Ford 6.7L Power Stroke Diesel :: Making Grinding Noise While Turning On Hill
May 17, 2013
a few times when making a tight turn on hilly terrain or a hill on a road, I've noticed a grinding sound in the front of the truck and a vibration in the steering wheel. I've so far chalked this up to the hill assist feature, but today I was on relatively flat ground in a parking lot with a dip in it. While crossing the dip in a tight turn, I noticed the same thing again.
I've checked the tires/wheel wells and there is no rubbing, etc.
View 14 Replies
Advertisement
In addition to significantly louder noise from the Turbo on start-up, we've started to hear a pretty concerning noise while descending a hill in Tow-Haul. Not sure that the T/H has anything to do with it other than getting the engine in a RPM range that causes the noise. We've taken it in and tech says "That's just normal noise"... What ever that is.
Here is a link to an example : Tow haul making a lot of noise in my F350 diesel. Pulling a very heavy horse trailer. - YouTube
Best next steps for a 64,000 mile 2012?
View 8 Replies
I recently replaced the front wheel hub and upper and lower ball joints on the the driver side of my 2004 f250 CC SB 6.0 fx4. Now when I put into 4 wheel drive I get a grinding noise that sounds like a worn out break pad from that side only. It didn't do it before and it only happens in 4x4. I have replaced the wheel hubs before and it was fine. Also The needle bearing race on the axle is good.
View 4 Replies
Wheel bearing go out? My left front just starting making noise and when turned by hand you can hear the bearings are shot. Called around this morning and with my luck its on back order and the entire hub has to be replaced since the bearing is built into the hub.
Anyways, I was wondering replacing this unit themselves and how long it took to complete? I was going to let Ford do the work but I figured I have never done a job like this and wanted to give it a try and looking at some Youtube videos on older vehicles it did not look that difficult.
If I find that its not difficult I will tackle the other side as well since I figure it is probably not long before that side is gone also and I would not want that to fail while I am out towing somewhere.
View 8 Replies
I have a 2003 F250 6.0l 4x4 with 230k miles. All of a sudden it seems that the fan is very very loud and there may be a very little lost of power. Also i just replaced the fan clutch not sure if that may have anything to do with it. What could it be. I need to get this fixed this week...
View 14 Replies
AC compressor makes a loud growling noise and lugs the engine briefly when engaged at idle and the truck has been sitting for weeks. After that initial grind, it works perfectly and makes no harsh noises. Can I replace the compressor bearing or should I swap out the entire compressor?
View 2 Replies
Ok here goes. I recently replaced the front wheel hub and upper and lower ball joints on the the driver side of my 2004 f250 CC SB 6.0 fx4. Now when I put into 4 wheel drive I get a grinding noise that sounds like a worn out break pad from that side only. It didn't do it before and it only happens in 4x4. I have replaced the wheel hubs before and it was fine. Also The needle bearing race on the axle is good.
View 2 Replies
I have noticed my truck makes a front end noise when I make turns, like from a main road to a side street. What seems to cause it is if there is a little dip or bump during the turn. The noise it makes sounds almost like a tire rubbing a splash guard or something. It comes from the drivers side. It he truck is stock with stock tires and wheels and has 4300 mi on it. I was maybe going to take it to the dealer...
View 14 Replies
My buddy has a 2011 250 and is having some weird issues with a clicking noise. It started out when you put the truck in gear (D or R) and touch the gas it would click. Seems to be coming from the middle to rear part of the truck. Now it clicks when he's driving. This all started after he got 35's and a leveling kit. It's taller springs in the front and added a block in the rear. It has less than 15k on it.
View 14 Replies
I posted a few threads about the P04DB code over the past several months. Last month while on vacation it came back and this time I was getting an engine light. So I finally got around to taking it in. The A/C blower was also making a clicking noise so I thought I would take care of both of those. At 41k and 42 months in service, the factory drive train warranty covered the CCV sensor replacement. The fan blower had to be replaced. So if getting that P04DB past 3/36, it is covered under the 5/60.
View 2 Replies
I've got a noise that I just can't find. Have replaced a bunch of stuff trying to eliminate this sound.. steering pump, both front wheel bearings, new pads up front, both caliper brackets and pins. Did a new turbo, verified the new pump is not air bound, brakes work, no noise with wheels up, lock to lock, pumping brakes the whole time.
Sound is prominent at 1400 RPM, does go up with RPM, seems sometimes to follow a steer to the right. When I shut down, not at full temp a clunk happens, like a mechanical stop. That clunk is less noticed once up to temp and it really started after the steering pump. Sparky came over, listened with a probe, says it's not the pump, my BIL and a close friend say the same thing.
Today, when I nailed it, rpm came on hard, tires smoked and when I let off quick, truck died, like something held the belt. It just slowed and died, restarted immediately.
Shawn listened to the transmission, says he heard nothing there either but did hear something above that near the back of the motor.
IPR is spot on 21.8%, ICPV is .80-.82 and [email protected] However, it has been dropping to lower numbers recently, saw 15.4% and it often sits near 19.4%-20.4% for periods of time. Tap the throttle, right back to 21.8%.
I'm at a loss. I've tested everything I can think of. I can power brake the truck, no trans slippage, it spins the tires easily around 10lbs boost. The A/C seems low on the charge, it is freezing the dehydrator and I added some freon, 18oz can, the clutch is not frozen. Turn it off, compressor stops spinning like it's supposed to. The tensioners are not frozen or squealing, water pump is not making noise, temp is 200 on the dot. Trans is full, no burned smell. Motor oil is fresh, filters clean.
It sounds like a grinding noise and I'm about to tear the cover off the HPOP. I'm at 150k now and know it will need replaced soon, I've spent $2500 in the last 2 weeks, but before I tear it apart......
View 13 Replies
One of the many things that impresses me about the 6.7 is how well it lugs...... it'll run right down to near 1,000 rpm in 6th gear and stay there till it absolutely has to shift. Like a diesel should. Well, recently, and now more frequently my truck is making some strange noises when it lugs down. It'll mainly do it if I'm towing light, like my flat trailer empty, or maybe if I have a decent load in the bed. But occasionally it'll do it empty. As soon as it lugs down low to 1,000-1,200 and pulls there for a few seconds you'll hear a couple squeaks, then a kinda chugchugchugchug noise. It immediately quits if you let off or make it shift down. It sounds like a turbo-related noise, but I don't really know. Truck only has 9k miles on it. I just know this is one of those things I'll take it back to the dealer and they'll give me the ol "we can't duplicate the problem here." What it could be?
View 8 Replies
Ok haven't been on here in a LONG time. Sold my '12 and bought a DRW '14 F350 to tow our fifth wheel. Just got back from a 775 mile round trip pulling our fifth wheel. My dad noticed my passenger front tire was going bald on the outside. I said yeah it was pulling to the right and thought my tire was low but when I checked it was the right psi.
Turning to the left I was starting to get a grinding type noise. If I rolled my passenger window down you could here something just grinding away but when you straightened out nothing.
So I took it into the dealer and they tell me the outside tire wear is normal. I said it has 22,000 miles and the passenger tire will be bald on the outside in 4,000 more miles or less. Said they can't hear any noise, yet my wife can hear it, kids can hear it and people outside the truck can.
It's not normal for the passenger or drivers tire for that matter to go bald in less than 25,000 miles? Tires have always been kept to proper psi, I've towed only about 5,000 miles total with it. They are also taking the worthless rancho rebranded shocks off and going with bilstiens. I should have replaced them 10,000 miles ago. They are horrible shocks.
It really torques me that they have it for a week and can't find anything wrong. When turning to the left it's almost like bump steer in 4wd just not quite as bad but with also a grinding sound that you can hear inside the cab and can feel it in the floor board. Nothing evident but just looking under the truck.
View 14 Replies
Yesterday it was running fine today only half throttle, going up a hill no power throttle push 12 down let off the throttle engine smooths out and starts picking up speed ....
EGR stuck????
CAC boots look good do not hear any leaks on the tubes
no smoke
ICP 675 at idle full temp, cold 1200
OEM filters with OEM caps
ficm 48.5 to 47.5
Can hear the turbo spool up
Oil temp less than 10 dec difference with water temp
No code showing up
141,000 2003 F-350 dually
View 14 Replies
While I'm cursing at highway speed everything is fine. But when u punch it it pass someone it's like I actually slow down, same from a red light. I've got a livewire programmer in it and this problem is somewhat new. It just seems to keep getting worse, I was going up a hill on the interstate this morning and at 2800 rpms I was actually slowing down. I'm not sure if the fuel pump is going out or if the transmission is slipping or what.
View 7 Replies
I have a 2003 6.0l... When I first bought truck, seemed to run fine. Since then truck has broke down on me once. I took it on a six hour drive, and couldn't turn vehicle off, because if so, truck wouldn't start back up until cool. After getting to my destination, fans seemed very loud every time I pressed pedal, and seemed very sluggish. Drove it a couple days and boost was low and fans continued to sound like they werre engaging even when I first started truck for the day. Had truck towed to shop, because it cut off on me when driving.
At shop : Truck had air filter, water in fuel sensor, o-ring for draining plug, new ICP sensor and harness, and HFCM cleaned up as it was filled with gunk.
After shop : Fans quit being so loud, but have not had near the boost I had before issues started. Truck struggles to go from stop, and around 15 psi boost gauge starts shaking erratically. Also, I have been losing coolant in a short period of time, and can't see any leak coming from anywhere, and also my radiator has been making a sloshing/gurgling noise and it will stop, then come back all within bout ten seconds. And I guess while I'm writing, I should mention the bucking after it downshifts in about third or fourth gear giving it gas makes the truck buck until the RPMs are above 2000 or it upshifts or downshifts, and at an idle seems to miss until warm.
View 14 Replies
2005 ford f250 6.0 Started making this noise from front about a month ago, can't figure out what it is. Only happens when letting off accelerator or changing from P - D. The truck acts normal, seems to be louder when the truck is warm.
[URL] .....
View 2 Replies
Was driving back home from shopping tonight and my truck was making a lot of noise when I tried to accelerate. I noticed the boost gauge on the dash was stuck at 35psi but the MiniMaxx showed 0psi.
No engine light so I babied it home which was about 30mins driving and managed to accelerate slowly to avoid the engine rattling. I didn't want to shut it down and restart in case it wouldn't start again for some reason.
When I got home I idled until EGT was <300F like I normally do (it never went over 700F when I was driving home) and then restarted it. The gauges worked fine, MiniMax showed boost and the engine revved freely with no rattling noise. I haven't taken it out for a road test, I'll do that when it's daylight.
Bad sensor somewhere? I would think if the turbo had failed it wouldn't have been fine after a restart.
View 5 Replies
Well, I last summer my fuel filter/ pump started squealing, and making vibrating noise, replaced the fuel filter changed the noise slightly, some times it would go away, sometimes the line going to the filter under the hood would vibrate, couple weeks ago truck warning light came on- "low fuel pressure warning" came on, hum... went out, came on a couple days later, then finally put me into limp mode, luckly only 1/2 mile from home... checked filter on frame/ tightness, it was tight, the pump on the filter housing was very noisey still, well, I figured 200 dollars cheaper than taking to ford....
I waited and pump arrived 3 days later, replaced it and low pressure warning still on, but pump was very quiet, and when I restarted low pressure warning and reduced power came on in driveway, hum.... I thought code was still in computer, I disconnected battery and turned headlights on to try and kill the code, started it and now the engine light came on, nothing else, and truck ran fine....hum.... went to autozone, and they pulled the code, low fuel rail pressure, p0087, guy said to drive and code should go off, truck runs fine. Drove truck a couple days and engine light went off, Truck runs great.......All is good.
View 5 Replies
Just over 7000 miles all of a sudden I got this loud grinding noise in the rear end like a brake locked up. Pulled into a parking lot. Don't think it's brakes. Put the truck in reverse it got even louder for a second then it quieted down after that. Naturally this happened on a Saturday.
View 6 Replies
Just bought my 2013 Platinum 350 DRW 2 weeks ago. 9,000 miles on it. I was cruising along yesterday at around 45 mph in 6th gear going up a slight incline. Truck was fairly low rpm don't remember what exactly. As I'm going up this hill it begins to shudder quite a bit almost seemed like the turbo shuddering while lugging up the hill at a low rpm in 6th. I stepped into the throttle to get it to downshift into 5th and it stopped. I never experienced anything remotely like this in my 2011 6.7.
View 6 Replies
