I changed the fuel filters today and saw a couple of small pieces of what looked like aluminum or aluminum foil in the bottom. Nothing in the filter itself it still looked good. I will try to post pictures later but I'm not sure it will show up. I don't recall seeing anything the first filter change and this is the second. Is this normal?
View 2 RepliesThis is my first personal diesel so first one I've done maintenance on.
Bought the truck with almost 15k miles, it now has just over 16k and I changed the filters when I noticed the underhood filter was the original 3 port style.
There were some very small particles in the DFCM. Maybe dirt from dirty fuel nozzles?
Guessing this is nothing to be worried about?
Changed fuel filters today. Now my water in fuel light is coming on. But the truck is not running any different no sputtering or anything. ????? Could this be human error
View 14 RepliesI was going to change the fuel filter on my truck yesterday, but couldn't figure out how the guard comes off. It has a bolt but it also has a rivet in it and looks like its all one piece so Id have to drill the rivet to remove. I tried to just spin the housing off.
View 8 RepliesNoticed change in power after changing the fuel filters on 6.7 .... Seems like it has a fuel restriction at times maybe even air somewhere in the line. Thought I felt the truck hesitate after hitting the gas and Cavitating when I hit the gas petal. Both new filters are motorcraft parts. I did follow the procedure after installing filters by turning the key on 6 times waiting 30 seconds in between. Could it be a problem with the fuel pump. I should say I didn't have this until I changed the primary filter.
View 9 RepliesOK what is the trick to changing the oil filter on the 6.7 without making a mess. My last truck, which was another brand, if I would let the truck sit for a couple of hours, I could get the filter loose, put a zip lock bag around the filter, & remove the filter without any drips. With the 6.7, even if I let the truck sit overnite, it seems like the oil doesn't drain from above the filter, & as soon as it comes loose my hand gets a bath. Any tricks to changing the oil filter.
View 14 RepliesNew to me 2006 F350 6.0 dually. Going to change oil and filter as well as the transmission fluid.
Should I replace the transmission filter on the Auto I have or just have Jiffy Lube do their thing?
I am changing fuel filters for the first time. I started by draining the DFCM into a quart container, but after that filled up 6 times I switched to a bucket. So far I have drained over 2 gallons and it shows no signs of stopping. Initially the truck was on a slight incline. That's the way I have always done fuel filters, with the tank lower than the filter. After the first gallon came out, I rolled the truck down to level ground.
View 14 RepliesI was twisting off the DFCM housing when I heard a pop and alot of fuel leaking. It appears I sheared off the 32mm plastic nut. I know for a fact that I was turning it counter clockwise just like the manual stated. Now what do I do? I cant run my SD can I? The simplest solution is to get another housing and install it but im not sure ill be able to get the remnants of the original housing off with out the nut to twist it. I watched Epics video on changing the filter and his came off with little effort? My same story just different result.
View 14 RepliesI have a very slow fuel drip off the housing for the fuel filter on the engine. Can't see where it's coming from. It started sometime after I changed the filter a couple of months ago.
View 5 RepliesI have a 2011 Ford F-350 with 6.7L I have had cooling issues when pulling a trailer up a grade it heats up where it hadn't in the past. I had it in the shop 4 times before it went out of warranty and they changed the oil cooler and thermostat. The last time it was in the shop was November which it was to cold out to duplicate problem. It's heating up on just about every grade and now it's out of warranty when it should have been fixed last year.
I'm guessing it's the water pump because when I changed the antifreeze there was metal shavings in it. I told my dealer about it and they said it was probably from manufacturing. I haven't called dealer yet because I think it should be covered under warranty since the problem was never fixed after being in the shop last year!
Within the last month I've had 2 cracked fuel filters the filter up by the engine...
View 12 RepliesWell I finally had time to change out my composite oil pan to the metal one. Nothing was wrong with the old one but Ive seen the composite pans get hit by a rock and crack so I decide to get the metal one. It didnt take long once I had the oil drained and its very easy to get to. Once i had the old pan off I did find two piece of sludge stuck to the oil pickup screen, they had a sliver of aluminum in them. My oil reports have been coming back with high aluminum content so I am not really sure what to think being my motor had 33k miles on it now.
I also changed out the fuel filter and when I dropped the frame mounted filter I found about a teaspoon of rust in it. I'm not one to run my truck down to E but I admit I did so twice since the last filter change. Since I found the fuel filter kit for 60 buck(ford dealer wanted $140) I think I will move my fuel filter changes to 10k miles instead of 15k. Last but not least I also added SPE 6.7 Full Lock Diff Kit which allows the locked rear end to stay engaged past 20 mph. It was a simple 10 min installation with just a few wires and easy directions to follow
New oil pan
Composite pan
Old pan off and view of oil pickup
Two pieces of sludge that came off oil pickup screen
New pan on
Rust in the bottom
While driving from SD to Chicago today 2 warnings popped up at the same time saying to change the oil and fuel filters. Had both done 2500 miles ago. Am I right that the Dealer just didn't reset these? I thought these were measured by miles and driving habits.
View 8 RepliesI got fuel running dn from top fuel filter it looks like an filter hasn't been changed in a long while what could have happen?
View 5 RepliesWhile I was changing the oil yesterday, I also changed the fuel filters. The primary filter had some debris that was confirmed by a magnet to be metal. I have seen a little bit of this all three times I have changed the filters. The filter itself is very clean, but there remains a small amount of metal slightly more coarse than filings.
I don't really have any concerns that it could be coming from the HPFP because that is after the secondary filter and would not be returned to the tank. Also anything from the HPFP would have fouled several injectors by now. I don't even think there is any iron in the pump.
I guess it could be useful to put a magnet in the water separator reservoir, but I don't even know what good that would do since the debris is large enough that it is being caught by the filter and of course the secondary filter is even less microns. It would just be nice to know where in the world this stuff comes from.
Changed my filters and this was in the bottom of the filter housing. I looked on the pleats and down in the center didn't find anything. Went to two Ford diesel techs one said is was the hpfp and should do the the whole fuel system. The other said if the hpfp was coming apart the shaving would not be in the bottom of bowl and to check the filter again in 5k miles. No check engine light, drives great, no other problems.
View 14 RepliesReplaced both fuel filters same as usual. Cranked right up and I let her run while I put up the tools and look for leaks. Notice it started running rough, so I jumped in and started to back out of carport and it went dead. Ran battery down and it won't hit a lick. Replacement (racor) filter same as last few changes. Running just fine before change so it has to be something simple, but what?
2006 6.0 powerstroke
How many miles should I go before changing fuel filters and air filter?
View 14 Replies2013 6.7 F350 13,500 miles... Changed the fuel filters and got them bled out and truck runs OK but have a whining noise from the engine compartment fuel filter area.
View 14 RepliesI'm dripping fuel on top of the engine at the fuel filter . Where the line ties into the filter canister , there is a small plate that's attached with small Allen screws its dripping between this plate and the canister .... I assume there is a gasket/oring that is causing it ...... What is the part number or correct description so I can go to ford dealer and get one.
2007 Ford 4X4. 6.0 diesel