Ford 6.7L Power Stroke Diesel :: Lower Fuel Filter Housing Broke
Apr 25, 2013
This past week my wife and I took a short trip and returned on a gravel road. I went to start my truck the next morning and there was a puddle of diesel fuel on the driveway. When I looked under it, I noticed that the tip of the fuel filter housing is gone and is leaking slowly from there. I called the dealer and they would not fix it on warranty, the truck has 20k on it. The service man said he would not turn this into ford. I've had the similar problems with this particular dealer. It's obvious that a protective cover is needed for this. I kept the part and am thinking of sending it to ford.
View 13 Replies
Advertisement
I have a very slow fuel drip off the housing for the fuel filter on the engine. Can't see where it's coming from. It started sometime after I changed the filter a couple of months ago.
View 5 Replies
I've got a leak that appears to be coming from the secondary fuel filter housing (the one in the engine compartment)... It's not coming from the filter, but from the side, where there are 4 allen bolts that attach a fitting to the side of the housing...Can I change out the gasket for that piece? I've already tightened the bolts, but the leak persists.
View 14 Replies
I was twisting off the DFCM housing when I heard a pop and alot of fuel leaking. It appears I sheared off the 32mm plastic nut. I know for a fact that I was turning it counter clockwise just like the manual stated. Now what do I do? I cant run my SD can I? The simplest solution is to get another housing and install it but im not sure ill be able to get the remnants of the original housing off with out the nut to twist it. I watched Epics video on changing the filter and his came off with little effort? My same story just different result.
View 14 Replies
I have a 2001 f250 7.3l 4x4 and the fuel filter housing is leaking real bad from either the back or under it. I need to get info on parts that i would need as well.
[URL]....
View 5 Replies
I went to change the small filter that is mounted just behind the radiator and is inline with the 5r100 . with a socket on the bottom all i was able to do was flex the brackets going to the 3 mounting bolts as this thing is on there real good. Looking for examples on unthreading the bottom cup to access filter?
View 6 Replies
This pump hangs down fairly low and appears easy for ice and rocks to hit on my 2013. Something hit mine and took a chunk out of the drain tube. No leaks yet but I am looking to get a new one and keep this as a spare, or just JB weld it. Can I just buy the lower section, or do I need to get entire pump?
Any creative protection bracket made? Would just have to take it off to change filter though. Any leak in this housing is a major show stopper when in the middle of nowhere! Maybe why it is getting brought into the tank on new models?
View 6 Replies
Changed fuel filters today. Now my water in fuel light is coming on. But the truck is not running any different no sputtering or anything. ????? Could this be human error
View 14 Replies
I have a 2010 Camry and on Friday I got my oil changed at a local shop and while there the guy told me that they broke the lip off of the oil filter housing that I need to get a new one from Toyota before my next oil change. Said not a big deal right now but do before next change. My first mistake was paying for the oil change and not making them replace the housing since they are the ones that broke it. Well that night I drove about 150 miles and the next morning I drove 75 miles my car started making a odd noise when I would accelerate but not while I was just cruising. Then is just died while I was pulling into parking spot. Started it back and died again and just kept dying and not stay started. I check the oil and the stick is bone dry. There is oil all over everything under my car and had to pull it home on a trailer. Obviously the filter leaked all of it out, but my oil light never came on. Question is do you think there is damage to my motor? Do I make the oil changing place replace my motor so if it did damage I don't have to pay for it in a few thousand miles?
View 4 Replies
Within the last month I've had 2 cracked fuel filters the filter up by the engine...
View 12 Replies
Well I finally had time to change out my composite oil pan to the metal one. Nothing was wrong with the old one but Ive seen the composite pans get hit by a rock and crack so I decide to get the metal one. It didnt take long once I had the oil drained and its very easy to get to. Once i had the old pan off I did find two piece of sludge stuck to the oil pickup screen, they had a sliver of aluminum in them. My oil reports have been coming back with high aluminum content so I am not really sure what to think being my motor had 33k miles on it now.
I also changed out the fuel filter and when I dropped the frame mounted filter I found about a teaspoon of rust in it. I'm not one to run my truck down to E but I admit I did so twice since the last filter change. Since I found the fuel filter kit for 60 buck(ford dealer wanted $140) I think I will move my fuel filter changes to 10k miles instead of 15k. Last but not least I also added SPE 6.7 Full Lock Diff Kit which allows the locked rear end to stay engaged past 20 mph. It was a simple 10 min installation with just a few wires and easy directions to follow
New oil pan
Composite pan
Old pan off and view of oil pickup
Two pieces of sludge that came off oil pickup screen
New pan on
Rust in the bottom
View 12 Replies
While driving from SD to Chicago today 2 warnings popped up at the same time saying to change the oil and fuel filters. Had both done 2500 miles ago. Am I right that the Dealer just didn't reset these? I thought these were measured by miles and driving habits.
View 8 Replies
I got fuel running dn from top fuel filter it looks like an filter hasn't been changed in a long while what could have happen?
View 5 Replies
I was going to change the fuel filter on my truck yesterday, but couldn't figure out how the guard comes off. It has a bolt but it also has a rivet in it and looks like its all one piece so Id have to drill the rivet to remove. I tried to just spin the housing off.
View 8 Replies
While I was changing the oil yesterday, I also changed the fuel filters. The primary filter had some debris that was confirmed by a magnet to be metal. I have seen a little bit of this all three times I have changed the filters. The filter itself is very clean, but there remains a small amount of metal slightly more coarse than filings.
I don't really have any concerns that it could be coming from the HPFP because that is after the secondary filter and would not be returned to the tank. Also anything from the HPFP would have fouled several injectors by now. I don't even think there is any iron in the pump.
I guess it could be useful to put a magnet in the water separator reservoir, but I don't even know what good that would do since the debris is large enough that it is being caught by the filter and of course the secondary filter is even less microns. It would just be nice to know where in the world this stuff comes from.
View 14 Replies
Noticed change in power after changing the fuel filters on 6.7 .... Seems like it has a fuel restriction at times maybe even air somewhere in the line. Thought I felt the truck hesitate after hitting the gas and Cavitating when I hit the gas petal. Both new filters are motorcraft parts. I did follow the procedure after installing filters by turning the key on 6 times waiting 30 seconds in between. Could it be a problem with the fuel pump. I should say I didn't have this until I changed the primary filter.
View 9 Replies
Changed my filters and this was in the bottom of the filter housing. I looked on the pleats and down in the center didn't find anything. Went to two Ford diesel techs one said is was the hpfp and should do the the whole fuel system. The other said if the hpfp was coming apart the shaving would not be in the bottom of bowl and to check the filter again in 5k miles. No check engine light, drives great, no other problems.
View 14 Replies
Replaced both fuel filters same as usual. Cranked right up and I let her run while I put up the tools and look for leaks. Notice it started running rough, so I jumped in and started to back out of carport and it went dead. Ran battery down and it won't hit a lick. Replacement (racor) filter same as last few changes. Running just fine before change so it has to be something simple, but what?
2006 6.0 powerstroke
View 10 Replies
I've recently brought her back to life after a couple months of delayed loving due unforeseen reasons. And now the fuel gauge is completely under the E marking! I'm fairly smart and have looked some things up from other forums just trying to get a one on one response of that makes sense. "If were in the military you will understand" please break it down Barney style!! Not saying I'm dumb just want a good understanding
View 10 Replies
I'm dripping fuel on top of the engine at the fuel filter . Where the line ties into the filter canister , there is a small plate that's attached with small Allen screws its dripping between this plate and the canister .... I assume there is a gasket/oring that is causing it ...... What is the part number or correct description so I can go to ford dealer and get one.
2007 Ford 4X4. 6.0 diesel
View 10 Replies
With an AD2 and no HFCM, need to have a part number for just the top of engine filter? All I can find (Motorcraft, AMSOIL, Racor) are the dual filter kits.
View 4 Replies