Ford 6.7L Power Stroke Diesel :: Dirty Exhaust Pipes / How To Clean
Jan 15, 2014
I haul a 5th wheel camper about every other month. The rest of the time, my truck is a commuter mobile. On one of the camper forums, the guys were talking about how clean their 6.7's run and how their exhaust pipes are clean. Well, the last time I camped, I walked around the campground looking at exhaust pipes on 6.7's. Most have clean exhaust pipes. Mine has dirty exhaust pipes! Does this mean mine is not running properly or is it the way I drive? Anything to be concerned about?
View 14 Replies
Advertisement
Is there any good product recommendations to clean the caked on carbon build up on the exhaust pipes? I want these pristine shiny again.
View 14 Replies
We have had our Ford 6.7 diesel for a week today and on the way home I am pretty sure it did a regen. It flashed up and said "clean exhaust filter, then the miles per gallon dropped to down around 11 from 15.5 rather quick. The truck smelled really hot and we drove it for about 35 miles to home and MPG started going up and now it's ok. The thing that stumped me was that the truck only has 620 miles on it vs 6.7 miles it had when we bought it last weekend.
View 11 Replies
I've been having frequent, low speed, short trips lately and have been seeing the 'Cleaning Exhaust Filter' message pop up. Given that I have only been mere minutes from my destination in each case, I thought 'good luck with that'.
Today I see the 'Drive to Clean' message, followed by the 'Cleaning Exhaust Filter' message which stayed on (I have been used to it appearing for only a second or two.)
It should all be fine tomorrow though as I have a longer trip planned.
View 6 Replies
I am at 34,600 miles and had the oil changed yesterday afternoon. My son picked the truck up for me and on his way home the "drive to clean exhaust message" came on with the "check engine light" at the same time. I get home from work, re-check owners manual and no mention of the check engine light coming on with the drive to clean message.
I called my service rep and he says drive it as per owners manual, so I head out drive about 45 miles, averaging 60 mph nothing changes, both lights/messages are still on. Truck seems to be running fine and the last cleaning exhaust message was Sunday and I believe I was out long enough for it to do its job. It will go into the shop tomorrow, but was looking for thoughts from the the rest of you pros before I go.
I mention the oil change only because after the last oil change at around 30,000 miles I drive to work 2 days after and my water pump starts leaking.. coincidence I know.. but getting freaked out as I approach 36000 miles..Truck is a 2011 and I bought it new in Jan of 11.
View 14 Replies
Well at 200,008 miles it's time to change my newly leaking EGR pipes. Is there gaskets that goes with these parts? difficult to install? Part numbers? no "installation kit".
View 14 Replies
My '04 F250 6.0L has 220k on it. I've had the EGR serviced several times and, unfortunately, the intake manifold boiled out in one of those services.
The engine light is on now and I've got "EGR Performance Problems" just below 2000RPM most of the time but not all of the time (runs better when warmed up)
I've been unemployed for quite sometime so I'm going to have to make this fix myself.
First question, of course, is should I plan to clean or replace the valve?
The second is how to clean the manifold chambers (? right word? The carbon accessible when the EGR is removed. I've seen people on YouTube scraping them with what looks like brake tools. Is there an appropriate tool or chemical?
The third question is is it going to be very difficult removing an EGR valve that may have carbon buildup on it? Too difficult for an aging seldom mechanic to think about tackling?
I guess those are good starter questions. I didn't know until today that EGR cooler may also be part of the problem. Unlike many of the people who post here, I have not kept good repair records. I don't know when I last had my EGR valve replaced at the Ford dealership but it was probably 50,000 miles ago.
View 12 Replies
I got this hankering to re-do my exhaust while my truck is all dissembled. My true dual has been a mistake since day one. It never gave me that deep growl that I wanted, and I miss my old cat back. Anyway I thought of an idea that would give me my one muffler back with plenty of air going into it. Check out the pics, and let me hear it. I will be leaving the pipes coming out of the headers alone, that way I don't have to buy doug thorleys expensive y-pipe.
View 2 Replies
I've topped up the DEF and the warning is still showing that I'll have reduced engine power within 45kms.
Its weird, just yesterday it showed 550kms to empty so I added one full container, all day it kept showing less and less kms' til empty. Warning lights and bells etc.
This evening topped it completely and still shows. Is there a way to reset it without having to stop at the service dept.
View 14 Replies
Say I just purchased an 06 f250 crew cab with the 6.0.
I had her trailered home due to dead batteries. I got her started up and drove about 5 miles until she got up to operating temp.
When I came to a stop and tried to accelerate, she immediately bogged down and started studdering with white smoke coming from the exhaust.
I shut her down and started her up again. She started and idled fine, but as soon as I pressed on the accelerator, she bogged and studdered again. I shut it down again and started it back up. Normal idle, and I shifted her into gear and was able to mozy on idling forward without having her bog, but as soon as I touch the accelerator, she bogs and studders.
I towed it home and the next day (today) she started just fine and I shifted her into drive and moved it forward about 10 feet. Did not touch the accelerator so she didn't big or studder.
1. I am guessing the white smoke was coolant burning through a failed EGR circuit. Do you seasoned members agree?
2. It the a check engine code when studdering. I have yet to check codes so I am still in diagnosis mode.
3. I plan to block off the EGR pipe and throw in a new oil cooler. Anything else immediate I should be considering??
View 14 Replies
I have an exhaust smell in the cab of the truck. It is pretty strong. Seems worse when it is really cold outside and goes away when outside temps warm up. I checked the tube (passenger side behind engine) and did not see any soot.
View 12 Replies
Was cold this morning, -15c, and I remote started the truck and then left home about 5min later. I could smell exhaust in the cab. I read some of the other threads about this. How can I tell if it was doing a regen? I have an Edge Insight. Is the a parameter I can display to know the regen was active?
View 14 Replies
Looking for if it would be okay to tune my 6.0 with the SCT SF3 tuner with the stock exhaust, I measured it and the stock exhaust is 3 and 5/8 inches...
View 5 Replies
yesterday I went out started my truck and white smoke started coming out my exhaust so I turned it off waited a bit started it back up let it run for a bit smoke went away drove it about 60 miles. Later that night it did the same thing but I was 2 gallons short on coolant drove it another 60 miles ran fine. Next morning decided to take it to a shop put more coolant in it drove maybe 20 miles to shop got there turned it off everything was fine never over heated once. So this shop is now telling me my trucks hydro locked and I steamed the EGR valve. And there telling me it's gonna be $8000 to fix it .
View 3 Replies
Last winter I pulled something and getting out has been difficult. Climbing in my F 350 even tougher so it hasn't been used much. Now that I'm driving a bit I have not seen it regen. Truck stop regenning, is it possible? What happens if it just stops? It use to regen every 200 miles or so and I have been paying attention.
View 7 Replies
I'm at 76K miles and I had another exhaust sensor go bad. This time the check engine light came on and the truck did not shut down. I was prepared this time and had an extra sensor / code reader handy.
It was the last sensor in line and very easy to get to. It took me less than five minutes to complete the job. I did use anti seize, but as easy as it came out it probably wasn't necessary.
View 14 Replies
I can't get my exhaust manifold bolts off. They are in bad shape. The 10mm is too loose and 3/8 just rounds. I have had the torches on them too! Can the bolts be cut off with a torch?? Haven't broken any. Can't get the bolt heads to move. It's an 04, original manifolds. I am working the driver's side. I can't figure this one out. How to get this manifold off?
View 4 Replies
How difficult is it to change the passenger exhaust manifold? I have just finished replacing the left exhaust manifold. The biggest issue was rusted fasteners and inexperience. Have torches. Any you tube videos show the left manifold being changed but not the right. I do not have a hoist and work in my driveway. Is the right side more difficult and should I leave it to someone with a hoist?
View 4 Replies
So for the first time in a while I started my truck when it was cold outside, 33 degrees according to the truck. It didn't do this at initial startup but when i started driving there was what i think steam coming from the exhaust because it dissipated fairly fast. It steamed slightly until i went to pull out of my neighborhood and got on it to get up to speed which was only 45mph. The oil temp was in the 90s at that point but when i got on the pedal the truck just started pouring white steam out of the exhaust.
Over time the truck warmed up and the steam stopped and everything was fine. Even when its warm outside the truck blows something when its not at operating temp but when its warm I can only see it at night when there's headlights behind me. Since I've had the truck the only thing that I've had to replace was the radiator because it was leaking coolant and even after that i still smell burning coolant occasionally and sometimes when i check my tank its low and then sometimes it never changes. Its very inconsistent.
The only other bad thing that's happened to the truck happened after i got my oil changed for the first and last time at NTB. They replaced the filter when they changed the oil but didn't pull the old gasket off when they put the new filter on and long story short i lost about a gallon within 30 minutes because of that and had my truck towed home. My engine light never came on or anything. I fixed the problem, added new oil and that was it. The reason I bring up the radiator, the coolant, and the oil is because i don't know if that could have anything to do with the steam.
View 10 Replies
I want to get rid of the stock exhaust and run a 4' or 5' exhaust all the way back. Will I still need to use DEF? Completely remove the whole system.
View 9 Replies
I just looked back and it has been since July 7th that my girl has been sitting in my shop. Well this past weekend I finally got her back together and started. It took a while to build pressure but she finally came to life..
While I am thrilled that she is running again i have low power before the boost kicks in and is idling rough with a blueish- white smoke coming out of the exhaust. Once i kick her a little she will get up and go but I've never had the smoke before.
I'm thinking maybe a bad injector???
View 3 Replies
