Ford 6.7L Power Stroke Diesel :: New Oil Pan On / Rust In Fuel Filter
Oct 20, 2012
Well I finally had time to change out my composite oil pan to the metal one. Nothing was wrong with the old one but Ive seen the composite pans get hit by a rock and crack so I decide to get the metal one. It didnt take long once I had the oil drained and its very easy to get to. Once i had the old pan off I did find two piece of sludge stuck to the oil pickup screen, they had a sliver of aluminum in them. My oil reports have been coming back with high aluminum content so I am not really sure what to think being my motor had 33k miles on it now.
I also changed out the fuel filter and when I dropped the frame mounted filter I found about a teaspoon of rust in it. I'm not one to run my truck down to E but I admit I did so twice since the last filter change. Since I found the fuel filter kit for 60 buck(ford dealer wanted $140) I think I will move my fuel filter changes to 10k miles instead of 15k. Last but not least I also added SPE 6.7 Full Lock Diff Kit which allows the locked rear end to stay engaged past 20 mph. It was a simple 10 min installation with just a few wires and easy directions to follow
New oil pan
Composite pan
Old pan off and view of oil pickup
Two pieces of sludge that came off oil pickup screen
New pan on
Rust in the bottom
View 12 Replies
Advertisement
Changed fuel filters today. Now my water in fuel light is coming on. But the truck is not running any different no sputtering or anything. ????? Could this be human error
View 14 Replies
I have a very slow fuel drip off the housing for the fuel filter on the engine. Can't see where it's coming from. It started sometime after I changed the filter a couple of months ago.
View 5 Replies
Recently my 2011 F-250 Diesel with 21,000 miles seemed to start hard one morning. After starting the truck it ran well that day and started fine. The next morning it would not start. Had it taken to the dealer and they went to work. Started at the fuel filters and replaced low pressure fuel pump. Thought a piece of the defective pump had moved up fuel line. Removed high pressure pump and found signs of rust. All regular service intervals have been met. Didn't see this coming. No water in fuel light or other warning.
View 14 Replies
Within the last month I've had 2 cracked fuel filters the filter up by the engine...
View 12 Replies
While driving from SD to Chicago today 2 warnings popped up at the same time saying to change the oil and fuel filters. Had both done 2500 miles ago. Am I right that the Dealer just didn't reset these? I thought these were measured by miles and driving habits.
View 8 Replies
I got fuel running dn from top fuel filter it looks like an filter hasn't been changed in a long while what could have happen?
View 5 Replies
I was going to change the fuel filter on my truck yesterday, but couldn't figure out how the guard comes off. It has a bolt but it also has a rivet in it and looks like its all one piece so Id have to drill the rivet to remove. I tried to just spin the housing off.
View 8 Replies
While I was changing the oil yesterday, I also changed the fuel filters. The primary filter had some debris that was confirmed by a magnet to be metal. I have seen a little bit of this all three times I have changed the filters. The filter itself is very clean, but there remains a small amount of metal slightly more coarse than filings.
I don't really have any concerns that it could be coming from the HPFP because that is after the secondary filter and would not be returned to the tank. Also anything from the HPFP would have fouled several injectors by now. I don't even think there is any iron in the pump.
I guess it could be useful to put a magnet in the water separator reservoir, but I don't even know what good that would do since the debris is large enough that it is being caught by the filter and of course the secondary filter is even less microns. It would just be nice to know where in the world this stuff comes from.
View 14 Replies
Noticed change in power after changing the fuel filters on 6.7 .... Seems like it has a fuel restriction at times maybe even air somewhere in the line. Thought I felt the truck hesitate after hitting the gas and Cavitating when I hit the gas petal. Both new filters are motorcraft parts. I did follow the procedure after installing filters by turning the key on 6 times waiting 30 seconds in between. Could it be a problem with the fuel pump. I should say I didn't have this until I changed the primary filter.
View 9 Replies
Changed my filters and this was in the bottom of the filter housing. I looked on the pleats and down in the center didn't find anything. Went to two Ford diesel techs one said is was the hpfp and should do the the whole fuel system. The other said if the hpfp was coming apart the shaving would not be in the bottom of bowl and to check the filter again in 5k miles. No check engine light, drives great, no other problems.
View 14 Replies
Replaced both fuel filters same as usual. Cranked right up and I let her run while I put up the tools and look for leaks. Notice it started running rough, so I jumped in and started to back out of carport and it went dead. Ran battery down and it won't hit a lick. Replacement (racor) filter same as last few changes. Running just fine before change so it has to be something simple, but what?
2006 6.0 powerstroke
View 10 Replies
I'm dripping fuel on top of the engine at the fuel filter . Where the line ties into the filter canister , there is a small plate that's attached with small Allen screws its dripping between this plate and the canister .... I assume there is a gasket/oring that is causing it ...... What is the part number or correct description so I can go to ford dealer and get one.
2007 Ford 4X4. 6.0 diesel
View 10 Replies
This past week my wife and I took a short trip and returned on a gravel road. I went to start my truck the next morning and there was a puddle of diesel fuel on the driveway. When I looked under it, I noticed that the tip of the fuel filter housing is gone and is leaking slowly from there. I called the dealer and they would not fix it on warranty, the truck has 20k on it. The service man said he would not turn this into ford. I've had the similar problems with this particular dealer. It's obvious that a protective cover is needed for this. I kept the part and am thinking of sending it to ford.
View 13 Replies
With an AD2 and no HFCM, need to have a part number for just the top of engine filter? All I can find (Motorcraft, AMSOIL, Racor) are the dual filter kits.
View 4 Replies
Went and changed my fuel filters today... Primed the truck 6 times. Started it. Ran great, then got a low fuel pressure and reduced power notification. Turned it off. tried priming it 10 more times, no start, tried 15 more times. No start. Took off the outlet on the secondary filter, solid flow. Took off the return on the L/H fuel rail, pinched the line and put a hose on the rail... Once again solid flow. I can hear air somewhere under the hood but I don't know where... Driving the 7.3 to work tomorrow but this is driving me up the wall.
View 14 Replies
So I changed my fuel filters the other day.
All was tight and no leaks. Even ran the motor the customary few minutes and then went on an errand to lowes. So drove it a few miles. All good.
So just outside of town about 10 miles, third gear, up hill plenty of boost the inlet line on the filter let loose.
Sorta looked like I was driving on wet roads except I had all this smoke coming from the hood of the truck.
Pull over quickly so didn't loose much. That darn yellow quick connect had somehow worked itself loose.
Simple reconnect, check three times, wipe as much stuff up as I could and on my way again.
Not fun when trailer is in tow. So I suppose I lost a quart or two at most but enough to do some undercoating anyway.
Check those connections often.
View 9 Replies
Installing the diesel site fuel filter / water separator system for our 6.7's . And If so how do you like it. and your pro's and con's besides price.
View 4 Replies
I changed the fuel filters today and saw a couple of small pieces of what looked like aluminum or aluminum foil in the bottom. Nothing in the filter itself it still looked good. I will try to post pictures later but I'm not sure it will show up. I don't recall seeing anything the first filter change and this is the second. Is this normal?
View 2 Replies
I have a 2004 F-250 changed out both fuel filters and now can't get it to run. It will start up and run for about a minute then stall out. I have cycled the key/pump numerous times with no luck. When I look into the fuel bowl when I engage the pump it looks like it's pushing more air rather than fuel. It seems to be burning the fuel in the bowl and then stalling out. When I take the bowl cap off after it stalls it's empty.
View 14 Replies
Which is, Injector Control Pressure Too Low. First filter change on this truck. Purged the truck six times. No start. Purged it six more times. The truck started momentary. I've been purging for the last two hours. Now I have the code. What next?
View 14 Replies
