Ford 6.7L Power Stroke Diesel :: Tick / Tap Noise Occurs Immediately After Start Up And Happens At Idle
Feb 4, 2015
So my 2015 has a touch over 1K miles on it. It has "ticked" loudly since day 1. I generally keep my truck in my shop and hear the ticking every single time when I pull it outside. It occurs immediately after start up and happens at idle. Easily heard anywhere around the front end of the truck. This is not the normal diesel engine noise and absolutely sounds like the tick-tick-tick of an old typewriter.
So in doing some research, I came upon the TSB for put out for the 2011-2014 models, in which it CLEARLY states the typewriter noise can/will occur AFTER an oil change and eventually go away...
So, is the noise only supposed to be heard AFTER an oil change, and if so, why would my truck do it even though it has not had an oil change?My 2012 did not have the tick before, during or after an oil change, ever.
View 14 Replies
Advertisement
just got a new to me 05 f250 with the 6.0. Truck has 152k its super clean. I think there is an odd noise. That occurs every 20-40 seconds. This is my first diesel. There is no check engine light. No loss of power. No stutter.
But, there is a bump sound behind the firewall on the drivers side. And a felt bump on the throttle pedal. At first I thought it was a sub woofer behind the firewall, not really, just the feeling of the sound and vibration. Since there is no check light on I'm concerned as to what this could be if it's not a normal diesel sound/vibration.
There is no correlation with throttle position(occurs at idle and pedal depressed) RPM (I feathered the throttle attempting to elicit the sound no result). bumps in the road (bump stop,steering nothing wrong there). Does seem in the afternoon it's more prevalent. I drive about 20mi to work and around 5mi through out the day. The sound occurs approximately every 20-40 seconds.
View 2 Replies
My 2011 6.7 has a strange tick when I accelerate once I speed up it goes away it happens in drive or reverse I only have 29000 on the truck it will tick one to three times and then stops I had new rear u joints put on and is still ticking and is driving me crazy u can only hear it with windows down ....
View 14 Replies
I have a strange issue and it happens very sporadic. Sometime it occurs at startup, sometimes while driving. Not sure whether it is limp mode, but I have no throttle. It starts fine, idles, but no throttle. Like I said, sometimes it happens while driving and I have to pull over and shut it down and restart. Mods are few, it has an airaid air filter and I had the turbo rebuilt and egr delete both completed in May. FICM was rebuilt by ficmrepair.com a couple years ago. It does seem to happen more often when it is raining or with a heavy dew after sitting for many hours. 128k.
I adjusted the pedals all the way out and back in and it stopped for almost 5 weeks, but it has been pretty dry here in SW Ohio. then it got really foggy one day and rained the next and it has started again. Could it be that the EGR pigtail is getting moisture. It does not throw a CEL and my scan gauge II shows no codes. I did run a dose of hotshot's secret thru the fuel back in may, ran a couple tanks of fuel, then changed the filters with OEM. I have had this truck for almost 3 years, but still a newbie when it comes to diesels.
View 14 Replies
Have a 2004 f250 that is having issues. Once the truck is started the idle goes from normal to loud almost sounds like its going to stall. A few weeks back the same happened when i was on a red light. It choked almost to where it was going to die. I accelerated when light turned green and would not move at all. I had to literally use full throttle to get out the road at about 5 mph. I pulled in to a gas station and fueled up as i had a quarter of diesel left and it stopped the rough idle and power starvation once i started the truck up again. It sees like this time its getting more persistent... FML AND THESE 6.0 problems
View 9 Replies
I'm new to diesels. I just bought a 2004 F250 with the 6.0 V8. I have the high and low circuit, contribution codes on cylinders 4 and 8. I've only had the truck for a few days but I've been reading a ton. The symptoms are hard start, rough idle/shaking, no power when cold. When it heats up and I'm over 2000 RPM it seems to be just fine. Even when hot and below 2000 RPM it does ok. I've check the FICM. It reads 48V with key on and 48V running. My plan is to do the following:
Change the Fuel Filters
Change the oil filter
Change Air Filter
Change oil with 5-W30 synth and I have both Hot Shot/Rev-X
If that doesn't work, I'll replace the two injectors. How does that sound.
View 14 Replies
So after replacing all injectors, I was getting a rough idle and drive. Got an imbalance on 5 & 4. Cleared out codes and 5 still showed. The guy doing my work and I couldn't trace it to anything so we thought well maybe we got a bad one. Did fail the buzz test. So got a warranty one and put in. Wouldn't you know it's still not running quite right. Only thing we can think of is maybe the ficm is at the start of going out. Voltage reads good still though. Staying constant at 47/48. Is more noticeable to run rough when starting from cold then smooths out but you can still make out/feel an injector going in and out.
View 14 Replies
Have a 2004 6.0 that stalled out while driving. Wouldn't restart. Took readings this morning. ICP was very low (below 100) and IPR was at 85. After a few times of taking readings I could get the truck to start up with an ICP reading over 500 but IPR was still at 85. When it did start up it would almost immediately die. Does this sound like an IPR problem or a oil pressure problem?
View 5 Replies
I have an 03 f250 that i think is getting air in the fuel line when it sits. It turns over starts and immediately shuts off. Then i have to crank it for a minute or so before it will start. After that it is good all day. Next day it might sputter on start but stays on. More than a day it shuts off immediately and needs cranking for a minute...
View 13 Replies
Fast idle 6.7 when cold remote start. My GM had what could be called a auto fast idle when it was cold it idle a lot faster.
It appears my 2012 f350 does not , Ford dealer said he could install a fast idle using one of the switches.
And then if I park truck with park brake on and switch on it when I start it will fast idle to around 1300.
My question is being if truck is started by remote , will not this switch be off and by being off fast idle will not work , is this not the case?
View 9 Replies
I recently did the high idle mod but as many of you know it does not work with remote start. I found the below link on how to make it work with rewiring how the aux switches receive power. Are the aux switches hot all the time even with the key off?
[URL] ....
View 5 Replies
I have been debating if i should use seafoam engine treatment. My truck has been having issues with the first cold start of the day. I've noticed the rough idle that accompanies the cold start. I live in Denver so this truck sees alot of stop n go traffic. Will seafoam do anything about the dirty fuel injectors. They have to be replaced here soon but will adding seafoam solution buy me more time. If so, what are the steps on how to add. The can isn't very detailed on instructions and Internet isn't being useful. I have an 04 F250 Lariat Power Stroke 6.0L diesel
View 14 Replies
On cruise control, engine went dead immediately after passing gear kicked in. After 2 days on the side of the road got a pull to the house. Then after having a charger on it over night the electric seems to be messed up. Switched on, the dash lights light full strength for a fraction of a second before appearing as thought the battery is real low. Also the doorlocks act crazy. I think maybe I blew out the BB on the high oil pressure pump.
View 6 Replies
I'm having an issue with the truck not staying idle after cold start up. The truck will turn over and start right away (not even 2 second crank) but immediately dies. The throttle will not work at low RPM. When I start the truck, it will instantly rev high, the revs will drop low, it will try to compensate and rev high again, then it will immediately die.
If the RPMs are under under 2.5k, the truck will immediately stall and die. When I attempt to use the throttle under that RPM, it will not work. No matter how much I depress it, the engine will instantly cut and stall out. It will not attempt to deliver fuel. The only way I can get the truck started is if I rev the engine high and hold it. I need to hold the truck at 2.5k+ RPM for atleast 30 seconds. It generally takes me about 5 tries to finally get it running (mainly due to the throttle immediately cutting out and I have to 'catch' and hold it.) After that, there is no sign or issue. The truck will start immediately back up after it's been running for a couple minutes.
CEL: MAP sensor (0069?) -- Sensor is spotless. Harness looks fine. I replaced the injectors, both batteries, and the alternator this summer. It doesn't sound to be any these either as the truck sounds extremely healthy and immediately turns over.
View 8 Replies
Having that flash on the dash? Truck was running fine and the buzzer when off and dash said I think -- when safe stop and shut off engine immediately. Scared the scr-p out of me so not sure if that was word for word. Jump on the binders and got it off the road and called a wrecker. Now it's at the dealer waiting for them in the morning. Checked oil and don't see any leaks. Now I have lost my confidence in the truck. 42000 miles on it.
View 14 Replies
I need to get my oil cooler replaced but that's besides the fact. I drove it on a little trip the other night ran fine. Then went to start it after i was done with what i was doing turned it over didn't start the first time. Cycled the key and cranked it again. Started up drove it back home on the high way no spitting or sputters got off the high way it started idling like crap and shaking as i accelerated but made it home. Let it sit over night and day (was at work) got home to start it and it fired up no problem but still idled funny.
Revved it a couple times and it seemed to clear up so i took it around the block. Floored it and it ran like it was suppose to then go to the other side of the block floored it again and it had no power and sounded like it was running on 4 cylinders. Pulled it back in the driveway idled weird and cleared up again went down the street and floored it ran like a scaled ape and then just died. tried cranking it over and nothing finally got it to start after holding the ignition on ran and then died again. Got it pushed home and decided to fire again after a VERY long crank and it idled for a couple minutes very horrible and died on its own and hasn't started since.
View 14 Replies
Rough idle I have had for little bit.Would stall out at idle or a stop, but fire right up? No one could figure it out with the stalling, but now its bad, started yesterday. Have white/blueish smoke sometimes, ( white smoke smells fuel) on restart after warmed when it dies, first time it took 25 mins to restart, now only takes 5 to 15 mins, when I step on it INCREDIBLE full power, fuel mileage gone to hell also since yesterday. Had full tank, now 1/2 tank.
No problems on cold start at all, no check light, 325,000 and never had this before.
Bad fuel?
ICP?
FICM?
Recent work, new turbo, ( turbo was original turbo installed when built) cooling line to waterpump, oil change, new fuel filters, front brakes and 2 new batteries.
View 5 Replies
Started my 2005 f250 powerstroke, idle about 15 min and died like I turned key off. Hooked up scan guage had no flp, fmp or syc ipr and icp was good. Checked ficm relay and fuses and all checked good. Next morning went out and it started flp, fmp, sycall good. Idled about 1 hr and died again same bad readings. Messed with relays and wiring to ficm, it started and died after 2 min. No start again, next morning still no flp, fmp. Went out again in afternoon and everything was good again, I did nothing to it from am to pm, was loading my pistol they shoot horses don't they. I have new batterys, I changed the ficm power card last summer for low fmp. When it is running everything looks and sounds good no miss.
View 14 Replies
Truck has been doing this and now getting worse. 06 f250 6.0 147,000 miles. Runs like crap when you first start and truck has trouble shifting when I first take off in the mornings until it warms up then it idles fine and runs like a champ no problem shifting. Not in a cold climate 40F at the least. Not trying to take it to the dealer and get raped. Been doing research some people say get the inductive heat flash, some say needs new injectors, some say could have a bad gasket on the injector idk. I'm trying trying to get it resolved....
View 4 Replies
My '05 Excursion recently started having rough idle and some loping when started cold. It seems to run good and idles pretty good when it warms up. I'm also getting a P0488 code (EGR Throttle Control Circuit A Range/Performance). I do have a BPD EGR and I don't recall if that would throw a code alone? I'm taking a trip next week and want to get it straightened out. Does it sound like an EGR valve issue?
I also thought about a battery issue, I know that can cause weird problems. I have Duralast batteries and they always seem to fail at about 2-3 years. I took it in and they say it tested good but I'm not always sure with them. Long story, but when cranking for longer than normal, the cranking power would drop quite a bit. Checked battery and had some corrosion. Cleaned and upon further inspection, the positive post is a bit eroded at the base and sunken in. The voltage was about 12.35 after sitting all night, a couple of the cells were reading lower than the others (about 50%, other 75%) when checked specific gravity. I tested voltage after batteries had been in the truck overnight, then unhooked from truck when testing.
I also thought about a glow plug/harness issue. The truck cranks for awhile before starting, 5-6 seconds sometimes, but not all the time. It starts up pretty quickly when warm. That's been going on for some time. Anyway, I will try to get a video of the rough start after cools down.
View 6 Replies
I have recently bought a 04 f250 6.0, and it has the intake thumping noise that varies speed with idle... I was told it could be a broken rocker, a bent push rod, or a broken roller... I am not that much experienced with diesels. I've spoken to the dealership, and they don't wanna fix it, they said it wouldnt hurt it to drive it like that, but the noise bothers the hell out of me, and everyone notices it. so i wanna get it fixed. I am hoping its just a rocker. if it is just a rocker how deep am i in? truck has 240xxx miles on it, and runs perfect other than that noise.
View 7 Replies
