Ford 6.7L Power Stroke Diesel :: Plastic Oil Pan Leak
Dec 6, 2015
I had my truck at the dealer a while back while it was still under warranty and I told them that it was leaking around the oil pan. It was bad enough to coat the pan in oil, but no drips on the floor. They claimed no issue and sent me home. Well now my warranty is up and it's dripping on my shop floor. It is weeping out around the bolt heads.
I'm going to call the dealer in the morning and see if they will work with me since I did have it in under warranty for this same issue.
View 14 Replies
Advertisement
What it is or why there is a three inch pull handle hanging down on the bottom of the Diesel Tank on my niece new 2012 F350??? It is sitting hanging there begging to be snagged and ripped off the bottom of the tank!!!!! I'm at least going to Gorilla Tape it up to the bottom of the Tank.
View 10 Replies
Looks like now the radiator in starting to seep a little between the core and the plastic sides. Couple questions. Whats the best replacement that wont cost a ton. Would this have anything to do with the intermittent not starting when warm.
View 6 Replies
I have a 2011 f450 that I just bought and it has the plastic oil pan. I see that the newer 6.7 have the metal lower oil pan. Is there a good reason to change over to the metal pan? Is the 1/4 turn drain plug the problem?
View 13 Replies
I am having a heck of a time finding this coolant leak. It drips off the power steering pump. I replaced the upper radiator hose and the heater "y" hose that goes to the bottom of the Degas bottle. I recently replaced the lower radiator hose as well. So the truck runs normal. When the system is under pressure I do not see any leaks. But after the engine is completely cold it starts leaking a small puddle of coolant. Its appears to be coming from the power steering pump. But I am sure its something above or near it. This is on my 2005 Excursion with a 6.0. Can the water pump be going bad and leaking this direction. I would expect a water pump to leak straight down the middle of the engine. What to look for? The thermostat seal stays dry. but it has to be in that area. What is really messing with me is. When it is hot and pressured up It does not seem to leak. Only after it has been sitting for hours and cools off..........What the heck!
View 14 Replies
Crawled under the new to me 13 super duty last weekend to see this. Where it's coming from? Over tightened oil filter maybe? The filter in the picture is the new filter fyi. Old filter had a little oil on it. It's all the way across the back of the oil pan.
View 14 Replies
2007 F350... I noticed I have a small power steering leak where the master cylinder bolts onto the hydroboost. Is there a o-ring or seal between the two? or do I have to replace the hydroboost? Been looking online for a schematic but can't seem to find one.
View 13 Replies
We got "bad" gas in Feb, 2016, had to replace entire fuel system. Haven't driven the truck but 4000 miles. Last week, she started spitting and sputtering and lost power. We could see fuel pouring out. NO CEL. Towed (AAA has paid for itself several times over with this truck) to dealer that replaced the fuel system, still waiting to hear from them. Does this sound like it should be under the warranty for the work they did? We have averaged a huge repair bill about every 3-4 months on this truck, 2011 F250 Lariat, 8cyl, 6.7L, since we bought it 2 years ago.
View 1 Replies
Truck has a high oil pressure leak, only leak i have found is in the high pressure rail, I cannot get to it till sat, or sunday. So I have to let the oil cool before I can start. Any way testing to find the right temp for Oil to thicken enough to Build? I've been here for hours and its went from 180's to about 100 now...
View 3 Replies
I just had my 14 350 dually in for its 10k mile service. They told me I had a oil leak somewhere on right side of my engine. They cleaned it and put some die in it, told me drive and bring back so they can put uv light on it to see where it's coming from. I haven't had time to take back yet as I just started a new job, but I've put about 900 miles on it and it's definitely got a leak! I crawled underneath today and the oil pan right beside the oil filter is wet with oil. Trying to figure out what I might be looking at.
View 14 Replies
I have a 2003 6.0 and I am havi g problems with it stalling once getting up to operating temps. I found a leak earlier after the engine stalled, it was leaking pretty good around a drop every 2 seconds but stops once the engine cools down some. I noticed the oil dripping from under the oil pan.
Can this be the cause of the engine stalling? Or just another problem? If it can be the cause where can the leak possibly be coming from?
View 6 Replies
I've had a minor oil leak since I got my truck back from having the EGR, head studs, head gaskets, oil cooler done. It's gotten quite a bit worse lately to the point that I'm going to have to fix it. I added some UV dye and traced it up to the engine valley. All the leakage seems to be toward the back of the valley. Is there a common component that is prone to leaking in the valley that could be a starting point?
View 14 Replies
just picked up a 2004 (May, 04) F350 DRW with the 6.0 Powerstroke. I love this truck so far. After sitting in the driveway overnight, I noticed a decent sized puddle of oil on the driveway, probably the size of my fist. I took several pictures for diagnosis:
Any quick thoughts as to where this oil leak is originating?
View 6 Replies
I have a High pressure oil leak somewhere, and where it can be. I tore the oil rails out and replaced the nipple cup seals last night. I got it all back together and air tested it and sure enough a leak is present. I have no problem paying for your time (I always provide good beer). I can rebuild gas motors all day long, but these diesels has me thrown for a loop. The frustration I am experiencing is crazy at this point. All the injectors are new, and the dummy plugs and standpipes were replaced as well.
View 11 Replies
I was just outside and noticed a little puddle under the front of the truck. I crowled under her to find orange coolant on the seam of the radiater right above the drain. I thought maybe the drain was open a little but no, it was tight. I have 40000 miles on the truck.
View 14 Replies
Popped the hood after smelling fuel and it was dripping about every 30 seconds. Before I order parts can you steer me in what it might be. Was going to do blue spring mod soon but is there more?
View 4 Replies
I found out by accident that my vacuum pump is now running all the time. It's not the gray line to the heater valve and it's not the vacuum canister as I already checked the easy stuff. I need some direction where to start looking under the dash as I have never been under that part of my truck. Any common issues or where to look?
More information: The pump only runs all the time when the HVAC control is set to OFF or MAX AC.
View 2 Replies
I was spraying undercoating yesterday and noticed a trans leak, it looks like its coming from the top of the trans. Not a lot of fluid just enough to coat the trans on top. I tried using an inspection mirror but i still cant see the leak.
View 4 Replies
I got fuel running dn from top fuel filter it looks like an filter hasn't been changed in a long while what could have happen?
View 5 Replies
I'm working on an early 2004 6.0 currently. The guy was driving down the road when it cut back to nothing but an idle and now is a no start. In the four months it's been dead, they've been able to tell him fuel pressure is good and they found to broke wires. So watching numbers while cranking on it, ficm says yes, voltage is at 48, Icp desired was over 1600, Icp actual is just cresting 550-600 where the engine is just about to start. So that tells me it has a hpo oil leak. I pulled the oil filter and held down the valve and had someone crank to test low pressure just in case. So I pulled the passenger side valve cover and it's an 04 so no standpipe, it's a high pressure line, I capped the line off and cranked watching numbers and Icp actual climbed over 900 and she fired and ran, on the driver side of course. So this being an early 04 with no dummy plug or standpipe, the only hpo oil leaks left are the oil rail nipple o rings and the top injector o rings correct?
View 14 Replies
Well hear I am again fix one problem now I got another problem last time it was fuel now it's oil so what I got going on is a oil leak that looks like it's coming from on top the motor on the back I first discovered this nice surprise when I went into the store and came back out and seen two 8 inch round puddles of oil laying on both sides of the motor like I said at the back I thought rear main seal but upon further inspection it's coming from somewhere on top and rolling down both sides of the motor looks like near the turbo what could this be possibly a line or a check valve or seal or o ring on the turbo? Is there a common thing to go bad on these trucks to cause a leak in that area?
View 13 Replies
