Ford 6.7L Power Stroke Diesel :: Orange Engine Light On?
Jan 5, 2015
Engine light came on over the weekend, then went off and back on and off. All orange. Called My ford dealer this morning and they had me bring it down there for the day. Drove me home then picked me up this afternoon when it was done. Also had oil change and fuel filter change.
Scanned for codes found P202D Reductant Leakage and P20E8 reductant pressure to low found tsb 11-12-03 followed tsb and replaced reductant tank pump cleared codes preformed koer glow plug on demand self test passed and preformed reductant leakage test passed road tested to verified repair ok at this.
View 14 Replies
Advertisement
Truck was throwing that collect temp different than oil temp light then started to heat. When I drove temp went down. When I stopped I checked coolant t as low and left orange rust dust around and under overflow I have topped off but can't find a leak. I clean it and it comes back I have a leak somewhere? Head gasket? But oil is fine I drive my truck 200 miles no issues?
View 14 Replies
I have a knock ! (hoping its just an injector) No engine light, No drivability issues 190k Not there at start up, not there right after a drive. any thoughts?
[URL]
View 14 Replies
My low fuel light came on tonight. I drove about 2 miles, stopped and shut the truck off. When I restarted it and began to drive off to the fuel station a notice came on that isaid power reduced then a check engine light came on. I was about a mile or less from the fuel station so I filled up. I cycled the key but the engine light is still on. No low power message tho. The power is fine.
I came home and drained the water drain on the filter, didn't see any water but hoped it would solve the problem. I cycled the key a few times and started the truck but the light is still on. My truck is a 2013 f350 6.7 and has 211500 ish miles on it. I bought it a month ago with 18500 miles and haven't had any issue until tonight. My only thought is maybe the fuel filters need changed. I don't know if or when the previous owner changed them.
View 10 Replies
I started my '16 6.7 this am and drove it about a mile.
The check engine light came on and at the same time the display said "Reduced Power". I decide to turn around and try to make it back to my shop but shortly after turning around the display said "Low Fuel Pressure" and within a couple of hundred yards it shut down leaving me stranded by the side of the road.....
I called my local dealer who gave me the Ford Cares 800 number. I got a flat bed in about 1.5 hours which I didn't think was too bad considering I live in the country and they brought it to the dealer. The SA said it might be a couple of days before they could look at it as they were pretty busy... What it could be? The engine is stock with 9100 miles on it...
View 14 Replies
I have a 06 f250 king ranch with 6.0 . A few days ago my scangauge showed a code P0405
I changed my egr and after it showed two codes : P0405 and P0404
It still has a hesitation and loss of power , although better than before the Change.
View 3 Replies
So last night my check engine light came on so I checked by by turbo and seen this hose not sure where it goes?
View 7 Replies
Check engine light is on...not blinking. All fluid levels are good. Mileage is 10,700. No code displayed in engineering mode. Truck seems to be running fine..
View 11 Replies
Engine light came on today, so I stopped at autozone for a scan # 7 fuel injector offset learning at minimum .
So what is the cause and how can it be fixed ? a new injector, calling to make an app. in the morning.
I would like to know the answer so I don't get a BS story from the dealer then again its warranty work.
View 14 Replies
I found out today that the 2012 6.7 that I have purchased used with 30, 500 Miles on it a month ago has been in previously for warranty work. It appears that the previous owner took it in with a check engine light and after diagnostics found that the EGR cooler had "no Flow". Ford replaced the EGR cooler core under warranty before I bought it. (It now has 31, 950 on it). Normally I would think, GREAT, something I don't have to worry about doing. But being new to the diesel world, I was just wondering if this is something I should be concerned with. Anything else I should be keeping an eye on etc.... Also is this abnormal to occur with such low mileage?
View 14 Replies
I just replaced my batteries today on my 2011 F250 because of a no start situation. I guess it was about due since they were original and that gives me 5 + years of service and it happened in my driveway so I definitely am not complaining. However after I replaced them and started the truck the check eng lite came on....
View 8 Replies
If doing a EGR delete on a early 2004 6.0 will turn on the check engine light? I was going to leave the valve in place and harness connected, I was just looking to add durability to the truck so don't want to use a tuner but also don't want the engine light on, I seen conflicting reports that it may or may not turn on the light!
View 3 Replies
So I am happily driving my 2011 F250 Powerstroke and the water in fuel light comes on. I drain the filter and drive about 10 miles and it happens again. Drain again and 5 miles later the engine dies. Had it towed to my dealer who found an exploded high pressure diesel injection pump. They talked to Ford and found out that they needed to install an all new fuel system from the injectors to the tank! The bill was 18,000 and no warrantee. Bad stuff gets right by the filters!!! I have two of those trucks and since the dealer used exactly the same parts as the broken ones, it can happen today again.
View 14 Replies
I had a bad Glow Plug on my 2004 F350 6.0L Diesel causing the check engine light to go on. I replaced the Glow Plug and cleared the OBD2 error. The check engine light is off now, but I can't pass the smog check because EGR Monitor "Not Ready"
I put 100+ miles city/freeway miles on the truck, but I still get EGR Monitor "Not Ready" Even tried "Drive Cycle" with no luck...
View 5 Replies
My check engine light came on today and the code read P1335. What code is that?
View 14 Replies
CEL came on.. hooked up my cheap OBD/CAN scanner.. getting code P21B0..googled it and this is what i find: P21B0 - Reductant Level Sensor C Circuit High. What is this for? I've about had it with this truck..this having to replace a sensor every time I take it on a long trip stuff is getting ridiculous..2 EGT's, air charge cooler sensor, blower motor, and now this...
View 14 Replies
Check engine light is on says low turbo boost but gauge says it has a lot of boost. Only happened after I put catalytic back on for smog test. Before that no problem.
View 10 Replies
Well another problem with my 11. It was just at the dealer getting the fuel pressure sensor replaced and then it started throwing a different check engine light. Dealer says it needs a new EGR cooler. They said there is a TSB for this. I don't have the exact code it was throwing right now. I haven't heard much about EGR coolers being a problem.
View 4 Replies
A couple of weeks ago I got a service engine soon light and it turns out that the egr cooler core was bad. I had it replaced this week under warranty but now this has me thinking that maybe in the long run I would be better off to tune the truck. I had not even considered it until now, but this is a truck that I plan on keeping and I think that all of this emissions crap is shortening the life expectancy of the truck, at least without dumping money into it on a regular basis. Would this have been caused by anything that I have done? Am I not driving the truck hard enough maybe?
View 2 Replies
The truck was running great besides a little black smoke on WOT and a little jerk while towing. No codes at all. I pulled the EGR valve and got it all cleaned up and reinstalled. I also had time to pull the MAP hose and clean it. I pulled the nipple out of the intake and cleaned it also. I didn't unplug the sensor, just cleaned the hose. Now I am getting an engine light, the MAP gauge reads 2.9, and my turbo gauge is at 22.4 at idle. The truck isn't running right. What should I try first? I don't see what I could have done wrong but this is a pain.
View 11 Replies
I have a 2012 Ford F 450 turbo diesel dual wheel truck,my problem is an engine light came up on the instrument panel so i hooked up my scangauge and found the code P20BA I went further into the diagnostics of the scangauge and found nothing,i cleared the code and drove down the road and the light came back on could the sensor be faulty and if so does any body know where the sensor is located.
View 6 Replies
