Ford 6.7L Power Stroke Diesel :: Jump Starting With Dual Batteries
Jan 16, 2017
If I'm giving a jump:
Assume I hook positive and negative cables to the respective terminals of one of the two batteries. The alternative would be hooking positive cable to one battery and negative cable to the other battery, or does that make 24 volts? I'm also assuming if it is just the one battery, it does not matter which one you jump from?
If I'm receiving a jump:
I assume positive cable to positive post of one battery and negative cable to a good ground under the hood somewhere? Again, does it matter which battery I use? I wonder where a good ground is on this crowded diesel engine and aluminum body. Front radiator supports?
View 14 Replies
Advertisement
I have a 2000 watt inverter and I want to connect it to my 2011 F250 Super Duty. Which battery do I connect it too. This will only be used every once in awhile.
View 12 Replies
This is my first dual-bat vehicle. 2011 F250 with ~60K. Dual alternators. Bought in August of 2010. One battery(passenger side) was leaking pretty badly in ~2012 and was replaced under warranty along with the harness as it was corroded.
Yesterday, I drove the truck quite a bit on ~20-25 mile trips and left idling during a couple of them while inside Home Depot. No indication of any trouble.
Today, would not remote start, and when I put the key in and turned it to the on position, the dash lit up for about 3 seconds but once it started waking everything up, it all went dead. Start results in a faint click. I got 11.2V from a trusted meter. I've got my 20A charger hooked to one side right now.
Is there any special trick or attachment procedure to charge a dual battery setup? What about jumping off? Does one bad battery cause both to "act" bad? If I can determine which battery is causing the issue, am I safe to replace just that one, or should I get two new batteries?
View 14 Replies
Got the single controls with my 2011. How hard is it to change to dual controls?
View 6 Replies
Got two brand-new Motorcraft batteries installed about a month ago and truck has been cranking great. However, the last couple days in the mornings the truck is starting slow and dragging as if the batteries are going bad. It does crank pretty quick but just has a noticeable starter drag now. Since I have no way of diagnosing the batteries with a tester over the holidays.
What are the odds that brand new batteries are going bad? I was thinking this is a starter issue since the drag is most prominent in the morning but it does it throughout the day while I'm driving driving on each start. But it's not as bad as the first start-up.
I hooked up a scan tool (Forscan and Dash Command) and the only trouble code I received that something to do with the turbo boost pressure fault, it was a code P1247. I don't see how a turbo boost pressure fault, low pressure, could have any starting related issues but you never know. Just a note this code only came up on my FORScan Lite app but it did not come up on the dash command app so I'm not sure if it's a legitimate code.
So I'm back to a battery or starter issue. Is there a way that I can check without much equipment to detect whether not I have a starter or battery problem. I do have a battery charger but no other equipment.
View 14 Replies
I have a 2013 F-350 with the 6.7L. I pull a 36' 5th wheel with a Swivel Wheel motorcycle on the back. So I'm pretty heavy. Plenty of pulling power, but going down hill, the automatic braking doesn't work anywhere near as well as the exhaust brake I had on my '96 F-250 with the 7.2L. Considering installing the BD Dual Vane Exhaust Brake. Looking for feedback about installing the BD DVEB. How well does it work?
View 2 Replies
My batteries go dead over night, had them checked but they say there good, can't figure out what's causing them to die.
View 8 Replies
My 2014 350 DRW has a battery problem......If it sets for a couple hours, it won't start. With a jump from a very small battery box, it starts right up. I charged it last week for 4 hours and still when in OKC it would need to be jumped at each restart. Do I have one of the batteries going bad.....
View 6 Replies
I didn't drive my truck for one day and the batteries are died. This is the second time this has happen. That is a pretty fast drain time. THe truck only has 2500 miles on it. And I;m talking the batteries a dead dead. I hate having to take the truck to the shop. Just a big inconvenience. And it only happens about three weeks apart. I bet that would be pretty had to find the problem.
View 5 Replies
About how long do batteries hold up in this truck? I ask because in my 06 6.0 it was an annual event 2 batteries and an alternator.
View 14 Replies
In the last 2 months I've replaced my starter and 2 new batteries. I've tested the alternator and it's fine. What more is there? I'm guessing the FICM is going to crap. If I attach a scangauge 2 to it now would it tell me if that's the problem?
View 14 Replies
Is there a way to check to see battery health with Dashboss? I know I can check charging system, but is there a way to monitor if the batteries themselves are going south on me?
View 5 Replies
I have both a hydraulic dump trailer with two 12v batteries and an RV trailer with two 6v batteries to supply 12v. Both trailer's batteries are wired to be charged from the tow vehicle if the TV is equipped with a charge line.
Does the OEM 7 pin connector on a 2005 Ford 6.0 F250 CC 4X4 have a charging line on it? If so which terminal / pin is it?
What gauge of wire is it and how much amperage will it deliver to the connector? For testing, when is it hot? When the truck is running only? When the key is on? Is it hot all of the time?
View 11 Replies
I ve been noticing that the alternator isn't charging correctly, or at least it seems like it. We drive short trips sometimes two times a day, a mile or less. One day, night actually, I noticed it started to not turn over with it's usual enthusiastic sound. When the batteries get discharged to a certain point, the voltage at idle will be less than 12 volts. If I rev the engine for a bit, the volts jump up, but at idle it drops back to 12 or below. Seems to me that it should be at least 12v or above if the batteries are discharged, and more towards 12.5ishV if the batteries are fully charged.
After I put it on a 6A charger overnight, the voltage upon starting is above 12, sometimes over 13. But if the batteries start to dwindle down from short trips, the voltage drops to 12 or below at idle.
I did install the smaller pulley a few years back, and that worked massively. I couldn't get 12V at idle before installing the smaller pulley. But now it seems like I'm back to that same situation before installing the smaller pulley.
So, I m guessing that a alternator bench test is in my future? The batteries are fairly new, tho they have been down to nothing at least twice from boneheaded moves by yours truely!
And, I'm speculating that this charging situation contributed to the recent FICM replacement that I went thru.
View 14 Replies
1st to 2nd fine 2nd to 3rd it jumps a few times like it cant find the gear and you will see it on the video. I am confused what it could be. the truck received a new solenoid last year from ford because the tow haul light was flashing and now i have this issue. I believe it is also the reason the truck is running much slower down the 1/4.....
Video : F250 shifting problems - YouTube ....
View 2 Replies
I just bought the batteries I was asking about in this posting. Bought them at auto zone on my lunch hour today, they swapped them out right there in the lot, no problems. Watched carefully to make sure terminals were not crossed, etc. When I came out of work a few hours later, the #20 fuse for door locks was blown. I chalked it up to the battery change, and put a new fuse back when I got home. I come out an hour later to leave, and the fuse is blown again. I have not replaced it again, need to go get more of the proper amp rating.
No other changes to the truck other than the battery replacement. And that's the only anomaly. No other problems, nothing. Getting ready to head cross-country on a skiing trip, this Friday, so there really is no time to get to the dealer to get this looked at.
View 6 Replies
I have a 2006 F250. Past two winters my batteries have died. Last yr., bought 2 new batteries and a new alternator. This winter, battries have been replaced twice. I only drive the truck maybe once a week, about 5 miles total. I live in Indiana and we have had many sub zero temps this yr. Its been in the shop all week, the mechanic states that they are finding an extremely small draw but cannot find where it is coming from. The mechanic is wondering if I am driving it enough. Any thoughts on this? Also my batteries came from auto zone, the mechanics thought it was bad that I had bought them from auto zone.....not sure if that should even be a factor....
View 14 Replies
I went out to start my truck yesterday which is a 2004 F350 6.0 Diesel. It wouldn't crank over so of course I tried to jump start it and it fired right up. Went to town while I was there got 2 new batteries and put them in went to start truck and again nothing but will only start when jumped even with new batteries I'm guessing there is a grounding out issue. Where to start?
View 1 Replies
Just a quick question but is it normal for the ICP voltage (ICV) to jump around a lot at idle or while cruising or accelerating? Started watching this pid and not sure what's normal and what's not.
View 13 Replies
I'm relatively new to the 6.7 engine , I have a 2014 F-350 SRW with aprox 51,000 miles on it. Normal driving I see about 8 to 10 psi of boost even under moderate acceleration although at times it will go to about 18 psi at WOT and it does this with heavy loads. At moderate acceleration the boost will jump to 10 psi quickly but immediately stop there and sometimes as the RPM"s increase boost pressure decreases. Only issues I have had with the truck was a clogged EGR cooler.
View 2 Replies
2003 F250 crew cab 6.0 ... Where are the main problem areas on the ficm wiring harness truck will start and run great at times and at times it just start and misfire lope jump and buck it has to be a short I've changed the icp and crank / cam sensors some days it runs fine had issue with alternator replaced it.
View 10 Replies