what and where. well i don't even see the f250 fuse box is and don't know which one it is to see if its blown.
View 7 Replies
Advertisement
My trailers lights aren't working at all- so frustrated right now!! I've checked all the fuses and those are good, I've got no power back to the 7 pin connector...
View 9 Replies
I've got a 2001 f150 supercrew 4x4 with the 4.6. I plugged in trailer lights and now I have no brake, turn signal, or hazard lights. I've checked fuses and none are blown.
View 8 Replies
2013 F250 XL with factory towing package.
My camper and boat trailer do not have turning signal or brake lights when plugged into the round seven pin trailer connector. I have tried both the connector in the bed and under the bumper. I've also connected the trailers to other trucks and the lights work fine so I know the problem is in my truck.
View 9 Replies
Been having a on/off problem with my trailer lights. Some times the right hand side does not work, them it starts working. I thought it was my trailer until I rented a bobcat this weekend. They couldn't get the right side lights to work.
I stopped by my Ford dealer and a service tech came out and checked out my pigtail. All checked ok. It seems odd that both trailers would not work on the right side. Two different types of trailers. One is my RV, the other was a flat bed for hauling the bobcat.
View 10 Replies
Borrowed a buddys trailer that had wiring issues. I ended up blowing a mini fues & maxi fuse in my truck. 06 F350 CC ... Replaced both fuses in the truck and had park lights on the truck but now dont get any lights on any trailers. All factory plugs 7pin & 4 pin. I get turn signals and brake lights on the trailers but that is all. If the fuses are good were should I start looking for problems? or is there more fuses I may be missing. I have metered all the fuses under the dash aswell as under hood all check out. Where to go next ???
View 14 Replies
Is there a fuse or something to check? All other lights work, just book the running lights
2006 f250 4x4 CC
View 7 Replies
I've been looking for the fuse that runs the trailer running lights and couldnt find it and it got dark on me.. Does anyone know if its under the hood or inside the cab? I blew the running lights fuse hooking up the trailer while the lights was on...
View 13 Replies
I have a 2012 ford 150 what fuse controlls the trailer lights.
View 2 Replies
luckily about 5 minutes from home my trailer running lights AND the lights on my dump truck body stopped working. i assume they hooked the lights to my dump body to the trailer lights. i was towing an old trailer that has electrical issues so I'm sure that caused it. Under the hood there is a 30 amp fuse #26 that i think is the culprit. (All the other similar fuses are shiny and that one is kinda black). I've never bought fuses like this before, what type is it? it's a big square one. Are they available at auto zone? Does the whole thing pull out and do you need a special tool for it?
View 3 Replies
My left turn signals have went out again on the rear of my truck and trailer. I replaced a body control module about three months ago and now its done it again. It has not blown any fuses. Why this is happening.
View 4 Replies
Ok 2011 ford f350 6.7. Turn key on, no crank, no start. Trailer brake module failure flashes on the screen. If you leave the key on after 5 to 10 minutes the heater kicks on and you can start it. Runs down the road, hitting every pot hole for 1000 miles fine. Shut it off, try to immediately restart, same thing. If you hook up a booster box to it it starts. Replaced both batteries, cleaned cables. Scanned it, only codes are with the instrument panel : loss of communication with trailer brake module, with abs, with heat and air, and with parking aid modules. Tried to scan abs, parking aid, and brake, scanner would not communicate. When it is running communicates fine with them. Need a direction to go from here?
View 14 Replies
Started truck, used windshield washer and noticed High Beam Indicator was lit on dash. Headlight switch not on. Drove to Ford dealer, turned off truck, high beams would not shut off. Dealer replaced the Turn Signal/wiper/High beam switch assembly. Dealer had one in stock. Service manager said they have replaced a few of these Switches. So if your High Beams come on without the headlight switch on you cannot turn them off even if you shut off and exit truck. Also the "You left your lights on warning chime" does not sound when you exit truck.
View 14 Replies
The other day i noticed my turn signal was blinking rapidly. I found that my drivers side bulb was burned out. I am trying to convert most of my lights to LEDs on my truck and figured that I'd replaced the tail lights with LEDs. After replacing both rear taillights with LEDS I still have the rapid blinking turn signal. Whats the deal? is it just the LEDS or what?
View 13 Replies
All of a sudden, my turn signal won't stop automatically after making a turn. I read that the multi function lever needed to be replaced. I did, and nothing changed... what is wrong since its not the lever assembly itself?
View 6 Replies
Purchased 2011 3 weeks ago. Due to not paying attention, put gas in diesel. Had tank dropped and drained but after reassembly, fuel gauge inop. When turn ignition switch on, get normal sweep of all dash gauges but fuel gauge does not read. 2nd tech says sender okay, must be gauge. Dealer ssays if it sweeps, it isn't the gauge. 011 F250 6.7L.....
View 7 Replies
Hearing a whistle noise after installing the Recon smoked turn signal lense? The whistle starts between 40 and 50 mph and is the driver side only. I have triple checked the installation and it has the same clearance all the way around as the left side. I sent Recon an email on Jan 5th about this issue and still haven't heard back from them.
View 14 Replies
I'm looking for a 3156 LED Amber turn signal bulb for the front turn signal, I've looked around haven't found anything! Any success story with this particular bulb, and does it require a load manager when installing?
View 14 Replies
2004 F250 6.0L!!
An issue I noticed right off the bat was that whenever I had the driver side turn signal on, and the brake was applied, the turn signal freezes.
I took apart the tail light and found a concoction of wires...I posted a diagram illustrating what it looks like.
There is this pesky Red wire that is spliced into the tail light bulb socket wire (specifically the green wire).
There is a trailer brake installed...if this means anything. I've tried disconnecting that with no luck on fixing the issue.
How to further troubleshoot would be great...electrical work is not my forte!
View 14 Replies
So I was doing the DRL - Dimming on indication mod with the VAGCOM. I used the following steps:
Go to [09] Central Electronics
Go to Security Access and enter 31347
Go to adaptation channels and set the following (they're quite far down the list):
"Leuchte2SL VLB10-Lichtfunktion G 2" to Blinken links active (besides Phasen)
"Leuchte2SL VLB10-Dimmwert GH 2" to 35
"Leuchte2SL VLB10-Dimming Direction GH 2" to minimize
"Leuchte3SL VRB21-Lichtfunktion G 3" to Blinken rechts aktiv (beide Phasen)
"Leuchte3SL VRB21-Dimmwert GH 3" to 35
"Leuchte3SL VRB21-Dimming Direction GH 3" to minimize
Now my right front turn signal is inop. Checked voltage and swapped bulbs left to right. the bulb is good. No sure what I did. Could I have disabled the blinker somehow? Where is the channel for the right front blinker?
View 1 Replies
I have a buddy with a 1999 F250 W/7.3 TD. His property is accessed through a couple miles of hard terrain, so this may wind up being a loose ground or something that pulled loose.Anyway, the truck just all the sudden won't accelerate. It'll crank & idle all day long, but when you hit the gas.....nothing happens. I realize the diesel doesn't have an accelerator cable, as it is drive by wire. First thought was the APP sensor(accelerator), but most of the dash indicator, O/D, etc. lights are inop too.
View 5 Replies
