Ford 6.7L Power Stroke Diesel :: Decreased Power Message Across The Dash Info Center
Nov 2, 2015
Got a Decreased Power message across the dash info center today and was limited to only around 5lbs boost. I stopped and pulled the codes and here is what I found:
P054E - Fuel Quantity lower than expected
P1249
P1247
P0471 - Exhaust pressure sensor range/performance
P02D7 - Injector learning @ max
P0402 - EGR flow excessive detected
I dumped the trailer and limped home to change the fuel filters. I could only go 35mph on the flats and 10mph on any kind of up hill slope. I switched out the filters, purged the air, fired her up and cleared the codes, all seemed well. I backed out and went for a test lap around the neighborhood, as soon as I turned the corner and rolled on the throttle and reached 35 the message came back and the codes returned. I will be towing it in to the dealer tomorrow for diagnostics.
View 5 Replies
Advertisement
A couple of weeks ago, had a weird thing happen. When turning left at slow speed there was a click sound that came from the upper part of the steering column (similar to the sound you got with the indicators on in the old super duties when turning and it would go over the clockspring). It hasn't repeated the noise since.
Anyways, a week or so after this, I happened to try to use the buttons for my message center to reset my odo, which I rarely use. Didn't work. In fact all of the 5 buttons associated with the message center on the left side of my steering wheel are not working, but the cruise control buttons are. The buttons on the right side of the steering wheel are also working fine.
I am not sure if the noise in the steering column is related (but it has me suspicious...), or just coincidental, but wondered on peoples thoughts to diagnose. I pulled off the cover over the steering column, all the wires in and out of the clock spring look fine, I haven't pulled the switch yet (need to look at the service manual to make sure I don't break it as I do it), but wanted to see what was the diagnosis.
View 4 Replies
Dealer forgot to reset oil life warning oil change. I cleared it in the "settings" but then "oil filter" and "fuel filter" warnings came in and won't clear. How do I get rid of them?
View 3 Replies
2015 F350 6.7L, 43,000miles
My family and I were driving into West Virginia this morning when the reduced engine power message came up on the dash and the truck died. I coasted off to the side of the road as best I could and got out. Immediately I smell diesel fuel. I look under the truck and there is fuel all over the passengers side frame and when I keyed it back up fuel started spraying down by the right front wheel.
Pulled the fender liner back and saw a small rubber hose that looks like it came off of a tee fitting down by the egr components. I tried to get it back on but wasn't able to get it seated 100% and when I tried to restart it blew off again. Truck is completely stock and ran perfect right up until it died.
View 3 Replies
I called my servicing dealer and he was unaware of the message or how to check/test this. He also did not think it was a warranty issue.
View 14 Replies
I am towing my 5th wheel RV trailer and just started out on my journey. I've driven 350 miles. I stopped for a breather for about two hours. Now my truck won't start and a low oil pressure indicator beeps in the message center. My truck is a 2011 F250 super duty 6.7ltre diesel. Recently had oil change and fuel filter change.....
View 14 Replies
2005 6.0L F250 Lariat. I picked up a couple weeks ago. The message center in the gauge cluster will only show my mileage (kilometres) and engine hours but nothing else.
Also the three buttons/controls to the right of the steering column don't do anything. I checked the wiring behind the dash and it's all plugged in... The other problem is the SRS light will flash on and off while driving.
View 2 Replies
Got the upgrade done this week to allow manual regen. Instruction sheet says 'press the 'Info' button until 'EXH FULL XXX%' illuminates. Not sure I have that button. I've scrolled through everything in the info center and am seeing nothing under any menu item that gets me even close.
View 14 Replies
is there anyway to adjust the brightness of the lcd info and nav displays. I know the light dimmer adjusts it but not in relation to the gauges, if I turn the screens down enough I can barely read the speedometer. is there a way to adjust just the screens?
View 3 Replies
I have seen this pop up on the truck I think 3 times now over the first 4000 miles on the truck.
Usually it's when I'm on the highway around 70mph or so.
It comes on for a few seconds, then goes away. I do have an exhaust / tune on the car.
View 8 Replies
I haven't had any issues with this truck before but last night I pulled out onto the highway and my check engine light came on and a message saying engine power reduced I finally got it to reset after 4 times of shutting the truck off, was wondering what this may be without knowing the code. I tried plugging my edge cts into it from my 6.0 but it wouldn't communicate guess it needs a update trucks a 15 f350 with only 30000km.....
View 2 Replies
My low fuel light came on tonight. I drove about 2 miles, stopped and shut the truck off. When I restarted it and began to drive off to the fuel station a notice came on that isaid power reduced then a check engine light came on. I was about a mile or less from the fuel station so I filled up. I cycled the key but the engine light is still on. No low power message tho. The power is fine.
I came home and drained the water drain on the filter, didn't see any water but hoped it would solve the problem. I cycled the key a few times and started the truck but the light is still on. My truck is a 2013 f350 6.7 and has 211500 ish miles on it. I bought it a month ago with 18500 miles and haven't had any issue until tonight. My only thought is maybe the fuel filters need changed. I don't know if or when the previous owner changed them.
View 10 Replies
So I just went on a vacation pulling my horse trailer (first time leaving the state with this truck) and at about 5 hrs into the trip I had a message Reduced Engine Power and went from 70 on the interstate to 10 miles an hour and slowing rather quickly. I ended up shutting it off and restarting and it came back just like normal. I found the nearest ford dealer and they put the computer on it and it showed absolutely nothing, no codes and nothing wrong. The mechanic reset some things and we went on our way.
Then I ended up getting a check engine light saturday. I found someone to read the code and it came up with P164A which is an O2 sensor, he was able to clear it and I put on probably 50 miles today and no check engine light. I have about a 10 hour drive back home. Still debating if I take it to ford near here if they will do anything now that it doesn't show a light?? I hate to chance getting broke down on the highway with a truck that will basically shut down like that?? It just doesn't make sense to me.
View 7 Replies
I have a 2011 Ford F250 6.7 Powerstroke. It has 107,000 miles on it.
The other day I was driving it down the highway and it got a Reduced Engine Power message on the dash. It lost power and I got off the highway to the service road. Then it died on me.
Had to get it pushed to a station then towed home. It wouldn't start. The starter cranks over for a few seconds but engine won't start. Checked all the fluid levels and batteries. My DEF fluid was only a half gallon low.
What I have noticed is that the DEF level indicator hasn't reminded me that it was low for over 4-5 months now. I had been putting in about 2-3 gallons every 3 months or so. But it hasn't reminded me lately and I just forgot. This is my first diesel.
View 5 Replies
I've got a 2005 F350 that i recently did balljoints, tierods and shocks/stabilizer on. Just stating that because i don't believe anything could be binding up to cause this.
If i am to take a left turn, more than 45 degrees, the truck will seem to lose power assist on the return to center and be very stiff when i return it by force until i jerk the wheel past center and let it come back the other direction and it seems to regain power assist.
Also, the steering is just generally bump. I have not driven a better condition 2005 to tell the difference but i'm sure this isn't the way it's supposed to be
I am not having any issue with braking force, as of yet. The first winter i got the truck i blew a power steering line that goes from the gear to the cooler, in which direction i don't know. It's been a year and a half since then so not sure that caused any failure.
Before this symptom the pump would whine when on left turns only, no problem turning right if i feel like doing right turns the rest of my days. I guess what i'm getting at is, does this sound like a bad pump? Bad gear? Both?
View 14 Replies
Ive changed all relays underhood cause i could not find info on which relay is which, checked all fuses under dash. Checked to make sure up stream on 4x4 fuse position has power. And i checked for power at 2 wire on transcase no power at 2 wire, i am also finding no power at back of dashswitch.. Looking for a wiring diagram that shows complete esof schematic
View 14 Replies
Stopped at the store, came out, started truck, ran for two seconds, shut off, hasn't run since,had no codes,or any other issues. I have checked all the fuses,breakers,main power supply off of passenger battery, still nothing. I have head and taillights, power points on dash, dome lights, chime for headlights. 79674 miles.
View 6 Replies
I am looking for a source for switched power under the dash. I am going to wire up power to my TST507 TPMS but I would like to have switched power. I have a bundle of wires all capped off under there but no idea if any are switched power. I thought I would ask before trying to probe each and every one.
View 7 Replies
My truck gave me the message that "DEF under 1/2 full", so since we are on the road, I stopped by a dealer and picked up 5 gallons of motorcraft DEF. I did not want to get the countdown message in an unfamiliar area and have to look for it. While going out site-seeing, I forgot and left it in the back seat of the truck for about 8 hours in the heat of the day. I know you are supposed to store it under 86 degrees or so. Now, did I just ruin 5 unopened gallons or is it still safe to use?
View 9 Replies
I have a 2010 F350 that has been throwing the "tire pressure monitor fault” on the dashes info center. Here is where it started. I purchased new wheels, tires and sensors a few weeks ago. I put them on and they were fine on the way home because I assume that the stock ones where still being read (they were in the bed of the truck). Put the old ones in the garage and then while driving to work the next morning I got the message. I tried to reset or “learn” the new sensors that night with no luck. There are two ways to get my truck into learn mode. One uses the hazard flashers then releasing some of the tire pressure until the truck horn beeps. The other method is a series of break pumps and turning the ignition from on to off then using the TPMS tool that apparently comes with the truck.
The truck went into learn mode every time with either method but it would never recognize the new sensors. After attempting everything on the sensors I checked to see if for some reason the trucks actual monitor was in a “fault” mode. Last night I tried relearning the old stock sensors with great luck. They all were recognized… for about 10 minutes. After getting them to work I left the shop I work at and on the way home the "tire pressure monitor fault” came back again. So just in case something had been in sleep mode when I did it I pulled over and reset them once more. Again with great luck… until this morning on the way to work again it went back to fault mode even with the stock wheels still in the bed.
View 1 Replies
10,178 miles and no oil change message yet.
View 14 Replies
