Ford 6.7L Power Stroke Diesel :: Rear Tires Wearing Unevenly - Tire Pressure?
Oct 9, 2012
I do 98% of my driving unloaded and almost never tow. (Kinda weird for an F350 huh) I know that the truck recommends going with 65psi front and 80psi rear but the rear tires seem to not be wearing evenly across the tread pattern. The edges still have the little rubber stubs sticking out of them even after almost 3000 miles. Should I be running a lower tires pressure in the rear when empty or should I just let tire rotations take care of the uneven wear. If I should air down, what pressure would be recommended? The front tires are wearing normally at 65psi and they have more weight on them then the rear.
View 14 Replies
Advertisement
My front tires had previously been wearing out a lot faster on the inside. I was told it was due to the front lower control arms, does this sound right? Is it possible and cost effective to just have the bushings rebuilt (replaced) or will i have to buy new control arms. How can I tell what my car actually needs? I just put 4 new tires on the car and am weary of driving it until i get this fixed.
View 11 Replies
I have about 20,000 miles on my elantra gls with the stock 16" wheel.
I was measuring my tire tread and noticed that the outer groove of all 4 tires is down to 3/32 tread depth while all of the middle and inner grooves have about 5/32 to 6/32. My car was aligned about a year ago. Tires rotated every other oil change, i do oil changes at about 3,500 miles.
I drive pretty conservatively, though the street in front of my neighborhood is 50mph and has heavy traffic, so I have to take an aggressive about half the time I pull out of my neighborhood.
View 32 Replies
On my 2009 Matrix XR (2.4L), my right rear brake pad is wearing unevenly. I'm up to 87000 km (54000 miles). My first pad change was one year ago. I kept the pads and only noticed this time that the wear was at an angle on the outer pad, both times.
The inner pad is ok.
Multiple pictures below:
The other pictures:
View 4 Replies
I had new nitto snows put on my truck and low tire pressure light is on.....Checked tire pressure 65 front and 80 back.....Started truck and screen said tms pressure low.....Hit ok and drove around on and off for 2 days now and cant get the light to go out......Is there some way to get the light out or do I have to go to my dealer to have it reset???
View 14 Replies
I just bought 4 new tires and since then the Tire Sensor light comes on after I drive about 20 minutes. The place I bought the tires from has used their tool twice now and it is still happening. Could they have done something to have made this happen because I had no problem before they changed the tires...
View 1 Replies
Why are my tire pressure sensors going off, I have 70#'s in the front and 62#s in the rear, which is more than enough air.
None of the tires have a leak in them, yet I keep getting the sensors to trigger, and why would it be so hard for the system to point out which tire is low??
View 14 Replies
I had the low tire pressure message and light come on back when i was visiting california, about 3 weeks ago..i checked the tire pressure, and a couple tires were maybe 5 psi low at the most.. i aired them back up to the right pressure (as stated on the door pillar sticker) and the damned light/message is still coming on.. how do I reset the TPMS? it says in the manual to just drive the truck 20mph+ for about 2 mins after getting the tire pressure correct, and the light/message should turn off. i have done that...
View 14 Replies
One of the few disappointments I had with my 2011 F350 was it lacked a display of individual tire pressures like both Dodge & GM have. I figured the idiot light would have to do. Recently I found that an inner dual tire was flat. It made a subtle squeal when braking or turning sharply, and a quick inspection showed I picked up a nail.
I never got a tire pressure alarm. I read my manual and it describes the system, but the writeup only indicates setting up four tires. Am I missing something? Have you guys got a working tire pressure monitor on your duallies?
View 1 Replies
Well, at a little over 10k I have my first issue. My monitor displayed a Tire Pressure Monitor Fault. All tires are OK. Light won't go out. Guess it just earned a trip to the dealer.
View 14 Replies
2013 F350 SRW . Pressure is correct . Anything special you need to do to make the light go away ?
View 14 Replies
Truck started riding weird, checked and my right rear tire is cupped. So now I get to buy new tires! I guess 60K and change on the original Michelin's is pretty good - whatdy'all think?
View 9 Replies
I have a question for 11-15 Superduty, regarding the factory option remote door unlock and remote start. How far away does your system operate from?
Mine is good for only 50 ft or so MAX most of the time it won't work until about 15 ft from the truck. Been trying to get the dealer to look into it, but got told today that in the owners manual it is only good to 30 ft. Plus I randomly get a tire pressure sensor fault. The sensors are fine, but since the TPMS and door unlock/ remote start share the same antenna I think the 2 are related.
Since my 2011 would work from 100 yards most of the time I call B.S. on the 30ft. I feel that the new truck should work at least as good as my old one. Besides that 30ft is a complete waste, and virtually useless, in my opinion.
View 14 Replies
Today as I was adding pressure to my tires I noticed the front brake pads were wearing unevenly. Both outer pads wore the same. More "meat" on the inner section of pads than on the outer, evenly worn, just sort of slanted down as you move out towards the outer rim of the brake disk.
Is this normal? What would cause this? Should I have it looked at? I've never seen anything but even pad wear, perfectly parallel to the brake disk.
Edit for these pictures to clarify.....
View 24 Replies
I have a 04 F250 6.0 and change transmission and transfer case. Now all of a sudden the rear passenger tire is locking up but the rear driver side still moves. I've dropped the carrier and the ring and pinion looks great and so does the spider gears ... Need on whole new rear....
View 14 Replies
I'm trying to figure out why I am having problems with my read tires wearing fast. I knew my car was out of alignment and took it to a shop and they told me I have -1.05 negative toe and bad camber.
Can some shims fix my issue or would I be better with a whole new rear beam. As far as I know the car has never been lowered, but how would I be able to tell?
View 5 Replies
About a week ago I had my car on a hoist getting new exhaust tips installed. At that time I noticed the rear tires are wearing prematurely on the inner edges. So are the fronts but not nearly as bad as the rears. I asked around and was told that this is normal for the factory Pirellis because of the negative camber built in to our cars. This being the reason the car corners so well. I understand the physics of this and I really like the way the car corners. My question is this---Can the negative camber be taken out of the car thusly reducing wear on the inner edges of the tires?? And how much will this be noticed while driving the car normally, and during spirited driving?? I have noticed that some fellows will purposely mod their cars with increased negative camber on the rear wheels, I'm assuming this is to achieve a certain "look".
View 5 Replies
The front and rear driver's side tires are wearing on the outside edge. Searching about, I find that camber problems are indicated with outside edge wear -- but....
View 19 Replies
My passenger rear tire is wearing out on the inside edge. Thoughts as to cause and possible fix?
View 14 Replies
Last week I was driving on the highway and noticed the oil pressure gauge showed no pressure. Limped a half mile to the mother-in-laws and called for a tow. As my truck was pulled onto the flatbed I could see oil all over the bottom of the engine, tranny, rear end, etc. Turned out to be a bad oil pressure sender, which was leaking enough oil to blow the plug off the top of it.
I replaced the sensor, cleaned the engine and under-carriage, checked oil level (which showed no loss of oil) and drove around for a week without an oil pressure gauge while I waited for a new pigtail. Put the pigtail in yesterday and drove it today for the first time since. Gauge was working, got to the bank and it was reading zero pressure again. Limped home and watched the gauge go back up quickly and then back down. This happened twice and was showing pressure when I shut it off. Checked under hood, no oil leaks and plug is still secure.
View 9 Replies
My truck gave me low fuel pressure and reduced pressure limp mode at 21,000 miles. The fuel and air filters were changed at 16,000. The dealer said all they found was the fuel filters (at 21,000) were what needed to be changed. Also, why does my truck hum??
View 14 Replies
