I have an intermittent noise that I believe might be transmission. Here are 2 recordings first with nose and second without. I haven't the mic behind the front wheel and I walk around the front to the passenger side.
[URL] ....
Got home from work this morning and noticed when I pulled in the drive and opened the door a ticking noise coming from under truck. Finally had time this evening to crawl under truck and investigate noise. It's coming from the front of the transmission where it bolts up to engine. It's a pretty much steady tick and goes away for a few seconds here and there. when you increase RPM's it's still there and I think goes away at higher RPM's, it doesn't get louder as you increase RPM's just stays the same level. Will get it to shop Monday hopefully and get this checked out and NoX sensor changed out too.
View 14 RepliesWhen the truck shifts into 5th gear i instantly feel a constant vibration and noise until it shifts to 6th gear. This happens nearly every time while driving at 40mph. Rpm range 1200 - 2000. I bought the truck new on June 30th and noticed the problem on my way to work on Monday July 2nd. Took it to the dealer on July 5th and the tech said it was the torque converter slipping. I drove it home because they didn't have time to work on it. Took it back on July 12th and the dealer has had it since (currently 30 days) They originally told me it was not the engine or transmission and it was an exhaust problem. Last week they said it was the motor mounts and said they would be done.
View 14 RepliesJust bought a used 2011 ford f350 with the 6.7 diesel engine. Coming from a 7.3 1999 f350 with 330,000 miles, still going good. Took a 1000 mile trip on the 11 truck with out pulling anything did good. Hooked my enclosed trailer to it did a trip of 900 down and 900 back. Transmission temps were staying around the 250f, almost in yellow on gauge. Highest it went was 255f. Light never came on. Yesterday on trip without trailer was staying at 230f on trans temp. This is the first concern.
Second concern, had antifreeze coming out the cap on the degas bottle. Rolled over the hood and hit the drivers side windshield. Stopped un did the cap, it hissed. Put 2 quarts of antifreeze in drove on, this at 300 miles of trip. Primary water pump went out, half way there, at about 550 miles of trip. On trip back, about 1600 miles of trip, antifreeze was on windshield again. Undid cap, hissed, did not need to add any to it. Drove on no problems since. Have bought a new cap and installed.
Transmission doesn't want to shift right when its cold. First starting out. When it warms up shifts great. That's third problem.
I was warming my truck up this morning and I turned my wipers on to get the bit of snow on my windshield off. The wipers moved a few inches, stopped, and a mechanical buzzing noise is coming from under the wipers. I can move the wipers with my hand and they'll go all the way up and return to the bottom, but do the exact same thing when they move again. I searched the forum but can't find anything about the wiper problem I'm having. I also see a lot of discussion about GEM in relation to wipers...
View 13 RepliesJust pu my new 2013 6.7 Diesel with 1300 miles... There is a most annoying whining coming from under the hood and sound like its coming from the secondary filter area or turbo (you can even feel it if you put your hand on the filter lines and housing) and it starts a minute or so after the vehicle has been running and you can her in the cab at 70-mph... At drive through restaurants I have to shut the tk down to place my order and never goes away..
[URL] .....
The truck always made a few strange noises after shutdown, but this is new and annoying.
Here's the scenario: Truck is warm and no CEL. A few seconds after shutdown, I hear all the normal(?) noises and then a noise that sounds like a vacume pump running starts and continues for about 20 to 30 seconds. Cycling the key, but not starting the motor will cause the noise to happen again and again on each key on/off cycle.
The noise seems to be coming from the top front of the motor. Could this be fuel pressure bleeding off? Is there a check valve that is maybe not doing it's job??
My dad has a 2012 6.7 powerstroke with about 84,000 kms on it. Truck runs great, works great, but has a noise that sounds like its coming from a pump of some sort on the engine. I know nothing about these trucks and told him I would see what I could find out before we take it to the dealer to see if its a warranty issue. Video below.....
View 4 RepliesA while back I posted a thread trying to fix a clicking noise coming from the front end on my F-350 dually when applying the brakes at slow speeds (under 15 mph).
While returning from our camping trip last week the noise is back again. It does not occur after the truck sits overnight or for a few hours. But after driving for 30 minutes or longer the clicking will return when I apply the brakes at slow speeds. I tested the rotor temps with a heat gun and it seems to start when the rotor temps get above 120 degrees F. So I removed the brake pads & calipers, regreased the slide pins, cleaned up the pads and applied some lubricant on the back of the pads. I also bent the pad clips so they would fit snugger/tighter in the slots.
Whatever I did seemed to cure the clicking while driving around this weekend. I made sure I got the front brakes nice and warm - up to 180 degrees or so.
When I did this same procedure a few months ago the clicking went away - but eventually returned.
Should I get some better clips? Replace the sliding pins? Pads? The rotors & pads were replaced this winter & the shop said they and the labor are still under warranty. But if they use the same clips - I'm concerned I'll be back to square one in a month or so.
So my 2013 is making a strange noise that seems to be coming from the front end when turning and going over a bump. While riding with the Service Writer, we also felt that the noise could be coming from the rear of the truck. I think it's two seperate issues, he mentioned something about the rear end noise being "body shift". So two questions:
1. What a "clunking noise" would be coming from around the steering column.
2. What the heck is "body shift"?
Fixing issues with my truck. I just ordered some latex surgical tubing and am getting ready to fix the rattling noise in my rear door by using the Epic's Door Seal Mod. Hopefully this will take care of that issue.
One more annoying noise though. Has there been any fixes to the buzzing window noise that is coming from the front passenger side. If the wind is blowing right and I'm running over 50mph, at times get a loud buzzing noise and really bugs me. Something is vibrating and at first i thought i had a speaker going out but found out that wasn't it.
I've called my dealer and informed them of this and asked if they've heard of this but of course they haven't and this usually means the won't do anything besides look for recalls or something. I have the noise recorded and scheduled an appointment with my Ford Dealer but again, they won't do anything most likely.
Well, last night I took my F-350 up a wheeling trail. I'd been up quite a few times in my old Rover, so I knew I could go a ways in without damage. Just uphill, muddy, and ruts / rock steps.
One thing I notice is that when you engage low range in the diesel, the transmission starts in 2nd gear. My previous gas Super Duties always started in 1st. I'm assuming this is to protect the transfer case from torque overload. Also, the throttle response seems to change when low is engaged (the pedal becomes less responsive, which is nice).
I've had the gas Super Duties off road before, and all of mine have had the locking rear diff. The diesel lugged along perfectly. My biggest fear was crunching the DPF / SCR / DOC canister on a rock step. In that respect, I'd rather wheel a gas. The manual shift function makes a lot of sense in low range - you can force a start in 1st, 2nd, or 3rd. And prevent meaningless up / down shifts since the grade can change quickly.
These trucks' biggest hindrance is their size. However, if you have the trail room, they are actually excellent off road. Many people look at a Super Duty and see a vehicle good only for pulling or hauling. Not so, these trucks are as good as a Jeep off road, again with trail room being the only concern. The locking rear diff was never really needed, but I engaged and disengaged a few times to keep the mechanism free. I really love this feature.
One thing that happens frequently for me in north-east wheeling is water crossings. Could be a simple brook but mostly it is mud holes encountered on tight trails. In some cases these are only a foot or so deep; in other cases they are 4 feet deep. Ford states to "try" to keep the water below the level of the hubs, which amounts to about 15". Aside from possible front axle contamination, my biggest concern would be the electronics on the diesel which are mounted to the frame or floor pan (transmission module, NOx module, etc.) The gas Super Duties don't have these concerns. In the old days, as long as a diesel had air, the engine would run under water. This engine requires electronic control of many things, including the injectors...so it won't. There are also some axle / transmission breathers which run about floor pan high to be concerned about, but these can be easily extended.
Maybe it's due to the twisty frame which GM loves to insult Ford about, but these trucks have excellent wheel articulation. I'd be surprised if a coil sprung power wagon flexed more, at least in the rear. I'm impressed.
Finally, the traction control. I experimented a bit on a slippery rock step. This was the only step which required the rear locker - sort of. The front wheels climbed the step, but the back flexed to the point of one rear wheel basically almost off the ground and severely unloaded. With 4x4 Low engaged, and traction control "off" as much as Ford will allow, the truck could not pull itself up. Turning traction control on allowed the truck to very nearly pull itself up. A little more throttle / finesse probably would have gotten the truck over, but lots of ETC operation glazes the brakes and spews brake dust everywhere. Being able to start in a higher gear manually really adjusts the torque control. Locking the rear end and the loaded wheel bit right in and she went up and over.
When doing some off-road driving, the "off-road" screen for those of you with the LCD message center is kind of fun and informative to watch. It's nice to see how far your wheels are turned left or right when spinning in ruts or what crazy angle your truck is on. Howie Long could probably document the exact up / down / left / right slope angle a Super Duty needs to be on in order for the tailgate not to open. I never had an reason to open the tailgate while in these crazy angles, of course.
Overall, very impressed. It's not as good as my old Range Rover, but I would say more talented off road than ALL other Ford vehicles except the Raptor.
I just purchased an 04 f-250 Lariat. It only has 103k miles. first time diesel owner. When I drive it, it shifts smooth as ever. BUT, when I need that extra power to downshift, nothing happens. Nothing raddles, it stays cool when it warms up. Again, normal driving behavior its fine, until it needs to downshift. I have two referred mechanics, but id like to get a little more info before I take it in.
View 14 RepliesHaving this problem, what to do to correct it? There is no hole in the boot and this just started about a year ago. Does not do it all the time.
View 4 RepliesI was wanting to drain my trans pan and refill with new fluid. I was curious what the pan capacity is. With my 6.0 I did the drain and refill every 10,000-15,000 miles depending on how hard I worked it in those miles. It always drained out bright red and shifted like new until I had a T/C failure at 278,000 miles.
View 4 RepliesNew to me 2006 F350 6.0 dually. Going to change oil and filter as well as the transmission fluid.
Should I replace the transmission filter on the Auto I have or just have Jiffy Lube do their thing?
I tow a car hauler that is about 8000 lbs. On my last trip occasionally when the truck would downshift into 5th under a load, it would bang in there pretty hard. Not a smooth transition, not every time just some times. Just wondering it that was normal or the start of a potential issue.
View 6 RepliesShot in HD as are all my vids, view in YouTube and force a 720p view to see better detail.
(Tap the title bar at the top of the video box; at YouTube tap the three vertical dots at the top right; select the quality gear icon; select 720p).
Over at TDS I did pictorials, some of which are in my TMT Facebook page.
What is the average temp the transmission runs at? Wondering because it slipped the other day and the fluid smelt like it was burnt almost. Wanting to monitor it on my scan gauge and just try to ride it out as long as possible..
View 14 RepliesSo, had a transmission fluid leak. Couldn't find the leak so I went to a transmission shop. The diagnosis is that a snap ring broke and resulted in a hole in my tranny, something about reverse gear pressures weakly designed snap ring.
Not too happy about this, being that I had thought that the transmission was the strong point of my truck... Is this common?
I just looked back and it has been since July 7th that my girl has been sitting in my shop. Well this past weekend I finally got her back together and started. It took a while to build pressure but she finally came to life..
While I am thrilled that she is running again i have low power before the boost kicks in and is idling rough with a blueish- white smoke coming out of the exhaust. Once i kick her a little she will get up and go but I've never had the smoke before.
I'm thinking maybe a bad injector???