My 6.7 makes a humming noise when i shut down my engine. Starts a little loud and gets softer at the end. it last maybe for a minute. But here's the catch if i stick the key back in the ignition it stops and as soon as i pull it out it starts again.
View 4 Replies2011 F-250 Lariat with 38,000 miles. What is the cause or source of humming or buzzing noise from the under the hood that starts once I turn the truck off and close the door? Lasts from 3-4 minutes and only started noticing it in the last two thousand miles or so.
View 13 RepliesSo I changed my fuel filter today and everything went as planned. I replaced it with a Ford OEM filters. I drained the filter housing under the truck by turning the yellow thing 1/4 turn. I then used a wrench and changed the filter. I put the new gasket on there and and tightened back down until it mechanically stopped. I then changed the one under the hood. I then did the bleed procedure 10 times and the truck fired right up.
Now for the reason with the post. I am getting a humming noise from the lower filter. I can find the issue. The yellow thing if fully seated closed and the housing is tightened as far as it can go. Under the hood, both lines are snug and on there properly. I can't figure out what is causing the humming.
The truck fires right up and the noise seems to go away, but I get the humming noise each time I turn the key on. I know something isn't right. I drove the truck around the block and didn't get any codes, but I have to drive it tomorrow and I don't want to risk damage to the truck.Thoughts on things I should try?
So with the hurricane coming to my house I did the balljoints on my drivers side yesterday to prepare to evacuate today. Everything went smooth with no problems. Now fast forward to the drive to Orlando, I hit a bump going 65 and my front right side (ball joint replacement side) starts humming. I pull over and it stops, get out see nothing obviously wrong and start back on my way with no noise to speak of. It happened again and again I just slowed to almost a stop and it went away. Yesterday after the repair I took it on a trip through some crappy roads, the freeway, and all that to ensure she was safe with no problems. Maybe it is the bearing failing all of a sudden (it looked fine when I took it off). I have had a vibration at 55 consistently i think is the tires now that I replaced the ball joints (was waiting to have the tire shop check balance until after the repair) maybe that could be it?
View 3 RepliesI have 2003 f250 6.0, had the turbo rebuilt and I put it back in, my turbo is whistling but I'm also getting a humming noise kinda sounds like a when u down shift at high rpm's idk what's going on, I try and power break as well to build up boost and the tires do not even spin...
View 4 RepliesMy 2011 6.7 just started making a hum noise after shutdown. I've read that it might be the wastegate solenoid. Is there a TSB for this. My truck is tuned so hopefully my dealer will be tuner friendly.
View 14 RepliesI am working on a 2007 F350 ambulance for a volunteer fire department. It run great, even with the key turned off sometimes. This is an intermittent problem. About every 10 times it is used the engine will not shut off when you turn the key off. The instrument cluster turns on and off as normal. The other odd part is if you leave the key in the off position when the engine does not turn off the RPM starts going up. I have not left it in off long enough to see how high it would go. It does not have a remote start and never has.
View 6 RepliesAfter I shut off my truck, about 5 to 10 seconds later it sounds like a compressor or small motor is running, and it runs for about a 50 to 60 seconds. It seems to do this even if i turn the ket on and off, sometimes. What this is.
View 2 RepliesOk this may be the norm, but I'm hearing something like a motor running after i kill my engine? It sounds like a fuel pump or something!!! O ya I have a 2011 6.7. I've had the truck for several months but just now hearing this....
View 11 RepliesI do not think, I have seen anything about the engine shutting down descending a steep grade. first it threw the "wrench" warning and than that the engine was going on limp mode. luckily no one was on the road with me, coming or going. i pulled off on the shoulder with part of the pickup and 5er on the road. no steering or brakes used the 5er brakes to stop. turned the key off and restarted it again and no code or warnings. like nothing happened. it happened twice today between yellowstone park and great falls, mt. the second time the engine light stayed on and i had to stop and turn it off and restart it and it went away.
View 14 RepliesThe EMS service in the county next to ours lost one of it's new trucks for a few days on Tuesday. While going on a call, the engine made a tapping sound for only a few seconds, then a loud pop and shut off. Ford dealer went and picked it up and took it in for evaluation. VERDICT: Broken rod and cracked block. I have to say, this is the first I've heard of a 6.7L having a problem like this in our area.
Ford was really interested in this engine, as a new one is already on the way and the old one is to be shipped back for complete breakdown. So far, the Director and County Manager have been impressed with Ford's response to this problem. Dealer has told them the truck should be ready by the middle to end of next week. If I hear anything else, I will let you know. Any engine can break at any time, I'm just glad they are moving quickly to rectify the situation.
Having that flash on the dash? Truck was running fine and the buzzer when off and dash said I think -- when safe stop and shut off engine immediately. Scared the scr-p out of me so not sure if that was word for word. Jump on the binders and got it off the road and called a wrecker. Now it's at the dealer waiting for them in the morning. Checked oil and don't see any leaks. Now I have lost my confidence in the truck. 42000 miles on it.
View 14 RepliesMy 2011 is making a strange humming sound after shutdown. It seems to be related to the normal waste gate sound. I have a video....
View 12 RepliesI am having an odd issue that i don't want to turn into a bigger one.
When I am sitting at a stop at idle and have the brake pressed i hear a humming sound and the pedal vibrates but when I am moving an press the brake it doesn't do it. Ive checked the pads all around they're fine brake fluid is fine it didn't start doing this till a few days ago.
I am just trying to figure this out before i end up going down the road one day and go to stop and have nothing there.
I just recently bought a 2011 powerstroke f250 and while running I can hear the fuel pump humming pretty loud. Is this a possibility that it's going out? Or is this normal?
View 3 RepliesNot sure, it doesn't seem to me the dreaded fuel pump problem. Was driving on highway pulling my 5th wheel after going though the toll both it never went out of 3rd gear and motor started taping pretty bad, turned tow haul off and it shifted up. All along never seemed to lose power, as I was looking to pulled off high way and into A park in lot it started losing power then just shut off. All along this 2min ordeal the motor was knocking/taping. Seems to me like the motor blew.
View 14 Replies2003 crank no start, 196k bone stock truck egr still in truck and stock head bolts. Replaced the icp sensor and ipr sensor, both from ford. What happened is I got fuel then about 15 minutes afterwards my truck acted like it was going up a hill and was just losing power and shut itself off. ficm tested 48.5 volts all 8 injectors tested good and there is oil pressure. Had an egr fault code but I'm at a loss.....
View 7 RepliesLast November I forgot to plug my truck in and it got down to 0, my girlfriend tried unsuccessfully to jump start it. When I got home I jumped it and got it running. I took it down to a heated shop to troubleshoot the glow plug circuit. I discovered it was not getting 12v to the glow plug relay. Also I started it and tried to back it up in the shop, when put in reverse it killed the engine, not lugged it down it was like you shut the switch off.
Also I discovered if you turn the lights on it kills the engine immediately. It will not crank with the lights on either. So far I have replaced the computer,ignition switch,batteries, and cam positioning sensor. Now comes the weird part!! I decided to get it running and pull the bulbs out of the back up lights I pulled the drivers bulb first then the passengers side bulb. When I pulled the passengers side bulb it killed the engine.
It is not my daily driver so it still sits in my shop. I have a hunch it's a ground issue but I've checked and cleaned up all the grounds I can find and it still has the problem.
I just got 500 miles to empty message. On my next trip out I grabbed a 2.5 gallon at my local auto parts store. When I had 99.9 percent of the jug in, it actually started to spit back out. I got the rest in and figured I was done. It did seem strange that it only took 2.5 as I figured it was just about empty to get this message and 2.5 would only take me half way. Anyways, a few trips later and the message is still there. Do I have a bad level sensor or was it spitting out prematurely? Shouldn't 2.5 gallons have killed the warning even if it didn't fill it?
View 14 RepliesI have a 2005 f350 6.0 and it has a startup kit installed. When I start by using the key works perfect. But won't shut off by key! I have to use the stop button on key fob to kill the engine. I'm thinking relay might be stuck? And the relay on start up kit is working? Key removed it doesn't diesel down, it runs like key is still in.
View 12 RepliesJust to give you a run down on my truck. It's a 06 F-350 4x4 supercrew 6.0 with 78,994 miles. The trucks has been studded with Apr and aftermarket head gasket, Powermax turbo with a wicked wheel, RCD EGR delete kit, 5" turbo back MBRP exhaust, Driven Deisel regulated fuel return system, high REV valve spring kit, EBT sensor, 58volt swamps diesel FICM, edge evolution, within the last 4000 miles New oil cooler, crank sensor, cam sensor, IPR valve, ICP, batteries and lift pump. I think I'm missing a couple things but that's the layout.
Now for my problems recently took the truck to Florida from Illinois towing a 8500# boat. Before I left I had the oil cooler changed, Rotella T6 5w40 ,New filters And 2 bottles of REVX. The try k didn't miss a beat on the 1300 miles trek down. It sat for 3 days before coming back up lite truck. I was gonna drive straight thru and with 1100 miles down and 200 to go the truck acted like it was running out of fuel and died at 90mph. Fuel Gage read 1/2 tank to go.
After letting it site a 1/2 hr it finally fired back up and drove 5 miles before doing it again. This went on 3 more times. I even limped it to fill up the tank thinking the gauge was bad. Nope did it again And called for a tow truck. This was in mid october and 20 miles ago. Since then I've replaced fuel filters, lift pump, IPR, ICP, cam and crank sensors, sent the FICM in to have tested, replaced batteries. No the problem is worse. It Now has created a serious miss when it's cold till 90 then it Idles smooth but keeps dying on me like it did when it was towed.