Own a 2011 6.7 diesel, 59K mileage, short bed 4 WD. Was driving at 70 mph and noticed my instant mileage display read 0. Usually I see a instant mileage reading of at least 16. No regen was in progress. Steady gas throttle. Display could be changed to other screens. After a few minutes it came back. But it jumped to 16 and did not ramp up.
View 3 RepliesI am going along and the power just goes away. Sometimes it is a 50% loss other times it is an 80% loss. I hooked up my scanner and found an IPR code. I replaced the IPR and connector, nothing changed.
As the scanner info shows the Duty Cycle and Pressure track about identically until something goes wonky. When I loose about 50% power the pressure will not get above about 1500 psi but the duty cycle will run up to 60%. Other times when I have a bout an 80% loss the pressure and duty cycle both track low, no more than 1200psi and about 20%.
just picked up a 2012 F-250 6.7 XLT. I won't be driving the truck too often, probably no more than 5000 miles a year, and was wondering how long can oil last time wise. I would wait for the change oil indicator to come on, but was wondering if it's takes a year or so or what. Was probably thinking changing it out once a year regardless of low mileage. I have the service plan from my dealer for 3 years which they threw in but it's for 7500 mile intervals so maybe I can work something out with them. Def love the truck and now I hate having to drive my other vehicle as dailys.
View 9 RepliesA month ago I changed engine oil, oil filter and both fuel filters. All replacement filters are Motorcraft and my mileage is off a solid 2 mpg after the fuel filter replacement.
View 14 RepliesI just bought my first diesel truck back in November. It's a 2005 F-250 with the 6.0L and the 5 spd torq-shift automatic tranny. Last weekend I drove the truck to South Carolina, about a 600 mile round trip from where I live. On the trip the truck only got 13 mpg! I wasn't towing a trailer and the truck was empty except for me and my suitcase. It's not loaded up with mods or anything, it's completely stock power wise.
I'm extremely disappointing, especially since a friend of mine has a 2006 F-250 identical to mine and he gets up to 21 mpg on his. What can be done to improve my mileage? I'm not a lead-footed driver, and the trip was done with almost all interstate and highway driving, very little driving on back roads or stop and go. If this is the best the truck will get, I'm going to sell it and buy a F-150!
I've been told that manually unlocking the front hubs on my '15 F350 dually, might just improve milage. Any concerns about the axle lubrication from being unlocked for extended periods of time? I rarely need the 4WD.
View 9 RepliesOn my monitor, when I really get on it, I see the boost come up nicely and then when it gets to about 22 -23 lbs, it drops to zero on my monitor display, but the engine does not seem to falter in anyway. Why or what I might do about it?
I find it very annoying and do not believe it should be doing so, thus figure it might be causing some other problems or so. ..? I hear others talking about seeing 24 and up boost being displayed... why not me?
I cannot believe outside temp is not available on 2015's...I don't see it on any screen or in the manual.
View 13 RepliesI know that when you are in the manual mode you can see which gear you are in on the right hand side of the small display between the speedo and tach (forget what that display is called). Is there a way to configure that screen so you can see which gear you are in while in "Drive"? With six gears to go through and these things shifting so smooth, I just think it would be nice to be able to tell what gear you are in at any particular time (especially when towing). -Glenn
View 14 RepliesI have my check coolant message on my display again... I need to get the fuel filters changed so I'm thinking of having the coolant flushed too. 45,500 or there abouts on the ODO.
View 9 RepliesHow do I change the Oil Life display to show a percentage? The owner's manual isn't very clear on this. Presently it shows "OK" until it wants an oil change. The bride's '13 Explorer shows the Oil Life as a %.
View 9 RepliesMy truck started to display exhaust filter clogged and cleaning exhaust filter multiple times today. The cleaning exhaust message stayed on until I hot OK and then it comes back later. Not sure what this means?
View 14 RepliesSo for 4500 miles since new my truck has been displaying, on the right side of the instrument display in the center dash, the actual gear the truck is in. I would shift from park to drive and move out and the truck would display what gear it was in by placing a lighted box around the gear number as it shifted 1-6. Now that display is gone. It's not anywhere. If I go to the manual mode it will display that, but the normal numbers from 1-6 , bottom to top , are gone.
View 14 RepliesWell, at a little over 10k I have my first issue. My monitor displayed a Tire Pressure Monitor Fault. All tires are OK. Light won't go out. Guess it just earned a trip to the dealer.
View 14 RepliesI came across a post where someone said it was possible to add a gauge/setting to the blank "gauge display" screen. I've searched and searched but can't find the post. Ho to add to the gauge display blank screen.
View 14 RepliesWas driving the last week and happened to look down and notice the display for my climate controls was completely black. They were still running at whatever I had them last set at but couldn't change anything or turn the system off. Pulled into a parking lot, turned the truck off then started it again and everything was working fine.
Couple days later, was driving down the road again, glanced down and now my climate display, stereo display and odometer display were all black but once again everything was still functioning, just couldn't change anything. Turned my wipers on to check those, heard a little click, and all the displays popped back on like normal???? Wipers worked just fine too.
I'm assuming a short somewhere but wouldn't even know where to start to look or if it's even within my limited skill set to try and track down.
New 2015 King Ranch. Has the navigation screen where it displays the outside temp. Just watched a youtube video where another 6.7 truck had their ambient temp displayed on the dash screen between the speedo and RPM gauges.
Also going under "gauge mode", it shows tranny and engine oil temp, move over one position it shows compass, and move over third, it shows nothing. What this third position is supposed to be for?
My 2015 F350 6.7 has 13,400 miles and displayed the check coolant additive warning as I pulled into town from an 850-mile round trip this weekend. If the radiator in 2015 is still the same as the one used in 2012 etc discussed in another thread?
I will call my local dealer tomorrow. I do not see any obvious leak at this point. I had the oil changed before taking the trip and assume all fluid levels were checked.
Brought my truck (2012 F350) for recall service for one of the faulty exhaust temperature sensors. It took them one week to replace the sensor (!), then when I came to pick it up I got: "Trailer Brake Module Fault" message on the display.
I have never seen this message, since I own the truck (I am original owner). The service adviser said it will take a minute to reprogram the module and took the truck back to the shop. Came back after a while, saying that it didn't work and I need to leave the truck, so another technician can work on it tomorrow. Tomorrow came and I got the call that they reprogrammed the module, but the message still shows up, so they need to work on it (another day!).
As of now they still don't know what is going on. Apparently they broke something while replacing the EGT sensor and how to fix it.
2005 6.0L F250 Lariat. I picked up a couple weeks ago. The message center in the gauge cluster will only show my mileage (kilometres) and engine hours but nothing else.
Also the three buttons/controls to the right of the steering column don't do anything. I checked the wiring behind the dash and it's all plugged in... The other problem is the SRS light will flash on and off while driving.
How does one clear the computer to prevent the display "Check Coolant Additive" from appearing every time I start the truck. I know that a chemical test is needed to determine the status of the coolant.
View 2 Replies