Need to know the Ford part number for cab light wiring harness? I am wanting to install some LED cab lights but I do not currently have any so I will need the wiring harness.
View 3 RepliesAs it turns out my entire dash needs to come out to repair the HVAC so thinking while it's out I should add the diesel supplemental heater. What's involved with this? I need to replace the entire HVAC plenum so imagine the version with the supplemental heater can be bought instead. I know it's an 1800W electrical heater so my main question is the wiring harness on a regular truck setup for it or do I need to change the harness. And then I suspect the HVAC control module would need to be reprogrammed as well.
View 13 RepliesFirst I lost the power window functionality in the rear left door... didn't think too much of it, then I lost the power door lock functionality, which was bad because I was assuming my door was getting locked when it wasn't actually. Pulled open my door this evening and found this:
I think my truck overheard me when I was saying "I like a good electrical problem, those are my favorite." I'll solder it up to get it working tonight, and then I'll see what a new harness costs... although really they should have used ultra-fine-strand wire with silicone insulation for an application that sees lots of flexing.
My multimeter's test leads are such an example of wiring that is intended to see lots of flexing.
Looking for an electrical schematic and or wiring diagram of the windshield wiper circuit for a 06' Super Duty?
View 5 RepliesI need to connect a remote start stop for a bucket truck attachment to this new 2016 F550. Found everything except the ignition wiring harness diagram. Need to know what I can tie in to.
View 4 RepliesWhere I can get the head light to fog light wiring harness..it is almost as hard as finding the holly grail..... 2001 f350 7.3 .......
View 9 RepliesI am going to add some led's to illuminate the steps getting into my truck at night. I plan on putting them directly under the door over the steps. Is there a wire under the door threshold I can tap into at each door? If so what color? If not, where to get the power from. I want them to turn on and off with the interior lights when doors are opened.
View 1 RepliesMy 2000 f350 has wires that dont match anything I've seen. I need to mate this to an 08 harness so I need to be accurate. I have
(2) yellow. I know this is 12v constant
(2) green/purple I know this is 12v constant
(1) red/black
(2) solid red
(1) solid black
(1) gray/light blue
I have a 2000 Ford F550 7.3. I bought a Superchips programmer to read the codes on my truck and up pops this P1316, so I did some research and found out that the most common problem is the injector wiring harness. I bought new valve cover gaskets and the injector wiring as well because the truck is old and I figured new wires wouldn't hurt.
So after installing the new wiring harness and gaskets I'm still getting this Code! The truck idles rough and serge's sometimes, also there is a lack of power and some shaking between 40 and 50 miles per hour, however form 50 to 60 MPH seem's to be just fine. I don't trust the "Mechanic Shops" around here and will only take the truck in as a last resort.
Where to connect my new Recon cab lights to? I pulled the side piece off of the dash and looked for an empty plug but didn't see any. Is there one in there somewhere? If so what does it look like and what color wires do I use?
View 10 RepliesWhere I can find a wiring diagram of the inside and outside lights on the 6.0s? I'm trying to wire up my running boars lights to my dome lights and tail lights but don't know the colors or locations of the wires. The tail lights wouldn't be as hard to find as the dome lights, what is the location and color of both.
View 14 RepliesJust wiring up some light on the front and want to activate the relay off my high beams.. Where the best place to hook into... I'm running it off number 1 upfitter switch. But also want it connected to the high beam switch as well.
View 12 RepliesIs there a difference between the two harness #'s here besides the first number:
3C3z9d930aa
4C3z9d930aa
Are they the same part? Is one for a different model truck than the other?
Is it possible to add the decent control if my truck didn't come with it? Is the harness already wired for it and the computer programmed for it or would I have to get it reprogrammed and get a new harness?
View 6 RepliesWill a 05 injector harness work on a early 04?
View 1 RepliesHave a 2010 Lariat crew cab and I just bought an upfitter switch set and relay harness. Found where to mount the relay block and have been able to get the switch panel installed in its home. For the life of me though I cannot find the plug in the main harnes under the dash to plug the relay harness into to power everything up. I've read several threads here and even found the drawings that indicate plug #C215 in a diagram for the 2011+ trucks. When I get access panel out and look underneath the dash where it should be....no spare or open plug. Is the plug location diferent in 2010 from the 2011?
View 2 RepliesCould a leaking passenger side glow plug harness cause a "hot no start?
View 5 RepliesI'm really struggling to get this sucker off my 2014 6.7 F350
it says in the ford manual to lift the plastic tabs then pull off, I did that easily with 3 on each side, but the end plug on each side (the one closest to the windshield) does not seem to have a liftable tab (it looks different to the others as its at the end of the cable)
I've almost broken it but not quite, its over $300 for new harness, ouch
I do have the odd little hook tool they sell for this, it worked with the other 3 for sure, but I've spent ages on the 4th on each side and cannot budge either of them
Got a 2003 6.0 that seems to be leaking from the glow plug harness. How hard would it be to just replace them? I've heard that trying to remove these things can be a pain because they almost always break. But if I'm just going to replace them who cares right?
Is there anything I need to be careful about? Or can I just rip em on out? Also I've noticed two different styles of harness should I replace mine with the other style or just keep it the same? And yes those valve cover nuts are loose. I'm aware
Replace the tft but still the problem, someone cones the number part of tft sensor harness, and as replace , 2006 f350 4x4....
View 2 RepliesMy fathers truck had the tail lights go out the other night so we checked the fuse and the bulbs both good. Took it to ford and they found that a wire harness in the front left wheel well had rubbed through and needed replacement. I went and checked mine and yup it was rubbing through the wire just not all the way yet. Might want to take a look. It is at the top of the well near the coil spring. I will get the camera out tomorrow in the daylight and take a picture of the location.
View 13 Replies